軸向應變 的英文怎麼說

中文拼音 [zhóuxiàngyīngbiàn]
軸向應變 英文
axial strain
  • 軸 : 軸Ⅰ名詞1. （圓柱形的零件） axle; shaft 2. （對稱部分的直線） axis 3. （圓柱形的纏繞器物） roller; spool Ⅱ量詞（用於纏在軸上的線以及裝裱帶軸子的字畫）
  • 應 : 應動詞1 （回答） answer; respond to; echo 2 （滿足要求） comply with; grant 3 （順應; 適應） suit...
  1. In general, the deformation of the model grille is a combination of axial and shear strains.

    一般情況下，模型柵格的變形是軸向應變和切向應變的組合。
  2. On this foundation the article inducts in detail the method which is based on the relative settlement of calculating unit area end support ( qb ) force at the same time considering the feature of pedestal pile ' s " arch effect " the article introduces conception of pile effective length and finally obtain t he formula of calculating man - made pipe with bulb - shaped axial carrying capacity. the article uses marc program to calculate and analyze foundation soil ' s stress and displacement and gets the change curve chart and the proportion that is shared by king - pipe side soil friction resistance and pipe end counterforce respectively. the article inducts the structure of pedestal in detail on the basis of generalizing pedestal application cases of many countries

    在此基礎上論文詳細歸納了以相對沉降為依據確定單位面積端承力q _ b的計算方法，並考慮擴底樁的「拱效應」特點引入了有效樁長的概念，最後結合公路規范推出了比較實用的人工挖孔擴底樁軸向承載力計算公式。論文運用了marc程序對地基土的應力和位移進行了有限元數值計算分析，得到了地基土的應力和位移場的變化曲線和在加載過程中樁側土摩阻力和樁端反力各自所承擔的比例；本文還在總結各國挖孔擴底樁應用情況的基礎上就擴底樁的構造進行了詳細的歸納。
  3. This paper simply introduces the device of on - line monitoring for the thrust of the rotating maching, then discu ed the finite dement analyses on the on - line monitoring elastic dement for measuring thrust in detail, in order to develop the performance of the se or and the device, we calculated the distribution of the stre 、 strain 、 axial di lacement in the elastic element using the finite element method when the axial forces f = 3 104n, the result is very satisfied

    簡單介紹大型旋轉機組軸向力在線監控裝置，然後詳細介紹軸向力測力彈性元件的有限元分析，為了提高所研製的測力傳感器的性能，採用有限元方法計算了彈性元件在軸向力f = 3 104n時的應變、應力、靈敏度及軸位移等的分佈情況，分析結果表明：所設計的測力傳感器完全符合廠方的要求及儀表性能指標。
  4. Through developing the comprehensive experiment device with large - scale drum strength and stability, the stress - measuring experiments of various wall thickness of the normal drums of the cranes were performed. the law that the stress of the drums along the circumference and along the axis changes with the load increase of the wire ropes was studies for the first time

    通過研製全比尺大型捲筒強度、穩定性綜合試驗裝置，對起重機常用規格的捲筒進行了各種壁厚條件下的應力測量試驗，首次對捲筒體周向和軸向應力隨鋼絲繩逐步加載過程變化的規律進行了研究，發現最大應力產生在鋼絲繩繞過后3 ~ 5圈截面處，該現象與理論分析結果也是符合的。
  5. Here, fem is applied in the analyses of i ) fiber axial stress and interphase shear stress in fragmentation tests during initially applied strain, ii ) influence of temperature on the stress transfer across the interface, iii ) modulus and thickness of the interphase and their influence on interfacial stress transfer, iv ) interfacial debonding process, and v ) fragment aspect ratio, contact friction along the interface and their influences to the interfacial stress transfer efficiency

