輸出電壓擺幅 的英文怎麼說

中文拼音 [shūchūdiànyābǎifú]
輸出電壓擺幅 英文
output voltage swing
  • 輸 : Ⅰ動詞1 （運輸; 運送） transport; convey 2 [書面語] （捐獻） contribute money; donate 3 （失敗） l...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 壓 : 壓構詞成分。
  • 擺 : Ⅰ動詞1 （安放; 排列） put; arrange; set in order 2 （顯示; 炫耀） display; show off; put on; assu...
  • 幅 : Ⅰ名詞1. （布帛、呢絨等的寬度） width of cloth 2. （泛指寬度） width; size 3. （姓氏） a surname Ⅱ量詞（用於布帛、呢絨、圖畫等）
  • 輸出 : 1 （從內部送到外部） export 2 [電學] output; outcome; outlet; out fan; fanout; 輸出變壓器 output ...
  • 電壓 : voltage; electric tension; electric voltage
  1. Output voltage swing

    輸出電壓擺幅
  2. For the demand of output swing, the bias is provided by high - swing cascode current mirrors

    為了獲得高輸出擺幅，設計低壓共源共柵電流鏡為運放提供偏置。
  3. The thesis has done the widespread investigation and study to the domestic and foreign ’ s technologies of analogy low voltage and low power, and analyzes the principles of work, merts and shortcomings of these technologies, based on the absorption of these technologies, it designs a 1. 5v low power rail - to - rail cmos operational amplifier. when designing input stage, in order to enable the input common mode voltage range to achieve rail - to - rail, it does not use the traditional differential input pair, but use the nmos tube and the pmos tube parallel supplementary differential input pair to the structure, and uses the proportional current mirror technology to realize the constant transconductance of input stage. in the middle gain stage design, the current mirror load does not use the traditional standard cascode structure, but uses the low voltage, wide - swing casecode structure which is suitable to work in low voltage. when designing output stage, in order to enhance the efficiency, it uses the push - pull common source stage amplifier as the output stage, the output voltage swing basically reached rail - to - rail. the thesis changes the design of the traditional normal source based on the operational amplifier, uses the differential amplifier with current mirror load to design a normal current source. the normal current source provides the stable bias current and the bias voltage to the operational amplifier, so the stability of operational amplifier is guaranteed. the thesis uses the miller compensate technology with a adjusting zero resistance to compensate the operational amplifier

    本論文對國內外的模擬低電壓低功耗技術做了廣泛的調查研究，分析了這些技術的工作原理和優缺點，在吸收這些技術成果基礎上設計了一個1 . 5v低功耗軌至軌cmos運算放大器。在設計輸入級時，為了使輸入共模電壓范圍達到軌至軌，不是採用傳統的差動輸入結構，而是採用了nmos管和pmos管並聯的互補差動輸入對結構，並採用成比例的電流鏡技術實現了輸入級跨導的恆定;在中間增益級設計中，電流鏡負載並不是採用傳統的標準共源共柵結構，而是採用了適合在低壓工作的低壓寬擺幅共源共柵結構;在輸出級設計時，為了提高效率，採用了推挽共源級放大器作為輸出級，輸出電壓擺幅基本上達到了軌至軌;本論文改變傳統基準源基於運放的設計，採用了帶電流鏡負載的差分放大器設計了一個基準電流源，給運放提供穩定的偏置電流和偏置電壓，保證了運放的穩定性;並採用了帶調零電阻的密勒補償技術對運放進行頻率補償。
  4. It has a wide input common - mode voltage range and output voltage swing, making them easy to use on single supplies as low as 2. 5 v

    該產品具有很寬的共模輸入電壓和輸出電壓擺幅，使其可使用低至2 . 5v的單電源供電。
  5. The main work has been finished in paper is below : 1. all kinds of structure of low - voltage op - amp were compared and analyzed, such as the three - times current, redundant difference pair, dc level shifter input stage, large current output, very low - voltage output stage. 2

    對國內外的相關研究動態做了廣泛的調研，仔細比較了各種實現電路的優缺點，如輸入級的三倍電流鏡法、冗餘差分對法、電平移位法等，輸出級的大擺幅輸出級、超低電壓輸出級等。
  6. In order to expand the signal the dynamirange, the low voltage operational amplifier usually needs the input signal scope and the output signal scope to be able to achieve the entire amplitude, in view of this question, this article discusses as follows : one is designed with ab rail - to - rail output stage

    為了擴大信號的動態范圍，低電壓運放通常需要輸入輸出的信號范圍能達到全擺幅。針對這個問題，本文做了如下工作: 1 ）設計了一個是包含ab類軌對軌輸出級的低功耗運算放大器。
分享友人
分享到 Line

分享到臉書