起重力 的英文怎麼說

中文拼音 [qǐzhònglì]
起重力 英文
lifting force
  • 起 : 起Ⅰ動詞1 （站起; 坐起） rise; get up; stand up 2 （取出; 取走） draw out; remove; extract; pull 3...
  • 重 : 重Ⅰ名詞（重量; 分量） weight Ⅱ動詞（重視） lay [place put] stress on; place value upon; attach im...
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 重力 : [力學] gravity; force of gravity; gravity force; power of gravity; pull of gravity; gravitational...
  1. There is adequate support for the great weight of the crane.

    對起重機巨大重量有足夠的支承力。
  2. Implementation of a load moment limiter for crawler crane

    履帶式起重機力矩限制器的實現
  3. On gravity field variations and geodynamic characteristics in mainland of china

    中國大陸重力場變化及其引起的地球動力學特徵
  4. Let us trace out in greater detail this computation of acceleration due to gravitational forces.

    讓我們詳細追查這些由重力所引起的加速度的計算方法。
  5. With variations of gravity the weight rises or falls.

    荷重隨著重力的變化而升起或降落。
  6. Plc has been use on huge engineering machine such as gate crane, gyre crane etc., but the moment limiter configures in addition. whereas considering implement the function of moment limiter by plc, that can reduce the cost of crane

    鑒於此，本文作者考慮將力矩限制器的功能通過plc來實現，以充分利用plc的強大功能和高可靠性，同時也降低了起重機的製造成本。
  7. The consequence is, when the majority of structure does n ' t enter yield habitus, but the position of belly - board has been reached the ultimate habitus, it lead to material waste of the other positions, we should pay attention to the disastrous result it will bright to us

    它帶來的後果就是當結構的大部分處于彈性狀態時，箱梁腹板處由於剪力滯效應一般最先達到強度極限狀態，導致腹板間材料的抗力沒有得到充分的使用，如不引起重視會帶來災難性後果。
  8. Jchi has cooperated with tadano ltd. of japan establishing a joint venture of bq - tadano ( beijing ) crane co., ltd. to manufacture truck cranes and rough terrain cranes, and with singapore technologies kinetics for beijing zhonghuan kinetics heavy vehicles co., ltd to off - road heavy dumpers and habour haulers

    京城重工與世界著名起重機廠商日本株式會社多田野合資設立北起多田野（北京）起重機有限公司，生產汽車起重機和越野輪胎起重機；與新加坡科技動力設立合資企業中環動力（北京）重型汽車有限公司生產重型礦用汽車、港口牽引車等工程車輛產品。
  9. Articulated hydraulic crane

    關節液力起重機
  10. The gravity model explicitly relates flows between zones to interzonal impedance to travel

    重力模型明確的通過地區間的阻抗來將分佈量和小區聯系起來。
  11. Specification for power - driven travelling jib cranes rail - mounted low carriage type

    動力驅動的動臂式起重機
  12. Tecsis supplied force measuring devices with the innovative thin - film technology for lifting gear in nuclear power stations

    Tecsis的力測量儀器在核電站中應用了創新的起重裝置薄膜技術。
  13. The adjustment of the torque limiter of tower crane

    塔式起重機力矩限制器的調試方法
  14. Design of load limiter with pulling ring for tower crane

    起重機拉力環型載荷限制器的設計
  15. Jib type cranes - load moment limiters - general technical requirements

    起重力矩限制器通用技術條件
  16. Recent observations during spaceflight or by ground simulations have both suggested that adaptive alterations in the arterial vasculatures may play a pivotal role in the occurrence of postflight orthostatic intolerance

    近年地面模擬研究及航天觀察均表明，動脈血管的適應性變化在飛行后立位耐力不良發生中可能起重要作用。
  17. The lifting capacity of this chain hoist ( hydraulic jack, screw jack ) is 5tons

    這個吊鏈（油壓千斤頂、螺旋千斤頂）的起重能力為5噸。
  18. Tower crane has following characteristics : discontinuous working, starting & braking frequently ; there are noticeable vibration and impulsion in running ; high lifting height and extend rang, heavy lifting moment, etc. with the advent of more and more high - rise and large - scale buildings, requirements for the efficiency, lifting height, lifting moment, and safety features are becoming higher and higher

    塔式起重機具有下述工作特點:斷續工作、頻繁啟動、制動;運行過程中有明顯的振動和沖擊;起升高度和工作幅度較大，起重力矩大。隨著社會中各類高層建築和大型工程的出現，使其對塔機的工作效率、起升高度、起重力矩和安全性等工作性能提出了更高的要求。
  19. Feed pulling force

    立軸最大加壓起重力：
  20. The method of determining tower crane lifting torque curve with double - suspension

    雙吊點塔式起重機起重力矩曲線的確定
分享友人
分享到 Line

分享到臉書