調制脈沖寬度 的英文怎麼說

中文拼音 [diàozhìmàichōngkuāndù]
調制脈沖寬度 英文
modulating pulse length
  • 調 : Ⅰ動詞1 （配合得均勻合適） harmonize; suit well; fit in perfectly 2 （使配合得均勻合適） mix; adju...
  • 制 : Ⅰ動詞1 （製造） make; manufacture 2 （擬訂; 規定） draw up; establish 3 （用強力約束; 限定; 管束...
  • 脈 : 脈名詞1. （動脈和靜脈的統稱） arteries and veins2. （脈搏的簡稱） pulse 3. （像血管的組織; 連貫成系統的東西） vein
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  1. Position control of d. c. motors has been done by means of pulse width modulation.

    直流電機位置用脈沖寬度調製法控制。
  2. Flexible dimming control utilizes either an analog control signal or direct digital pwm control without external rc filtering. this also increases dimming accuracy at low brightness levels

    電路採用靈活的調光控制方式，既可輸入模擬控制信號，也可直接輸入數字脈沖寬度調制信號而不需要外置rc濾波器。
  3. The feedback of the output voltage is the major control loop. to achieve better frequency response and disturbance rejection of the input voltage, a input voltage feed - forward system is introduced in control loop. the duty - cycle of pwm applied at the gate of power mosfet is modulated by both input and output voltage

    該晶元採用的控制方式為電壓型pwm （脈沖寬度調制， pulsewidthmodulation ）控制方式，以輸出電壓反饋作為主要控制參量，同時為了提高晶元對輸入電壓擾動的響應速度，採用了輸入電壓前饋方法，將輸入電壓因素引入了反饋控制環中，通過對輸入輸出電壓的檢測，控制加在功率mos管柵極電壓上矩形脈沖的占空比，進而調節輸出電壓。
  4. Due to the complexity of the structure and control of cycloconverter - type three - phase hf link inverter for soft - switching based on phase - shift - controlled full - bridge mode, a simple and optimized vvvf control strategy is proposed. this control strategy includes : produced pwm by space voltage vector ( svm ) and equivalent carrier frequency fe = 1 / te are introduced into the pdm control of the cycloconverter ; softened equivalent pwm wave is generated at the notches of hf voltage pulses ; the harmonious control between regulating pulse width by phase - shifted angle and regulating voltage of equivalent pwm is to minimize the harmonics content of output voltage of the inverter

    西安理工大學博士學位論文針對這種前級移相全橋軟開關周波變流型三相高頻鏈逆變器結構和控制的復雜性，提出了一種實現簡單而整體優化的vvvf控制策略:將空間電壓矢量產生p姍的方法svm和等效載波頻率fe = 1 / te引入到周波變流器的pdm控制;按高頻電壓脈沖前後沿軟化等效p翎波;用移相調節高頻脈沖寬度和等效p姍調壓協調控制逆變器輸出電壓，在滿足輸出電壓條件下使諧波最小。
  5. It works at high frequency with a selectable pin outside ; the working frequency is fixed at 640k / 1. 2mhz. so far as the output signal of the single - chip ic is concerned, the maximum time proportion of its high level is 88 percent, but the minimum one is 10 percent

    該控制器為pwm脈沖寬度調制方式;電路正常工作溫度范圍為- 20oc 85oc ;工作開關頻率根據外圍電路輸出電壓需要為640k / 1 . 2mhz可選;輸出信號的最大占空比為90 % ，最小占空比為10 % ，晶元主要應用於lcd電壓電源管理設備。
  6. The tests of e - o applications by our flux ktp has been realized, the results showed : optical waveguides fabricated by using an ion - exchange process, which have an exchange - ion concentration depth profile and refractive - index profile, is close to a complementary error - function distribution, optical homogeneity and device thermal stability is much better. amplitude modulation switch formed by our flux ktp has the contrast ratio of 150 : 1 and insert loss is 2. 5 % at 1064 nm. high quality optical pulse with 1 ns width was cut successfully by using an e - o modulator from a laser pulse with 50 ns width, this modulator had run for three years, and the crystal did n ' t blackened, it showed our low conductivity flux ktp can endure high modulation voltage for a very long time

    Ktp晶體的電光應用試驗表明：用離子交換法製作的電光波導，其離子交換濃度、折射率變化符合餘弦誤差函數，光學均勻性以及器件的溫度穩定性較好；製作的強度調制電光開關，消光比為150 ： 1 ，對1064nm激光的插入損耗為2 . 5 ；製作的電光調制器用於激光脈沖整形試驗，從脈沖寬度50ns的激光脈沖削出脈寬1ns的高質量光脈沖，該電光開關經過長達三年多的使用，沒有出現晶體變黑現象，說明本實驗的低電導率ktp晶體能夠耐受長時間的調制電壓。
  7. The antenna pointing control is open loop control without feedback. the antenna pointing errors due to antenna tracking motion and satellite attitude adjusting ( trusting ) were analyzed, as well as the influence of damping, tacking velocity and trusting time

    文章分析了天線作跟蹤運動和星體作姿態調整時，對星體姿態控制精度和天線的指向精度影響，同時分析了阻尼、跟蹤速度、噴氣脈沖寬度等因素變化對動力耦合程度的影響。
  8. In this paper, researching and producing on current waveform control system of inverter carbon dioxide welding machine is given. the overall plan, the design of hardware structure, the programming and debugging of software is described in detail. the bang - bang and alterable structure discrete pid synthetic control algorithm are used to modulate the width of pwm signal in real time, to acquire the fiat character by driving and controlling the opening and shutting time of igbt, the technology of " double impulse " is adopted to realize electric current waveform control

