調基振蕩器 的英文怎麼說

中文拼音 [diàojīzhèndàngqì]
調基振蕩器 英文
tuned-base oscillator
  • 調 : Ⅰ動詞1 （配合得均勻合適） harmonize; suit well; fit in perfectly 2 （使配合得均勻合適） mix; adju...
  • 振 : 動詞1. （搖動; 揮動） shake; flap; wield 2. （奮起） brace up; rise with force and spirit
  • 蕩 : Ⅰ動詞1 （搖動; 擺動） swing; sway; wave 2 （無事走來走去; 閑逛） loaf; wander; roam; loiter; go a...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  1. 3. a 4. 2ghz vco tuned by an accumulation - mode mos varactor in tsmc 0. 35 m sige bicmos process is obtained after debugging with the simulator spectrerf

    3 .基於tsmc的0 . 35微米鍺硅bicmos工藝，採用spectrerf模擬器進行壓控振蕩器的調試和模擬。
  2. In this dissertation, two kinds of optimization, methods are proposed. firstly, only these linking weights corresponding to the control rules that affect the control performance significantly are updated in order to reduce the compute works and speed up the training progress. secondly, the updating step is adjusted adaptively in accordance with the error and the change of error of the system based on the t - s model to get better performance

    針對模糊神經網路控制器一般存在著在線權值調整計算量大、訓練時間長、過度修正權值可能導致系統劇烈振蕩等缺點，提出了兩種模糊神經網路控制器的優化方法：在線自學習過程中僅對控制性能影響大的控制規則相關的權值進行修正，以減小計算量，加快訓練速度；基於t - s模糊模型，根據偏差及偏差變化率大小動態自適應調節權值修正步長，抑制控制器輸出的劇烈變化，避免系統發生劇烈振蕩。
  3. During the circuit design, the author analyzed the basic principle of the direct current motor, pwm control, h - bridge power driver, and two control techniques of h - bridge power drive circuit, designed its general structure, so the feasibility of the design is confirmed. then, reference, oscillator, power dmos gate drive circuit ( charge pump, bootstrap ), and dead time generation circuit are designed and analyzed in the sub - circuits. a current - controlled oscillator is presented in this thesis

    在電路設計中，作者介紹了直流電機的工作原理和數學模型、脈寬調制（ pwm ）控制原理、 h橋電路基本原理和h橋功率驅動電路的兩種控制模式，設計了驅動電路的總體結構，給出了電路的功能模塊，確定了設計的可行性，然後在子電路模塊中，重點分析設計了基準源電路、振蕩器電路、高端功率管柵驅動電路（電荷泵及自舉電路） 、低端功率管柵驅動電路和死區時間產生電路。
  4. The thesis discussed a parameter extraction program for the mosfet level1 model. in the analysis and design of circuit, at first, the thesis described the system function of the new dc - dc switching converter. then several sub - circuits of converter ic such as oscillator, over - temperature shutdown circuit, auto - restart counter circuit and control circuit were completely discussed

    在電路設計中，本文首先分析了開關電源電路的基本拓撲結構和psm調制模式，接著對開關電源變換器進行了系統的原理分析並設計了總體框圖，然後詳細設計了振蕩器電路，熱保護電路，自動重啟計數器電路和主控門邏輯等子電路並進行了功能模擬。
  5. Theoretical model of self - mixing interference in a linear frequency modulated laserdiode is presented by using the dynamic theory of semiconductor laser with weak external optical feedback. the characteristics of oscillation frequency shift and output power changes of the laser diode are analyzed by using the theoretical model. the absolute distance from front facet of laser diode to target can be found by measuring spectrum of output power of the laser diode

    使用半導體激光器在弱反饋條件下的動力學理論，建立了線性調頻半導體激光器的自混頻干涉理論模型.基於該模型，分析了激光器振蕩頻率偏移與輸出功率變化特性.通過測量激光器輸出功率譜，可以得到激光器前端面與被測目標之間的距離
  6. In the thesis, some of the most important functional modules of the smart power control ics are researched and designed, including voltage reference, voltage regulator, under voltage lockout, oscillator and zero - voltage comparator. their topologies, schematics and layouts are introduced and developed

    本畢業設計研究和提出了構成智能電源控制晶元的主要功能模塊，完成了其中若干模塊ip核的電路與版圖設計? ?包括基準電壓源，電壓調節器，欠壓鎖定比較器，振蕩器，電壓過零比較器等。
  7. In this circuit, reference current sources are used to charge and discharge capacitors. this oscillator ’ s output is very ideal through control circuit under 5. 7v reference voltage, and oscillator ’ s frequency and duty - cycle could be adjusted if reference current source or capacitors in the circuit was adjusted. and the changes of temperature and voltage affect stabilize of the frequency little

