負電流 的英文怎麼說

中文拼音 [fùdiànliú]
負電流 英文
negative current
  • 負 : Ⅰ名詞1 （負擔） burden; load 2 （虧損） loss 3 （失敗） defeat Ⅱ動詞1 [書面語] （背） carry on th...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 電流 : current; galvanic current; electric current; electricity; current flow電流保護裝置 current protec...
  1. The test shall demonstrate to the satisfaction of the owner that the equipment meets all specified performance criteria, is properly installed and anchored, and operates smoothly throughout the specified speed range without exceeding the full load amperage rating of the motor or excessive motor heating

    測試應該讓用戶滿意，證明這些設備符合所有規定的性能標準，經過正確的安裝和錨固，在額定轉速范圍內運行平穩，沒有超過電機的額定滿負荷運轉電流安培數，或發生電機過熱。
  2. The load current is handled directly by the controller through semiconductor switching devices.

    負荷電流由調節器通過半導體開關元件直接控制。
  3. In this paper, a kind of output current feed - forward circuit is added into the input of the current loop. by adding this compensatory circuit, the output character of the inverter is improved greatly

    本文還研究了一種提高逆變器輸出電壓外特性的思路，通過將負載電流正反饋給逆變器的電流環輸入端，從而達到提高輸出電壓的外特性的目的。
  4. It looks upon water resistant as load, simulate every instance of locomotive running and check its every parameter automatically, then collect and dispose these data of parameters, calculate the power of simulating running of locomotive, which is based on the current, and voltage of host dynamotor. afterward, it can be judged from the working state of locomotive. through experiment and adjust each parameter, it can provide important warrant to the components of locomotive whether they can work normally and credibly

    即以水阻作為負載，模擬機車運行，對機車的主發電動機的電流、電壓和柴油機的轉速等參數進行檢測，並對檢測結果進行處理，計算出模擬機車運行時的功率，並以此為依據，對機車的工作狀念進行判斷，通過水阻試驗，調整有關參數，使機車運行時能發揮所要求的功率和滿足規定的工作特性。
  5. Because of the elements which run under nonideal linearity and unentire symmetry in the power system, the loads which are different and change randomly, the methods which adjust and control the system faultily and operate improperly, the disturbance and the malfunction which happen somewhere, the current and voltage in the supply system are distorted seriously and thus large amount of harmonics are produced

    但是，由於電力系統元件運行的非理想線性或非完全對稱、負載的性質各異且隨機變化、調控手段的不完善以及錯誤操作、外來干擾和各種故障的存在，供電網中的電流（電壓）發生畸變，產生大量諧波。
  6. In order to eliminate the influence of the output filter capacitor current on the grid current, a novel control strategy for the grid - connected inverter in grid - tied and off - grid modes is proposed. the control strategy can also realize seamless transfer between grid - tied and off - gird modes. the grid - connected inverter can supply power to the critical load when the grid is off

    本文針對傳統並網控制策略進網電流受輸出濾波電容電流影響的問題，提出了一種新的並網控制策略，該控制策略能基本消除輸出濾波電容對進網電流的影響，實現獨立與並網兩模式之間的無縫切換，對關鍵負載起不間斷供電的作用。
  7. The products is of high water hydrophobe device usedin suitable and has the characteristics of aging resistance, resistance, tracking resistance, and corrosive resistance. it can withstand high bent load, strong impact force fn12 - 12 series indoor use high voltage load switch fn12 - 12 and fn12 - 12r is of three phases indoor use ac high voltage load switch for breaking and making the circuit of 50hz, 12kv system under rated loading

    Fn12 - 12和fn12 - 12r組合電器是額定電壓12kv額定頻率50hz的三相高壓開關設備用於分合負荷電流閉環電流空載變壓器和電纜充電電流關合短路電流配裝接地開關的負荷開關，可以承受短路電流
  8. The theories and design principles of each circuit of the spwm three - phase frequency inverter experiment unit are in detail introduced in this thesis. at the same time some experiment results are shown that include the output voltage and current waves when the load is in resistivity, inductivity or asynchronous motor

    文中詳細介紹了spwm三相變頻實驗單元所包含的各電路環節的理論基礎及設計過程，並給出了調試結果，如負載為阻性、感性和異步電動機時，實驗單元輸出的電壓和電流波形。
  9. The distributions of current density and potential on the negative plates with the radiational or expanded grid designs are more uniform than those on the positive plate

    輻射式和拉網式負極板在化成開始時電流密度和電位的分佈都比正極板上分佈均勻得多。
  10. At the end of the formation, both current and potential distributions are uniform. however, their distributions on the negative plate with the expanded grid design are a little more uniform

    化成結束時電流密度和電位分佈都比較均勻，且拉網式負極板比輻射式負極板更均勻。
  11. When formed for 8h, because most of paste on the negative plate has converted into lead, the polarization increases and the potential changes greatly, these distributions on the two kinds of negative plates become non - uniform again

    當化成8h時，由於負極板上的鉛膏大部分轉化為鉛，極化上升，電位變化很大，所以兩種負極板上電流密度和電位分佈又變得不均勻。
  12. This paper researches on the practical current and potential distributions on the positive and negative plates of automotive batteries in the course of their formation processes by the means of an in situ electrochemical scan, and then studies the influences of the formation and also the additives on the performance of the automotive plates