    本文介紹了逆變波形控制co _ 2焊機控制系統的研製，詳細闡述了總體方案的制定、硬體研製及軟體的編寫與調試，採用變結構、離散型pid + bang - bang復合控制演算法、實時調節輸出pwm信號的脈沖寬度，驅動控制用於逆變的大功率開關管igbt的開通與關斷時間，獲得逆變焊機平外特性。
  9. For the measurement of analog signals such as voltage and current of astg, a filter card for pre - disposing is designed, in order to improve real - time performance, algorithms for ac analog sampling is simplified, and a compensation algorithms for phase error due to sequence - sampling is brought forward. for the measurement of impulse - width signals such as rotor - speed and rotor - position - angle, an intelligent interface card based on isa bus is designed. all programs for measure and control based on c + + are compiled and debugged and the flow for system debugging is summarized

    為了提高實時性，對交流采樣演算法進行了簡化，並提出了由於非同步順序采樣所造成的相位誤差的補償演算法；針對轉速、轉子位置角等脈沖寬度信號的測量，深入分析了測量原理，設計了基於isa總線的智能介面卡；編制和調試了基於c + +的全部測量控製程序；完成了整個系統的調試，並總結了調試方法。
  10. Most drive systems offer a choice between transistorized silicone - controlled rectifiers and pulse width modulation over the full range of amplified voltages

    大多數驅動系統提供兩個調節全程放大電壓的選擇：晶體管化的硅樹脂控制整流器和脈沖寬度調制器。
  11. The whole pwm circuit contains two subcircuit, the front - end is pwm module that make up of the counter that based on nine mosfet true - single - phase - clock d flip - flop ; the back - end is demodulated module, which is consist of a three order chebyshev low - pass filter used trans - conductor capacitor. all the subcircuits are simulated. at last, an approving simulated result of the whole circuit is given too

    在調制部分，利用九管單相時鐘d觸發器構成計數器，並由此組成了脈沖寬度調制電路，同時給出了在典型溫度下的模擬結果;在解調部分，介紹了低通濾波器從無源到有源的設計方法，設計了三階切比雪夫低通跨導電容濾波器，同樣給出了相應的模擬結果;最後，作為將脈沖寬度調制電路和濾波器作為整體電路，以脈沖調頻波為輸入進行了模擬，取得了令人滿意的結果。
  12. The circuit utilizes 1mhz current - mode pulse width modulation ( pwm ) control to allow small input and output capacitors and a small inductor, while reducing the circuit ’ s volume and minimizing the input supply ripple to 15mv

    該電路採用頻率為1mhz的電流反饋模式脈沖寬度調制模式，可使外部電路選用小的輸入、輸出電容以及小電感，減小了電路的體積，同時能將輸入電壓紋波減小到15mv 。
  13. However, it is difficult to make the product available because most of the academic institution focused on certain aspect only. the experts indicate that the ic designers should know more about the system though they don ’ t design the system directly. it points out a way for us ic designers when we are engaged in the research work

    本文提出的開關變換器，利用反饋原理將輸出電壓穩定在某一需要的值，根據負載的不同而採取兩種控制模式，即脈沖寬度調制（ pwm - pulsewidthmodulation ）模式和脈沖頻率調制（ pfm - pulsefrequencymodulation ）模式。
  14. In the design, the diode of agilent ' s hsch - 9161 is used. with the diode circuits in parallel, the millimeter - wave short pulse detector has been designed. it works at the frequency of 37 to 38ghz, and the pulse duration is 400ps

    本文採用agilent公司的hsch - 9161檢波二級管，選取二極體並聯檢波電路形式，完成了工作頻率為37 ~ 38ghz 、脈沖寬度為400ps的毫米波短脈沖檢波器的研製，同時設計了一個毫米波短脈沖調制器。
  15. The sinusoidal pulse width modulation variable - frequency speed - regulated system based on 80c196mc microcontroller

    單片機的正弦脈沖寬度調制變頻調速系統
  16. This paper presents a new capacitive accelerator readout circuit used pulse width modulated ( pwm ) in single chip

    本文的目的就是研究與設計單片微硅電容加速度傳感器讀出電路中頻變脈沖寬度調制模塊。
  17. Abstract : the experiment about ignition property of solid e nergetic materials was done by laser which was generated by big powerful laser i nstrument - nd : yag. the influence on the ignition property of difference enery, puls e width and different frequency of laser instrument and different webs of the pr opellant. was studied and analyzed which may be used to do further researches for ignition

    文摘:使用大功率nd : yag激光器產生的激光，對固體含能材料的激光點火性能進行了實驗研究，分析了不同能量、脈沖寬度、調制頻率及藥粒尺寸等因素對點火特性的影響，為激光點傳火系統的研製提供了實驗依據。
  18. The main circuit of the design in this article we used is fb zvs pwm dc / dc converter, full bridge zero voltage switching pulse width modulation dc / dc converter, which is a full bridge circuit composed of four power switches using resonance to implement zero voltage when turning - on or turning - off

    本文設計的通信電源充電模塊的主電路採用的是fbzvspwmdc dc變換器，即全橋零電壓開關脈沖寬度調制的直流變換器，它是由4個功率開關管組成的全橋電路，利用諧振使每個開關管在零電壓的條件下完成導通和關斷。
  19. Pwm pulse width modulation

    脈沖寬度調制
  20. The system had auto startup and stop function by software. the dsp based motor control system had lower current harmonic, more efficient use of supply voltage than spwm, less switch loss. on the other hand, this system make a lower noise for the pwm modulation. frequency is up to 20khz

    本系統實現了電機的軟啟動、軟關斷功能，電機電流的諧波失真較少，電壓利用率比常規的正弦波脈沖寬度調制（ spwm ）有了較大的提高，器件的開關損耗也得到了明顯的減少。
分享友人
分享到 Line

分享到臉書