轉動耦合 的英文怎麼說

中文拼音 [zhuǎndòngǒu]
轉動耦合 英文
rotational coupling
  • : 轉構詞成分。
  • : Ⅰ動詞[書面語] (兩人並耕) plough side by sideⅡ名詞1 (古農具名) plough2 [書面語] (兩人一組) a...
  • : 合量詞(容量單位) ge, a unit of dry measure for grain (=1 decilitre)
  • 轉動 : 轉動turn; run; twirl; roll; revolve; rotate
  • 耦合 : [物理學] coupling; interconnection; catena; linkage; linking
  1. The stability of the tiltrotor in the heli copter mode is analyzed aiming t a semi span soft - inplane tiltrotor model with an elastic wing

    集成了非定常態人流方程與傾過渡狀態的多體力學力程,建立了傾旋翼機時域非定常氣彈分析模型。
  2. The convert and evolution course of periodical response, quasi - periodical response, double - periodical bifurcation, chaos of the system response is analyzed. ( 3 ). it is deduced that the general differential equation of bending - torsional - pendular coupling vibration about rotor with the gyroscopic moment

    ( 3 )推導了一般意義下,考慮陀螺力矩的單盤子彎扭擺非線性方程,基於該方程,推出了不平衡子和碰摩子的非線性彎扭擺方程。
  3. On the basis of this equation, the general differential equations of coupled bending, torsional and pendular nonlinear vibration about rotor with unbalance character and rubbing character are deduced. the bifurcation and chaos behavior especially the influence on bifurcation and chaos behavior of impact and rubbing fault rotor system

    應用數值方法研究了碰摩子的彎扭擺相應的復雜力學行為,重點研究了速、偏心量等系統參數對碰摩子彎扭擺的分岔和混沌行為的影響以及扭和擺對彎曲振的影響。
  4. In this paper, the rotating machinery at high speed is studied. there are discussed about numerical calculating methods for non - linear dynamical system, the rotor system radial impact and rubbing dynamics behavior analysis having the nonlinear rigidity on the unsteady and non - linear oil film, the rotor system dynamics behavior analysis with bending - torsional - pendular coupling vibrations, application of wavelet, fractal and network in fault diagnosis. the main works in this paper are as follows : ( 1 )

    本文以高速旋機械為主要研究對象,系統、深入地研究了非線性力學系統的數值計算方法、具有非線性剛度的子系統在非穩態非線性油膜力作用下的徑向碰摩力學行為、子彎扭擺力學分析、小波和分形理論及人工神經網路在故障診斷中的應用問題。
  5. Accordingly, using graph theory and operating experience abroad for reference, it firstly brings forward a new method of voltage rectification which based on pilot bus with voltage control area in view of the weak coupling among every vca ( voltage control area ), using decomposing method of multi critical value, it realizes the eliminating vinculum of every vca. and then, the rectification starts by pilot bus voltage of every vca. so the resolution of whole power net is diverted into calculating smaller sub - net

    由於各個電壓控制區之間無功電壓的弱性,利用多閥值分解的分區演算法,實現區域間的解,然後根據各個子網路的主導節點的電壓進行校正,從而把求解整個網路的問題化為求解各個小的子網路,降低了網路維數,減少了無功設備控制作次數,提高了校正成功率,縮短了計算時間。
  6. In addition, the dynamic equation about ammonia fertilizer affected by interaction of water and temperature is gotten. 3. the phenomenon about water vaporization - induced ammonia volatilizing is verified, and it is studied quantitatively

    此外,通過回歸分析還建立了表徵施入土壤中尿素化為銨態氮的力學型方程,其參數均與土壤水分、溫度有關,並得到這些參數的水熱效應關系式。
  7. The flying stability of the unguided projectile with wrap around fins could be influenced by the self - induced rolling characteristics and the cross coupling effects of the waf badly. it is necessary to study further on this special aerodynamic problems

