輻射量熱器 的英文怎麼說

中文拼音 [fúshèliángrèqì]
輻射量熱器 英文
radiation calorimeter
  • 輻 : 名詞（車輪中車轂和輪圈的連接物） spoke
  • 射 : Ⅰ動詞1 （用推力或彈力送出） shoot; fire 2 （液體受到壓力迅速擠出） discharge in a jet 3 （放出） ...
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 輻射量 : radiant quantity; radiation quantity
  • 輻射 : radiation; exposure; radio; beaming
  1. Energy consumption of heating rooms will increase when air exchange rate become large. because the mechanisms of heating methods used currently, such as radiator heating, ceiling heating and warm - air heating, are different from each - other, the indoor thermal environment is not the same when each one of them employed for room heating. for enhancing energy efficiency of heating rooms, indoor thermal comfort and energy saving effects should be investigated when natural ventilation is used to make a good air quality indoors

    房間換氣次數的增加勢必導致供暖房間能耗加大，頂棚輻射、散熱器和熱風等三種採暖方式由於供暖機理不同，形成的室內熱環境特徵不同，通風換氣時產生的通風熱損失也有所區別，為了提高大換氣量房間的供暖節能效果，必須對不同供暖方式在大換氣量情況下的熱舒適性與節能效應進行研究。
  2. Measuring method for normal total emittance of infrared heater

    紅外輻射加熱器全法向發射率測量方法
  3. Measuring method for normal spectral emittance of infrared heater

    紅外輻射加熱器光譜法向發射率測量方法
  4. 3. on boiler retrofit, the calculation of fuel burning, the heat calculation of boiler inside structure and convection section, and the design of structure parameter of feed water heat exchanger are made. the flue gas channels " resistance calculation and the boiler strength verifying are also carried out. replacement of water cooling wall improves heat exchanging and decreases loss of heat radiant

    對鍋爐本體進行了燃料燃燒計算、爐膛結構熱力計算、對流受熱面結構熱力計算、鍋爐給水加熱器結構參數設計、煙道阻力計算及鍋爐元件強度校核等；改進了水冷壁布置使換熱效果更好，減少輻射換熱損失；改進對流段結構，更充分的利用爐膛出口煙氣余熱，提高熱效率；並且進行了煙氣阻力計算、熱效率計算和能量平衡測試，對改進后的稠油燃料和改進前進行了對比，燃燒狀況和熱效率有明顯改善。
  5. Method for measurement of mass loss and ignitability for screening purposes using a conical radiant heater

    使用圓錐輻射加熱器測量屏蔽用質量損耗和可燃性的方法
  6. Measuring method for normal spectral emittence of infrared heater

    紅外輻射加熱器光譜法向發射率測量方法
  7. The new device consists of paint - drying box, heat carrier boiler, heating pipe, expansion tank, gas separator and oil tank, etc. the data of two applied examples shows that heat carrier paint drying method is able to make painting - drying cost drop by 88 %, compared with the conventional one, that it has some advantages such as uniform temperature field, good appearance and lower costs, compared with conventional hot air convection mode

    該裝置主要由熱載體烤漆爐、輻射加熱管，熱載體爐、膨脹器、油氣分離器和儲油槽等組成。應用實例的測試數據表明，與傳統的遠紅外電加熱鋼瓶烤漆方式相比較，鋼瓶熱載體烤漆節能和降低能耗費用十分顯著，能耗費用降幅達到88 。與熱風爐對流烤漆方式相比較，熱載體烤漆方法不僅節能，而且烤漆爐溫度場均勻穩定，同時烤漆的外觀質量也得到了明顯提高。
  8. Test method for calibration of heat transfer rate calorimeters using a narrow - angle blackbody radiation facility

    用窄角黑體輻射設備校準傳熱速度量熱器的方法
  9. On the contrary, the infrared passive sensors detect and locate the targets in the space by the use of the heat of the targets, and they do n ' t radiate any energy to the space

    和雷達不同，紅外無源探測器通過接收目標輻射的熱能進行定位和跟蹤，不向空中輻射任何能量，因而不易被偵察或定位，具有很強的抗干擾能力。
  10. Measuring method for insulation resistance of infrared heater

    紅外輻射加熱器絕緣電阻測量方法
  11. Abstract : the in servie tubular heaters built early in refineries and chemical plans have low thermal load and low heat efficiency, therefore measures for technical reform are offered, including ( 1 ) enlarging the surface area of convection tubes to increase the thermal load of rhe convection section ; ( 2 ) increasign the heat interchanging area of radiant tubes ; ( 3 ) changing the height of the chimney ; ( 4 ) using new burner with forced air supply to increase calorific capacityu ; ( 5 ) adding air preheater between the convection section and chimney to enhence the temperature of the air entering the furnace ; ( 6 ) adopting high temperature radiant coating to improve the effect of radiant heat interchanging

