負荷率 的英文怎麼說

中文拼音 [fùhélǜ]
負荷率 英文
burden rates
  • 負 : Ⅰ名詞1 （負擔） burden; load 2 （虧損） loss 3 （失敗） defeat Ⅱ動詞1 [書面語] （背） carry on th...
  • 荷 : 荷名詞（蓮） lotus
  • 率 : 率名詞（比值） rate; ratio; proportion
  • 負荷 : [電學] load; charge; weight
  1. Also a refined - pulp quality predictive model, with specific energy, specific load as the model inputs, and beating degree, wet weight as the model outputs, is presented. simulation results show that the models can be acted as theoretical bases for the automatic control of high - consistence pulp refining process

    即，建立了以原漿流量、白水流量、盤磨機功率為輸入變量，比能量、比負荷、濃縮機漿位為輸出變量的動態模型，以及基於比能量、比負荷的成漿質量預報模型。
  2. Advices : during the training time you should use the rneasurment of heartrate very efficenly to control the arrangement of burthen intensity

    建議：在運動訓練過程中應該運用心率的測量有效的控制負荷強度的安排。
  3. Long - hole and geometrical proportion type of mixing unit is finally adapted in lpg supply system, and power and torque output of lpg engine are improved by increasing compression ratio, and ignition characteristic is tried to adjusted to satisfy engine performance. meantime emission performance and noise level of lpg engine at full - throttle and other various part - throttle operations are tested and compared with former gasoline engine. ( 3 ) it is verified by engine dyno tests that lpg engine has better synthesized performance at aspects of power and torque, fuel economy, as well as emission than former gasoline engine

    選擇了等比例長孔式混合器控制空燃比；通過提高壓縮比來彌補動力性的損失；以動力性為主控目標，對最大功率點、最大扭矩點、中等轉速、最低轉速點所對應的發動機轉速做了點火特性的調節；通過空燃比的合理控制，直接改善發動機的動力性、經濟和排放指標；作為對缸內燃燒過程的理論分析，進行了燃燒特性的實驗測試；對原汽油機和新開發的液化石油氣發動機，進行了外特性和部分負荷特性以及怠速的排放及噪聲對比性測試。
  4. In the process of arithmetic design, newton " method is used to compute power flow of network. graph theory knowledge is used to determine all paths from generator to load. to improve efficiency, thesis use branch expunction method to optimize the node order

    在演算法設計過程中，採用牛頓拉夫遜法進行潮流計算得到系統潮流分佈，利用圖論原理中的路徑搜索演算法確定了發電機對負荷的供電路徑，此外為了提高潮流跟蹤的計算效率，利用了支路消去法進行節點順序的優化。
  5. The thesis discussed the fundamental which is voltage grade, reliability, connection mode, transformer load and power equipment

    論文闡述了城市電網規劃中電壓等級、供電可靠性、接線方式、變壓器負荷率取值和供電設施的基本原則。
  6. The autor thought that for the main transformer, the load rate should be increased above 85 % ; and for the distributor transformers set with the electrial room, according to efficiency first principle, the load rate should be control at 40 % ~ 60 %

    作者認為：主變壓器設計選擇時，應考慮提高其負荷率達85 %以上；電氣室配電變壓器選擇時，應按效率優先原則為主，其負荷率控制在40 % ~ 60 %之間。
  7. The regenerative electrothermal boiler heating system can increase the ratio of charge, it have nice developmental outlook

    能充分提高電網負荷率的蓄熱式電熱鍋爐供暖系統具有很好的發展前景。
  8. The competitive ability of power enterprises weakened and their profits declined as well. the thesis aims at shoving such existing problem as difficult selling

    文章中主要解決魏縣地區電力銷售困難，供大於求，電網負荷率過低問題。
  9. This present dissertation analyzed the practice of power price in china ’ s dsm by using quantitative method and qualitative method. though the price shifted part of peak load to the valley, and enhanced the electro - efficiency. it did not lead to the load ratio remarkably rise

    盡管電價在我國電力需求側管理中具有移峰填谷的作用，提高了電能的使用效率，但是，價格杠桿的運用沒有帶來用電負荷率的大幅提高，電價對調荷節電的作用並不明顯。
  10. Average load factor

    平均負荷率
  11. Load rate of plant

    設備負荷率
  12. Monthly load factor

    月負荷率
  13. Annual load factor

    年負荷率
  14. The results show that under the new power supply scheme, load rate of equipments, power factor of supply system and supply efficiency of system all have been greatly improved

