輸出能量 的英文怎麼說

中文拼音 [shūchūnéngliáng]
輸出能量 英文
energy output
  • 輸 : Ⅰ動詞1 （運輸; 運送） transport; convey 2 [書面語] （捐獻） contribute money; donate 3 （失敗） l...
  • 能 : 能名詞（姓氏） a surname
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 輸出 : 1 （從內部送到外部） export 2 [電學] output; outcome; outlet; out fan; fanout; 輸出變壓器 output ...
  • 能量 : 1 [物理學] energy; amount of energy 2 （能力） capabilities; capacity; 能量不滅 conservation of e...
  1. It is well known that nonlinear self - focusing effect is one of the important factors to limit icf laser energy and worsen beam quality

    實踐表明，非線性自聚焦效應是限制icf驅動器激光輸出能量及破壞光束質量的主要因素之一。
  2. Input - output energy decoupling of linear singular systems

    輸出能量解耦
  3. Thus, 21mj of single pulse energy has been obtained. in the case of 10 % reflectivity, less than 3. 7ns with 8. 6 : 1 pulse - compression ratio has been observed

    應用200 m光纖獲得了21mj的四通放大輸出能量並在能量反射率10的情況下獲得了高達8 . 6倍的脈沖壓縮比。
  4. The object of this method is the reduction of energetic relation between inputs and outputs, i. e., the energy of every input controls mainly the energy of a corresponding output and influences the energy of the other outputs as weakly as possible

    所謂能量解耦，就是從被控系統的輸入輸出能量關繫上實現解耦，使得任何一個輸入的能量主要控制對應的一個輸出的能量，而對其它輸出能量的影響盡可能小。
  5. The variable polarity power supply circuit uses two stages full - bridge inverter, the former inverter is regarded as a constant - current source with fast dynamic response, and supplys energy for the second one, and the latter one is to produce variable polarity current excellently, and low - frequency pulse current by variable polarity power supply is used to reduce input energy and control the shape of weld bead while welding. a series of high - frequency pulse current is superposed on direct - current - electrode - negative ( dcen ) current through the high - frequency pulse power supply, which is used to compress the arc and improve process of crystallization

    其中變極性電源採用二次全橋逆變結構，一次逆變提供快速的響應速率並給二次逆變提供能量，二次逆變提供良好的變極性性能，使輸出能量最優化，並用其低頻電流特性減小電弧線能量，控制焊縫成形;高頻脈沖電源提供的高頻電流疊加在反極性電流dcen上，利用電流的高頻特性壓縮電弧，改善焊縫金屬結晶過程。
  6. At last, an experiential power supply was made, and a series of experiments is done. a lot of high - frequency pulse current was superposed on dcen current, modulated the welding current waveform we required and optimized the energy distribution, which satisfied the basic requirement of cathode cleaning

    最後製作了一臺實驗電源，並進行了一系列的電弧實驗，通過在變極性電源電流dcen基礎上疊加一系列脈沖電流，調制出所需電流波形，實現輸出能量的最優分配，在滿足陰極清理的前提下，最大限度地提高焊接效率。
  7. The conceptual design of a lighting system using sea waves as the energy source demonstrates that the proposed approach can not only maintain tile consistency of input and output energy objects in detailed features, but also achieve efficient synthesis of solutions with aid of tile shortest path knowledge and other heuristic knowledge

    一種海浪照明系統的概念設計實例證明：該模型不但能在復雜能量轉換系統的概念設計過程中正確考慮輸入輸出能量對象在細節特徵上的匹配性，增強組合解的可行性，而且能藉助最短路徑知識和其他啟發式知識較迅速地從知識庫中找到合適的組合原理解。
  8. Furthermore, the fiber phase - conjugator has been used in ld - pumped solid - state laser system with four - pass configuration to suppress the self - oscillating ( so ) phenomena caused by amplified spontaneous emitting ( ase ) in laser amplifier. when using 200 m fiber, the energy of so has been successfully decreased from 12mj to below the precision of energy - detector

    將光纖相位共軛鏡應用於四通放大結構中，有效抑制了放大級中的放大自發輻射引起的自激振蕩現象，使得自激振蕩輸出能量從12mj降低到能量計最小精度以下。
  9. With the development of infrared tunable opo, its application is more and more wide. lt is possible for us to estimate the quality of resonant mirrors in laser with high energy and to improve the output energy of laser, by measuring the reflectivity of resonant mirrors of coil and df laser by cavity - ring - down which use output wave of opo as the laser source, instead of coil and df laser with high price and huge space

