跟蹤饋電 的英文怎麼說

中文拼音 [gēnzōngkuìdiàn]
跟蹤饋電 英文
tracking feed
  • 跟 : Ⅰ名詞（腳的後部或鞋襪 的後部） heel Ⅱ動詞1 （在後面緊接著行動） follow 2 （指嫁給某人） be marrie...
  • 蹤 : 名詞（腳印; 蹤跡） footprint; track; trace; trail
  • 饋 : 動詞（饋贈） make a present of
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 跟蹤 : follow the tracks of; tail after; following; follow up tracing; track; tracking; trail; lock on; ...
  1. A niched - penalty approach is used to transform this optimal kinematical design problem to an unconstrained one. a kinematic accuracy comparison of the genetic designed fine - tuning stewart platform with the quasi - newtonian designed one is made. the comparison results have shown that the kinematic accuracy of the genetic designed fine - tuning stewart platform has a much higher accuracy and a compact structure than that of the quasi - newtonian designed one, which guarantees the accomplishment of high precision trajectory tracking and reduces the disturbance of wind to the feed - supporting system

    以並聯機器人jacobian矩陣的條件數為優化設計的目標函數，提出了基於遺傳演算法的並聯機器人最優運動學性能結構參數優化設計方法，採用實值遺傳演算法，對精調stewart平臺進行了優化設計，得到了最優運動學的精調stewart平臺結構參數，為實現新一代大射電望遠鏡饋源指向跟蹤系統高精度軌跡跟蹤控制奠定了堅實的基礎。
  2. To make full use of the karst formation in guizhou province of china, a large spherical radio telescope array of the arecibo telescope was proposed in china in 1995. therefore, a completely new design project that integrating mechatronics and optics technologies with several large span cables is proposed to drive the feed - supporting system to realize the high precision positioning. for the high requirement of trajectory tracking of the feed - supporting system with large span cables, the feasibility of stewart platform served as a fine - tuning platform and the accomplishment of the high precision tracking are considered in details in this paper

    本文依託新一代大射電望遠機電光一體化創新設計方案，針對饋源指向跟蹤系統高精度軌跡跟蹤要求，以精調stewart平臺為研究對象，進行了6自曲度並聯機器人的運動學優化設計、動力學分析與奇異性分析，設計了強魯棒性自抗擾控制器實現高精度軌跡跟蹤控制；提出了新一代大射電望遠鏡饋源指向跟蹤系統軌跡跟蹤獨立控制策略、軌跡規劃策略和控制模型； 50米縮比模型實驗驗證了軌跡跟蹤控制策略與方法的工程有效姓和可行性。
  3. The influence of swinging ship to los is analyzed in detail. the tracking precision of the shipborne tv tracker will be improved greatly when the feedforward signal otship swaying is measured by rate gyro

    本文詳細分析了艦船搖擺對視軸穩定的影響，通過理論推導和模擬分析論證了採用速率陀螺測量並前饋艦船搖速度信號將極大的提高艦載電視跟蹤儀的跟蹤精度。
  4. In order to improve dynamic performance of the control system in the assembly robot, according to acpmsm ( ac permanent magnet synchronous motor ) vector control model and the control idea about preview control, the paper presents a kind of control strategies that is composite of a primary pid ( proportion integral dif - ferenfial ) with a preview feed - forward compensation, its compensation is equivalent to linear combination of future adjacent difference, the simulation results show that it can not only improve the system tracking performance effectively, but also implement easily

    摘要為了提高裝配機器人控制系統的動態性能，依據交流永磁同步電機矢量控制模型，從預見控制的思想出發，提出了一種在原有pid基礎上外加預見前饋補償的控制方法，這種控制方法的前饋補償項取未來幾項目標值一階差值的線形組合，並模擬驗證了該控制方法對提高系統跟蹤性能的有效性和簡單可行性。
  5. The pid control of output voltage feedback is easy to give attention to static and dynamic performance of the control system. output performance of inverter of ups is improved when rms of output voltage feedback is added to pid control system. the hardware and software is designed in order to achieve the digital pid control of inverter of ups

    設計了用於逆變器數字化控制的采樣調理電路，結合tms320f240的硬體資源，通過軟體實現了ups系統的緩起動和市電跟蹤，並改進了逆變器電壓瞬時值控制，通過引入輸出電流中心值檢測，對反饋電壓進行補償，解決了逆變器輸出的偏磁問題。
  6. After analyzing compensation conditions for 3 - axis stabilization to overcome disturbance from ship surge, sway and yaw, two control strategies - feed - forward compensation and closed - loop feedback compensation - are given. these two strategies are applied to antenna stabilized tracking system with good performance. intelligent pid is used in closed - loop feedback compensation to get high tracking precision and rapid response

    重點分析了天線穩定控制系統的三軸補償條件，提出了穩定系統抑止載體擾動的控制策略：對于橫滾和俯仰系統採用前饋補償的控制策略；對于方位系統，在以步進電機為驅動元件的特定條件下，研究了變控制周期的閉環反饋策略，同時成功將智能pid演算法應用於實際系統，提高了系統的跟蹤精度和響應快速性。
  7. The electro - hydraulic proportional control law is given. the laws of tracking control of displacement and speed of aircraft as well as tracking control of angle and angular speed of belt wheel are designed by means of state feedback linearization and quadratic performance index linear optimal control method. the robustness of the designed systems is analyzed, and arresting processes are simulated

