負極性 的英文怎麼說

中文拼音 [xìng]
負極性 英文
negative polarity
  • : Ⅰ名詞1 (負擔) burden; load 2 (虧損) loss 3 (失敗) defeat Ⅱ動詞1 [書面語] (背) carry on th...
  • : i 名詞1 (頂點; 盡頭) the utmost point; extreme 2 (地球的南北兩端; 磁體的兩端; 電源或電器上電流...
  • : Ⅰ名詞1 (性格) nature; character; disposition 2 (性能; 性質) property; quality 3 (性別) sex ...
  1. Cluster models and quantum chemical methods were used to study the charge - discharge mechanism, performance and their relationship with the structure of lig for the purpose of providing a theoretical ground to the preparation, function improvement and application of materials

    本文採用簇模型並利用量子化學等方法探究了嵌鋰石墨充放電機制、能和與嵌鋰石墨結構間的關系,為材料的研製、改及應用提供材料設計的理論依據。
  2. Negative plates generally used litharge as the lead oxide material.

    板一般用氧化鉛做活動物質材料。
  3. This paper researches on the practical current and potential distributions on the positive and negative plates of automotive batteries in the course of their formation processes by the means of an in situ electrochemical scan, and then studies the influences of the formation and also the additives on the performance of the automotive plates

    本文利用電化學掃描方法研究鉛酸蓄電池正板在化成過程中電流密度和電位分佈及化成對板電能的影響。同時分析了正添加劑的質及其對能的影響。
  4. A molecule where the centers do not coincide is called a polar molecule.

    電荷中心不重合的分子稱為分子。
  5. A lot of experiments have been done in the process of exploiture soft packaging li - ion battery about how to choice the rational arts and crafts. the content include : how to deal with the collector, add how much pvdf in the material, how long the material need to stirring and the right viscidity, how much condubtivity agent the electrode need, what theckness is best, choice different collectors, the degree of dryness of the electrode, theckness of pressed model, how much electrolyte will be added, placement how long after added the electrolyte, system of formation how to influnce the battery, in formation the battery need or not need preesure from outside, how to vacuumize and the optimize matching positive pole and negative pole. with these practice make sure the parameter of the positive pole should less than 90 m ; according to different vacuumize order the conduc - tivity agent in anode will be 5mass % and 9mass %, respectively, and in cathode the data is 2mass % ; every 100mah added to 0. 4 ml electrolyte ; before formation the battery should be placement 8 hours and the system of formation must be less than 0. 01c before the voltage reach to 3. 0v ; should press in outside when battery in formation ; to these batteries which capacity more than 350mah the vacuum time not excess 15s ; the optimize matching positive pole and negative pole between 2. 10 : 1 and 2. 15 : 1. finally make out the battery which cycling performance and security are all very well

    液態軟包裝鋰離子電池的研究主要是對關鍵工藝進行了優化設計,具體包括:集流體的處理、 pvdf的加入量、漿料攪拌時間和粘度、導電劑的加入量、電膜的厚度、不同集流體的選擇、電膜的乾燥程度、壓型的厚度、電解液的加入量、注入電解液后靜置時間的長短、化成制度的影響、化成時電池所具有的壓力影響、抽真空的處理、正物質的匹配。最後確定出液態軟包裝鋰離子電池最佳工藝參數:正膜的厚度小於90 m ;根據化成時不同抽真空順序,確定正膜中的導電劑的加入量分別為5mass %和9mass % ;膜中導電劑的加入量為2mass % ;電解液的加入量為每100mah添加0 . 4ml ;化成前電池的靜置時間應當大於8h ;電池在3 . 0v之前採用小於0 . 01c的化成制度;在化成過程中應當施加一定的外部壓力;對於350mah的電池抽真空的延時不應大於15s ;而正物質的質量比應當在2 . 1 : 1 2 . 15 : 1之間。
  6. One was using the cyclic ether to pretreat the lithium metal electrode. and a favorable surface sei film was wished to form on the lithium metal, to enhance the interface stability of lithium electrode and the cycleability of lithium battery

    方法一:嘗試採用環醚類化合物對金屬鋰電進行表面預處理,預先在金屬鋰表面形成良好的表面sei膜,提高鋰電界面穩定和鋰的電化學能。
  7. Such additions to the negative paste produced the desired performance with the use of synthetic separators.

