載頻振蕩器 的英文怎麼說

中文拼音 [zǎibīnzhèndàng]
載頻振蕩器 英文
carrier frequency oscillator
  • : 載Ⅰ名詞(年) year : 一年半載 six to twelve months; six months to a year; 三年五載 three to five ...
  • : Ⅰ形容詞(次數多) frequent Ⅱ副詞(屢次) frequently; repeatedly Ⅲ名詞1 [物理學] (物體每秒鐘振動...
  • : 動詞1. (搖動; 揮動) shake; flap; wield 2. (奮起) brace up; rise with force and spirit
  • : Ⅰ動詞1 (搖動; 擺動) swing; sway; wave 2 (無事走來走去; 閑逛) loaf; wander; roam; loiter; go a...
  • : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
  1. For digital audio encoding and decoding modules, delta - sigma modulation is introduced and audio data, preambles with accessorial data are multiplexed according to the digital audio interface standard ; for carrier wave, pll frequency synthesizer is used ; for frequency modulation, voltage control oscillator is taken ; for demodulation, pll frequency discrimination is adopted

    調制方式,並按照數字音介面標準對音數據、同步字和附加信息進行通道復用;對于波信號,採取鎖相環率合成技術手段;對于率調制,採用壓控;對于解調電路,採取鎖相環鑒電路。
  2. There are five parts are as follows : in part one, the concept of switching function is introduced first to establish the nonlinear mathematical model of the induction motor variable frequency speed adjustment system which is fed by a sine pulse width modulated ( spwm ) inverter and takes the effect of the main magnetic circuit saturation into consideration, then the low frequency oscillation of the system is simulated according to the model. next, from the view point of energy conversion of the inverter - induction system, a criterion for the low frequency oscillation is proposed to determine whether the system is in low frequency oscillation which is judged by whether the interval of the negative current component of the inverter input current is more than 1 / fc ( fc is the carrier wave frequency of the inverter ) or not

    首先引入開關函數概念,建立了正弦脈寬調制( spwm )逆變供電異步電動機,考慮主磁路飽和時的變調速系統整體數學模型,模擬系統的低;其次從逆變-異步電動機系統能量轉換角度出發,提出通過檢測逆變輸入電流中負電流的間隔時間是否大於1 / f _ c ( f _ c為逆變率)來判定系統是否出現低;最後的實驗結果驗證了系統低建模和判據的實用性和正確性。
  3. The equivalent cavity model is used to deduce the threshold condition of the ecld, and the expression of the threshold carrier density n ( v ) when ecld is tuned to oscillate at different frequencies has been obtained. using the expression of n ( v ) and the carrier dependent refractive index, the simple basic equation describing the bistable characteristics has been derived after choosing an appropriate reference frequency nf

    通過建立等效腔模型來推導外腔半導體激光的閾值條件,得到ecld在不同率v所需的閾值流子密度n ( v )表達式,利用該表達式及相關的折射率表達式,在選擇合適的參考流子密度n _ f后,導出了一個描述雙穩所需的基本方程。
  4. At present the manufacture of surface acoustic wave use the technology of the final submicron. a series of the devices of low insertion loss, high q saw rayleigh surface acoustic wave resonators or stws that insertion loss has less than 5db, load quality factor ( ql ) is more than 1000 on the quartz piezoelectric with zero of first temperature factor in the research. these difference frequencies are 60mhz, 280mhz, 739mhz and 1ghz of normal frequency and at also surface acoustic wave. using 1. 25db noise factor amplifier, careful design curcuit, good setting printed curcuit board, and using the 1ghz surface transverse wave resonator as frequency element, researching the low phase noise surface acoustic wave with sideband phase noise near ? 120dbc / hz deviating 1khz on carrier, spurious suppress with 80db

    本研究採用一階溫度系數為零的壓電石英基片上製作出損耗小於5db 、有品值因素( ql值)超過1000的一系列低損耗、高q值聲表面波rayleigh波或stw諧率分別為60mhz 、 280mhz 、 739mhz和1ghz等不同率的高性能聲表面波諧。並採用噪聲系數為1 . 25db的低噪聲系數放大,精心設計電路,優化設計布置印製電路板,用標稱率為1ghz的聲表面波諧率控制元件,製作出在偏離1khz處的單邊帶相位噪聲近- 120dbc / hz 、雜波抑制達80db以上的低相位噪聲聲表面波
  5. Experimental data indicate control system can correct completion the rise or fall of voltage transformer and the throw or cut of capacitor - group, prevent equipments from frequently regulated and shakes, raise the lifespan of the equipments

    實驗數據表明,將模糊控制引入電壓無功綜合控制中,控制系統能夠正確的完成對有調壓變壓分接頭的升降和電容組的投切,並可以避免設備繁調節和,提高設備運行壽命。
  6. Resonant frequency at which the unloaded transducer without force translation parts oscillates after shocklike excitation in the direction of the measuring axis, whereby the basis intended for securing it is coupled to a sufficiently large mass

    沒有力平移元件的空轉換在測量軸方向上受到類似震動的激勵下會產生震。在基本共率下會對固定基礎造成很大傷害。
分享友人