    給出了電液比例控制規律；利用狀態反饋線性化及二次型性能指標線性最優控制方法分別設計了系統跟蹤控制飛機位移與速度以及跟蹤控制帶輪轉角與角速度的非線性控制規律；對所設計的攔阻系統進行了魯棒性分析及攔阻過程模擬，模擬結果表明，通過選取適當比例系數或控制權系數，兩種控制系統的控制效果及魯棒特性均優于新型飛機攔阻系統。
  8. By use plc, system can complete function as follow : this auto - control system be applicable to the temperature and smoke and dust the deal the variety quick, control the process is difficult with the operation is ; by the temperature controlor can automatically follow to the wet tower " exit temperature, error in the ? 3 v including ; by to automatically spray fog to lower the electric resistance, with the function for full the electricity equipment accepting the dust ; because of adopting feedback closed loop, and come to a to respond to the speed quick, constant temprature control the accuracy is high ; because of adopting the sensors, and make the system circumstance to leak water quick ; system have many control parameter can set exit control temperature and adjust value low limit by key ; can communication with remote computer and have remote control

    通過使用plc ，使該自控系統可以完成如下功能：適用於溫度及煙塵量變化快、控制過程難以操作的場合；通過溫控表自動跟蹤增濕塔出口溫度，誤差達到3以內；通過自動噴霧來降低粉塵比電阻，以此充分發揮電收塵器的作用；由於採取了閉環反饋迴路，達到了響應速度快，恆溫控制精度高；通過使用各種檢測傳感器，使得異常情況泄水快；該自控系統具有多套控制參數，增濕塔出口控制溫度及調節閥下限值可通過按鍵設定；可與上位機通訊，具有「現控遠控」功能。
  9. The closed loop control mode including position feedback, velocity feedback and current feedback is adopted for the driver motor so that high precision and steady running can be realized. the closed loop control mode including velocity feedback and current feedback is adopted for the momentum balance motor so that fast and accurate trace can be realized

    其中驅動伺服電機採用絕對位置光電編碼器作為位置反饋確保系統的精度要求，實現了位置、速度、電流三環控制，達到了伺服電機的高精度、穩速運行；平衡電機採用電流和速度雙閉環控制，實現平衡電機快速、精確的跟蹤。
  10. The conclusions are : internal feedback has superior performance to a conventional feedforward control in master - slave system force tracking electro - hydraulic loading to reduce disturbance force and improve the dynamic behavior

    模擬結果表明，內部反饋在主從電液跟蹤加載控制中能減小多餘力的影響，系統特性的改善優于傳統的前饋方法。
  11. State feedback pole assignment technique is used to gain fast tracking of the output voltage, and a repetitive control is designed to reduce voltage distortion under nonlinear loads

    系統利用狀態反饋極點配置獲得了電壓跟蹤控制的快速性，利用重復控制較好地抑制了非線性負載工況下的電壓畸變。
  12. This paper put forward a demodulation method of fbg sensors based on the voltage drive fabry - perot cavity ( f - p ), on which we have a feedback control voltage to drive. a novel automatic trace method is creatively proposed

    本文提出了一種基於電壓驅動可調法布里腔自動跟蹤掃描濾波的光纖光柵傳感器解調方案，利用電壓反饋控制可調法布里腔的方法，達到對外界的振動、應變等物理量引起的布拉格光纖光柵反射光譜的漂移進行解調。
  13. Using the phase conjugation mixer the compact wire antenna with two isolated ports presented in chapter 2 is simulated, and the results show that the antenna can follow the incoming signal with the main beam and has 4 - 8db gain improve against the standard monopole in the incoming signal direction

    對本文第二章提出的兩饋電埠的高隔離度線天線的模擬表明，利用相位共軛電子科技大學博士論文混頻器，天線系統能以主波束在0 』一360 』的范圍內跟蹤入射波方向，具有一定的方向回溯能力。
  14. The load of the dc motor has a great influence on the tracking effect of speed control system, so a kind of load disturbance observer is constructed to compensate the load disturbance, and a new variable structure controller is designed by employing lyapunov speed error function

    針對實際直流電機負載對速度控制系統跟蹤效果有較大影響的情況，提出了一種重構軋制負載擾動的觀測器，進而對負載擾動進行前饋補償控制，設計了一種新的利用lyapunov速度誤差函數構造的變結構魯棒控制器。
  15. In this paper, the reason of treating current as feedback is analyzed with circuit theory, the system of ultrasonic generator controlled with a single - chip computer and the realization methods of frequency tracking and amplitude stabilizing are introduced, the software of adaptive tracking and pid are completed

    本文用電路理論分析了電流作了反饋控制量的理論依據，介紹了發生器的結構、頻率跟蹤和恆幅輸出的實現方法，完成了變步長頻率跟蹤和pid恆幅控制的軟體設計。
分享友人
分享到 Line

分享到臉書