輻射式供熱 的英文怎麼說

中文拼音 [fúshèshìgōngrè]
輻射式供熱 英文
radiant heating
  • 輻 : 名詞（車輪中車轂和輪圈的連接物） spoke
  • 射 : Ⅰ動詞1 （用推力或彈力送出） shoot; fire 2 （液體受到壓力迅速擠出） discharge in a jet 3 （放出） ...
  • 式 : 名詞1 （樣式） type; style 2 （格式） pattern; form 3 （儀式; 典禮） ceremony; ritual 4 （自然科...
  • 供 : 供Ⅰ名詞1 （供品） offerings 2 （口供; 供詞） confession; deposition Ⅱ動詞1 （供奉） lay （offerin...
  • 輻射 : radiation; exposure; radio; beaming
  1. It does not need much area, not any pollution, not consuming much electricity power, not need much cost. gshp combined floor radiation air - conditioning system possess high seasonal average cop value and great capacity of edaphic depositing heat energy, can ease up supplied water temperature fluctuating with the change of the outdoor air temperature

    地源熱泵技術聯合地板輻射對房間進行冷暖聯供的形式，具有地源熱泵季節性平均性能系數高、土壤蓄熱能力強、能緩解空氣源熱泵存在的供冷供熱能力隨環境溫度波動大的矛盾等優點。
  2. The variations of sea ice in the arctic ocean are simulated by using a improved high resolution hibler dynamic - thermodynamic sea ice model during 1979 - 1998. the model is driven by surface atmospheric and oceanic forcing consists of geostrophic winds, surface air temperature, specific humidity, and longwave and shortwave radiative fluxes provided by international arctic buoy program ( iabp ). the simulated results show that arctic sea ice have noticeable seasonal and annual variability

    利用一個hibler海冰熱動力模式，在改進了其熱力部分和改變模擬范圍以及提高解析度的基礎上，以北極國際浮標計劃（ iabp ）提供的1979 - 1998年間逐日變化的日平均海平面氣溫場，濕度場，長短波輻射場，風場，洋流場，海洋熱流量場為強迫場，模擬了上述20年間北極海冰的時空演變。
  3. Energy consumption of heating rooms will increase when air exchange rate become large. because the mechanisms of heating methods used currently, such as radiator heating, ceiling heating and warm - air heating, are different from each - other, the indoor thermal environment is not the same when each one of them employed for room heating. for enhancing energy efficiency of heating rooms, indoor thermal comfort and energy saving effects should be investigated when natural ventilation is used to make a good air quality indoors

    房間換氣次數的增加勢必導致供暖房間能耗加大，頂棚輻射、散熱器和熱風等三種採暖方式由於供暖機理不同，形成的室內熱環境特徵不同，通風換氣時產生的通風熱損失也有所區別，為了提高大換氣量房間的供暖節能效果，必須對不同供暖方式在大換氣量情況下的熱舒適性與節能效應進行研究。
  4. At last, there is a practical design of gshp - radiant system in a villa in chongqing. the compare of the gas - heater radiant floor system and the gshp radiant floor system indicates that the heating performance coefficient of the gshp is higher than the gas - heater to a large extent. in addition, this united system can use the closed circling water in the underground heat exchanger to remove the surplus heat load in transitional season

    通過燃氣熱水器制熱的輻射地板供暖與地源熱泵制熱的輻射地板供暖性能實驗的對比，可以看出地源熱泵的供熱性能系數高於燃氣熱水器，同時在長江中下游地區還可在過渡季節利用閉式循環水吸收土壤冷量對房間進行供冷，提高系統運行的經濟性。
  5. Pmv and the indoor temperature field can be used to evaluate the effect of heating in a large amount air current condition. the result of analysis indicate that the radiation heating and radiator heating have some advantages in such rooms, and hot - air heating is an unsuitable way for room heating

    分析結果后認為， pmv和室內溫度分佈是評價大換氣量房間不同供暖方式室內熱環境的重要參數，在這類房間中，輻射供暖和散熱器供暖將各有優點，而熱風供暖則是一種不宜採用的供暖方式。
  6. Given the thermal physical parameters of the envelops and the weather data, the above two parameters are determined by the following system design parameters : radiant panel dimension, radiant panel location and radiant panel layout style ( center or peripheral ). based on the thermal net model, digital analysis of the energy consumption and thermal environment are carried out to the several representative spaces under different design parameters, through which the relations of the heating load to the design parameters are obtained and can be a reference in the practical system design

    對于給定圍護結構熱物性參數和室外氣候參數的條件下，室內平均輻射溫度和室內空氣溫度的大小取決于系統的設計參數：輻射板的布置方式（周邊布置和中心布置） 、輻射板尺寸和輻射板鋪設位置。基於熱網模型，利用matlab軟體編程對採暖空間在不同設計參數下室內的熱環境和能耗進行數值分析，得出了低溫熱水地板輻射採暖系統的性能和能耗指標隨這些參數變化的規律，從而為低溫熱水地板輻射採暖系統的優化設計提供了參考。
  7. Abstract : the in servie tubular heaters built early in refineries and chemical plans have low thermal load and low heat efficiency, therefore measures for technical reform are offered, including ( 1 ) enlarging the surface area of convection tubes to increase the thermal load of rhe convection section ; ( 2 ) increasign the heat interchanging area of radiant tubes ; ( 3 ) changing the height of the chimney ; ( 4 ) using new burner with forced air supply to increase calorific capacityu ; ( 5 ) adding air preheater between the convection section and chimney to enhence the temperature of the air entering the furnace ; ( 6 ) adopting high temperature radiant coating to improve the effect of radiant heat interchanging

