載波降低度 的英文怎麼說

中文拼音 [zǎibōjiàngdīdù]
載波降低度 英文
carrier reduction
  • 載 : 載Ⅰ名詞（年） year : 一年半載 six to twelve months; six months to a year; 三年五載 three to five ...
  • 波 : Ⅰ名詞1 （波浪） wave 2 [物理學] （振動傳播的過程） wave 3 （意外變化） an unexpected turn of even...
  • 降 : 降動詞1. （投降） surrender; capitulate 2. （降伏） subdue; vanquish; tame
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 載波 : signal carrier; carrier wave; carrier: 3路載波 three channel carrier載波傳輸 carrier transmission...
  1. 4. in data acquisition system, the application of phase - locked and synchronous detection reduce the cost of the whole system and improve the sensitivity. carrier signal and modulation signal achieve entirely synchronous too

    數據採集系統採用鎖相技術、同步檢波的原理，降低了整個系統的成本，提高了靈敏度，並使得載波信號與調制信號完全達到同步。
  2. Abstract : based on the iterative bit - filling procedure, a computationally efficient bit and power allocation algorithm is presented. the algorithm improves the conventional bit - filling algorithms by maintaining only a subset of subcarriers for computation in each iteration, which reduces the complexity without any performance degradation. moreover, a modified algorithm with even lower complexity is developed, and equal power allocation is introduced as an initial allocation to accelerate its convergence. simulation results show that the modified algorithm achieves a considerable complexity reduction while causing only a minor drop in performance

    文摘:基於迭代的比特和功率分配機制，提出了一種低復雜度的比特和功率分配演算法.與傳統的迭代分配演算法不同，該演算法在每次迭代中只需要比較幾個特定的子載波.該方法在保持傳統迭代演算法性能的前提下極大地減小了迭代分配演算法的復雜度.此外，通過選擇等功率分配方案作為初始方案加快了演算法的收斂速度，進一步降低了演算法復雜度.模擬結果表明，提出的改進演算法在基本不犧牲系統性能的前提下有效地降低了演算法復雜度
  3. Multiband transmission permits a reduction in error probability in exchange for at least a twofold increase in bandwidth and carrier power

    多頻帶寬傳輸能降低誤差概率，但其代價是速度及載波功率至少增加一倍
  4. 2. clipping is used to reduce the papr ( peak - to - average power ratio ) of multicarreir gmsk signal. the conclusion is that the moderate clipping introduces small performance degradation

    採用削波方法來降低多載波gmsk信號的峰平比，結論是中等程度的削波只引起系統性能的略微下降。
  5. In this thesis, a kind of 2 - dimention signal acquisition method is presented which combines parallel pn code phase and carrier frequency acquisition, as a result the acquisition time is shortened greatly. besides, according to the fact that the detection of spread spectrum signals is always the key point in the receiving system

    在擴頻信號的捕獲過程中要求有較小的時延和較高的概率，本文介紹一種二維信號的捕獲方法，這種方法結合偽pn碼和載波頻率的獲取，捕獲時延將大幅度降低，實際上，擴頻信號的檢測是接收系統的關鍵。
  6. Capacity and performance of mobile radio systems essentially depend on the choice of the multiple access scheme. a novel and promising wireless digital modulation / multiple access technique called multicarrier cdma is studied in this thesis, including reducing the peak - to - average ratio, which is one of its key techniques. mc - cdma is combination of ofdm and cdma, thus advantages of both techniques are exploited

    移動通信系統的容量和性能在很大程度上取決于多址方案的選擇，本文主要討論了在通信領域新興的擴頻多址方式一多載波cdma （ mc - cdma ） ，並對降低mc - cdma系統峰值平均功率比這一關鍵技術進行了研究。
  7. What the subject researching is that power energy should be measured with base wave ammeter to power systematic nonlinear user ; and that it is high veracious by base wave ac parameters measurement method to those not bad contaminative. it is well known that all kinds of ac parameters including of base wave and harmonics, but the content of harmonics in power systems increase largely with the mass disturbance to power using high - power electric equipment. which makes wave shape of voltage and current aberrence, so the measurement veracity and reliability decreased largely. at the same time brings out serious infuency to safe run of power system and electric equipment. the power which any non - linear loads consumes can be divided into two sides, one is base power absorbed in power and the other is minus harmonics power

    本課題所研究的問題是針對電力系統非線性負載用戶採用基波電度表來計量電能；而對諧波污染不嚴重的線性用戶採用基波交流參數測量的方法仍然具有較高的準確性。眾所周知，各種交流參量都包含基波和各次諧波，然而隨著電力電子技術的迅速發展，大功率的用電設備對電網的干擾也是越來越嚴重，導致電力系統諧波含量迅速增長，使電壓和電流的波形產生嚴重畸變，測量的準確性和可靠性都大大降低，同時也對電力系統和用電設備的安全運行帶來嚴重的影響。任何一種非線性負載所消耗的功率都可以分為兩部分，一部分為從電網中吸取的基波功率，另一部分則是負的諧波功率。
分享友人
分享到 Line

分享到臉書