轉感器 的英文怎麼說

中文拼音 [zhuǎngǎn]
轉感器 英文
transducer
  • : 轉構詞成分。
  • : Ⅰ動詞1 (覺得) feel; sense 2 (懷有謝意) be grateful; be obliged; appreciate 3 (感動) move; t...
  • : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
  1. Depend on the comprehensive analysis and study of the structure, principle, and exterior characteristic of the motor, through the methods of system modeling and digital simulation analysis, two kind of control device that work for the low voltage ( lvdc ) and the high voltage ( hvdc ) in avigation are researched respectively. point to the control technique of close - loop speed stabilization at a limited adjustment speed range, we bring out the close - loop speed control method that using the rotor position sensor indirectly measure the speed of the motor

    在全面分析了稀土永磁無刷直流電動機的結構特點、工作原理、運行方式以及外部特性的基礎上,通過系統建模和數字模擬分析,分別針對航空低壓直流( lvdc )和高壓直流( hvdc )兩種電動機構用永磁無刷電動機,在小范圍速連續調節下的閉環穩速控制技術進行了詳細理論研究,提出了利用子位置傳信號間接測量電機速進行電機速閉環穩速控制的策略。
  2. Mems ( micro electromechanical system ) has become one of the most rapidly development technologies. along with the rapid development of mems techniques, capacitive sensor is used widely whose capacitance changes small, which has put forward the new request to the measurement technique. the common measure for capacitance measurement is that convert capacitance to voltage, electric current or frequency. the area of polar plate of the capacitor becomes smaller and smaller, and the total capacitance of micro capacitive sensor is usually several pico farad only. as a result, its change amount is smaller

    Mems ( microelectromechanicalsystem )近年來發展最快的技術之一,隨著mems技術的快速發展,電容式加速度計的電容變化變化量越來越小,對檢測技術提出了新的要求。在電容式傳中,常用電容檢測電路是將其換為電壓、電流或者頻率信號。目前的微型電容傳的極板面積變得越來越小,電容總量只有幾個pf ,變化量就更小。
  3. This paper simply introduces the device of on - line monitoring for the thrust of the rotating maching, then discu ed the finite dement analyses on the on - line monitoring elastic dement for measuring thrust in detail, in order to develop the performance of the se or and the device, we calculated the distribution of the stre 、 strain 、 axial di lacement in the elastic element using the finite element method when the axial forces f = 3 104n, the result is very satisfied

    簡單介紹大型旋機組軸向力在線監控裝置,然後詳細介紹軸向力測力彈性元件的有限元分析,為了提高所研製的測力傳的性能,採用有限元方法計算了彈性元件在軸向力f = 3 104n時的應變、應力、靈敏度及軸位移等的分佈情況,分析結果表明:所設計的測力傳完全符合廠方的要求及儀表性能指標。
  4. Lk - coriolis mass flowmeters made according to the coriolis mass inside prineiplecloses the dischange apperrance of the fluid quality. discharge inside the piping, its structure be generally spread feeling machine and signal by signal diagraph to comvert to machine two part constituce

    Lk系列質量流量計是根據科里奧原理製造的一種新型的直接測量封閉管道內流體質量流量的流量測量儀表,其結構一般由信號測量傳和信號兩部分組成。
  5. Using the color sensor as the navigation sensor, with mcu for control centre, the robot is drived and change direction by the differ direct current motor

    用顏色傳作為導航傳,以單片機為控制,直流電動機實現驅動和差動向。
  6. Study of the transport of small molecules in a microemulsion - based organogel is of great significance to broaden the research area of micellar enzymology and to promote its application in biosynthesis, bio - transformation and biosensor

    微乳凝膠中小分子傳質研究對于拓寬膠束酶學研究內涵、加速酶在生物合成與化領域中的應用、研究高性能生物傳等具有重要理論意義和潛在應用價值。
  7. Secondly, it describes the hardware system of the exoskeleton hand, including the circuit design of the driver, the fpga - based motion controller, the processing and the a / d conversion for the sensor signal

    其次,設計了外骨骼手底層控制系統的硬體電路,包括微型驅動模塊電路的設計,基於fpga的運動控制電路的設計,傳信號調理以及模/數換電路的設計。
  8. First, the wheelset is fixed and rotated by the device used hi vehicle depot as usual. second, the center line of wheelset axis is determined by a device called axis - center probe. last, the acting device for sensor can draw a whole felloe profile, which is made up of parallel - pole device and rotating - probe

    鑒於此,本文給出了一種全新的測量方案:採用車輛段普遍使用的實現被測輪對的定位;採用車軸基準探尺測定被測輪對的軸線;採用並聯式伸縮機構和旋測頭作為傳的執行機構,測定輪輞斷面的輪廓線。
  9. Program management of the rotating shells by use of geomagnetic sensors

    運用地磁傳對旋彈進行程序控制
  10. Based on the model of safe following distance, the design blue print of system is presented in the text. using the multiple impulses horae rotate speed sensor to measure the vehicle speed and nanometer radar to measure the distance of own vehicle to frontal vehicle, and analyzing and judging collected information by at89c51 which is the control centre of the system

