負荷跟蹤 的英文怎麼說

中文拼音 [fùhégēnzōng]
負荷跟蹤 英文
load following
  • 負 : Ⅰ名詞1 （負擔） burden; load 2 （虧損） loss 3 （失敗） defeat Ⅱ動詞1 [書面語] （背） carry on th...
  • 荷 : 荷名詞（蓮） lotus
  • 跟 : Ⅰ名詞（腳的後部或鞋襪 的後部） heel Ⅱ動詞1 （在後面緊接著行動） follow 2 （指嫁給某人） be marrie...
  • 蹤 : 名詞（腳印; 蹤跡） footprint; track; trace; trail
  • 負荷 : [電學] load; charge; weight
  • 跟蹤 : follow the tracks of; tail after; following; follow up tracing; track; tracking; trail; lock on; ...
  1. In the process of arithmetic design, newton " method is used to compute power flow of network. graph theory knowledge is used to determine all paths from generator to load. to improve efficiency, thesis use branch expunction method to optimize the node order

    在演算法設計過程中，採用牛頓拉夫遜法進行潮流計算得到系統潮流分佈，利用圖論原理中的路徑搜索演算法確定了發電機對負荷的供電路徑，此外為了提高潮流跟蹤的計算效率，利用了支路消去法進行節點順序的優化。
  2. First from system aspect, this paper uses voltage sensitivity, pv curves method, equivalent reactive compensation method, back - up generation method to evaluate the reactive value of the generators in seven buses system and ieee 14 buses system. the vs and pv methods can evaluate the source ' s ability of tracking the load ' s variation. the erc and back - up methods can evaluate the availability of replacing other generators. the value determines the cost

    從對系統貢獻角度，採用電壓靈敏度方法（ vs法） 、 pv曲線法、等效無功補償法（ erc ） 、無功備用方法來確定一個七節點系統中的發電機的無功價值和ieee14節點系統的發電機的無功價值，電壓靈敏度法和pv曲線法可比較出不同電源跟蹤負荷變化的靈敏度大小，而等效無功補償法和無功備用方法可比較出不同電源替換其它發電機是否是最有效率的。
  3. It can serve for synchronous spinning reserve, load following, frequency control and synchronous condenser operation. due to the difficulty of quantitative calculation, the typical cases on dynamic function of pumped storage plant are qualitatively analyzed in this paper

    抽水蓄能電站具有運行靈活、啟動迅速的特點，其在電力系統的動」態效益主要表現在緊急事故備用、負荷跟蹤、調頻和同步調相上。
  4. The assignment of the load of the steam turbine can be solved by the reverse follow, the assignment of the load of the boiler can be solved by dsfd

    根據兩種規劃問題的特點，汽輪機系統負荷分配問題採用分枝限界反向跟蹤的優化演算法來求解，鍋爐系統負荷分配問題採用轉動坐標軸直接搜索可行方向法（ dsfd法）來求解。
  5. Tune the trace file or table workload

    優化跟蹤文件或跟蹤表工作負荷。
  6. Execute individual queries or workload trace files and monitor

    執行單獨的查詢或工作負荷跟蹤文件，監視
  7. Trace file or trace table workloads that contain the loginname data column

    包含loginname數據列的跟蹤文件或跟蹤表工作負荷
  8. But in fact, most of these efforts try to get a good trade - off between the tracking characteristic and the anti - disturbance characteristic. when the controlled object changes as load changes, the control performance will manifestly deteriorate

    但其實質上是在系統的跟蹤特性和抗干擾特性取得較好的折衷，而且當被控對象隨負荷變化時，其控製品質要明顯下降。
  9. For information about using the sql trace stored procedures to create a trace file workload, see

    有關使用sql跟蹤存儲過程來創建跟蹤文件工作負荷的信息，請參閱
  10. Column from the events that were not tuned, and then save only the untuned events in a new trace file or table

    列來創建新的工作負荷，然後只將未優化的事件保存到新的跟蹤文件或跟蹤表中。
  11. Because existed power flow tracing method is too complex, a new power flow tracing method is put forward, including downstream tracing and upstream tracing. the method accords to proportional sharing principle, then the line flow " constitution of generator and load can be got, as well as relationship between generator and load

    針對現有潮流跟蹤的復雜性，提出了按比例分配原則進行潮流順流和逆流跟蹤的演算法，得到線路潮流中各用戶引起的潮流組成以及電源和負荷的供用電關系。
  12. This paper validates the feasibility of the proposed method by proceeding the simulating calculation of typical run day of ieee - 30 nodes system, and analyses the transmission rate in the situation of the different transmission power quantity and load level with the consideration of the line constraint

    本文通過對ieee ? 30節點系統進行跟蹤潮流與過網費用的模擬計算，分析了在不同負荷水平下，不同時段過網費用的變化規律，驗證了本文所提方法的合理性。
  13. Make sure that tracing has stopped before using a trace table as a workload

    確保在將跟蹤表用作工作負荷之前已經停止了跟蹤。
  14. To create trace file and trace table workloads by using sql server profiler

    使用sql server profiler創建跟蹤文件和跟蹤表工作負荷
  15. To create trace file or trace table workloads, use sql server profiler

    若要創建跟蹤文件或跟蹤表工作負荷，請使用sql server事件探查器。
  16. Utility takes trace files, trace tables, and transact - sql scripts as workloads

    實用工具使用跟蹤文件、跟蹤表和transact - sql腳本作為工作負荷。
  17. Make sure that tracing has stopped before using a trace table as a workload for database engine tuning advisor

    在使用跟蹤表作為數據庫引擎優化顧問的工作負荷之前，確保跟蹤已停止。
  18. The workload can be a sql server profiler trace file or table, or a transact - sql script

    工作負荷可以是sql server profiler跟蹤文件或跟蹤表，也可以是transact - sql腳本。
  19. Database engine tuning advisor assumes that the workload trace file is a rollover file

    數據庫引擎優化顧問假定工作負荷跟蹤文件是滾動更新文件。
  20. Specifies the name of a table containing the workload trace for tuning

    指定包含用於優化的工作負荷跟蹤的表名。
分享友人
分享到 Line

分享到臉書