    這類板添加劑隨著使用合成材料隔板而產生合乎需要的能。
  8. The investigated anode materials include modified carbons, nitrides, silicides, oxides and novel alloys

    研究的材料主要有:改碳材料、氮化物、硅化物、氧化物和新型合金。
  9. The most important aim of this forum is providing information and opportunities for private enterprises, accelerating the enterprise transformation, promoting the international communication and cooperation of new power to a new step, as a leading orator, our board chairman expressed his particular opinions on " grasp the chances, adjust resource, sostenuto improve the core competition of our company among the new power field "

    4高功率mh ni電池的研究和改進從sc和d型電池入手,對其高功率放電能和組合電池放電能加以研究,通過對其正材料添加劑隔膜電解液等方面的研究改進,提高其大功率放電能,進一步適應市場的需要。
  10. Lithium metal is one of the electrode materials those have the highest specific mass energy, and the lithium secondary battery with lithium metal anode always attracts people ’ s attentions. whileas, before the commodity of lithium secondary battery, it is the dissatisfactory cycleability and safety of lithium metal anode that must be resolved firstly

    金屬鋰是目前已知的質量比能量最高的電材料之一,以金屬鋰作為材料的鋰二次電池長期受到人們的關注,但在其商品化之前,必須解決金屬鋰在循環能和安全能上的不足。
  11. The results show that : nano - nickel powder is not useful for mh electrode during the high rate discharge phase as a conductor or additive ; superfine nickel powder is applicable for the conductor of the negative because of the good performance especially the cyclic stability at 1c rate by using 5 % ( mass percentage ) nickel powder ; the utilization of alloy, specific mass and volume capacity are increased with the decreased particle size of nickel powder in negative, however, the capacity fading rate at 1c discharge rate is also increased, so the capacity and the cyclic stability should be taken into account to make a choice of the particle size

    結果表明: mh電中加入納米鎳粉對的大電流放電能不利。 mh電中加入超細鎳粉后電綜合能好,尤其是1c循環穩定,其最佳添加量為5wt 。減小鎳粉粒度提高了電合金利用率、質量比容量、體積比容量,但增大了1c容量衰減率,因此鎳粉粒度的選擇應綜合考慮mh電容量和循環穩定
  12. The effect of electrostatic force of the drive voltage on the accelerometer had been researched when the bias voltage polarity is positive - negative configuration

    前人在研究驅動信號對傳感器的靜電力效應時,用偏置電壓為正?配置的驅動信號進行研究。
  13. It has high selectivity in adsorpting water, polar molecule or polarizable molecule on account of the existing of mighty coulomb field and polar interaction in the internal of crystal cave of zeolite, the high electric field gradient and the uneven surface caused by the exposure of exchangable cation of equilibrium framework negative charge in framework structures

    由於分子篩晶穴內部有強太原理工大學碩士學位論文摘要大的庫侖場和作用,再加上骨架中大量平衡骨架電荷的可交換陽離子的暴露造成的高電場梯度及表面的不均,使其對水、分子及可化的分子具有高選擇的吸附能。
  14. The other was to research new li - al solid solution alloy material and use it as anode in lithium battery. by the trace alloy component, aluminum, doping in lithium metal, it was hoped to improve the sei film stability of lithium / electrolyte interface and consequentially enhance the performances of lithium anode. meanwhile, different form the previously studied lial alloy that had very high content of aluminum, such alloy should not decrease the mass specific energy and electrochemical potential of lithium electrode

