輸出增幅器 的英文怎麼說

中文拼音 [shūchūzēngfúqì]
輸出增幅器 英文
output amplifier
  • 輸 : Ⅰ動詞1 （運輸; 運送） transport; convey 2 [書面語] （捐獻） contribute money; donate 3 （失敗） l...
  • 幅 : Ⅰ名詞1. （布帛、呢絨等的寬度） width of cloth 2. （泛指寬度） width; size 3. （姓氏） a surname Ⅱ量詞（用於布帛、呢絨、圖畫等）
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 輸出 : 1 （從內部送到外部） export 2 [電學] output; outcome; outlet; out fan; fanout; 輸出變壓器 output ...
  1. ( 3 ). the flattening arithmetic of an edfa was presented based on the inter - correlative function between the gain spectrum function of the edfa and that of the reserve transmission spectrum of the lpfg. for optimal matching between the two spectra, the flattening arithmetic calculates the variation of the resonant amplitude and wavelength of the lpfg

    Iii .提出了一種動態增益均衡的平坦演算法，這種演算法的本質就是利用摻鉺光纖放大器增益譜函數和新型長周期光纖光柵的透射譜反轉譜函數的相關性，給出新型長周期光纖光柵諧振峰幅度和位置的調節量，使改變后的新型長周期光纖光柵的反轉譜線能和edfa的增益輸出譜線進行最佳匹配。
  2. The thesis has done the widespread investigation and study to the domestic and foreign ’ s technologies of analogy low voltage and low power, and analyzes the principles of work, merts and shortcomings of these technologies, based on the absorption of these technologies, it designs a 1. 5v low power rail - to - rail cmos operational amplifier. when designing input stage, in order to enable the input common mode voltage range to achieve rail - to - rail, it does not use the traditional differential input pair, but use the nmos tube and the pmos tube parallel supplementary differential input pair to the structure, and uses the proportional current mirror technology to realize the constant transconductance of input stage. in the middle gain stage design, the current mirror load does not use the traditional standard cascode structure, but uses the low voltage, wide - swing casecode structure which is suitable to work in low voltage. when designing output stage, in order to enhance the efficiency, it uses the push - pull common source stage amplifier as the output stage, the output voltage swing basically reached rail - to - rail. the thesis changes the design of the traditional normal source based on the operational amplifier, uses the differential amplifier with current mirror load to design a normal current source. the normal current source provides the stable bias current and the bias voltage to the operational amplifier, so the stability of operational amplifier is guaranteed. the thesis uses the miller compensate technology with a adjusting zero resistance to compensate the operational amplifier

    本論文對國內外的模擬低電壓低功耗技術做了廣泛的調查研究，分析了這些技術的工作原理和優缺點，在吸收這些技術成果基礎上設計了一個1 . 5v低功耗軌至軌cmos運算放大器。在設計輸入級時，為了使輸入共模電壓范圍達到軌至軌，不是採用傳統的差動輸入結構，而是採用了nmos管和pmos管並聯的互補差動輸入對結構，並採用成比例的電流鏡技術實現了輸入級跨導的恆定;在中間增益級設計中，電流鏡負載並不是採用傳統的標準共源共柵結構，而是採用了適合在低壓工作的低壓寬擺幅共源共柵結構;在輸出級設計時，為了提高效率，採用了推挽共源級放大器作為輸出級，輸出電壓擺幅基本上達到了軌至軌;本論文改變傳統基準源基於運放的設計，採用了帶電流鏡負載的差分放大器設計了一個基準電流源，給運放提供穩定的偏置電流和偏置電壓，保證了運放的穩定性;並採用了帶調零電阻的密勒補償技術對運放進行頻率補償。
  3. The common detector output pulse signal scope is several dozens millivolts, but the multichannel pulse analyzer input pulse amplitude request is 1 - 15v, therefore the pulse linear amplifier must have the certain voltage gain, about ten times to several times

    一般探測器輸出脈沖信號幅度為幾十毫伏，而多道脈沖幅度分析器輸入脈沖幅度要求為1 - 10v ，所以脈沖線性放大器必須具有一定的電壓放大增益，為數倍到上百倍。
分享友人
分享到 Line

分享到臉書