超負荷分數 的英文怎麼說

中文拼音 [chāofùhéfēnshǔ]
超負荷分數 英文
overload fraction
  • 超 : Ⅰ動詞1 （越過; 高出） exceed; surpass; overtake 2 （在某個范圍以外; 不受限制） transcend; go beyo...
  • 負 : Ⅰ名詞1 （負擔） burden; load 2 （虧損） loss 3 （失敗） defeat Ⅱ動詞1 [書面語] （背） carry on th...
  • 荷 : 荷名詞（蓮） lotus
  • 分 : 分Ⅰ名詞1. （成分） component 2. （職責和權利的限度） what is within one's duty or rights Ⅱ同 「份」Ⅲ動詞[書面語] （料想） judge
  • 數 : 數副詞（屢次） frequently; repeatedly
  • 負荷 : [電學] load; charge; weight
  1. This article aims at the boiler ' s problems in operation : 1 ) under nominal load, the smoke temperature at the outlet of hearth reaches 1200, far more exceeds 1050 the original designed temperature. this will always result in slag inside boiler and the temperature of overheater ' s pipe superheat, so that boiler cannot take nominal load and all these influence boiler ' s nomal operation heavily, 2 ) this article also studied the reason why the assistant oil becoming necessary when coal changes. during the nomal operation, many factors ( makeup of combustor and its disposal, smirch and encrust of water wall, excessive air coefficient, temperature of primary air, coal type and density of coal dust ) can deviate the designed working conditions, then affect the boiler ' s nomal operation

    本文針對該鍋爐在實際運行中存在的問題：在額定負荷下，爐膛出口超溫、低溫段過熱器前煙溫高達936 ，遠遠超過815的設計值；噴燃器四周水冷壁結焦嚴重，過熱器管壁溫度超標，無法帶上額定負荷；甚至有時因燃煤質量的變化，必須投油助燃的嚴重情況進行了分析研究。在實際生產過程中，燃燒器的結構、布置，水冷壁的粘污、結垢，過剩空氣系數、一次風溫、煤種及其濃度變化等許多因素都會偏離鍋爐的設計工況，從而影響爐內的傳熱和燃燒，造成爐膛出口超溫、水冷壁結渣等問題。
  2. In chapter 4, for the first time, in the way of virtual malfunction simulation, cooling water of diesel engine type 4135 has been simulated under the stopping water supply malfunction. and the analysis and discussion has been taken on the result of transient temperature curve of the simulation. and in the same way, internally cooling oil piston of diesel engine type 180 has been numerically simulated on the virtual thermal loading mal

    得出了虛擬其斷水故障模擬的瞬態溫度曲線結果，並對其進行了分析和探討；同時也用虛擬模擬的思想對180型柴油機內油冷活塞進行了虛擬其熱負荷故障的數值模擬，得出了其在斷油情況下和超負荷運轉情況下的分析結果。
  3. This program can predict the wall temperature 、 internal wall heat tranfer coefficient 、 fluid temperature and entropy profile along the water wall. all of these provide an important foundation for designing this type of water wall structure to ensure the safety of the boiler operation. this hydrodynamic calculation program and the results can be used to analyze operation reliability and structure design of water wall system

    利用所開發的程序對設計的超臨界cfb進行了計算，給出不同負荷下，水冷壁出口工質溫度分佈，水冷壁受熱面不同位置處的金屬壁溫、內壁放熱系數、流體溫度焓值分佈，以及不同管子的流動壓降等結果，為分析鍋爐工作可靠性及水冷壁系統的結構設計提供了重要依據。
  4. The temporal, spatial and frequency - field characteristics are discussed. the validity of the corresponding empiric formula is analyzed and the atmospheric effects and correction method are investigated in the data analysis of the ground - based observations. the atmospheric effects on the gravity observations are analyzed and detected using the gravity data recorded with the superconducting gravimeters at the global geodynamic project ( ggp ) stations

    利用實測地面氣溫、氣壓資料獲得大氣負荷效應時間序列的數值結果，研究大氣影響的時間、空間和頻率特徵，分析經驗公式的有效性，研究地面觀測和數據分析大氣影響和改正的方案；利用ggp臺站超導重力觀測資料，分析檢驗大氣重力影響；分析igs臺站大氣位移改正的可能性
  5. Package handling module ( package _ server ) is responsible for assigning all received messages, which can advance real time capability ; communication agent module ( sp _ agent & smc _ agent ) is responsible for communicating with external entities, but does n ' t identify message contents, which can lighten burden of package handling module ; store - and - forward module ( store _ server ) completes store - and - forward mechanism by setting up timer, and implements overtime retransferring and failure handling ; routing module ( route _ server ) is responsible for maintaining the links with the other ismgs to implement routing ; feeing module only consists of some functions which can be called to record message items

    其中，業務處理模塊（ package _ server ）負責分派所有收到的外來消息，提高實時性；通信代理模塊（ sp _ agent & smc _ agent ）負責與外界實體通信，不具體識別消息，可減輕業務處理模塊負荷過重的壓力；存儲轉發模塊（ store _ server ）通過設置計時器完成存儲轉發機制，實現超時重傳和失敗處理；路由模塊（ route _ server ）負責維護與其他網關的通信鏈路，實現路由；計費模塊只是一些可供調用的函數，用來完成話單記錄的功能。
  6. The scale, facility, setup mode and the topper application are increasing, but the network management system still adopts a centralizing structure based on manager / agent model. in the centralizing structure, the network management system can ’ t change with the scale and complexity, which made the system bigger and bigger. all management logic is computing in one workstation, that will occupy too many bandwidth, depress performance and made the workstation become the weakest part, if the workstation overrun or dead, agent can ’ t come back because it must wait manager ’ s command

    目前，我國電信網路正處于高速發展中，網路的規模越來越大，設備種類越來越多，組網方式越來越多樣化，應用越來越復雜，但是網路管理系統仍然普遍採用管理員/代理的集中式管理方法，在集中式網路管理模式中，網管系統不能隨著網路規模和復雜度的變化而變化，致使網管系統越來越龐大;網路管理邏輯全部集中在一個管理工作站中計算，需要佔用大量的帶寬來傳輸設備數據，有效性差，同時管理工作站是系統中最脆弱的部分，一旦管理方超負荷或死機，代理方因為必須等待管理方的指令而無法恢復系統，導致系統崩潰。
分享友人
分享到 Line

分享到臉書