輻射測溫法 的英文怎麼說

中文拼音 [fúshècèwēnfǎ]
輻射測溫法 英文
radiation thermometry
  • 輻 : 名詞（車輪中車轂和輪圈的連接物） spoke
  • 射 : Ⅰ動詞1 （用推力或彈力送出） shoot; fire 2 （液體受到壓力迅速擠出） discharge in a jet 3 （放出） ...
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 法 : Ⅰ名詞1 （由國家制定或認可的行為規則的總稱） law 2 （方法; 方式） way; method; mode; means 3 （標...
  • 輻射 : radiation; exposure; radio; beaming
  • 溫法 : therapy by warming
  1. Abstract : radiate thermometer uses a high definitive operation circuit in the modulation and linerization of weak optical signals. the theory of colorimetry was used in measuring the temperature. analogic channel and digital interfaces were added in order to expand the instrument. a kind of double channel ' s photocolorimeter including its hardware and software is introduced

    文摘:輻射測溫計採用高精度運算電路，對光弱信號進行調制和線性化處理，運用比色法原理對溫度進行檢測.為了便於儀器擴展，增加了模擬量輸出和數字介面，並對光纖式雙通道比色高溫儀的硬體與軟體的關鍵部分作了簡要介紹
  2. In this method of measuring temperature, when the measuring results of time - resolved spectrum have been completed, computing the fit spectrum of corresponding planck bold - radiation with least duple multiply theory, the temperature is measured

    溫度擬合方法的主要思想：獲得光譜的時間分辨測量結果后，用最小二乘法原理計算熱輻射譜（主要在可見光區）擬合得到相應普朗克黑體輻射加線，並解析其溫度。
  3. Standard test methods for radiation thermometers single waveband type

    輻射式溫度計的測試方法
  4. Total radiation thermometry

    全輻射測溫法
  5. As the microbolometer which is voltage biased express some characters different from other infrared detectors under the effect of electric heat and infrared radiation together, the computing method of parameters, such as responsivity, noise, noise equivalent temperature different ( netd ), noise equivalent power ( nep ), optical gain, detectivity and so on is given in this paper. some of these parameters are particular compared with other detectors, and some have difference between microbolometer and other detectors

    由於微測輻射熱計在施加偏置電壓的情況下，電熱效應與紅外輻射的共同作用使它表現出與其他紅外探測器完全不同的一些特徵，文中給出了響應率、噪聲、噪聲等效功率、噪聲等效溫差、光學增益、探測率等參數的計算方法，這些參數中的部分是微測輻射熱計獨有的，或者與其他的紅外探測器的同一參數有所區別。
  6. The main research contents of the physical design include : presenting the domestic and international status of space weather and expanding on the need and the importance about the space weather forecast ; sorting the disastrous space weather and discussing their effects and adapted prediction methods ; analyzing the solar disturbing resources of space weather and the precursor or concomitant phenomena of solar eruption based on the newest observational results ; probing into the radiation principle of solar short - wave ray and presenting the computing methods about solar continuum and line spectrum radiation ; extrapolating physical methods of reconstructing the temperature and the emission measure of coronal plasma ; argumenting the effective observing spectrum for space weather empirical forecast and space weather numerical forecast

    物理設計的主要研究內容包括：分析目前國內國際空間天氣預報的發展現狀及開展空間天氣預報的必要性和重要性；分類討論了災害性空間天氣的種類、影響及目前國際上的預報方法：分析了空間天氣太陽擾動源及擾動源爆發的先兆現象或者伴生現象；討論了太陽短波輻射線譜和連續譜輻射強度的計算方法：推導了利用望遠鏡多波段的觀測結果反演日冕等離子體溫度、發射量等參數的物理方法：論證了開展空間天氣經驗預報和發展數值預報有效的成像譜段。
  7. The aim of this paper is to find a method to estimate the thickness of lunar soil from the values measured by lunar microwave radiometer

    本文的主要目的是尋找一種反演方法，利用月球探測衛星微波輻射計的亮度溫度數據評估月壤厚度。
  8. The new device consists of paint - drying box, heat carrier boiler, heating pipe, expansion tank, gas separator and oil tank, etc. the data of two applied examples shows that heat carrier paint drying method is able to make painting - drying cost drop by 88 %, compared with the conventional one, that it has some advantages such as uniform temperature field, good appearance and lower costs, compared with conventional hot air convection mode

    該裝置主要由熱載體烤漆爐、輻射加熱管，熱載體爐、膨脹器、油氣分離器和儲油槽等組成。應用實例的測試數據表明，與傳統的遠紅外電加熱鋼瓶烤漆方式相比較，鋼瓶熱載體烤漆節能和降低能耗費用十分顯著，能耗費用降幅達到88 。與熱風爐對流烤漆方式相比較，熱載體烤漆方法不僅節能，而且烤漆爐溫度場均勻穩定，同時烤漆的外觀質量也得到了明顯提高。
  9. For getting temperature of transient thermal - radiation, lodging the method of measuring the temperature of the time - resolved thermal - radiation with least duple multiply theory, and measuring the temperature of wu lamp with this method, the results showed that the method have best properties for measuring temperature, and measuring the temperature of time - resolved spectrum of matter under pulse laser shocking with this method, getting the primary results