    在論文的這部分工作中，使用有限元法描述和分析了逐節斷裂試驗中初始應變下的纖維軸向應力和界面相剪切應力，溫度對界面應力傳遞的影響，界面相模量和厚度、纖維節長寬比、界面脫粘過程、界面接觸中的摩擦效應等因素對逐節斷裂試驗中應力傳遞的影響。
  6. 3. seismic response analysis is done by using time history analysis method in aluminum alloy double - layer cable dome and the displacement and the axis stress of the structure under the seismic response are obtained and the results are compared with the ones of the spectrum analysis

    採用時程分析法對肋環型鋁合金雙層球面網殼結構進行了地震分析，得出了結構在地震荷載作用下的位移、軸向應力的變化曲線，並且與譜分析結果以及相應的鋼網殼作了比較。
  7. The latest experimental results of rock creep were used : the third invariant of deviator stress tensor had greater effect on creep properties ; the stress threshold of lateral creep of rock was 20 % ~ 40 % less than that of axial creep of the same rock

    文中應用了課題組近期巖石流變實驗研究的結果：應力偏量第三不變量對巖石蠕變影響顯著；巖石側向蠕變的應力閥值比軸向蠕變應力閥值低20 % ~ 40 % 。
  8. Poisson ' s ratio represents the negative ratio of transverse and longitudinal strains

    泊松比的定義為樣品橫向應變與軸向應變的相反數。
  9. The parameters are measured respectively during the experimental process, such as bearing capacity, deformation, strain and so on. it concludes that when the other conditions is equal, the limit bearing capacity of the concrete filled steel tube long column subjected to axial compress is reduced along with the long diameter ratio increased

    從試驗結果可以看出：鋼管混凝土軸心受壓長柱的穩定承載力，在其他條件相同時隨長細比的增大而逐漸降低；試件在最大承載力狀態下，鋼管表面的平均縱向應變已超過鋼管的屈服應變值，破壞呈現為非彈性失穩破壞。
  10. The variation of axial stress, deformation and coefficient of lateral pressure is expounded in this paper

    分別研究了側壓力變化階段和穩定階段軸向應力、靜止側壓力系數以及變形的變化規律。
  11. By the use of dynamic buckling supplementary restraint conditions at the compression wave front of cylindrical shells at the instant when the buckling occurs, the critical load and dynamic buckling modes of shells were calculated from the solutions of finite element characteristic equations

    計算結果揭示了圓柱殼彈性軸對稱動力屈曲變形發展的機理，以及軸向應力波和屈曲變形的相互作用規律。
  12. Some results are as follows under the action of vertical load, piles and soils are able to support upper loads, this improving the bear capacity of composite foundation a lot ; changing the character of the pile during transferring the vertical stress, reducing compressive stress under foundation

    在垂直荷載作用下，樁、土都可以承擔上部荷載作用，進而能大幅度提高復合地基承載力，改變了樁傳遞軸向應力的特徵，減小了基礎底面的壓力等。
  13. The reflection wavelength tuning of fbgs by applying axial strain and lateral strain is discussed, and the theoretic results in both of the above situations are presented

    探討了光纖布喇格光柵的軸向應變調諧和橫向應變調諧機理，並對兩種調諧技術給出了理論分析結果。
  14. The sensor utilizes the parallelism relationship of twisted axis twisting strain and torsion, axial strain and axial force, and also adopts signal transmission principle with non - contact

    這種傳感器利用了受扭軸扭轉應變與扭矩、軸向應變與軸向力的對應關系，採用了信號非接觸傳輸原理。
  15. 5. the sensing properties of multimode fiber gratings was investigated experimentally and theoretically in this paper. experimental results show that the bragg wavelength of grating in multimode graded - index fiber is linearly dependent on its temperature and axial strain and its repeatability is good

