調制頻率 的英文怎麼說
中文拼音 [diàozhìbīnlǜ]
調制頻率
英文
chop frequency-
Frequency modulation is not possible with polychromatic light.
多色光不可能調制頻率。The system can generate three - phase spwm pulses and has following characters : the range of modulation frequency is from 0 khz to 4 khz. and can be divided to 7 classes to control. the carrier frequency may be selected up to 24 khz, and can be divided to 8 classes to control ; rotational frequency is defined to 16 bits
該系統能產生三相六路正弦脈寬調制（ spwm ）波形;調制頻率范圍為0 4khz ，分7級控制; 16位的速度控制解析度;載波頻率分8級控制，最高可達24khz ;系統介面兼容intel系列和motorola系列單片機;該系統控制簡單、精確，易修改，可現場編程;同時具有脈沖延時小、最小脈沖刪除、過壓和過流保護功能等特點，可應用於pwm變頻調速系統的全數字化控制。A comprehensive theory is presented for fm spectroscopy of doppler - broadened molecular iodine absorption lines. the relationship betwcen fm spectroscopy and modulation frequency and modulation index has been studied. the whole circuit for thc frcquency stabilized laser system has been developed
建立了多普勒加寬碘分子線性吸收fm光譜的一般理論，對fm光譜與調制頻率和調制度的關系進行了研究；並研製了532nmnd : yvo _ 4 / ktp碘吸收穩頻激光器的電路系統；提出了虛擬激光穩頻技術的概念。According to the results of experiments, the stability of detection and the significance of photocurrent normalized are discussed. how the illumination mode, the frequency and the resistance of photocurrent loop affect the response of photocurrent is analyzed in detail. and the pilot study on the real - time detection of laps system has been done
根據實驗結果分析討論了新系統的測量穩定性，以及光照射方式、光調制頻率和光電流迴路阻抗對光電流響應的影響，以及光電流歸一化處理的重要性，並且初步研究了laps系統的實用化實時檢測。The principle advantages of vcsels over conventional edge - emitting lasers lie in ultralow threshold current, small far - field divergent angle, high modulation frequency, potential for wafer level testing and the ease for single longitudinal mode operation and two - dimension integration. as a result they show considerable promise for applications such as optical fiber communication, parallel optical interconnects, optical information processing and neural networks, etc. a direct coupling theoretical model in quasi - three - dimension for the gain - wave guide vertical - cavity surface - emitting lasers has been created in this paper
它與傳統的邊發射激光器相比具有更優越的特性，例如，具有極低的閾值、較小的遠場發散角、調制頻率高、易實現單縱模工作和二維集成，無須解理封裝即可進行在片測試等，所以，它被廣泛應用於光纖通訊、并行光互聯、光信息處理、光神經網路等領域。From theoretical analysis, we know the existing demodulation methods have limitations as following : one is that the subtraction of the two signals frequencies will display as the result of demodulation when we demodulate two time - domain adding signals without modulating information ( fault information ) ; the other one is that aliasing phenomenon will occur as a result of getting absolute value, detection or square in the process of generalized demodulation analysis, such phenomenon will result in some superfluous frequency composition on the frequency spectrum, which will puzzle the detec tion of mechanical vibration. if the sampling frequency is selected from a suitable range, the aliasing phenomenon will be avoided ; the last one is that aliasing frequencies will be produced in zoom demodulation analysis because this algorithm cannot employ digital low - pass filtering to avert the folding frequencies of higher harmonics in the process of zoom sub - sampling
現有的解調分析方法存在以下三種局限性：將不包括調制信息（故障信息）的兩時域相加信號，也以其頻率之差作為解調信號而解出；廣義檢波濾波解調分析中，由於取絕對值、檢波或平方過程可能產生混頻效應，在解調譜中表現為無法分析的頻率成分，並由此推導出避免這種混頻現象的采樣頻率的選取范圍，從根本上避免此類誤診斷的產生；幾種細化解調分析新演算法中，因為無法在細化分析的選抽時進行數字低通濾波，有可能會出現調制頻率的高次諧波成分發生頻率混疊而反折到低頻部分的現象。The transform uses the scale of the signal to decompose and make self - adapting frequency band partition of the input signals. therefore the amplitude value and the modulating frequency of the flickering signal can be obtained. with the instantaneous frequency in this method, the present study also analyzes the signal in terms of both time and frequency, and thus gets the time at which the flickering signal occurs and terminates
運用該變換從信號本身的尺度特徵出發對信號進行分解的特點，對輸入信號進行自適應的頻帶劃分，從而求出了閃變的調制信號幅值和調制頻率;利用該方法中的瞬時頻率概念，從時頻兩方面同時對信號進行分析，從而獲得了閃變信號的發生時刻和終止時刻，得到了較好的檢測效果。Comparing with the traditional phase - shifted laser range finder, the method could implement the ranging with multifrequency by using single modulated frequency. it could not only solve the contradiction of the range and the precision, but has high degree of accuracy and wide range, simplify the hardware design, and reduce the cost. this paper introduced the theory of phase distance measurement, analyzed various testing methods and expatiated the hardware and the software for the proposal system
