負電流測試 的英文怎麼說

中文拼音 [diànliúshì]
負電流測試 英文
negative current test
  • : Ⅰ名詞1 (負擔) burden; load 2 (虧損) loss 3 (失敗) defeat Ⅱ動詞1 [書面語] (背) carry on th...
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : Ⅰ動1 (液體移動; 流動) flow 2 (移動不定) drift; move; wander 3 (流傳; 傳播) spread 4 (向壞...
  • : 動詞1. (測量) survey; fathom; measure 2. (測度; 推測) conjecture; infer
  • : 名詞(古代占卜用的器具) astrolabe
  • 電流 : current; galvanic current; electric current; electricity; current flow電流保護裝置 current protec...
  • 測試 : test; testing; checkout; measurement
  1. The test shall demonstrate to the satisfaction of the owner that the equipment meets all specified performance criteria, is properly installed and anchored, and operates smoothly throughout the specified speed range without exceeding the full load amperage rating of the motor or excessive motor heating

    應該讓用戶滿意,證明這些設備符合所有規定的性能標準,經過正確的安裝和錨固,在額定轉速范圍內運行平穩,沒有超過機的額定滿荷運轉安培數,或發生機過熱。
  2. It looks upon water resistant as load, simulate every instance of locomotive running and check its every parameter automatically, then collect and dispose these data of parameters, calculate the power of simulating running of locomotive, which is based on the current, and voltage of host dynamotor. afterward, it can be judged from the working state of locomotive. through experiment and adjust each parameter, it can provide important warrant to the components of locomotive whether they can work normally and credibly

    即以水阻作為載,模擬機車運行,對機車的主發動機的壓和柴油機的轉速等參數進行檢,並對檢結果進行處理,計算出模擬機車運行時的功率,並以此為依據,對機車的工作狀念進行判斷,通過水阻驗,調整有關參數,使機車運行時能發揮所要求的功率和滿足規定的工作特性。
  3. The auxiliary motor test - bed is one of the devices which can examinant and tests the auxiliary motor ' s general performances such as d. c engine, a. c engine and phase converter

    機車輔機驗臺便是責對直機、交機、劈相機等機車輔機綜合性能的驗檢修的設備之一。
  4. Energy consume, electric strength, insulation resistance, ground conductivity, leakage current, microwave leakage, power input, normal temperature, humidity treatment, glow wire, horizontal flame, vertical flame, tracking, ball pressure, rainproof, water splash, dustproof, salt fog, endurance, motor load test, cord flexing, cord pulling, pull & torque test, lamp replacement, construction check etc

    能耗、氣強度、絕緣阻、接地連續性、泄漏、微波泄漏、功率、溫升、濕熱驗、灼熱絲、水平燃燒、垂直燃燒、漏起痕、球壓驗、防雨淋、防濺水、粉塵、鹽霧、耐久性(壽命)驗、驗、源線彎折、源線提拉、拉扭力、燈頭互換性、安全結構檢查等。
  5. It shows that the injection quantity and the difference of temperature distribute as a parabola which is at the same load, and the minimum of the parabola corresponds to the optimum quantity of injection ( g ). under the condition that the quantity of injected mass, the air speed and the heat quantity is respectively g, v and q, the research demonstrates that the pentium iv chip ' s temperature variation can be controlled under 40c and work normally when the wind speed overpass 1. 5m / s and the power dissipation of the chip is 60w. otherwise this paper calculates the flooding limit of thermosiphon with several different methods

    對其充灌量、散熱量、子元件( cpu模擬晶元)表面與環境溫度之差及通風、速的影響進行了系統的,發現充液量與溫差的關系在荷不變時呈拋物線分佈,其極小值點對應的充液量是最佳充液量g 。在充液量為g時,對風速v 、散熱量q進行的研究表明,當風速超過1 . 5m / s后,奔騰晶元在60w發熱條件下晶元溫度小於40 ,能滿足長期正常工作。
  6. Therefore, the power department and users are concerned aboui harmonic and reactive compensation. the power department usually manage compute and measure the electric net " s harmonic condition and connected or new - connected harmonic load. and need to measure the harmonic vol tage current in some electric net " point. then, by manual making an in - depth analysis and statistics on measured - data, it can reduce harmonic harm on public not to take some effective measures

    力部門通常在實際中,需要對網的諧波狀況、已接入和新接入系統的諧波源荷進行管理、計算及量,需要對力網路各點的諧波壓、實際水平進行,然後對數據進行人工分析統計,並以此採取相應措施降低或減少諧波對網的危害。
  7. Each unit of transformer is tested in accordance with the following items : winding d. c resistance test. measurement of turn ratio and calibiation of voltage vector relation. measurement of impedance voltage and load loss

    匝數比量及壓矢量關系的校定阻抗壓及載損耗的量空載損耗及空載量工頻耐壓感應耐壓絕緣局部放外觀和尺寸的檢驗銘牌的檢驗等。
  8. Windings d. c. resistance measurement, measurement of impedance voltage and on - load loss, measurement of no - load loss and on cload current, power frequency withstand voltage test, inductive voltage with standing test, measurement of partial discharge level, inspection of appearance and dimension inspection of name plate

