較大拓撲 的英文怎麼說

中文拼音 [jiàodàtàpū]
較大拓撲 英文
larger topology
  • 較 : Ⅰ動詞1 （比較） compare 2 [書面語] （計較） dispute Ⅱ副詞（比較） comparatively; relatively; fair...
  • 拓 : 拓動詞（把碑刻、銅器等的形狀和上面的文字、圖形印下來; 拓印） make rubbings from inscriptions pict...
  1. The algorithms can generate multi - layers topology automatically, solve the problems of overlap, intercross, unreasonable layout of nodes in network topology

    實現了多層拓撲圖自動生成功能，解決了拓撲圖規模較大時存在的重疊、交叉和布局不合理等問題，具有較強的容錯顯示能力。
  2. 6. we examined the mode and tempo of evolution of cyt b in oedipodidae. for these grasshoppers, the most common amino acids and codons are leucine ( tta ), isoleucine ( att ) and phenylalanine ( ttt )

    運用cytb基囚的核』苦酸序列對斑翅蝗科昆蟲進行系統研穴時，各屬種問的分類關系都比較明確，得到的樹的拓撲結構大都一致。
  3. Finding a feasible and efficient load balanced strategy for the ultra - scalable multi - plane multi - stage switch architecture is a top of nowadays research. the dissertation proposes a two - stage load balanced scheme for the ultra - scalable multi - plane multi - stage switch architecture based self - routing and non - blocking permutation benes network. the approach uses reasonable and efficient logical queueing strategy and schedule scheme in ingress traffic managers and switch planes to realize the two - stage load balancing of ip traffic which for different destination addresses

    本文提出一種適用於基於完全可重排無阻塞benes拓撲構建的多平面多路徑（多級）超大容量交換結構的兩級負載均衡策略，通過在輸入流量管理器和benes交換平面內部實施合理而高效的隊列組織調度方法，有效實現了基於不同目的地址的ip流量在兩個層次上的負載均衡，較好彌補了ciscocrs - 1系統在平面選擇和中間級選擇時所採用的簡單隨機或輪循方案的不足。
  4. Secondly, compared with some other kinds of comparator structure and based on the preamplifier - latch fast - compare theory, a novel topology of cmos preamplifier latch comparator circuit is presented. considering trade - off between kickback noise and power dissipation, reference resistance value is optimized. according to the encode demands of different stage resolution, clock - control encode circuit is designed

    其後，在具體的子adc設計中，對比各比較器類型的優缺點，並基於預放大鎖存快速比較理論，提出一種新型高速低功耗預放大鎖存比較器電路拓撲;根據adc系統所允許的參考電壓最大波動限制，在回饋噪聲對輸入參考電平的影響和功耗之間折衷，確定優化的參考電阻串阻值;根據不同級精度的編碼要求，設計出時鐘控制編碼電路。
  5. In chapter 2, the nonlinear feature of iron core of transformer in switching power supply was studied. according to the characteristics of switching power supply, the topology structure of resonant converter was selected. the characteristics of out put voltage and current vs. frequency for the three kinds of resonant converter were analyzed and compared

    在第二章中，研究了高壓開關電源中高壓變壓器的非線性特性，選擇了諧振變換器作為高壓大功率開關電源的電路拓撲結構，並對三種形式的諧振變換器的電壓及電流頻率特性進行了分析比較。
  6. In geography space, compared with spatial topological relations, spatial direction relations without doubt have more abroad applications and more closed to the human ’ s life, they should occupy more important position and exert greater effect in spatial information field

    在地理空間中，與空間拓撲關系相比較，空間方位關系無疑是用途更廣泛、更貼近人們生活的一種空間關系，在空間信息領域應該佔有更重要的地位和發揮更大的作用。
  7. The principles and characteristics of synchronous rectification ( sr ) are given, and advantages of self - driven sr in low power applications is detailed. review of several topologies which incorporate self - driven sr makes the constrains of conventional self - driven sr scheme apparent and thus a new scheme to drive srs is proposed. the developed single - winding self - driven synchronous rectification ( swsdsr ) scheme works properly in topologies that drive symmetrically the transformer ( push - pull, half bridge, . . ). it allows for maintaining the srs on even when the voltage in the transformer is zero, which is impossible to do in traditional self - driven approaches

    本文針對低壓/大電流輸出的小功率dc / dc變換器，圍繞著變換器的效率問題，分析了同步整流的原理和特點，重點闡述了自驅動同步整流在低功率場合的優勢，在分析比較了多種與自驅動同步整流相結合使用的電路拓撲后，指出常規的自驅動同步整流方案限制了與之結合使用的電路拓撲的范圍這一局限性，從而給出了一種新穎的單繞組自驅動同步整流方案。
  8. This dissertation is faced to the process of steel rolling to found network of manufacture material flow, basing on it founding guide line evaluation system of the cost of unit standard producing working procedure, guide line evaluation system of the quality cost of unit standard producing working procedure and guide line evaluation system of performance and efficiency ; and base on the cost data of all kinds of material flows, manufacture flow, flux data, manpower, energy consume, material consume, capital asserts occupied, fund occupied, and the production in working procedure, throughput of the materials in working procedures in the flow and countercurrent flow in the network of material flow of recorded in working procedure producing, using the “ whole closed down lane ” model to describe network of manufacture material flow of steel rolling, found the cost analyzing model system of the network faced to producing process. make the cost increasing of the producing by abnormity material flow in working procedure, and even the cost increasing of the producing procedure as the cost of the management behavior of working procedure fallen under cost evaluation guideline in responsible working procedure, so as to ration measure the factors fast correlated with management behavior by measuring the cost