與傳統的相位法測距相比，本方法使用單調制頻率實現了多頻測距，有效地解決了相位法測距中測程與測量精度之間的矛盾，具有高精度、大量程、大噪聲容限的特點，而且簡化了硬體設計，降低了成本；其次在數據處理中採用數據加窗函數的方法，提高了方波信號的頻譜解析度，進而提高了測量的精度。Simulations on light intensity are validated by experiments and influence of mechanical dither on gyro frequency stabilization is studied for the first time. then it is point out that the key to improve the precision of frequency stabilization is to choose appropriate modulation frequency based on the frequency spectrum of sharp pulses, which is introduced by mechanical dither. thereafter, experiments of frequency stabilization under different modulation frequencies are made
通過實驗驗證了光強模擬結果，首次分析了機械抖動對穩頻的影響，指出提高機抖陀螺小抖動穩頻精度的關鍵在於：根據機械抖動引入的交流光強尖峰脈沖頻譜分佈選擇合適的調制頻率，並給出了不同調制頻率的穩頻實驗結果。Secondly, considering the need of frequency stabilization, mdrlg ' s light intensity is simulated. the simulations indicate that sharp pulses are produced in the ac light intensity by mechanical dither. as the pulses have a wide frequency spectrum and range over the modulation frequencies of frequency stabilization, mechanical dither may reduce the precision of frequency stabilization
其次，根據穩頻需要對機抖陀螺輸出光強進行了模擬，模擬表明機械抖動會在交流光強中引入尖峰脈沖，且尖峰脈沖頻譜分佈較寬，在小抖動穩頻調制頻率范圍內有功率輸出，因而可能降低穩頻精度。Numerical results show that the top - hat beam stl instrument is more sensitive than the gaussian beam stl instrument, with a maximum sensitivity enhancement factor of approximately 2. 3
測量了信號的衍射分佈，信號與激勵光功率、激勵光斑半徑、調制頻率、探測距離的關系，與理論吻合較好。Fiber lasers are very sensitive to environmental perturbations such as temperature fluctuations and mechanical vibrations due to their relatively long cavity length when the external environment changing. the cavity drifting produceing the phase noise and amplitude noise, this can cause the output pulse unstablely
但由於主動鎖模光纖激光器腔內有較長的光纖，而光纖的長度極易因外界環境的影響而發生漂移，因而調制頻率和腔長很難保持匹配。( 3 ). the theoretical analysis and the experimental study on an active mode - locked fiber laser are conducted. the harmonic mode - locked pulses of 2. 5ghz and 5ghz are achieved and the 2 - 4 order rational harmonic mode - locked pulses of 2. 5ghz are researched in active mode - locked erbium - doped fiber ring lasers
（ 3 ）對主動鎖模光纖激光器進行了理論分析和實驗研究，在主動鎖模摻鉺光纖環形腔激光器中實現了2 . 5ghz 、 5ghz的諧波鎖模，並在2 . 5ghz的調制頻率下獲得了二、三、四階的有理數諧波鎖模脈沖。Along with millimeter wave technology development, the high speed modulate 155mb / s millimeter wave receiver requires that the local oscilloscope performance should be excellent to satisfy its communication requirement. this article aimed at the requirement of 8mm millimeter wave receiver and developed a high performance millimeter yto frequency synthesizer. the article introduces several millimeter wave frequency synthesizers and analyzes their characteristic
隨著毫米波技術的發展，在毫米波段高調制速率的毫米波通信機對毫米波本振源提出了更高的性能要求，本文針對8mm高速寬帶155mb / s無線接入通信系統對毫米波本振源的要求，介紹了幾種毫米波頻綜的設計方案，並進行了分析，最後決定採用鎖相倍頻的方案。Abstract : the experiment about ignition property of solid e nergetic materials was done by laser which was generated by big powerful laser i nstrument - nd : yag. the influence on the ignition property of difference enery, puls e width and different frequency of laser instrument and different webs of the pr opellant. was studied and analyzed which may be used to do further researches for ignition
文摘:使用大功率nd : yag激光器產生的激光，對固體含能材料的激光點火性能進行了實驗研究，分析了不同能量、脈沖寬度、調制頻率及藥粒尺寸等因素對點火特性的影響，為激光點傳火系統的研製提供了實驗依據。This paper simulates and analyses the torque pulsation because of the modulation frequency and speed variation under ambipolar pulse width modulation, at the same time the results are given
本文對雙極性調制的無刷直流電動機模擬分析了轉速和調制頻率對轉矩影響同時給出模擬結果。This paper simulates and analyses the torque pulsation because of the modulation frequency and speed variation under ambipolar pulse width modulation ; the influence of snubber circuit, dead time effects, and modulation frequency to igbt pwm inverterbridge is taken into account, too
本文對雙極性調制的無刷直流電動機模擬，分析了轉速和調制頻率對轉矩影響；並綜合考慮緩沖電路、控制死區及載波頻率對pwm逆變電路中igbt開關損耗的影響。In this paper they study a position - detecting system based on microprocessor and psd ( position sensitive detector ). the method is as follows : when the ac - signal from psd which is illuminated by modulated light source passes through an active band - pass analog filter, it filters the ac signal which represents the object light source. then the dc - converter circuit transforms it into dc - signal which is used to calculate the position
這一系統採用的方法是通過對位置敏感探測器psd受到調制目標光源照射后輸出的模擬交流信號進行有源帶通濾波，提取出代表目標光源的調制頻率成份，再將該信號轉變為用來參與位置解算的直流信號，然後選用單片機組成硬體電路，對直流信號進行採集處理並與計算機建立通信，把數據送入計算機進行位置解算，分析判別目標光源和psd器件的相對位置。In order to improve the frequency stabilization of the doppler modulator, a series of affecting factors are considered in depth and optimized in the aspects of optics, mechanics and electronics
摘要為了提高激光多普勒調制器調制頻率的穩定度，通過從光學、機械、電子學等方面的優化，對影響多普勒調制器的各種因素進行了深入的研究。Pulse signal is connected by the customer. signal can be sine wave or square wave. modulation frequency can be to 1mhz few model can be to 10mhz ; inner modulation type no need signal from out side
外調制式激光器留有專用的信號介面，由用戶接入脈沖信號，信號可以是正弦波，也可以是方波，調制頻率可到1mhz個別型號調制頻率可到10mhz 。分享友人