    文摘:針對早期建造的煉油廠和化工廠在役管式加熱爐熱負荷和熱效率低的狀況，提出了若干技術改造措施包括，增大對流管表面積以增大對流段的熱負荷；增加輻射管的換熱面積；修正煙囪高度；換用新型燃燒器，變自然通風為強制供風，以增大燃燒器的發熱量，減小過剩空氣系數，節省燃料2 % 3 % ；在對流段和煙囪之間增設空氣預熱器以提高空氣入爐溫度；採用高溫輻射塗料增強輻射換熱效果，從而增加熱源對爐壁的輻射傳熱量和爐管的傳熱量等。
  8. The in servie tubular heaters built early in refineries and chemical plans have low thermal load and low heat efficiency, therefore measures for technical reform are offered, including ( 1 ) enlarging the surface area of convection tubes to increase the thermal load of rhe convection section ; ( 2 ) increasign the heat interchanging area of radiant tubes ; ( 3 ) changing the height of the chimney ; ( 4 ) using new burner with forced air supply to increase calorific capacityu ; ( 5 ) adding air preheater between the convection section and chimney to enhence the temperature of the air entering the furnace ; ( 6 ) adopting high temperature radiant coating to improve the effect of radiant heat interchanging

    針對早期建造的煉油廠和化工廠在役管式加熱爐熱負荷和熱效率低的狀況，提出了若干技術改造措施包括，增大對流管表面積以增大對流段的熱負荷；增加輻射管的換熱面積；修正煙囪高度；換用新型燃燒器，變自然通風為強制供風，以增大燃燒器的發熱量，減小過剩空氣系數，節省燃料2 % 3 % ；在對流段和煙囪之間增設空氣預熱器以提高空氣入爐溫度；採用高溫輻射塗料增強輻射換熱效果，從而增加熱源對爐壁的輻射傳熱量和爐管的傳熱量等。
  9. The experimental results indicate that when the air flow rate is determined, the key problem for energy saving is how to keep the indoor thermal comfort at a suitable level and reduce the difference between the internal and external temperature of the room. a formula is gained for calculating the critical values of air exchange rate. when ventilating rate is greater than the value, radiating heating is the better way for energy saving, or else, convection method in heating is more suitable

    實測還指出，當通風量一定時，如何保證人體熱舒適度不變而減少室內外氣溫差將成為大通風量房間節約採暖能耗的關鍵，本文結合圍護結構傳熱機理，在對三種方式的能耗狀況進行理論分析的基礎上，提出了換氣次數的節能臨界值，若換氣次數高於此值，則輻射供暖是較好的選擇，否則，散熱器供暖是較好的方法。
  10. According to thermal comfort theory, adopting radiation directly acting to human ' s body, people can also feel comfortable even if indoor air temperature is relatively higher in summer and relatively lower in winter than that of convection heat - supply which means that it is evident energy - saving as to the traditional convection heat transfer

    根據熱舒適指標理論，採用輻射方式直接作用於人體，在室內空氣溫度較高（夏季供冷工況） 、較低（冬季供熱工況）的條件下，仍可以使人達到熱舒適，與傳統的對流傳熱方式相比具有明顯的節能性。
  11. The advantage of this air conditioning, that is energy conservation, is for energy to overheat or overcool air in traditional air conditioning is saved with radiation directly acting to human ' s body. so, the radiant heat exchange between human body and enclosure was made as main point of this paper that the radiant heat exchange model was established and the radiant heat exchanges of different human body in different sites were calculated in detail

    本空調方式的先進性，即節能性，是由於採用了輻射方式直接對人體進行供冷、供熱，從而省去了傳統的過度冷卻或加熱空氣所消耗的那部分能量而表現出來的；因此，本文把人與室內環境之間的輻射換熱作為一個重點，建立了輻射板等室內壁面與人體間的輻射換熱模型，並詳細計算在不同位置各人體部分與室內環境之間的輻射換熱。
  12. Compared the heating load ( and energy consumption ) of a same room with floor heating or radiator heating under same operative temperature. revealed the energy consumption of floor heating room could reduce 5 % ~ 10 % to radiator heating, and the heating load could reduce 10 % ~ 15 %. the main season of energy efficiency is due to no apparent high temperature zone in floor heating room, which avoid additional heat loss in outside envelopes, rather than the lower of indoor air temperature

    利用對連續供暖房間溫度場的研究結果，對分別採用上述兩種供暖方式的典型房間的熱負荷和能耗進行了全面分析后發現：低溫地板輻射供暖房間熱負荷比散熱器供暖房間可降低10 15 ，能耗可降低5 10 ；低溫地板輻射供暖房間節能的主要原因並不是由於房間空氣溫度可以降低，而是消除了室內空氣局部高溫區，避免了由此產生的在外圍護上的附加傳熱量。
  13. Low temperature hot water floor radiant heating is a kind of energy - saving heating method which can adjust the temperature of rooms

    摘要低溫熱水地板輻射供暖是一種節能並可有效調節房間小氣候的供暖方式，應用廣泛，但在工程實踐中存在較多問題。
  14. As new terminal equipment in air - conditioning, the mechanism of radiant floor is heating or cooling the room mainly through radiation and convection

    輻射地板作為一種新型空調末端設備，主要利用輻射和對流形式對房間供冷或供暖；與常規空調送風相比，具有熱舒適性好、節能、美觀、對環境影響小等優點。
分享友人
分享到 Line

分享到臉書