    在新供電方案下，油田電網的設備負荷率、系統功率因數、供電效率都得到很大提高。
  15. Early exploited oilfields mostly adopt the power supply mode of single well & single transformer & single asynchronous motor, which causes that the load rate of equipments in oilfield network is low, the power factor of oilfield network is lower and the energy loss of oilfield network is bigger

    摘要早期開發的油田多採用「單井單變壓器單異步電動機」供電模式，造成油田電網的設備負荷率和系統功率因數過低，電網耗能較大。
  16. Based on the further study of dynamic characteristic of the tractor - implement combination, according to the integrated control model, which including the flowing three parameters : the engine load rate, drive wheel slip and work resistance, and the three control strategies, which are : highest production efficiency control strategy, oil consume economic control strategy and give attention to the above control strategy, we can adopt different control strategies according to different purpose of the task. applying the theory of the hybrid dynamic system to this case, the three control strategies can be abstracted to three discrete matters, and then the exchange model of the discrete matters of the top layer ( which called manage layer ) of the tractor - implement combination and the function decision model, which based on the nerve network, can be established. through this way, the best ad aptive controlling of the tractor came true

    本文研究了拖拉機機組的綜合控制問題及其最佳匹配方法，在深入研究機組動態特性的基礎上，根據發動機負荷率、驅動輪滑轉率和作業阻力三參數的綜合綜合控制模型以及三種綜合控制策略（最高生產效率的控制策略、燃油經濟性的控制策略和兼顧最高生產效率及燃油經濟性的控制策略） ，針對不同的作業目的，採用不同的控制策略，應用混雜動態系統理論，把三種控制策略抽象為三種離散事件，建立了拖拉機機組上層（管理層）離散事件切換模型，並建立了基於神經網路的功能決策層模型，從而實現了拖拉機機組的整機最優控制。
  17. On the base of thoroughly studying dynamic characteristic of tractor - implement combination, a control project of three parameters was put forward in the paper. the three parameters were engine load rate, drive wheel slip and work resistance. an integrated control model based on three parameters was established, which reflects colligated dynamic character of the unit

    拖拉機作業機組中，很多參數存在著耦合作用，給綜合控制帶來一定的難度，本文在深入研究機組動態特性的基礎上，提出了發動機負荷率、驅動輪滑轉率和作業阻力三參數的綜合控制方案，它反映了機組的綜合動態特徵，並建立了基於這三參數的綜合控制模型。
  18. As well, because of the development of national electric power industry, electric power supply is very enough, the popularize use of electrothermal boilers become possible the actual state of our country ' s electric power development makes the inactive standby capability of dynamos increased, ratio of electric power charge decreased, the difference of power transmission meshwork peak value and valley value become large

    同時由於我國電力工業的迅速發展，電力供應十分充足，為電熱鍋爐的推廣使用創造了有利條件。國內電力發展的現狀造成了機組停機備用容量明顯增加、負荷率下降、峰谷差拉大，給電網的調峰帶來了一定的難度。
  19. Under different rev and loads, the optimal diesel / alcohol proportion would be different. in order to find out the change rule of optimal diesel / alcohol proportion, an orthogonal regression rotating experiment of three factors ( rev, diesel / alcohol proportion and load ) at five levels has been carried out. based on the experiment, four regression equations including energy consumption, soot emission, noise level, and power equations concerning the three factors have been established

    在性能試驗的基礎上，還進行了三因素五水平的二次正交回歸旋轉組合試驗，建立了能耗率、煙度、噪聲、功率與轉速、酒精摻燒率及負荷率之間的回歸模型，通過分析可知，這些模型具有較高的可信度；利用這些模型，本文最後對不同工況下的最佳酒精摻燒率進行優化分析，並利用正交多項式回歸，求出了最佳摻燒率與轉速、負荷之間的回歸模型，該模型在今後的深入研究中將起到一定的指導作用。
  20. Seller ' s market is transiting to buyer ' s market. by sep. 1998, buyer ' s market has completely formed ; the average load rate of the power system is declining, and difference between apex and vale is becoming larger and larger ; power consumption increase rate in industry is dropping, and it is far lower than that of society power consumption

    分析表明：從1997年開始，重慶電力資源短缺狀況得到緩解，供需基本平衡，具備逐漸由賣方市場過渡到買方市場的徵候，到98年的9月已完全形成買方市場；重慶電網年平均負荷率逐年下降，峰谷差逐年加大；工業用電量持續下降，且其增長速度遠低於全社會用電量的增長速度，佔全社會用電量的比例逐年下降。
分享友人
分享到 Line

分享到臉書