載物玻片 的英文怎麼說
中文拼音 [zǎiwùbōpiān]
載物玻片
英文
glass slide-
Constructing cdna expressing library of erythrocytic plasmodium falciparum from hainan : the total rna was obtained by using. triplix kit. a modified oligo ( dt ) primer ( cds ffi pcr primer ) was used in the single - stranded ( ss ) dna synthesis reaction. the ss - dna was reversely transcripted from total rna. double - stranded ( ds ) cdna was amplified by long - distance ( ld ) pcrafter the digestion with proteinase k and sfi i, the cdna with no less than 200bp was collected and purified by glass - milk kitthe library was constructed after the ligation of cdna to tiplex2 phage particle packaged with the packaging extract system in vitro. a high titer and high recombinant ratio of cdna library was constructed
構建惡性瘧原蟲海南株紅內期cdna表達文庫提取紅內期惡性瘧原蟲海南株總rna ，直接以總rna為模板使用cdna文庫構建試劑盒，首先反轉錄合成ss一dna ，再擴增合成ds一dna （ cdna ） ，對擴增產物用蛋白酶k消化及左z丁i酶切，抽提蛋白、去除rna后，用玻璃奶試劑盒純化、回收20obp以上的片斷，經與載體連接再用蛋白包裝物包裝后形成未擴增文庫，最後擴增完成惡性瘧原蟲海南株紅內期cdna表達文庫的構建。A five - phase numerical model based on prism coupled is derived from maxwell equation and fresnel equation. using the professional software - mathcad, characteristic of this numerical model is simulated. the relationships between depths of the metal film, bio - sensitive film, cover slide, the refractive index of bio - sensitive film and the resonant angle ospr has been discussed respectively
根據maxwell方程和fresnel方程推導出5層棱鏡耦合spr數值化模型，利用數學軟體mathcad對該數學模型進行了模擬，討論了金屬膜厚度d _ 2 、生物膜厚度d _ 3和折射率n _ 3 、載玻片厚度d _ 1與諧振峰值_ （ spr ）的關系。It is proved by the simulation that the temperature of samples can be estimated from the thermo - couple placed on the cover glass and the planar temperature distribution of the cryostage is approximately uniform
分析結果表明：可以利用布置在蓋玻片上表面的熱電偶測量並推算實驗樣品層的溫度；低溫臺載物表面溫度均勻。The tio2, cds and cds - tio2 films on the common glass substrate were prepared, respectively, using ti ( oc4h9 ) 4, cd ( cooch3 ) 2 and scn2h4 as raw materials by sol - gel method. the influences of manifold preparing parameters ( such as the concentration of sol, the amount of the peg. the number of coatings, the heat - treated temperature and time ) on the structure and performance were studied
本文採用溶膠-凝膠技術，以鈦酸丁酯、乙酸鎘和硫脲為原料，以普通玻璃片為載體，制備了納米tio _ 2薄膜、 cds薄膜和cds - tio _ 2復合半導體薄膜，研究了制備過程中多種制備參數（如溶膠的濃度，聚乙二醇（ peg ）的加入量，鍍膜層數，熱處理溫度及時間）對薄膜結構和性能的影響，採用x -射線衍射（ xrd ） 、掃描電鏡（ sem ） 、能譜分析（ edxa ） 、紫外-可見吸收光譜（ uv - vis ）等測試手段對各薄膜進行了結構和物性表徵。分享友人