超高壓容器 的英文怎麼說

中文拼音 [chāogāoyāróngqì]
超高壓容器 英文
ultrahigh pressure vessel
  • 超 : Ⅰ動詞1 （越過; 高出） exceed; surpass; overtake 2 （在某個范圍以外; 不受限制） transcend; go beyo...
  • 高 : Ⅰ形容詞1 （從下向上距離大; 離地面遠） tall; high 2 （在一般標準或平均程度之上; 等級在上的） above...
  • 壓 : 壓構詞成分。
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 高壓 : 1 （殘酷迫害; 極度壓制） high handed 2 [氣象學] （高氣壓） high pressure3 （高電壓） high tension...
  1. Developming of an non - touch ultrasonic liquid level instrument for high pressure containers

    高壓容器壁外式超聲波液位檢測儀的研製
  2. So choose parameter of damping device with reduce energy storage to improve cvt become and respond effective way of characteristic wink rational, this increases the capacity of sending for raising the dynamic stability of the supervoltage power transmission and transformation system, guarantee power system safe and reliable to run and have important technology economic meanings

    因此，合理地選擇阻尼器的參數以降低儲能是改善cvt瞬變響應特性的有效途徑，這對于提高超高壓輸變電系統的動態穩定性，增大輸送容量，保證電力系統安全可靠運行具有重要的技術經濟意義。
  3. In accord with the state standard about harmonic. the harmonic permission value of tangqian line is calculated. some measurement data are shown and analyzed, and some main conclusion is drawed that the 7th harmonic voltages of tangqian line is near to the permission value, total harmonic voltage distortion ratio has oversteped the permission value. the 3th harmonic, the 5th harmonic, the 7th harmonic and the 9th harmonic current from tangqian line all overstep the permission, the largest 5th harmonic current ratio in tangsc reaches 44 %, the 7th harmonic and the 9th harmonic current in tang7c and tangsc is large maybe because the harmonic current is magnified. this paper studies the model of each element in tang yin substation

    根據有關公用電網諧波的國家標準，計算出湯牽線注入湯陰變電站的諧波電流允許值，從實測數據可以得出一些重要結論：湯牽線7次諧波電壓含有率的最大值接近國標中的限值，湯牽線的諧波電壓總畸變率的最大值已超標；湯牽線注入電網的3 、 5 、 7 、 9次諧波電流都超標；湯6c電容器的5次諧波電流含有率較高，最高達到44 ；湯7c和湯8c電容摘要器的7次和9次諧波電流含有率偏高，原因可能是發生了諧波電流放大現象。
  4. The research of this paper includes : ? high - speed photography and flash x - ray radiography are both used to capture the process of al shell ' s great deformation under low pressure. front illuminations are used to get the development of the fracture on the al shell. the relative energy release is analyzed from overpressure curves measured with some sensors

    本文的研究內容主要包括： ?在受試炸藥經歷低應力大變形過程的susan試驗中，同時採用高速攝影、閃光x射線照相對彈體的撞靶過程進行了拍攝，得到了殼體膨脹變形過程圖像，並使用前照明技術觀察到了鋁殼表面產生的裂紋及其發展變化過程；從壓力傳感器測量的空氣沖擊波超壓曲線，獲得反應釋放總能。
  5. By improving surface condition of parts and one shot seal - off clean room grade, using ultrasonic vapor phase cleaning process, the inner parts of vacuum interrupter get cleaner. movable particles have been diminished by automatic current ageing, power frequency hi - voltage ageing and dynamic high current ageing. as the dielectric strength of clearance in vacuum interrupter improved, the probability of re - ignition in test drops evidently

    通過提高零件表面加工質量，改善一次封排間的真空衛生條件、制定合理的超聲波氣相清洗工藝提高管內潔凈度，採用自動電流老煉、超高壓工頻老煉、大電流動態老煉等工藝進一步消除真空滅弧室內活動性微粒，可提高真空滅弧室真空間隙介質強度，使真空開關投切電容器組的重燃率大大降低，並通過實驗驗證真空開關投切電容器組的重燃率在製造工藝改進後由原來的10 . 7 %降低至1 . 3 % 。
  6. Raised the idea of constructing hybrid capacitor with a battery based positive electrode and a capacitor based negative electrode, experiment proved that a hybrid supercapacitor with a manganese dioxide based positive electrode and an activated carbon based negative electrode showed very good performance, double electrode specific capacitance could be enhanced to 95. 7f / g, that is 2 ~ 3 times that of the carbon based supercapacitors. furthermore, the maximal voltage of a single cell could be expanded to 1. 5v, as a result, the energy density could be ten times higher than that of a carbon based supercapacitors

