軸向後角 的英文怎麼說

中文拼音 [zhóuxiànghòujiǎo]
軸向後角 英文
axial relief angle
  • 軸 : 軸Ⅰ名詞1. （圓柱形的零件） axle; shaft 2. （對稱部分的直線） axis 3. （圓柱形的纏繞器物） roller; spool Ⅱ量詞（用於纏在軸上的線以及裝裱帶軸子的字畫）
  • 角 : 角Ⅰ名詞1 （牛、羊、 鹿等頭上長出的堅硬的東西） horn 2 （古時軍中吹的樂器） bugle; horn 3 （形狀像...
  1. In theoretical analysis, the motion of radially - emitted electron beam in diode region and drift region has been analyzed, and the relation between radial momentum or current of electron beam and the guiding magnetic field has also been studied, then the possibility to optimize the guiding magnetic field has been derived. the motion of radially - emitted beam electrons in smooth bore magnetron and smooth bore milo has also been studied theoretically. at last, the motion of radially - emitted beam electrons in compound axial and azimuthal magnetic field has been studied

    在理論分析中，初步分析了軸向發射條件下電子在二極體區域和漂移區的運動規律，電子徑向動量隨著外加磁場變化的規律，以及電子束電流隨著外加磁場的變化規律，還有二極體區域磁場優化的可能性;分別研究了有軸向磁場時以及有角向磁場時徑向發射的電子在光滑陽極結構中的運動規律，最後分析了在軸向和角向復合磁場中電子的運動規律。
  2. In addition to pic method, the numerical computation method is used as a compensation for the study of the characteristics of electron beam. the two methods are used separately to attain the trajectory of axially - emitted electron beam in diode region and drift region, and the trajectory of radially - emitted electron beam with axial, azimuthal, as well as compounded axial and azimuthal magnetic field. three two - dimensional codes and two three - dimensional codes have been made out to compute the trajectories

    本文特點之一就是採用粒子模擬和數值計算相結合的方法進行模擬計算，分別得到了軸向發射條件下電子在二極體區域和漂移區的軌跡，徑向發射條件下電子在角向磁場、軸向磁場、角向和軸向復合磁場中電子的運動軌跡，分別編制了三個二維電子軌跡計算程序和兩個三維電子軌跡計算程序，最後將粒子模擬和數值計算得到的結果進行了對比，得到了較為滿意的結果。
  3. Also the influences of the length, diameter, and the ratio of the stiffness of pipe to the stiffness of soil on the bearing mechanisms are discussed. based on these, some useful conclusions are reached

    然後從樁長、樁徑以及樁土剛度比等角度分析了其對單樁承載力、內外側摩阻力、樁端平面應力分佈、軸向荷載傳遞、樁身截面位移等的影響。
  4. Then navigation asteroids are selected under a integral evaluation, the planning of the photoing sequence is handled with an improved genetic algorithm, along with a difference selection method which optimizes the ratio of navigation evaluation to resource consumption. a single axis randomized expanding algorithm is proposed to solve the large angle slew maneuvers planning problem. this algorithm randomly produces

    對于自主探測器大角度機動規劃問題，本文提出單軸隨機擴展演算法，單軸隨機演算法在生成隨機節點過程中充分利用鄰近點的信息，把規劃問題構造空間的維數由3減少到2 ，從而減少問題求解的搜索空間，最後利用前向搜索的方法對規劃路徑進行優化。
  5. Firstly, when the pipe flow was laminar, the movement of fibers was computed in the 2 - d force formulae that were deduced from the slender body theory and in 3 - d integral method. results revealed that angles between fibers " axis and the orientation of flow would concentrate gradually on a low number as the re numbers increased. that is, the axis of fibers would rotate toward the orientation of flow

    首先，當管道內流動為層流時，分別利用從細長體理論出發得出的纖維二維受力公式和三維分段積分計算方法模擬了大量纖維在流場中的運動，然後在最終時刻統計了纖維的偏角分佈，並得出相同的結果：隨著re數的增加，纖維粒子的偏角逐漸集中於小角度，即纖維軸線方向越來越集中於流向，此結果與實驗吻合較好。
  6. Then with the introduction of the expression of radial electric field and azimuth magnetic field, the movement tracks of electrons in the interaction space are modified on account of the azimuth magnetic field decreasing with the decrease of the axial current

    接著，引入同軸系統中徑向電場和角向磁場的表達式，並且考慮到軸向電流的逐漸減小會導致角向磁場沿軸向的變化，推出修正後的電子運動軌跡表達式。
  7. At the end of the thesis, the basic physical characteristics of axially - emitted and radially - emitted electron beam are summed up, and the design methods of sws ( slow wave structure ) for high - efficiency beam - wave interaction according to the motion characteristics of e - beam are brought forward, these helpful discussions for design of microwave source are going to be validated by pic method

    最後，本文在總結電子軸向、徑向和角向運動基本規律的基礎上，從電子運動的角度提出了高效率束波相互作用慢波結構的設計思路，為微波源的設計提供了一些有益的參考。
  8. The filament winding angle when the fiber volume fraction of hoop orientation was equal to that of axial orientation was calculated

    最後計算了軸向取向和環向取向纖維體積含量相等時纏繞角的值。
  9. In the first stage of exploitation, the spatial development stratagem is that huaian should become a new growth pole in north jiangsu. after huaian has grown to some scale, it is considered that the spatial development should be changed from pole - shape exploitation to pole - axis exploitation, namely building up dual - nuclei spatial structure between huaian and lianyungang. considering that the economic foundation in north jiangsu is still weak, xinyi - huaian - lianyungang growth triangle should be built up to promote the development in north jiangsu after the form of dual - nuclei spatial structure. at the same time, the transformation should be realized from one line - shape exploitation model made up with one - pole - axis to area - shape exploitation model made up with many pole - axis

    最後，立足推動蘇北地區的發展的層面，提出淮安不同階段的空間發展戰略：開發初期，應以構建淮安為蘇北地區的新增長極的點狀開發戰略為主；等到淮安發展到一定階段，應考慮由點狀開發向點軸開發戰略轉變，即構建淮安? ?連雲港雙核型的空間結構；考慮到蘇北地區經濟基礎薄弱，單靠點或一條點軸的帶動可能會出現力不從心的局面，因而淮安? ?連雲港雙核型空間結構形成之後，在蘇北地區構建新淮連成長三角來帶動蘇北地區的發展，同時實現該區域的空間結構由一條點軸構成的線型開發模式向多條點軸構成的面狀開發模式的轉變。
分享友人
分享到 Line

分享到臉書