    卷弧翼存在自誘導滾特性、較嚴重的交叉效應等特殊氣問題,對于無控的卷弧尾翼彈而言,這很大程度上影響飛行穩定性。
  8. And smooth and effective knowledge transfer and exchange are the prerequisite of interactive learning within enterprise cluster, and interactors ’ proximity - based coupling is the important guarantee in knowledge transferring and exchanging smoothly. actors ’ proximity may be decomposed into geographical, social and indus - trial aspects in network for cii within regional enterprise cluster

    區域企業集群創新實質為創新,這是因為區域企業集群創新的形成是集主體交互學習作競爭的結果,主體間交互學習的實現是以區域企業集群內順暢而有效的知識移和交流為前提的,而企業集群中主體間的接近性是知識順暢移和交流的保證。
  9. The ultrasonic motor is a kind of direct driver which is uses the converse piezoelectric effect of the piezoelectricity ceramics, by using transformation and the coupling of each kind of expansion and contraction vibration pattern enlarging the material microscopic distortion by resonate effect and transforming it to macroscopic movement of the rotor or the slide by the friction coupling

    超聲波馬達是一種利用壓電陶瓷的逆壓電效應,通過各種伸縮振模式的換與,將材料的微觀變形通過共振放大和摩擦換成子或者滑塊宏觀運的直接驅器。
  10. Because the steering angles of front wheel and rear wheel couple with the directional angles, a kinematics approach is developed to compute these two steering angles

    由於月球車前後輪的舵角與車體向角存在,本文設計了一種運學計算方法來得到前後輪的舵角。
  11. The radical reason of lower ecosystem productivity and disharmonic developing in this ecotone is the improper configuration inner animal husbandry for example of ansai county and big animal scale exceeding the threshold of the primary productivity for example of wuchuan county, which above - mentioned leads to the fact that coupling mechanism between agriculture and animal husbandry system has not been established, and agriculture and animal husbandry is still in the state of disharmonic on the whole. 3

    主要表現為兩種典型結構模式,一種以安塞縣為代表,農牧能值總體利用率較高,但畜牧業內部結構偏重食糧物使得高質能化率低下;另一種以武川縣為代表,農牧業結構總體上朝趨于協調方向發展,但畜牧業規模過大,由於草畜平衡嚴重失調,導致農牧系統機制難以穩定。
  12. The performance of the bearings, the nature characteristics and stability of a symmetric rotor - bearing system equipped with a flexible laminated membrane coupling were discussed duo to misalignment of rotors

    以膜片聯軸器的對稱多跨子?軸承系統為研究對象,分析了子不對中量對軸承的靜特性、系統的固有特性和穩定性的影響。
  13. After discussing the forces on the typical components of the system and their motions, the dynamic model of the flexible laminated membrane coupling - rotor - bearing system was developed, in which the effects of the misalignment and unbalance of the rotor system were considered

    然後對系統中的各典型部件分別進行了受力和運學分析,同時考慮了子的不對中和不平衡因素對系統力學的影響,建立了膜片聯軸器子?軸承系統的力學模型。
  14. The dynamic model of misaligned rotor - bearing system equipped with a flexible laminated membrane coupling was developed by using the method of lumped parameter in this dissertation, and the dynamic behavior, such as the nature characteristics, stability, steady state response of the system, etc. was analyzed based on the theory of linear vibration

    本文根據集總參數法建立了膜片聯軸器的不對中子?軸承系統的力學模型。基於線性振理論分析了系統的固有特性、穩定性和不平衡響應。
  15. In order to investigate the unsteady flow frequency domain performances of an axial flow compressor at different mass flow, rotating speed and blade row spacing, plus inlet flow distortion, and considering aerodynamic characteristics and stability of the compressor, the low speed research compressor ( lsc ) at college of energy and power in nuaa is used to carry out the experiment studies. a large amount of test data has been gained through dynamic pressure transducers embedded in the stator blades at the tip, middle and hub section, then fast fourier transform algorithm ( fft ) is applied to calculate the frequency data

