調整到零 的英文怎麼說

中文拼音 [diàozhěngdàolíng]
調整到零 英文
adjust to zero
  • 調 : Ⅰ動詞1 （配合得均勻合適） harmonize; suit well; fit in perfectly 2 （使配合得均勻合適） mix; adju...
  • 整 : Ⅰ形容詞1 （全部在內; 完整） whole; all; complete 2 （整齊） neat; tidy; orderly Ⅱ動詞1 （整理; 整...
  • 零 : Ⅰ數詞1 （零數） zero2 （數的空位） zero sign （0）; nought 3 （表示沒有數量;無） nil; nought 4 （...
  • 調整到 : fit to
  • 調整 : adjust; tune up; trim; trimming; variation; modulation; arrangement; debug; rectification; redres...
  1. No adjustment needed. the magnetic coil is static and does not need dust brushes or similar protective devices. all components are located in the main body ( the clutch housing ) for fast and easy installation with no need for further adjustmeng

    不需要做調整. . .由於是磁場線圈靜止型，可以免去灰刷等的維護工作，而且所有的零件全部安裝于主體（離合器輪殼） ，可以很簡單地安裝到機械中，不需要做調整。
  2. Voltage segment network constituted by electron switch of bta and controlled by single chip microcomputer constitutes a new fast electronic regulator. for bta cross zero touch off, sine wave which is exported is integrity. a new way to generate stable ac current is found with feed back control system by single chip microcomputer. so a new high power ac current regulator is developed

    採用單片機控制雙向可控硅作為電子開關所組成的電壓分節網路，組成新穎快速的電子調壓器；由於雙向可控硅過零觸發，所以其輸出是不失真的完整正弦波；再用單片機組成反饋控制系統，從而找到了交流穩流的新方法，研製出一個大功率交流穩流電源
  3. Abstract : voltage segment network constituted by electron switch of bta and controlled by single chip microcomputer constitutes a new fast electronic regulator. for bta cross zero touch off, sine wave which is exported is integrity. a new way to generate stable ac current is found with feed back control system by single chip microcomputer. so a new high power ac current regulator is developed

    文摘:採用單片機控制雙向可控硅作為電子開關所組成的電壓分節網路，組成新穎快速的電子調壓器；由於雙向可控硅過零觸發，所以其輸出是不失真的完整正弦波；再用單片機組成反饋控制系統，從而找到了交流穩流的新方法，研製出一個大功率交流穩流電源
  4. The change and adjustment in retail prices directly affect the living expenditure of urban and rural residents, government revenue, purchasing power of residents and the equilibrium of market supply and demand, and th e ratio of consumption to accumulation

    零售物價的調整變動直接影響到城鄉居民的生活支出和國家的財政收入，影響居民購買力和市場供需平衡，影響消費與積累的比例。
  5. It is observable from the development and evolution of china ’ s ancient supervision law that, china ’ s ancient supervisory laws and regulations had been on the process of continuous development and perfection : from attachment to an integral code to an independent system, from scattered clauses to a complete and rigorous special code, and lastly to a legal system that has complete contents, rigorous structure, harmonious interior, and unitive form. these changes reflected the authority ’ s gradual accumulation of supervisory experiences, and their increasing recognition of supervision legislation

    從中國古代監察法的發展與沿革可以看出，中國古代有關監察的法律法規是在不斷的發展完善之中的，這些法律內容從附著于整體法典到獨立成篇，從零星條文到完整嚴密的專門法典，直至成為內容完善、結構嚴密、內部協調、形式統一的監察法律體系，其變化反映了特定時代監察實踐的需要和對監察立法的日益重視。
  6. 5. no parts and components warranty will be delivered if customer or non - warranty - taker dismantles disassemble and adjusts parts, assembly of the diesel and components that are not allowed to be adjusted such as injection pump assembly lead sealing, and reassembles them within the warranty term, which however, fails to meet technology demand such as torque and advance angle of major bolts, resulting in failure and damage of relevant components, assembly and parts

    在保修期內，顧客或非承擔保修者拆卸解體調整柴油機的部件總成和規定不得調整的部位如噴油泵總成鉛封等，重裝后又未達到技術要求如重要螺釘的扭矩噴油提前角等，導致部件總成和相關聯零部件失效和損壞，由此涉及的零部件
  7. The governor must have provision for adjusting speed ( generator frequency ) and speed droop ( no load to full load )

