載波檢測器 的英文怎麼說

中文拼音 [zǎibōjiǎncèqì]
載波檢測器 英文
carrier detector
  • 載 : 載Ⅰ名詞（年） year : 一年半載 six to twelve months; six months to a year; 三年五載 three to five ...
  • 波 : Ⅰ名詞1 （波浪） wave 2 [物理學] （振動傳播的過程） wave 3 （意外變化） an unexpected turn of even...
  • 檢 : Ⅰ動詞1 （查） check up; inspect; examine 2 （約束; 檢點） restrain oneself; be careful in one s c...
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 載波 : signal carrier; carrier wave; carrier: 3路載波 three channel carrier載波傳輸 carrier transmission...
  • 檢測器 : detector
  • 檢測 : check; detection; test; gauging; detecting; sensing; [工業] checkout; measuring
  1. Lightwave is employed in information technologies, implementing e. g. signal transmission, displaying, storing and sensing, etc. optical devices are key elements in these technologies

    光波作為信息載體，在信息的傳輸、顯示、存儲以及檢測等應用領域發揮著越來越重要的作用，光器件是光波信息處理中的核心技術。
  2. In the paper, prescale technology, interpolate method, averaging method and multiple period synchronization method are used to measure the frequency accurately. diode demodulating technology, and power attenuated method or probe coupling & water load technology are employed to measure the power of high power microwave. isothermal technology is used to improve the stability of demodulator and to expend the range of square linear region

    本文採用預分頻法、內插法、多周期同步法、平均法實現了頻率的精確測量;利用二極體檢波技術，結合衰減法或探針耦合+水負載技術實現了大功率微波功率的測量;採用恆溫技術提高了二極體檢波器穩定度;完成了單片機串口通信協議設計和系統電磁兼容的分析和設計。
  3. Refer to the impacting - echo technology, we impacted the apex of the steel bar and incepted the reflecting stress ave through the resonator that fixed on the apex of the steel bar, and the value of the consolidating wave speed was calculated based on the time of stress wave transmitted and the length of the steel bar, so, identifying the reflecting signal is the key of the consolidating wave speed method

    借鑒于沖擊回波技術，固結波速的測定方法是在鋼筋測桿的出露端施加瞬態沖擊載荷，由安設在測桿頂端的傳感器接收反射應力波信號，根據應力波的走時和測桿的長度折算固結波速的大小，因此反射信號的識別是固結波速法檢測混凝土強度的技術關鍵。
  4. This paper describes mainly system functions, measuring methods, circuit design, software program and errors analysis of a new type of measuring instrument. this instrument can measure and monitor electric parameters in single - phase circuits, three - phase ( three - wire or four - wire ) circuits. this system can be applied to electric devices and power plants, transformer substations with harmonic pollution. it can measure current, voltage, power, energy, frequence, power factor etc. it also can detect load quality, phase sequence, alarm, display and print results, as well as detect and dispose negative power

    該儀器適用於含有諧波污染情況下的機電設備現場、發電廠、供電局、企業變電所現場，可用來測量電流、電壓、有功功率、無功功率、視在功率、有功電能、無功電能、視在電能以及頻率和功率因數等電參數，並具有負載性質（感性、容性）判別，正、逆相序判別指示功能；超限報警功能；列印記錄功能和負功檢測及處理功能。
  5. There are five parts are as follows : in part one, the concept of switching function is introduced first to establish the nonlinear mathematical model of the induction motor variable frequency speed adjustment system which is fed by a sine pulse width modulated ( spwm ) inverter and takes the effect of the main magnetic circuit saturation into consideration, then the low frequency oscillation of the system is simulated according to the model. next, from the view point of energy conversion of the inverter - induction system, a criterion for the low frequency oscillation is proposed to determine whether the system is in low frequency oscillation which is judged by whether the interval of the negative current component of the inverter input current is more than 1 / fc ( fc is the carrier wave frequency of the inverter ) or not

    首先引入開關函數概念，建立了正弦脈寬調制（ spwm ）逆變器供電異步電動機，考慮主磁路飽和時的變頻調速系統整體數學模型，模擬系統的低頻振蕩；其次從逆變器-異步電動機系統能量轉換角度出發，提出通過檢測逆變器輸入電流中負電流的間隔時間是否大於1 / f _ c （ f _ c為逆變器載波頻率）來判定系統是否出現低頻振蕩；最後的實驗結果驗證了系統低頻振蕩建模和判據的實用性和正確性。
  6. Investigation on rf power amplifier imd detection and carrier cancellation

    射頻放大器互調失真檢測和載波抵消的研究
  7. On the basis of this, the control strategies for obtaining its reference voltage, one of pivotal technolog, are discussed. corresponding control circuits are designed, including the control strategies of detecting the source current and load voltage

    在此基礎上探討了串聯型有源電力濾波器的關鍵技術之一? ?獲得參考電壓的控制策略，包括檢測電源電流和檢測負載電壓兩種控制策略，並設計了相應的控制電路。
  8. It is composed of thirteen functin ? components including two 3 - db y - junction power splitter, two directional couplers, two waveguide attenuators and one polarizer of waveguide itself. the prominent feature of the device is that it has a beat detection function with respect to the single y - branch mioc device, and it plays an important role in improving the inertial - grade and the high precision steady - aim system because of the beat detection function. farthermore it has direct influence on the improvement of the high flexibility, shockproof and overload - resistance for the steady - aim system

