輻射加溫器 的英文怎麼說

中文拼音 [fúshèjiāwēnqì]
輻射加溫器 英文
radiant warmer
  • 輻 : 名詞（車輪中車轂和輪圈的連接物） spoke
  • 射 : Ⅰ動詞1 （用推力或彈力送出） shoot; fire 2 （液體受到壓力迅速擠出） discharge in a jet 3 （放出） ...
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 輻射 : radiation; exposure; radio; beaming
  1. Abstract : radiate thermometer uses a high definitive operation circuit in the modulation and linerization of weak optical signals. the theory of colorimetry was used in measuring the temperature. analogic channel and digital interfaces were added in order to expand the instrument. a kind of double channel ' s photocolorimeter including its hardware and software is introduced

    文摘:輻射測溫計採用高精度運算電路，對光弱信號進行調制和線性化處理，運用比色法原理對溫度進行檢測.為了便於儀器擴展，增加了模擬量輸出和數字介面，並對光纖式雙通道比色高溫儀的硬體與軟體的關鍵部分作了簡要介紹
  2. Cadmium selenide ( cdse ) single crystal is regarded as one of the most promising materials for room temperature nuclear radiation detectors, but cdse detectors have not been studied in detail because of the lack of high quality cdse single crystals and suitable technology for this semiconductor and the devices

    Cdse單晶體是最有前途的室溫核輻射探測器材料之一，但由於沒有制備出高質量的cdse單晶體，加上沒有成熟的半導體材料加工技術與器件製作工藝，人們對cdse探測器沒有進行深入的研究。
  3. As the microbolometer which is voltage biased express some characters different from other infrared detectors under the effect of electric heat and infrared radiation together, the computing method of parameters, such as responsivity, noise, noise equivalent temperature different ( netd ), noise equivalent power ( nep ), optical gain, detectivity and so on is given in this paper. some of these parameters are particular compared with other detectors, and some have difference between microbolometer and other detectors

    由於微測輻射熱計在施加偏置電壓的情況下，電熱效應與紅外輻射的共同作用使它表現出與其他紅外探測器完全不同的一些特徵，文中給出了響應率、噪聲、噪聲等效功率、噪聲等效溫差、光學增益、探測率等參數的計算方法，這些參數中的部分是微測輻射熱計獨有的，或者與其他的紅外探測器的同一參數有所區別。
  4. The resistivity of the films drops compared with the as - grown films, but the temperature of maximum magnetoresistance reaches 287k, very close to the room temperature. therefore it is not only an important improvement to fabricate the cmr bolometer which can work near room temperature, but also a prospective research for other applications such as magnetic - sensors, spintronics devices and infrared detectors

    同時，退火后薄膜的電阻率明顯下降，外加5t磁場時，最大磁電阻率溫度點上升到287k ，接近於室溫，這不僅為製作室溫超巨磁電阻測輻射熱儀打下了堅實的基礎，也為其它許多器件的應用提供了可能。
  5. The new device consists of paint - drying box, heat carrier boiler, heating pipe, expansion tank, gas separator and oil tank, etc. the data of two applied examples shows that heat carrier paint drying method is able to make painting - drying cost drop by 88 %, compared with the conventional one, that it has some advantages such as uniform temperature field, good appearance and lower costs, compared with conventional hot air convection mode

    該裝置主要由熱載體烤漆爐、輻射加熱管，熱載體爐、膨脹器、油氣分離器和儲油槽等組成。應用實例的測試數據表明，與傳統的遠紅外電加熱鋼瓶烤漆方式相比較，鋼瓶熱載體烤漆節能和降低能耗費用十分顯著，能耗費用降幅達到88 。與熱風爐對流烤漆方式相比較，熱載體烤漆方法不僅節能，而且烤漆爐溫度場均勻穩定，同時烤漆的外觀質量也得到了明顯提高。
  6. Production test of the production line is showed that anneal furnace combustion system with regenerative radiant - tube combustor compare with conventional radiant tube burner not only have superiorities on saving energy and environmental protection but also have advantages on temperature distribution and temperature control properties

    生產線試生產的情況表明，退火爐燃燒系統使用蓄熱式輻射管燃燒器比使用常規輻射管燃燒器不僅在節能、環保方面具有優勢，而且在加熱均勻性和爐溫控制方面也有一定優越性。
  7. Abstract : the in servie tubular heaters built early in refineries and chemical plans have low thermal load and low heat efficiency, therefore measures for technical reform are offered, including ( 1 ) enlarging the surface area of convection tubes to increase the thermal load of rhe convection section ; ( 2 ) increasign the heat interchanging area of radiant tubes ; ( 3 ) changing the height of the chimney ; ( 4 ) using new burner with forced air supply to increase calorific capacityu ; ( 5 ) adding air preheater between the convection section and chimney to enhence the temperature of the air entering the furnace ; ( 6 ) adopting high temperature radiant coating to improve the effect of radiant heat interchanging