    調速器必須具備轉速調整（發電機頻率）和降速降調整（零負荷到滿負荷）功能。
  8. Participate in project teams for the introduction of new parts, modifications and line transfers ensuring all bought out components are sourced in line with set timing plan

    參與新產品介紹、生產線轉移和調整的項目小組，確保所有采購的零件按時到位，並與生產線安裝計劃一致。
  9. Specifically, according to the w - w five parameters failure theory, the fracture criterion of crack is established, and the state of crack ( open or close ) is judged by the values of the crack strain. combining the two points, the predict - model about the failure of concrete material is established. this predict - model can predict 16 failure forms, and basing the different failure form predicted after crack, the stress - strain relationship matrix of concrete material is adjusted

    具體來講，根據w - w的五參數混凝土破壞理論，建立混凝土的開裂準則，根據開裂應變值來判斷裂縫是張開還是閉合，從而在兩者基礎上建立了裂縫的開裂預測模式，總共有16種開裂模式；裂后根據具體的開裂模式及殘余抗剪能力來調整混凝土的本構關系矩陣，即用等效剛度代替原有剛度，考慮到垂直於裂縫方向的剛度為零，這樣會使裂后的總剛出現病態，為此文中通過引用鬆弛系數來對出現裂縫的單元進行預處理，一方面可解決因過大的舍入誤差導致計算結果的不可信問題，另一方面就是可加速收斂。
  10. If the zero mark on the dial does not line up with the red jewel, adjust the height of the arm rest so that the mark and jewel do line up

    若鈕上的零標示並沒有對到紅寶石，調整唱臂架的高度使得兩者對齊[這我不清楚，要看到唱臂才會知道是什麼，可能是紅色的刻度吧] 。
  11. Its effects are certainly being felt in property prices, in the problem of finding jobs in hong kong for the unskilled, and in the pressures that the retail sector in hong kong has experienced

    當然，本港在物業價格非技術工人難以覓得工作，以及零售業面對的壓力等方面，我們都切實感受到調整過程所帶來的影響。
  12. When the ballbot ' s goal is to stand still, its control policy tries to simultaneously drive the body ' s position and speed as well as its tilt and tilt rate to zero in each direction, while minimizing the actions needed to do so

    若機器人要站立著不動，它的控制規則會試圖將身體的位置與速度，以及每個方向的傾斜和斜率同時調整到零，並且會盡量減少要維持不倒所需的動作。
  13. This paper contains three parts : cost estimating, profit decision and unbalanced bidding strategy. the cost estimaging part introduces the product assembly model and describes how to convert it to assembly logic net. then we use the msps algorithm to weigh the product complexity and get the analogy coefficient to estimate the cost. then we analyze the traits of bidding activity, erecting a profit decision model based on fuzzy set theory. this model can choose the best profit through quantifying quote objects, profit influence factor and candidate profits. then we introduce unbalanced bidding strategy on basis of the traits of the discrete manufacturing enterprise. we take amount, date, cost subjects and technology into account. we change the price of all parts of the product, in order to get more benefit negative influence. this paper introduces the design and implementation of the system

    接下來建立了基於模糊集的利潤率決策模型，以模糊集作為數學依據，量化企業投標目標、利潤率影響因素、投標利潤率三者之間的關系，為投標產品確定最適合的總利潤率，以最大化保證企業投標目標的實現。然後根據離散製造企業的特點，提出以bom為中心不平衡報價策略，從零件的需求數量、需求日期、成本科目劃分以及零件本身的技術難度進行考慮，通過在保持投標產品的投標總價基本不變的前提下，有意識有策略地調整產品各組成部分的報價，以達到既不提高總價，也不影響中標，又能在結算時獲得更理想的經濟效益的目標。
  14. First, it reviews the history of motivation in state owned enterprises. then it analyzes current motivation practice in state owned enterprises with the example of enterprise a, an affiliate of china space science and technology group. it is pointed out that current motivation level is relatively low at state owned enterprises due to insufficient attention, as well as loose and rigid management under the influence of old traditions

    首先對我國國有企業激勵歷史進行總結，並以航天科工集團某企業為例對當前國有企業激勵實踐進行分析，指出現階段我國國有企業激勵機制受長期計劃經濟體制的影響，雖然在改革中有所調整，仍未受到足夠重視，比較僵化和零散，激勵水平不高。
分享友人
分享到 Line

分享到臉書