    此電路利用系統內部基準源產生的電流信號來對電容進行充放電，然後經過控制電路作用后，產生的輸出振蕩波形的上升時間和下降時間非常小，更接近理想矩形波形;通過調節基準源電流信號或者電容值大小，可調節振蕩波形的頻率和占空比，同時溫度和電壓的變化對振蕩器輸出波形頻率穩定度的影響很小。
  8. Finally, the rules used to design the induction motor and set the inverter v / f curve are summarized to improve the stability of the system movement in the forth part of the dissertation, three measures are brought forward to eliminate the system low frequency oscillation. the first measure adopts pulse based dead time compensation to suppress the oscillation. as second measure, considering the motor and inverter as an integration, the discontinuous space vector modulated strategy named dpwm3 is proposed for the first time to suppress the oscillation

    措施一是在總結常用死區補償方法的基礎上，提出脈沖為基礎的死區時間補償法（ pbdtc ）對死沈陽工業大學博士學位論文區進行補償，抑制系統的低頻振蕩;措施二是從逆變器與電機的機電一體化配合更加完善的角度，首次提出採用不連續空間矢量調制策略dpwm抑制系統的低頻振蕩;措施三是通過對系統中電機參數的調節，達到抑制系統低頻振蕩的目的;最後進行了實驗驗證。
  9. In the thesis, some of the most important functional modules of the pwm power control ics are designed and simulated, including error amplifier, voltage reference, voltage regulator, comparator, and oscillator. the topologies, schematics and layouts of some circuits are introduced and developed

    本畢業設計研究和提出了構成pwm電源控制晶元的主要功能模塊，設計了其中主要模塊ip核的多種結構電路並進行了模擬，完成了部分電路的版圖設計? ?包括誤差放大器，基準電壓源，電壓調節器，比較器，振蕩器等。
  10. It also gives the motive of the ka - band vco and mixer, associated with the subject ' s requirement and the realistic conditions, according to which a proposal is confirmed that the gunn diode and the varactor are mounted in the same cavity to fulfill the vco and an antiparallel diode pair is used to fulfill the harmonic mixer. in chapter 2, based on the basic theory of negative resistance oscillating, we analyses the gunn oscillator and it ’ s tuning character. chapter 3 introduces the theory of millimeter - wave harmonic mixer

    以此為根據結合課題需要和實驗室的實際條件，確定vco採用耿氏管腔體振蕩器形式，變容管與耿氏管安裝在同一個腔內以進一步減小體積，採用反向並聯二極體實現諧波混頻;第二章介紹負阻振蕩器理論及其調諧原理;第三章介紹毫米波諧波混頻器基本原理;第四章給出了振蕩器及諧波混頻器的設計過程，整個組件聯調的結果;最後是結束語，分析了電路中存在的問題，指出了改進方向。
  11. Based on this arithmetic, the high frequency characteristics of five - cavity with open boundary is calculated by the code written in fortran language. then the transit effect of five modes of five - cavity with open boundary is also calculated using code mathcad and matlab. the results show that the working mode of five - cavity transit tube oscillator is 3 / 6 mode, and the analysis of the theory are in good agreement with the simulation results

    根據從基於四腔渡越時間效應的自調制出發，經過一段飄移，然後再採用雙間隙提取腔邊耦合輸出高功率微波的思路，採用粒子模擬方法優化設計出一種峰值功率為1 . 5gw ，頻率為9 . 3ghz的六腔渡越輻射振蕩器，並研究了它的一系列工作特性。
  12. Using electronic sound oscillators and sophisticated photographic equipment, jenny documented the reality of wave phenomena underlying matter a new field he called cymatics by filming the instantaneous shaping effects of tones, music, and vocal sound on various substances.

    傑尼以電子聲波震蕩器electronic sound oscillators和精密照像儀器sophisticated photographic equipment拍攝到分佈在金屬盤上的各種物質粉末由於音調音樂和聲音的振動而瞬間成形的效果，證實了物質以波動為基礎。
  13. A new type of x - band high power microwave source - the resonator cerenkov oscillator - tapered amplifier tube ( rco - tat ) is put forward for the first time in the present paper. the proposed high power microwave device is based on a comprehensive investigation of related research work in the world and is in agreement with the demands to the development of practical high power microwave sources

    在較全面調研和認真分析高功率慢波器件發展趨勢的基礎上，結合返波振蕩器等切侖科夫器件和漸變錐形結構微波器件的特點，提出了一種新型x波段高功率微波發生器?低磁場諧振腔切侖科夫振蕩器?錐形放大管（ rco - tat ） 。
  14. In the control strategy, the basic value of rotation rate is calculated by corrected similar formulation and the adjustment value is ascertained by output of fuzzy controllers, the strategy can assure steady precision and to eliminate vibration

    在這種控制策略中轉速控制量的基值根據修正後的相似公式進行計算，而轉速控制量的調節值為模糊控制器的輸出，這樣做既保證了系統的穩態精度；也避免了系統振蕩。
分享友人
分享到 Line

分享到臉書