    本文利用電化學掃描方法研究鉛酸蓄電池正負極板在化成過程中電流密度和電位分佈及化成對極板電性能的影響。同時分析了正負極添加劑的性質及其對極板性能的影響。
  13. There is great change of negative current component when it happens the line - open fault. it is marked as the occurrence of the fault. and it can be concluded the phase characteristic of negative current in the line. in the transient course, there are plenty of harmonics in the fault line. through the transient analysis, it is drawed that the amplitude of each harmonic in fault phase is greater than other phases. harmonic current in fault line is far greater than other normal lines

    發生斷線故障以後，線路中會出現負序電流的突變，可以作為故障啟動判斷的標志，並且通過分析得出了故障時負序基波電流的相位特點。在故障暫態過程中，故障電流中含有大量豐富的諧波成分，各次諧波在故障期間有突變，並且衰減很快。
  14. The former was related to mn doping, both of p - carries supplied by la3 + or oxygen hole and n - carries induced by changing mn4 + into mn3 + can be locally displaced and simultaneously response with external electric field., furthermore due to the overlaps between positive and negative carries. the latter was due to the phase transformation between orthorhombic and cubic, which was in fact the curie point

    前者為la ~ （ 3 + ）和氧空位等產生的p型載流子和mn離子變價引入的n型載流子在外電場下發生局域重排產生的載流子極化，且由於正負載流子的迭加效應所致，該介電峰與mn離子的摻入相關；後者為體系出現相應的正交與立方結構的轉變所致，也即居里點。
  15. Bias voltage, which are related to the superlattice structural paraments, the doped densities and the applied bias voltage. we have also investigated the characteristics of superlattice under hydrostatic pressure by simulations

    超晶格的負微分電導區還導致出現固定偏壓下隨時間變化的電流自維持振蕩，振蕩產生的條件依賴于其結構參數，摻雜濃度和外加偏壓的大小。
  16. The second, at the high frequency primary coil, when switch turn on with control signal ( the spwm pulse is modulated ), in the positive or negative semi - period of low frequency modulation signal, transformer coil with same direction voltage. the magnetic flux of transformer core will increase step by step. at the end, it leads to magnetic flux saturation

    二、在高頻變壓器原邊，當開關管接收控制信號脈沖列（經調制的spwm波列）導通時，在低頻調制信號的正半周或負半周內，施加在變壓器繞組上的是同一方向的電壓，變壓器磁芯中的磁通可能將級進地逐漸增加，導致磁芯飽和，造成磁偏或單向磁化，導致低頻電信號放大失真或由於很大的磁化電流而無法正常工作。
  17. Energy consume, electric strength, insulation resistance, ground conductivity, leakage current, microwave leakage, power input, normal temperature, humidity treatment, glow wire, horizontal flame, vertical flame, tracking, ball pressure, rainproof, water splash, dustproof, salt fog, endurance, motor load test, cord flexing, cord pulling, pull & torque test, lamp replacement, construction check etc

    能耗、電氣強度、絕緣電阻、接地連續性、泄漏電流、微波泄漏、功率、溫升、濕熱試驗、灼熱絲、水平燃燒、垂直燃燒、漏電起痕、球壓試驗、防雨淋、防濺水、粉塵、鹽霧、耐久性（壽命）試驗、電機負載試驗、電源線彎折、電源線提拉、拉扭力測試、燈頭互換性、安全結構檢查等。
  18. The results show that : nano - nickel powder is not useful for mh electrode during the high rate discharge phase as a conductor or additive ; superfine nickel powder is applicable for the conductor of the negative because of the good performance especially the cyclic stability at 1c rate by using 5 % ( mass percentage ) nickel powder ; the utilization of alloy, specific mass and volume capacity are increased with the decreased particle size of nickel powder in negative, however, the capacity fading rate at 1c discharge rate is also increased, so the capacity and the cyclic stability should be taken into account to make a choice of the particle size

    結果表明： mh電極中加入納米鎳粉對負極的大電流放電性能不利。 mh電極中加入超細鎳粉后電極綜合性能好，尤其是1c循環穩定性，其最佳添加量為5wt 。減小鎳粉粒度提高了電極合金利用率、質量比容量、體積比容量，但增大了負極1c容量衰減率，因此鎳粉粒度的選擇應綜合考慮mh電極容量和循環穩定性。
  19. The vacuum interrupter is the heart of vacuum circuit break, which take charge of controlling the electric arc and breaking current

    真空滅弧室則是真空斷路器的「心臟」 ，擔負著電弧控制和電流開斷的重要任務。
  20. There are five parts are as follows : in part one, the concept of switching function is introduced first to establish the nonlinear mathematical model of the induction motor variable frequency speed adjustment system which is fed by a sine pulse width modulated ( spwm ) inverter and takes the effect of the main magnetic circuit saturation into consideration, then the low frequency oscillation of the system is simulated according to the model. next, from the view point of energy conversion of the inverter - induction system, a criterion for the low frequency oscillation is proposed to determine whether the system is in low frequency oscillation which is judged by whether the interval of the negative current component of the inverter input current is more than 1 / fc ( fc is the carrier wave frequency of the inverter ) or not

    首先引入開關函數概念，建立了正弦脈寬調制（ spwm ）逆變器供電異步電動機，考慮主磁路飽和時的變頻調速系統整體數學模型，模擬系統的低頻振蕩；其次從逆變器-異步電動機系統能量轉換角度出發，提出通過檢測逆變器輸入電流中負電流的間隔時間是否大於1 / f _ c （ f _ c為逆變器載波頻率）來判定系統是否出現低頻振蕩；最後的實驗結果驗證了系統低頻振蕩建模和判據的實用性和正確性。
分享友人
分享到 Line

分享到臉書