    五、對多模光纖光柵的傳感特性進行了實驗研究與理論分析，結果表明這種光柵三個反射峰的布喇格波長隨溫度和軸向應變變化均呈現出良好的線性關系，並且重復性相當好。
  16. With the data recorded by computer, the author studies the experiment progress in detail, which includes the development of pore press, strain, strength of the sand, etc. connecting the development of these phenomena with the development of stress path, the author finds new mechanism which can explain the phenomena in the experiment. what is more, according to the dynamic test of the sand, there appears a steady state at the last phase of the development of strain and stress path, in which the strength of the sand is studied because it is an important parameter in evaluating the stability of sand against liquefaction. secondly, the dynamic constitutive relation was studied through the dynamic tri - axial test

    本文首先採用目前國內較先進的微機控制動三軸儀，利用其可以適時採集和儲存數據的優勢，對砂土的實驗過程進行了細致的分析，研究該過程中孔隙水壓力發展、軸向應變發展以及它們與應力路徑之間的關系，對飽和砂土的剪脹、剪縮和卸載體縮等多個方面進行了研究，探索了砂土的動力特性，分析了影響砂土抗剪強度的各種因素，這些因素既包括土本身的特性（土的密度、結構、級配、透水性以及初始狀態等） ，又包括動荷載的特徵（振動力幅值大小和振動頻率等） 。
  17. Based on the modal analysis data of the displacement of the spatial grid structure getting by the structural finite element analysis software ansys, the modal analysis technology of the axial member straining rate is used to identify the damage of the spatial grid steel structure in different damaged conditions and is found to be able to accurately position the damaged places of the spatial grid member

    文中通過結構有限元分析軟體ansys得到網架結構位移模態分析數據，採用桿件軸向應變變化率的模態分析技術針對不同損傷狀況的鋼結構網架進行損傷識別，能夠較為準確地診斷出網架桿件的損傷位置。
  18. Both the effect of substrate deformation and the state of large deflection of the microbridge are involved in the theoretical expression. furthermore, the distribution of axial stress in the micro bridge is discussed in detail by taking different shapes of cross section into consideration. and a shape factor is introduced into the expression, which simplifies the theoretical expression

    理論上對薄膜微橋法的公式進行了進一步的化簡，在考慮襯底變形貢獻和大撓度的基礎上，進一步探討了微機械加工過程中不同橫截面形狀的情形；並對矩形和梯形截面微橋的軸向應力分佈作了分析，補充和發展了薄膜微橋法的理論；引入了橫截面形狀修正因子，簡化了公式的表達和計算。
  19. Four arrays of apparent resistivity are arranged at this measuring surface of granite sample symmetrically with symmetrical four - electrode method, and at an angle of 45 between any two adjacent arrays. the elastic constraint is exerted on 4 surfaces for parallel to the longest dimension of the sample. the samples are compressed along the direction parallel to the longest dimension of the cubic, and the variation of apparent resistivity during the whole loading process is observed

    在花崗巖標本測量面上，布設4條夾角互為45的視電阻率測線，將標本平行長軸方向的4個面加上彈性約束，沿標本長軸方向加壓，測量標本視電阻率隨軸向應力的變化，實驗結果為： 1巖石視電阻率變化形態顯上升-平穩-下降形態，但平穩段不明顯，時間很短2視電阻率開始下降時間，比其他受力方式實驗結果都早，約提前10 %破裂應力。
  20. The experimental results are the following : 1 the resistivity changing features of rock show rise - smooth - drop, and the smooth segment is very short and unobvious. 2 the time of first drop for the apparent resistivity is earlier than all other loading experimental results, the rupture stress about moves up by 10 per cent. viz : the apparent resistivity starting drop when axial rupture stress increases about 40 per cent for the array parallel to the axial ; the apparent resistivity starting drop when axial rupture stress reaches about one - third for the arrays non - parallel to the axial

    即：平行於軸壓方向的測道，在軸向破裂應力的40 %左右開始下降不平行軸壓方向的測道，視電現率約在1 3軸向破裂應力開始下降3電阻率從開始下降起，下降速率逐漸增加，但增加得很緩慢，巖石大破裂前，單位軸向應力變化引起的視電阻率變化幅度也不是很大。
分享友人
分享到 Line

分享到臉書