    方法二:研究新型鋰鋁固溶體合金材料並將其應用於鋰二次電池中,通過微量合金成份鋁的摻雜提高鋰電/電解質界面sei膜的穩定,進而提高鋰負極性能;而該合金不會像以往高鋁含量的鋰鋁合金那樣降低鋰電的質量比能量和電化學反應電勢。
  15. Thank to the toner is negative polarity of almost laser printers. use the paper with positive polarity for laser printing and it is possible to conduct more toner and increase color saturation

    幾乎所有的激光印表機都採用負極性的碳粉,選用正的紙張做激光列印能引導更多的碳粉至紙張表面上,達到增加色彩飽和度目的。
  16. Both positive and negative electric fields have the similar effects. the vickers hardness is enhanced but the conductivity change little

    對電場正、負極性的研究表明,兩種電場作用具有類似的效應和規律。
  17. Kvl : in traversing any loop in any circuit, at any instant of time, the sum of the voltages having one polarity equals the sum of the voltages having the opposite polarity

    在任一瞬間,沿著電路的任一(有向)迴路繞行,正向電壓(具有正的電壓)之和等於反向電壓(具有負極性的電壓)之和。
  18. The main work and conclusion for this paper is as following : according to the flashover test results of several kinds of iced insulators under positive voltage and negative voltage, this paper obtained : for the single porcelain insulator, the single glass insulator and the composite insulator bridged completely by icicle, the metal cathode ' s strong ability of emission electron is the primary reason that results in the lower negative flashover voltage ; the position difference of the high resistance district in method anode side results in that porcelain insulator cluster and glass insulator cluster have an evident effect of polarity ; when less ice and no icicle at the brim of the sheds, due to numerous non - polar arcs on the composite surface, the effects of polarity of composite insulator was lost using the test method of the average flashover voltage in the freezing period, dc flashover performances were investigated of several insulators with some typical structures and different material

    本文的主要工作和結論如下:在人工氣候室內,根據不同覆冰絕緣子正、負極性下的閃絡試驗結果,得出負極性電弧金屬陰的強電子發射能力造成了單片瓷、玻璃絕緣子及被冰凌橋接的合成絕緣子有較低負極性冰閃電壓;正電弧金屬陽側產生高電阻區所處位置的差異使得瓷和玻璃絕緣子串具有明顯的效應;覆冰較少時,合成絕緣子表面出現數量較多的非電弧使合成絕緣子無效應。利用覆冰期內平均閃絡電壓的試驗方法,對不同材質和結構的絕緣子在覆冰、低氣壓和污穢共存環境中的直流閃絡特進行了研究。試驗結果表明,直流平均閃絡電壓隨著海拔的升高、覆冰量的增加以及污穢度的增加而降低,且其特徵指數與絕緣子結構、覆冰量、覆冰狀態、污穢度等有關。
  19. The main works are listed as follows : ( 1 ) based on the excitation of bi - directional current pulse technique, a new measuring circuit for weak variation of resistance was proposed for electrical resistance tomography. traditional ac current source is n ' t adopted as the exciting source. through fast bi - directional current switching, the polarization effects are eliminated

    該電路主要優點如下:該電路沒有採用傳統的交流電流激勵法作為系統的設計原理,而是通過快速的正負極性電流切換來削弱直流電流激勵時激勵電化效應,使通過直流法來測量氣液兩相流的電阻微弱變化成為可能。
  20. Therefore, on the basis of detailed review of research on prescription of mh electrode at home and abroad, faced to the application of d type power battery, effects of prescription of mh electrode on the performance of the negative electrode for ni / mh battery are investigated by the open cell method

    本文在詳細綜述國內外mh電配方研究的基礎上,面向d型鎳氫動力電池,採用開口電池方式研究了mh電配方對ni mh電池負極性能的影響。重點研究了稀土氧化物添加劑、 coo和ceo _ 2復合添加劑對ni mh電池電化學能的影響。
分享友人