    本論文中我們提出了將電池哈爾濱工程大學碩士學位論文的正極與電容器的負極結合成混合超級電容器的構想，並成功實現了二氧化錳正極和活性炭負極的組合，構成的錳碳混合超級電容器雙電極比容量可達到95 . 7f / g ，比活性炭超級電容器提高了2一3倍，單體工作電壓可以高達1 . 5v ，從而使能量密度提高到碳基超級電容器的十倍。
  7. About design programs of propylene tower post weld whole heat treatment, we have made analyses and compare from the various technical and economic aspects, and in vertical state of large pressurized vessel, we propose to adopt the internal combustion heat treatment method, in horizontal state of it, to adopt high temperature flue gas heat treatment method, and propose center combustion tube method as the future direction of technical developmnet insights

    摘要圍繞丙烯塔焊后整體熱處理的各種設計方案，從技術、經濟等方面進行分析對比，提出對超大型壓力容器，立置狀態下宜採用內燃法熱處理；臥置狀態時宜採用高溫煙氣法熱處理，並提出將中心燃燒管法作為今後技術發展方向的見解。
  8. In order to compensate for the capacitive charging power of transmission lines, control reactive power flow, stabilize operating voltage and restrict arc current, the shunt reactors are usually installed on ehv transmission lines, especially for uhv transmission lines

    摘要超、特高壓輸電線路為了補償線路的容性充電功率，控制無功潮流，穩定網路運行電壓，限制潛供電流等，一般要安裝並聯電抗器。
  9. In this paper, shrink principle was also used to for designing and computing to the high pressure cylinder in order to prove the advantages autofrettage technique in designing of super - high pressure vessels. and the compute result gained by autofrettage technique was compared to the compute result gained from the shrink principle and original design project. it was shown from the results that the using of autofrettage technique in designing super high pressure vessel was more superiority than the shrunk principle

    為了說明自增強技術在超高壓容器設計中的優點，本文也採用了縮套原理對該高壓缸進行了設計計算和分析，將採用自增強技術的設計計算結果和採用縮套原理的設計計算結果及原設計方案的結果進行了比較，分析表明:採用自增強技術設計超高壓容器優于採用縮套原理設計的超高壓容器。
  10. The author still designed a set of experiment method exclusively for autofrettage experiment study to super - high pressure thick wall cylinder

    為了進行相應的自增強試驗，作者提出了一套實驗方法，專門用於超高壓厚壁圓筒形容器的自增強實驗研究。
  11. This paper discussed the development general situation of the domestic and international super high pressure vessel first, and then the calculative method of stress and the homologous strength theories about the single - layer ordinary round super - high pressure vessel, single - layer autofrettage thick wall round super - high pressure vessel and shrunk - on double - layers round super - high pressure vessels were elaborated systematically

    本文在論述了國內外超高壓容器的發展概況的基礎上，較為系統地闡述了單層普通圓筒形超高壓容器、單層自增強厚壁圓筒形超高壓容器、雙層縮套圓筒形超高壓容器的應力計算方法及相應的強度理論。
  12. This alarm ( high tolerance channel n 1 stange ) warns that the pressure vessel temperature is superior to its programmed reference value

    此警報（高容差通道n 1stange ）用於提醒操作者壓力容器中的溫度已超過設定參考值。
  13. New breakthroughs are obtained in manufacturing large - scale ultrahigh pressure container, design of ultrahigh hydraulic pressure system, design of multi - media large delay nonlinear control system, detecting state of device tested under simulation environment, modeling of in - well environment of oil field

    並在大型超高壓容器製造、超高壓液壓系統的設計、多介質大延時非線性控制系統設計、模擬環境中試驗設備工作狀態的檢測、油井井下環境的建模等方面取得了新的突破。
  14. The theoretical proof was provided for advancing and improvement of strengthen theories to super - high pressure vessels

    為超高壓容器強度理論的發展與完善提供了一定的理論依據。
  15. Standard practice for acousto - ultrasonic assessment of filament - wound pressure vessels

    絲繞制高壓容器的超聲波評定用標準實施規程
  16. 2 ) a new method was put for primary designing super - high pressure vessels and targets of evaluating the method were also put. these targets are original creation

    2 ）提出了一套超高壓容器初步設計的方法和評價該方法的效果的指標，這些指標均屬獨創。
  17. In order to effectively study the residual stresses of auto - frettagea super high pressure vessel, this paper first offers a new model of the constitutive relationship of stress - strain

    摘要為了有效地研究自增強超高壓容器的殘余應力，本研究提出了一個新型的應力應變關系模型。
  18. The main innovations and contributions in the paper are as below : 1 ) the third and forth strengthen theories were analyzed and compared particularly. the reason that according extent of every theory was closed the fact to a extent was analyzed and discussed on theory integrally. the strengthen theories fitted to super - high pressure vessels was perfected further

    本論文的主要創新點和貢獻如下: 1 ）對最大剪應力理論和最大應變能理論進行了詳細的對比分析，對各理論與實際的符合程度的原因進行了較完整的理論定性分析論述，從而進一步完善了適合於超高壓容器設計的強度理論。
分享友人
分享到 Line

分享到臉書