    在企業管理信息化輔助工具所建立的數據平臺基礎上，建立了以基準物流圖模型為基礎的軋鋼生產主流程物流網路拓撲圖，根據圖論的理論求解最大流量和最小費用;計算每個生產節點的加工成本，分離質量成本，克服了單純財務數據進行成本核算所帶來的缺陷;建立了軋鋼生產主流程工序含鐵物料吞吐能力基準圖模型，並根據此模型建立了軋鋼生產主流程工序激勵物流協調性和匹配性、工序響應物流協調性和匹配性分析的過程能力指數計算方法;通過引入決策單元綜合投入與綜合產出效率最優原則的模型和基於投入不變、分析產出是否有效或基於產出不變、分析投入是否有效的模型，實現了對多個績效指標在不同績效值集合之間的相對比較，並可根據投入產出效率準則、或者投入（產出）有效性準則進行排序。
  9. A new complex structure of 12 - stepped wave converter is presented in the paper. it can greatly increase the output voltage without increasing the input dc voltage

    摘要提出一種復合型12階梯波變流器的拓撲結構，在不提高直流輸入電壓的前提下可以較大幅度提高輸出電壓。
  10. Through analyzing and comparing several typical high frequency inverter circuits, an available high power topological structure is selected. all of these offer and plan good preparation of earlier stage for power source designing and device debugging, and reducing device cost and raising working efficiency

    通過參考比較幾種高頻逆變電路，選擇設計一種大功率逆變拓撲結構，為以後電源裝置的設計調試、減少器件成本及提高工作效率提供良好的前期準備。
  11. Based on the advantage of the solid - switch, many fcls with solid - state switch have been proposed. fcl with series compensation which could limit the fault current and also make compensation is more flexible and practical when compared to the others. in this paper, a type of fault current limiter with series compensation is studied

    基於此，研究者提出了各種不同拓撲結構的採用固態開關的故障限流器，其中，帶串聯補償的故障限流器，既具有串聯補償的功能，又能根據短路的實際情況改變限流程度，因而具有較大的靈活性和實用性。
  12. 1 ) through correlation analysis between programming time and influential performance parameter, this performance parameter is considered as the weight mapping to the expected time ; 2 ) considered the influence of each performance parameter, the input number of ann is reduced by declining the performance parameter that have little effect on the programming time

    1 ）通過數據相關分析來確定對程序執行時間有影響的性能參數的相關系數作為此性能參數的權重，在確定host時只需看這些參數與權重的函數來評定。 2 ）應用人工神經網路技術，考慮各個性能參數的影響，通過相關分析來確定和程序執行時間相關性比較大的參數作為神經網路的輸入確定網路拓撲結構。
  13. A necessary and sufficient condition is given in paper [ 16 ] for the sublinear case by the method of upper and lower solution and pontrjagin maximum principle. but the superlinear results are spare because of the essential difference between the superlinear case and the sublinear case. in section two, we gave a necessary and sufficient condition for the superlinear case

    對於四階奇異微分方程邊值問題有不少研究成果， o 』 regan [ 10 ]中利用拓撲橫截定理給出了其解存在的充分條件，文獻[ 16 ]則利用上下解方法和極大值原理給出了問題在次線性情形下正解存在的充分必要條件，由於超線性與次線性的本質區別，使得超線性的研究結果相對較少，本文第二節則致力於給出一類四階超線性常微分方程奇異邊值問題正解存在的充分必要條件
  14. In the practice application, the project ? the large dam secure supervising and measuring system of taipu brake, which the penman participated himself, is introduced in detail, which includes the system synopsis, the definition of the pressure, the crack, the horizontal displacement and the vertical displacement, the compare of diversified measuring methods, the choice of the instruments and the configuration of the instruments, the system network topology configuration, the collocation of various metrical dots and instruments " demarcating and testing, the system software and the application software, the communications between the intelligent instruments and the primary interfaces of actual system

    在實踐應用方面，詳細介紹了筆者親自參與實施的工程? ?太浦閘大壩安全監測系統，包括系統簡介，揚壓力、裂縫、水平位移和垂直位移的定義，各種測量方法的比較，儀器的選型以及儀器的結構，系統的網路拓撲結構，各測點的布置以及儀器的標定測試，系統軟體和應用軟體，智能儀器與上位機的通信，實際系統的主要界面。為了論文的完整性，介紹了大壩安全監測專家系統。
  15. So the network ' s average blocking probability is minimized. simulation results show that the algorithm performs well in dynamic traffic load situation. secondly, for mpls based approach, we study the problem of designing logical topology for virtual private networks ( vpns ) over ip / wdm networks considering different qos requirements

    對于給定的網路物理拓撲及業務矩陣，對不同qos要求的vpn進行資源分配時，首先照顧較高質量要求的vpn業務，並且，對于相同qos要求的vpn業務，優先考慮業務量比重較大的節點對，並盡量保證負載在全網均勻分佈。
分享友人
分享到 Line

分享到臉書