    為探討軸流壓氣機在工作流量、工作速及?靜葉排軸向間距變化時的葉片排流場非定常頻譜特性變化規律,並進氣畸變的影響,同時與壓氣機氣性能和氣穩定性相關聯,作者利用南京航空航天大學能源與力學院的低速大尺寸軸流壓氣機( lsc )試驗器,採取在靜子葉片表面埋入態壓力傳感器的實驗方法,對葉尖、葉中和葉根三個截面的態壓力進行了測量,獲得了大量的可靠的實驗數據。
  16. Based on the review, the fluid flow and heat transfer in the curved circular and rectangular pipes have been researched by employing perturbation method and numerical simulation with a physical model under the rotational orthogonal curvilinear coordinate in a rotating curvilinear pipe with multi - parameters. we firstly analyzed the fully developed fluid flow and heat transfer, mixed convection heat transfer, the development of flow and heat transfer in the inlet in different cross section ( circular, elliptical, annular and rectangular crossection ). the variations of the secondary flow, axial velocity, distribution of temperature, the friction force on the wall, the ratio of friction factor as well as the nusselt number with different dimensionless parameters had been examined in detailed

    本文在總結和分析了一個世紀以來有關曲線管道流和換熱特性的研究成果的基礎上,以旋正交曲線坐標系統下的多參數旋螺旋管道中的對流傳熱為物理模型,通過攝方法和有限體積法,首次對各種截面(圓截面、橢圓截面、環形截面、矩形截面)旋曲線管道內充分發展流的流結構和傳熱特性(包括對流傳熱特性)以及旋曲線管道開口段發展流的流結構和換熱特性進行了系統的數值模擬和理論分析,詳細討論了各種無量綱參數對管道內軸向速度分佈、二次流結構、溫度分佈、壁面摩擦力、摩擦系數比以及管道nusselt數的影響,獲得了若干創新性成果。
  17. Rigid - flexible coupling system ; rotating flexible beam ; active vibration control ; positive position feedback ; piezoelectric ceramic

    剛柔系統旋柔性梁振控制位置正反饋壓電陶瓷
  18. The characters of bank - to - turn control technology determine that the btt missile ' s mathematical model having kinematical coupling, aero dynamical coupling, inertial coupling and control coupling. so the widely used stt missile ' s autopilot, which is designed to be three - channel independent ca n ' t meet the btt missile ' s control need

    Btt控制技術的控制特點決定了btt導彈的數學模型存在運、氣、慣性和控制等多種因素,因此目前側滑彎( stt )導彈廣泛採用的自駕駛儀三通道獨立設計方法已不能滿足btt導彈控制系統的設計要求。
  19. The aim of this paper is to relate structural inherent characteristic with exterior excitation, to wield experimental mode analysis technique and structure intension theory in order to separate structural leading mode under practical work state on base of spectrum analysis of exterior excitation and identification each rank mode parameter of structure. sequentially, the issue of space complex stress state in effect of static and dynamic coupling transforms into the issue of simple stress state ( under mode form ) in reciprocal effect of each rank mode in order to analyze structural dynamical intensity

    將結構本身的固有特性和外部激勵聯系在一起,運用實驗模態分析技術和結構強度理論,在對外部激勵進行譜分析和識別出結構各階模態參數的基礎上,分離出實際工作狀態下結構的主導模態,從而將一靜力作用下的空間復雜應力狀態問題化為各階模態相互作用下的簡單應力狀態(模態形態下)問題進行結構強度分析。
  20. Setup of experimental system and experiment research first, coupling characteristic between flexible appendages and central rigid body is theoretically analyzed. based on simplifying the object studied, its theoretical model is derived by applying lagrange equation, and the coupling characteristic is analyzed. the control modals of flexible appendages are determined through calculating rolling couple coefficient and simulation of real coupling structure

    將研究對象簡化為帶有對稱柔性梁的剛性體,分析了柔性附件與中心剛體的運模式,並對影響中心剛體姿態角的反對稱模式建立了力學方程,通過對實際結構轉動耦合系數的計算和模擬分析,確定了柔性附件振控制的重點模態。
分享友人