    匝數比量及壓矢量關系的校定阻抗壓及載損耗的量空載損耗及空載量工頻耐壓感應耐壓絕緣局部放外觀和尺寸的檢驗銘牌的檢驗等。
  9. With regard to hardware, rigorous stress tests conducted by kcrc indicated that the earth return and surge arresters problems had been resolved after improvement had been made

    硬體方面,九鐵進行了的嚴竣證實,經過改良后,力迴及限壓器問題已經解決。
  10. Sub - c mh - ni power batteries were prepared with excellent electrochemical performance based on the research of the high rate performance at different temperature. the change of temperature, impedance and weight loss was investigated in the process of recycle at high rate. it showed that the discharge time is 5. 9min at 10c and the middle voltage is 1. 05v

    三、根據對池大和溫度性能的研究,研製了具有較好化學性能的動力型鎳氫池,並分別池在大循環過程中的溫度、內阻、重量和正極板等的變化情況,以此分析引起池性能衰減的原因。
  11. The investigation of the measure principles of direct current attenuation method, voltage integral method, and direct load method

    較為深入的研究了直衰減法、壓積分法和直接載法的原理。
  12. The inverted pwm changing electric current the technique is applied in the prototype model. the prototype model was tested and operated on spot, power factor could reach beyond 0. 95, the effect of following modulating voltage was better, the curve of factor of modulated voltage of exchanging systems changed following load rate was linear, the output of wave form was a flat and steady sinusoidal wave

    樣機採用了逆變式pwm變技術,對其進行了現場運行,結果是網側的功率因數可達0 . 95以上,跟蹤調壓效果良好,變系統輸出調壓系數( k )隨載率( p )的變化曲線基本滿足直線關系,輸出波形呈平滑穩定的正弦波。
  13. So the equipment is schemed out to simulate the work - state of aepds, according to the in - out signals of every solid - state power controller ( sspc ) and the stochastic voltage and current of buses. the top - down design method is adopted in the design

    所以作者根據固態功率控制器輸入、輸出信號模擬多路載,以及匯條的壓、等在飛機配系統中的各種工作狀況,研製了「先進飛機配終端自動裝置」 。
  14. Reecat company adapts dc - power test system, go on speed performance test, load test, heat circulation test, durability test. use in motorcycle matching test, catalyst performance aging test

    利凱特使用的是直功機系統,可進行速度特性荷特性驗熱磨合循環驗強化耐久驗,主要用於摩托車匹配驗和催化劑性能及老化驗。
  15. Reecat company adapts dc - power test system, go on speed performance test, load test, heat circulation test, durability test. use in motorcycle matching test, catalyst performance & aging test

    利凱特使用的是直功機系統,可進行速度特性驗、荷特性驗、熱磨合循環驗、強化耐久驗,主要用於摩托車匹配驗和催化劑性能及老化驗。
  16. Xitron ballast analyzers have the speed and versatility to completely change the way ballasts and tubes are being tested

    Xitron鎮器分析儀擁有其處理器與軟體從而提供順序,控制源來源及使量同步化于載功率應用
  17. Firstly, the experimental phase current and input power data obtained from load test are employed to estimate the parameters in ii rated condition. then, the phase current and input power data in locked rotor condition are used to track the variation of the parameters of the secondary coil with slip frequency. the classical method and the direct modification method are also used to estimate the parameters of the induction machine in comparison with this technique

    首先利用了驗的定子和輸入功率數據來識別額定工況下的機參數,然後又使用了堵轉時的定子、輸入功率數據來識別機二次繞組參數隨轉差頻率的變化,並與傳統參數方法和直接修正參數法進行了比較。
  18. By analyzing and rat testing on the current negative feedback, the voltage negative feedback and the electricity - powered loudspeaker, this paper shows that the current negative feedback can decrease the distortion of the loudspeaker, makes the frequency - response plot more smooth and improves the audio quality greatly

    摘要本文通過對反饋和反饋兩種路與動式揚聲器構成的系統進行對比分析,並進行實時分析,證實了反饋對動式揚聲器失真能從實質上得到改善,從而使頻響曲線更加平滑,音響系統的性能明顯提高。
  19. Gossip is more powerful than truth, a study showed on monday, suggesting people believe what they hear through the grapevine even if they have evidence to the contrary

    據德國邁克斯& # 8226 ;普蘭克研究所責人、進化生物學家拉爾夫& # 8226 ;索姆費爾德介紹,研究人員藉助一個腦游戲對學生們進行。結果發現,言在人們做決定的過程中起了重要作用。
  20. The charging - discharging performances of these samples used as the negative electrodes in lithium ion batteries ( lib ) were investigated by galvanostatic charging - discharging experiments and powder microelectrode cyclic voltammetry experiments

    用恆充、放實驗和粉末微極循環伏安實驗來檢上述ant樣用作鋰離子極材料時的充、放性能。
分享友人