    文摘:針對早期建造的煉油廠和化工廠在役管式加熱爐熱負荷和熱效率低的狀況，提出了若干技術改造措施包括，增大對流管表面積以增大對流段的熱負荷；增加輻射管的換熱面積；修正煙囪高度；換用新型燃燒器，變自然通風為強制供風，以增大燃燒器的發熱量，減小過剩空氣系數，節省燃料2 % 3 % ；在對流段和煙囪之間增設空氣預熱器以提高空氣入爐溫度；採用高溫輻射塗料增強輻射換熱效果，從而增加熱源對爐壁的輻射傳熱量和爐管的傳熱量等。
  12. The in servie tubular heaters built early in refineries and chemical plans have low thermal load and low heat efficiency, therefore measures for technical reform are offered, including ( 1 ) enlarging the surface area of convection tubes to increase the thermal load of rhe convection section ; ( 2 ) increasign the heat interchanging area of radiant tubes ; ( 3 ) changing the height of the chimney ; ( 4 ) using new burner with forced air supply to increase calorific capacityu ; ( 5 ) adding air preheater between the convection section and chimney to enhence the temperature of the air entering the furnace ; ( 6 ) adopting high temperature radiant coating to improve the effect of radiant heat interchanging

    針對早期建造的煉油廠和化工廠在役管式加熱爐熱負荷和熱效率低的狀況，提出了若干技術改造措施包括，增大對流管表面積以增大對流段的熱負荷；增加輻射管的換熱面積；修正煙囪高度；換用新型燃燒器，變自然通風為強制供風，以增大燃燒器的發熱量，減小過剩空氣系數，節省燃料2 % 3 % ；在對流段和煙囪之間增設空氣預熱器以提高空氣入爐溫度；採用高溫輻射塗料增強輻射換熱效果，從而增加熱源對爐壁的輻射傳熱量和爐管的傳熱量等。
  13. Measuring method for the surface temperature distribution of infrared heater

    紅外輻射加熱器表面溫度分佈測量方法
  14. In this article, a research on how the change of latitude and direction of a solar powered long endurance aircraft effect the received solar power was developed. and on the basis of the car air conditioning, the thermal properties of the single - effect lithium bromide absorption hot - coldwater unit and two - stage lithium bromide absorption hot - coldwater unit applied in car and driven by high temperature cooling fluid of the car engine are advanced and compared. the technique of energetic optimization is employed to investigate the optimal performance of an irreversible hybrid air - conditioning system consisting of a vapor compression refrigerator cascaded with a solar - driver absorption refrigerator

    本文對太陽能飛機的飛行緯度和飛行方向對能夠獲得的太陽能輻射量的影響進行了研究，以及對應用於汽車空調的兩種溴化鋰製冷機組，即單效溴化鋰製冷機組和兩級溴化鋰製冷機組進行了熱力分析和研究，同時，結合太陽能集熱器作為整個製冷系統的熱源，對系統的最優綜合性能進行了分析和研究。
  15. Measuring method for temperature rise time and fall time of infrared heater

    紅外輻射加熱器升溫時間和降溫時間測量方法
  16. Single burner gas fired overhead radiant tube heaters and non - domestic gas - fired overhead luminous radiant heaters - requirements and test methods for establishing the rational use of energy - radiometric method c

    單端燃燒器燃氣頂置輻射管式加熱器和非家用燃氣頂置光輻射加熱器.確定合理使用能量的要求和試驗方法.輻射測量法c
  17. Measuring method for the radio between radiant surface and rear surface of infrared heater

    紅外輻射加熱器輻射面和背面溫度比測量方法
  18. Standard test method for measurement of mass loss and ignitability for screening purposes using a conical radiant heater

    使用圓錐輻射加熱器測量屏蔽的質量損失和易燃性的標準試驗方法
  19. Single burner gas fired overhead radiant tube heaters and non - domestic gas - fired overhead luminous radiant heaters - requirements and test methods for establishing the rational use of energy - radiometric method a

    單端燃燒器燃氣頂置輻射管式加熱器和非家用燃氣頂置光輻射加熱器.確定合理使用能量的要求和試驗方法.輻射測量法a
  20. Single burner gas fired overhead radiant tube heaters and non - domestic gas - fired overhead luminous radiant heaters. requirements and test methods for establishing the rational use of energy. radiometric method c

    燃氣式單噴嘴裝于頂部的輻射管加熱器和非家用燃氣式裝于頂部的發光輻射加熱器.建立合理使用能源的要求和試驗方法.輻射測量方法c
分享友人
分享到 Line

分享到臉書