    本文在安全跟車模型的基礎上,提出了系統方案:採用霍爾多脈沖速傳測量汽車的速度,毫米波雷達測量兩車的距離和相對速度,利用at89c51作為信息採集單元的控制中心,對各種信息進行分析判斷,當行車距離小於報警距離時啟動相關的報警單元。
  11. Pressure sensor and hygrothermograph sensor are adopted respectively to sense these change ; a plc and its analogue cell are adopted to collect and analysis the data ; a mcgs component software is used to process and store the data in real time

    給出了以壓力、流量和溫濕度傳為測量元件、以plc為主控制、 plc模擬單元為數據換單元的詳細硬體設計、程序設計和組態軟體mcgs在上位機的運用。
  12. Some studies on control modes of the system, especially on a dc, pm, brushless and sensor - less motor driven systems. a method of rotor position identification without sensors has been developed. using a microchip to increate system efficiency, anti - disturbing ability and reliability of pwm modulation

    研究了適于直流、無刷、永磁、無位置傳電機子位置的檢測方法;採用單片機實現了該種電機的運行控制,提高了系統在pwm調制時位置檢測換相控制過程的抗干擾能力。
  13. After analysing several kinds of light - weighting structures through ansys, hexagonal speculum structure is confirmed. in the aspect of the controling of speculum, the paper adopts the brushless dc motor which is partial assembled to drive the point speculum and the inductosyn as angle measuring component is selected, the ad2s80a the system is used to get directly angle and angular velocity. double closed - loop speed and position control is designed, as the pid control is the well - developed algorithm, which can achieve stable rotation and precise position control

    在指向反射鏡的擺動控制方面,採用低速性能好的分裝式直流力矩電機作為指向反射鏡的驅動電機,並採用應同步作為角度測量元件,運用軸角ad2s80a進行角度和速度的輸出,採用技術成熟的pid控制方案,進行速度和位置雙閉環控制,以實現指向反射鏡動速度的平穩性和位置的精確性。
  14. Magnetic sensors are an important branch that can be used to detect the non - electronically characteristics through the magnetic field. the insb magnetoresistance photoelectric sensor in this paper is designed for the fine measurement of the photosignal of the luminant device. through the sensor, the photo - pulse signal is changed to electric pulse which can provides to other second instruments

    通過磁場的無接觸特性,對非電量的測量是磁傳應用的一個重要方面,本文所研究的銻化銦磁阻型光電傳即是針對于發光物體的光脈沖信號進行高精度無接觸測量的一類傳,它可以把光脈沖信號換成電脈沖信號,供二次儀表使用。
  15. Using domestic strained integrated resistor as weighing sensor, at89c52 single chip as control unit, combined with arithmetical magnification, analogtodigital conversion ( a / d ), real time clock, liquid crystal display ( lcd ), and series communication interface, a minitype automatic weighing lysimeter is developed. that made measurement of evapotranspiration become conveniently and effectively in studying on water use of crops

    為了方便、有效地測定植物的蒸散,為水分利用研究提供價廉物美、簡單易用的儀,本研究利用國產的集成電阻應變式稱重傳,採用at89c52單片機作為控制單元,結合運算放大、模數換、實時時鐘、液晶顯示、數據存儲、串列通信等外圍介面電路,研製了小型自動稱重式蒸散儀。
  16. Magnetoelectric phase difference torque transducer

    磁電相位差林矩傳
  17. Magnetoelectric tachometric transducer

    磁電式速傳
  18. According to the principle of energy transfer, an opto - chemical sensor with higher sensitivity to detect picric acid by using the mixture of porphyrin dimer and anthracene as fluorescent carrier has been developed

    基於能量移原理,採用卟啉二聚體和蒽的混雜體系作為熒光載體研製了一種靈敏度更高的苦味酸光化學傳
  19. Multiferroelectric magnetoelectri materials have a spontaneous polarization that can be reoriented by an applied electric field, a spontaneous magnetization that can be reoriented by an applied magnetic field. these materials have been exploited as transducer, waveguides, switches, phase inverters, modulators, etc. which also find a lot of technological applications in radioelectronics, optoelectronics, microwave electronics in instrumentation

    這類材料同時具有鐵電和鐵磁材料的性能可以應用到傳,波導件,,相位倒相,變頻,調節等,在無線電電子學,光電子學,微波電子學等領域的發展具有重要意義。
  20. Compared to the traditional converter, the new one can transform electric power from a static part to a rotary part without an electrocircuit connection, which makes the contactless power transform come true. one application of this converter is to supply a steady and regulable excitation circuit for synchronous generator by integrated its second winding with the motor while its primary winding is static. the thesis gives two methods of the rotating converter design paticullarly : flyback and fullbridge, and explains how the circuits are designed

    通過理論分析、模擬分析和實驗驗證,得出這兩種旋變換都能進行應電能傳輸,但它們的傳輸功率是不同的,反激式旋最大隻能傳輸幾十瓦功率的應電能,因此只能用在應電能傳輸較小的場合,或者信號傳輸的場合;而全橋式旋變換能傳輸較大的功率,可用於電機的新型無刷勵磁方案中。
分享友人