負供電軌 的英文怎麼說

中文拼音 [fùgōngdiànguǐ]
負供電軌 英文
negative supply rail
  • 負 : Ⅰ名詞1 （負擔） burden; load 2 （虧損） loss 3 （失敗） defeat Ⅱ動詞1 [書面語] （背） carry on th...
  • 供 : 供Ⅰ名詞1 （供品） offerings 2 （口供; 供詞） confession; deposition Ⅱ動詞1 （供奉） lay （offerin...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 軌 : Ⅰ名詞1. （路軌;軌道） rail; track 2. （比喻辦法、規矩、秩序等） rut; path; course Ⅱ動詞[書面語] （遵循; 依循） follow
  1. In order to describe the actual working processes of dielectric barrier discharge ( dbd ) circuit, an analysis model of differential - difference equations was presented, based on the working modes of full bridge serial load resonant dbd circuit, which was adopted with phase shifting control

    摘要為描述介質阻擋放電型臭氧發生器電路的實際工作過程，在分析一種移相全橋脈寬調制下串聯負載諧振電源供電的臭氧發生器電路的基礎上，提出了採用微分差分方程來描述電路的工作過程，並給出了電路可能的工作軌跡。
  2. Negative supply rail

    負供電軌
  3. The thesis has done the widespread investigation and study to the domestic and foreign ’ s technologies of analogy low voltage and low power, and analyzes the principles of work, merts and shortcomings of these technologies, based on the absorption of these technologies, it designs a 1. 5v low power rail - to - rail cmos operational amplifier. when designing input stage, in order to enable the input common mode voltage range to achieve rail - to - rail, it does not use the traditional differential input pair, but use the nmos tube and the pmos tube parallel supplementary differential input pair to the structure, and uses the proportional current mirror technology to realize the constant transconductance of input stage. in the middle gain stage design, the current mirror load does not use the traditional standard cascode structure, but uses the low voltage, wide - swing casecode structure which is suitable to work in low voltage. when designing output stage, in order to enhance the efficiency, it uses the push - pull common source stage amplifier as the output stage, the output voltage swing basically reached rail - to - rail. the thesis changes the design of the traditional normal source based on the operational amplifier, uses the differential amplifier with current mirror load to design a normal current source. the normal current source provides the stable bias current and the bias voltage to the operational amplifier, so the stability of operational amplifier is guaranteed. the thesis uses the miller compensate technology with a adjusting zero resistance to compensate the operational amplifier

    本論文對國內外的模擬低電壓低功耗技術做了廣泛的調查研究，分析了這些技術的工作原理和優缺點，在吸收這些技術成果基礎上設計了一個1 . 5v低功耗軌至軌cmos運算放大器。在設計輸入級時，為了使輸入共模電壓范圍達到軌至軌，不是採用傳統的差動輸入結構，而是採用了nmos管和pmos管並聯的互補差動輸入對結構，並採用成比例的電流鏡技術實現了輸入級跨導的恆定;在中間增益級設計中，電流鏡負載並不是採用傳統的標準共源共柵結構，而是採用了適合在低壓工作的低壓寬擺幅共源共柵結構;在輸出級設計時，為了提高效率，採用了推挽共源級放大器作為輸出級，輸出電壓擺幅基本上達到了軌至軌;本論文改變傳統基準源基於運放的設計，採用了帶電流鏡負載的差分放大器設計了一個基準電流源，給運放提供穩定的偏置電流和偏置電壓，保證了運放的穩定性;並採用了帶調零電阻的密勒補償技術對運放進行頻率補償。
  4. A pulldown resistor to the negative rail will allow the output to approach that rail ( provided the load impedance is high enough, or is also grounded to that rail ), but only slowly

    一個下拉電阻器將允許輸出迫近迫近該電源軌（所提供的負載阻抗足夠高，或負載也是接地的） ，但這樣速度較慢。
  5. This paper introduces the design of propulsion & power supply system for shanghai maglev transrapid project, including the choice of power supply, the load caculation, the layout of 110kv & propulsion substation as well as the wayside equipment

    摘要簡要敘述了世界首條進行商業運營的磁浮列車線上海磁浮快速列車示?運營線的牽引供配電系統的設計，包括供電電源的確定、負荷的組成，變電所的布置和軌旁設備的組成等。
分享友人
分享到 Line

分享到臉書