    器件的工作波長為1 . 3 m ，集分束器、合束器、起偏器/檢偏器、相位調制器、波導吸收器等十三個功能單元於一體，除了單y多功能集成光路器件具備的功能外，它還具有拍頻檢測功能，因而對提高慣導級和高精度穩瞄系統起著重要的作用，並直接影響著穩瞄系統的高機動性、抗沖擊力和過載能力的提高。
  9. Light source and the signal processing device are placed on the shore in the optical fiber hydrophone system using phase - generated - carrier technique, which make the wet end with no electronic devices

    採用相位載波調制解調技術（ pgc ）的岸基陣光纖水聽器信號檢測方案將光源與信號處理都放在岸上，系統濕端全光纖化。
  10. We analyzed the anti - jam and band inside anti - interfere performance of the system, and the low probability intercept ( lpi ) of the traditional direct sequence spread spectrum ( dsss ) modulations in the uav platform ' s applications. so a new modulation technique using a multi - level pseudo noise ( pn ) code has been presented. the new multi - level pn code is built from a high speed pn code through a low passed filter ( lpf )

    分析了系統抗阻塞式干擾和抗帶內頻帶干擾的性能，以及常規bpsk qpsk - dsss調制在無人機通信中存在的安全隱患，提出了一種用多電平pn碼進行擴頻調制的方法：採用高速pn碼，經過低通濾波器，產生多電平pn碼進行直序擴頻調制，能在低信噪比情況下有效抵抗平方率檢測器對系統載波的檢測。
  11. Three - phase four - wire apf with one - cycle control need not sense the three phase load currents or the three phase voltages, need not calculate the harmonics and reactive current components, as well as the use of any multipliers

    單周控制三相四線制有源電力濾波器不需要檢測三相負載電流和三相電源電壓，不需要檢測諧波和無功電流，也不需要使用任何乘法器。
  12. The purpose of this paper is to resolve some key technologies of the amplitude - modulation inductive displacement transducer signal processing circuit with nanometer resolution, such as the design of high stability signal generating circuit ; the technology of high precision digital phase - sensitive detection circuit ; the technology of digital filter and linearization, etc

    本文主要研究調幅式電感位移傳感器精密測量系統中涉及的高精度載波信號發生技術、高精度數字相敏檢波技術、數字濾波及線性擬和等關鍵技術，目的是進一步改善調幅式電感位移傳感器精密測量系統的測量精度，適應納米級測量的要求。
  13. The technology of research include following. the computer order control to attain testing condition of relay ' s turn - on and off. to control of testing ac voltage by adoption of advance control strategy

    測控技術包括：實現模擬繼電器接通與分斷負載條件的順序控制技術；採用先進控制策略的試驗電壓控制技術；試驗參數檢測技術；試驗參數波形的實時顯示技術；以dsp （數字信號處理器）為核心的試驗數據高速採集技術。
  14. Jinque co. has developed neo - generation reliable frame - structure ups, which is high frequency and on - line intelligent and whose height is 19 inchs. the product adopts cpu process, so it has excellent ability to calculating and accurately test every control point to guarantee reliability of quality. at the same time, due to the design of double - change power, the voltage and frequency are stable ; the product deletes all kinds of interrupted frequency and becomes power of sine wave to provide vital equipment with better power environment

    金雀公司根據網路系統的電源要求，開發出新一代高可靠的19英寸機架式高頻在線智能型gr系列ups ，採用cpu處理器，極強的運算能力，精確迅速地檢測ups各控制點，由於採用雙變換電源設計，供負載使用的電源電壓頻率穩定，濾除雜讀的純凈正弦波電源，為重要的設備提供更佳的電源環境。
  15. The theoretical and experiment results shows that the digital examine and control system which adopts vss lms algorithm can allow the apf to track changes in the system as well as produce a small steady state error, therefore ensures the speed and precision of apf. also erase / program flash on system and bootload are achieved

    實驗結果表明，採用變步長lms演算法的數字化檢測與控制系統同時保證了諧波檢測的速度與精度，在負載變化時有更好的跟蹤能力，滿足有源電力濾波器對諧波檢測的要求。
  16. After the analysis of power produce character of the typical three - phases unbalance load, the corresponding circuit is adopted. this main circuit is composed of the power filter series and tcr control circuit. secondly the theory of band - pass filter is analyzed in detail, and then a method of implementing butterworth band - pass filter is put forward

    簡要分析了無功補償的基本原理和工作特點，通過對典型的三相不平衡負載工作特點的分析，主電路採用電力濾波器與晶閘管控制電抗器相接合的結構；對用於無功檢測的帶通濾波器進行了分析，設計了用於負載電壓、電流信號濾波的帶通濾波器，並採用運算放大器加以實現。
  17. The list betterments aimed at the properties of system : through the testing of dc voltage, pulse width and inverting voltage and frequency can be regulated online to fit for different steady load ; reducing speed ripples by compensating with nonzero voltage working proportional time ; adopting the technology of harmonics suppression. as a result, the high precision and wide speed control is realized and the step out is overcome

    針對系統的性能指標，做了如下改進：對直流側電壓的檢測，在線調整逆變器導通脈寬、輸出電壓和頻率，可以適應不同大小的恆負載；並用非零電壓矢量作用時間進行補償的方法，減小電機的低速脈動；加入了諧波抑制技術等。
分享友人
分享到 Line

分享到臉書