    用opo紅外輸出激光作為光腔衰蕩的光源代替價格昂貴、體積龐大的氧碘和氟化氖激光器，對其諧振腔鏡的高反射率進行測量，以達到對高功率激光器腔鏡高反膜質量的評價，為改進膜系設計、鍍膜工藝優化和提高激光器的輸出能量提供理論依據。
  10. The conditions for long distance propagation and self - guiding are given. 3. an optical amplification system for 10 ps krf laser with polarization multiplexing is developed and the energy of 140 ml is extracted

    發展了一種適用於超短脈沖激光的光學偏振放大技術，並應用於10pskrf激光放大系統中，可在有限的激光輸出口徑內有效地提取激光的輸出能量。
  11. Mechanical sensitivity and explosive performance of nitroguanidine - based composite explosives

    粒度及其級配對塑料粘結炸藥沖擊波感度和爆炸輸出能量的影響
  12. This paper explored the micro pressure sensor that is used for the measurement of distributed pressure at the surface of smart - skin. firstly, established the surface pressure model according to the aerodynamic properties, defined the optical measurement system that based on intensity modulation principle, discussed the components of this system and theoretical analyzed its measurement theory in detail

    首先，根據空氣流動的基本規律給出機翼表面壓力分布圖，通過對光學式微型壓力傳感器的理論分析，採用強度調製法測量飛機機翼表面的壓力並建立基於此方法的光學測量系統模型，得到了壓力與敏感膜片變形以及光電轉換輸出能量之間的關系。
  13. Based on the theoretical analysis, we experimentalize to the output characteristic of laser and probe into the efficiency and output power of the er - doped yag solid laser, moreover, we research and development a compact, no water cooled and low frequency central wavelength 2. 94 u m laser sample

    在理論分析的基礎上，對該波長激光的輸出特性進行了實驗研究，探討了摻鉺yag固體激光器在效率和輸出能量等方面的問題。並研製出一套小型化，無水冷，低重頻，輸出中心波長2 . 94 m的激光器。
  14. We discuss how to select crystal, the type of phase matching and tuning precision, which offers some theoretical references to the design for tunable opo. 2. the device of surelite opo and mirage3000b are analyzed, and some experimental results of the output wave and energy are obtained and discussed

    對兩種參量振蕩器sureliteopo和mirage3000b的結構做了剖析，詳細地研究了其中的關鍵技術，對其輸出波形、脈寬以及輸出能量等特性進行了實驗研究，並做了理論分析。
  15. Laser facilities have been built with the output energy of about a hundred joules at the beginning up to a few mega - joules now and beamline numbers have increased to hundreds. for such facilities, each beamline contains numerous optical elements with enlarged apertures of up to a few tens centimeters and the optical paths extend as long as hundreds of meters

    激光裝置的輸出能量從初期的百焦耳級發展到兆焦耳級，其結構規模從小型單路輸出發展到上百路輸出，光學元件數量大幅度增加，光學元件口徑增大到數十厘米，光傳輸距離也從數十米增加到百米。
  16. This paper tries to seek an approximate decoupling method in the time - domain framework. it is called as an energy decoupling method

    本文試圖在時域范圍內尋找一種近似解耦方法，稱之為輸入-輸出能量解耦方法。
  17. The main works of the dissertation can be summarized as follows : 1. by exploring the model of ds - cdma systems, the performances of the decorrelating multi - user detector and minimum mean square error ( mmse ) multi - user detector are studied. further, the performances of blind adaptive mud and adaptive mmse mud ( lms style ) with fixed step size and varied step size respectively are studied based on mmse linear detect algorithms

    本文主要研究次最優的線性多用戶檢測技術，工作具體如下：從ds - cdma系統模型出發，研究了解相關多用戶檢測器和mmse多用戶檢測器的性能，並以mmse線性檢測技術為基礎，研究了變步長和固定步長的lms - mmse自適應多用戶檢測器和基於最小輸出能量準則的盲自適應多用戶檢測器。
  18. High power magneto guarantees the power supply to the vehicle

    採用大功率磁電機，輸出能量大，整車供電充足。
  19. 2. the input - output energy decoupling of linear discrete systems and uncertain linear discrete systems is considered

    研究了線性離散系統和不確定線性離散系統的輸入輸出能量解耦問題。
  20. In the situation that the system losses were fully considered, the energy and space distribution of the system output was provided

    在充分考慮系統損耗的情況下，模擬得到了系統輸出能量和光斑的空間分佈。
分享友人
分享到 Line

分享到臉書