    文摘:針對早期建造的煉油廠和化工廠在役管式加熱爐熱負荷和熱效率低的狀況，提出了若干技術改造措施包括，增大對流管表面積以增大對流段的熱負荷；增加輻射管的換熱面積；修正煙囪高度；換用新型燃燒器，變自然通風為強制供風，以增大燃燒器的發熱量，減小過剩空氣系數，節省燃料2 % 3 % ；在對流段和煙囪之間增設空氣預熱器以提高空氣入爐溫度；採用高溫輻射塗料增強輻射換熱效果，從而增加熱源對爐壁的輻射傳熱量和爐管的傳熱量等。
  8. The in servie tubular heaters built early in refineries and chemical plans have low thermal load and low heat efficiency, therefore measures for technical reform are offered, including ( 1 ) enlarging the surface area of convection tubes to increase the thermal load of rhe convection section ; ( 2 ) increasign the heat interchanging area of radiant tubes ; ( 3 ) changing the height of the chimney ; ( 4 ) using new burner with forced air supply to increase calorific capacityu ; ( 5 ) adding air preheater between the convection section and chimney to enhence the temperature of the air entering the furnace ; ( 6 ) adopting high temperature radiant coating to improve the effect of radiant heat interchanging

    針對早期建造的煉油廠和化工廠在役管式加熱爐熱負荷和熱效率低的狀況，提出了若干技術改造措施包括，增大對流管表面積以增大對流段的熱負荷；增加輻射管的換熱面積；修正煙囪高度；換用新型燃燒器，變自然通風為強制供風，以增大燃燒器的發熱量，減小過剩空氣系數，節省燃料2 % 3 % ；在對流段和煙囪之間增設空氣預熱器以提高空氣入爐溫度；採用高溫輻射塗料增強輻射換熱效果，從而增加熱源對爐壁的輻射傳熱量和爐管的傳熱量等。
  9. Measuring method for the surface temperature distribution of infrared heater

    紅外輻射加熱器表面溫度分佈測量方法
  10. Measuring method for temperature rise time and fall time of infrared heater

    紅外輻射加熱器升溫時間和降溫時間測量方法
  11. Compared the heating load ( and energy consumption ) of a same room with floor heating or radiator heating under same operative temperature. revealed the energy consumption of floor heating room could reduce 5 % ~ 10 % to radiator heating, and the heating load could reduce 10 % ~ 15 %. the main season of energy efficiency is due to no apparent high temperature zone in floor heating room, which avoid additional heat loss in outside envelopes, rather than the lower of indoor air temperature

    利用對連續供暖房間溫度場的研究結果，對分別採用上述兩種供暖方式的典型房間的熱負荷和能耗進行了全面分析后發現：低溫地板輻射供暖房間熱負荷比散熱器供暖房間可降低10 15 ，能耗可降低5 10 ；低溫地板輻射供暖房間節能的主要原因並不是由於房間空氣溫度可以降低，而是消除了室內空氣局部高溫區，避免了由此產生的在外圍護上的附加傳熱量。
  12. Measuring method for the radio between radiant surface and rear surface of infrared heater

    紅外輻射加熱器輻射面和背面溫度比測量方法
  13. Basic function : heat source is anti - blast infrared - tube made of microcrystal quartz ;, continuosly variable mattress tilt, radiant head can two - directory rotate on horizon, x - ray cassette shelf under infant bed ; high - bright erdiate lamp detect lightness ; advanced microprocessor control temperature system, auto - heated mode, separately display set temperature and real temperature ; 4sound - light alarm capacity : set - off, fan, sensor, over temp.

    基本配置：採用了防爆型微晶石英紅外管作輻射熱源，嬰兒床斜傾角度有級可調，輻射頭可在水平位置上雙向隨意轉動，嬰兒床下內設有x光暗盒架，檢查照明採用高照度射燈，溫度控制系統採用先進的計算機控制，自動加熱方式，設定溫度和實際溫度分屏顯示，有四種聲光報警功能（溫度上下偏差、傳感器、斷電、超溫） 。
  14. Basic function : heat source is anti - blast infrared - tube made of microcrystal quartz ; continuously variable mattress tilt, radiant head can two - directory rotate on horizon, x - ray cassette shelf under infant bed ; high - bright eradiate lamp detect lightness ; advanced microprocessor control temperature system, autoheated mode, separately display set temperature and real temperature ; 4 sound - light alarm capacity ; set - off, sensor, over temp

    基本配置：採用了防爆型微晶石英紅外管作輻射熱源，嬰兒床傾斜度有級可調，輻射頭可在水平位置上雙向隨意轉動，嬰兒床下內設有x光暗盒架，檢查照明採用高照度射燈，溫度控制系統採用先進的計算機控制，自動加熱方式，設定溫度和實際溫度分屏顯示，有四種聲光報警功能（溫度上下偏差、傳感器、斷電、超溫） 。
分享友人
分享到 Line

分享到臉書