軸折斷 的英文怎麼說

中文拼音 [zhóuzhéduàn]
軸折斷 英文
axle fracture
  • 軸 : 軸Ⅰ名詞1. （圓柱形的零件） axle; shaft 2. （對稱部分的直線） axis 3. （圓柱形的纏繞器物） roller; spool Ⅱ量詞（用於纏在軸上的線以及裝裱帶軸子的字畫）
  • 折 : 折動詞[口語]1. （翻轉） roll over; turn over 2. （倒過來倒過去） pour back and forth between two containers
  • 斷 : Ⅰ動詞1 （分成段） break; snap 2 （斷絕;隔斷） break off; cut off; stop 3 （戒除） give up; abstai...
  1. The diagnostic value of coronal and axial ct scan in orbital blowout fracture

    冠狀位與軸位掃描對眼眶爆裂骨折診斷的價值
  2. The problem of torque increase and drill fracture during the process of deep well drilling was analyzed, and a safety protection and control technique was introduced, where a torque sensor was fixed between drilling bar and motor axis, while an electromagnetic clutch was fixed in the transmission chain of feed system

    摘要對深孔鉆削過程中出現扭矩增大及折斷鉆頭鉆桿問題進行了分析，介紹了一種鉆桿主軸與電機軸的連接中安裝扭矩傳感器，進給系統的傳動鏈中安裝電磁離合器的深孔鉆削安全保護與控制技術。
  3. Abstract : the remedial maintenance method for broken gear shaft of small or medium equpment is introduced. the usual using can be essured after repaired

    文摘:介紹了中小型設備齒輪軸折斷的修復方法。通過裝配焊接的方式修復，可保證該軸正常使用。
  4. Long parts, ( such as axis, pole and so on ) varying along the profiled bar direction by the length or by a certain rule can be shortened to represent, and the broken part shall be represented by waved line or zipped lines, as shown in fig. 13

    較長的機件（軸、桿、型材等）沿長度方向的形狀相同或按一定規律變化時，可斷開后縮短繪制，斷開后的結構應按實際長度標注尺寸；斷裂邊界可用波浪線、雙折線繪制，如圖13所示。
  5. An investigation made into the fallure of motor shaft fit on 2zkx2148 linear vibration screen

    2148型直線振動篩電機軸折斷事故的探討
分享友人
分享到 Line

分享到臉書