    為了解析瞬態熱輻射溫度，提出用最小二乘法對由多道分析器採集的時間分辨熱輻射譜進行全譜溫度擬合的方法，在以鎢帶燈為輻射源的溫度測量中實現了較高精度的溫度擬合，用此方法對激光沖擊靶材所產生熱輻射的時間分辨譜溫度進行測量，得到了初步結果。
  10. 1. we summarized the methods applied to measure the temperature, expounded the problems in these methods, demonstrated the significance about how to ascertain the face of high temperature radiant body ; 2

    對國內外各種接觸式和非接觸式測溫方法和技術進行了較為系統的綜述，對其存在的問題進行了分析，並指出了被測高溫輻射體物面確定的意義和方法； 2
  11. It can educe the max of temperature raise from the curve. furthermore the numerical value is small than the max of temperature raise absolute radiometers measure the solar irradiance with sun - tracking

    從此曲線圖中，可以得出絕對輻射計的溫度升高所達到的最大值，而該值要比絕對輻射計用跟蹤太陽的測量方法測量太陽輻照度時，其溫度升高所達到的最大值略小。
  12. In order to make temperature measurement not effect temperature distributing, we developed a real - time temperature measurement system using radiation thermometry

    為了使溫度測量不影響曝光區的溫度分佈，需採用不接觸輻射測量方法。
  13. There are three mathematical models of multi - spectral thermometry based on calibration factor, brightness temperature and reference temperature respectively

    多光譜輻射測溫法的數學模型有基於檢定常數的數學模型、基於亮度溫度的數學模型和基於參考溫度的數學模型。
  14. The full text is divided into five chapters, chapter one recommends the commonly used high - temperature flame measure methods at present, including contact - type temperature measure method and non - contact - type temperature measure method, explain ccd flame temperature detection method based on optical radiation energy

    全文共分為五章，第一章介紹目前常用的高溫火焰測量方法，包括接觸式測溫法和非接觸式測溫法，闡述基於光輻射能的ccd火焰溫度檢測方法。
  15. The measurement system is made up of optical system, comparison system, control system and cooling system in the course of the temperature measurement of high temperature blackbody, we use filter radiometer that is a new approach to measure radiation temperature. the approach was adopted by ptb, npl and vniiofo in 1997 when they made international comparisions of spectral irradiance

    在測量高溫黑體溫度的過程中，使用了新型的輻射測溫法，濾光輻射計測量方法，該方法在1997年光譜輻照度國際比對時被ptb 、 npl 、 vn ofo等國家所採用，並得到一致認可。
  16. In this system, high temperature tvs are used to collect images, digital image processing technology is applied to process images, thermal radiation theory and plane surface array ccd ' s chroma theory are introduced and the three - colour method is discussed detailedly to detect the temperature

    本文旨在以全爐膛看火電視為圖像採集前端設備，以數字圖象處理技術為手段，運用熱輻射學和彩色面陣ccd色度學理論，採用三色測溫法來檢測爐膛火焰溫度。
  17. In this thesis, we discussed the basic theory and the status about this technology, designed software package, and analyzed the problem founded in calculation. the main works are follows : 1

    對國內外輻射測溫方法和技術進行了較為系統的論述，對其存在的問題進行了分析，並指出利用火焰圖像測溫的意義和方法。
  18. Then the temperature and spectral emissivity of material is calculated through processing the information data. this method has been quickly developed in the latest years because of the capability to get true temperature and emissivity without auxiliary instruments or other additional information

    多波長輻射測溫法是在一個儀器中製成多個光譜通道，利用多個光譜的物體輻射亮度測量信息，經過數據處理得到物體的溫度和材料的光譜發射率。
  19. In the temperature measurement, using a means of the optical fiber homochromous radiation temperature measurement, the mathematical model is created, and the temperature is monitored in real time. in the displacement measurement, the reflex mode method of displacement measurement of optical fiber is adopted. in order to eliminate the unstability of measurement system created by the illuminant receiving outside disturbance, the system designs referenced channel to assure the reliability of measurement and monitor the change of displacement in rea time

    在溫度測量中，採用光纖單色輻射式溫度測量方法，建立數學模型，實時監控溫度的變化；在位移測量中採用光纖反射式位移測量方法，為消除光源受外界干擾給系統測量帶來的影響，系統設計了參考通道，以此保證測量的可靠性和高精度，實時監控位移的變化。
  20. Test method for measuring total - radiance temperature of heated surfaces using a radiation pyrometer

    用輻射高溫計測量加熱表面的總輻射溫度的測試方法
分享友人
分享到 Line

分享到臉書