轉折線 的英文怎麼說

中文拼音 [zhuǎnzhéxiàn]
轉折線 英文
bend line
  • 轉 : 轉構詞成分。
  • 折 : 折動詞[口語]1. （翻轉） roll over; turn over 2. （倒過來倒過去） pour back and forth between two containers
  • 線 : 名詞1 （用絲、棉、金屬等製成的細長的東西） thread; string; wire 2 [數學] （一個點任意移動所構成的...
  • 轉折 : 1 （事物在發展過程中改變方向） a turn in the course of events 2 （文意的轉折） transition （of an...
  1. Effective decay curves and articulation formula

    混響曲線的轉折與清晰度評價
  2. The transition almost has the character of a knee on the curve.

    這變化差不多使曲線上有了一個轉折。
  3. The study in the paper starts with beam distortions, and it treats the plastic deformation area as pure bending sect, rest of the beam as rigid bodies. according to different shapes of the external tendons, it divides into three structural forms familiar in projects, that is the beams with no deviator, with a deviator and with two deviators, and studies the relation between the deformation of the external prestressing tendons and that of the beams, and derives the formulas of the ultimate stress increment of external tendons. in the formulas, the ultimate angle corresponding to half of the plastic deformation area is considered as a variable parameter

    本文首先從梁極限狀態下的變形入手，將塑性鉸區看作純彎段，將塑性鉸以外的區域看作剛體，按照體外預應力筋的形狀不同，分工程中最常見的三種體外結構形式，即無轉向塊的直線型體外筋混凝土梁、具有一個轉向塊的單折線型梁和具有兩個轉向塊的雙折線型梁，研究體外預應力筋變形和梁體的變形間的關系，推導出以極限狀態下塑性鉸區之半對應的轉角為參數的計算體外預應力混凝土簡支梁以及連續梁的體外筋應力增量計算公式，並進一步求得梁的極限承載力。
  4. In the end, the main content of this dissertation is addressed. in chapter 2, based on the analysis of present vibrator ' s principle and structure, two kinds of transfer functions and frequency response curves of the vibrator, driven by voltage feedback power amplifier and current feedback amplifier, are given separately. and turnover frequencies between different frequency rangs are also given

    第二章分析了標準振動臺的工作原理和結構，在此基礎上，建立了標準振動臺的機械和電氣方程，給出了恆壓源和恆流源功放激勵下的振動臺傳遞函數及幅頻、相頻特性曲線，列出了不同頻段間的轉折頻率。
  5. Then the slope rises ever more steeply as bacteria proliferate until it reaches an inflection point

    接下來隨著細菌的繁殖，斜線向上急速增長，直到達到轉折點為止。
  6. In terms of the narrative structure, to my surprise, the filmmakers did not employ any innovative techniques at all, a linear narrative approach is presented. everything is brought out plain and slow, that audiences may find some scenes boring. but when the story progresses, you ll soon realize that the simple narrative device is actually quite suitable for this story

    對于這類奇情故事的拍攝，很多導演都會在敘事方面標奇立異，增強懸疑味道，此片卻剛剛相反，無論劇情以至拍攝手法都非常平實，敘事以最平鋪直敘的直線方式處理，而且節奏較慢，一般觀眾或許覺得有點沉悶，但其實戲味就是透過生活化的情節慢慢滲透出來，為結局的轉折建立起張力。
  7. Because in the drinking water has the slight pollutant content to be low, may use the ideal solution adsorption theoretical model ( iast ) to process, the result is satisfying, this model to studies the activated charcoal to add water has the slight pollutant the adsorption rule to have the extremely important guiding sensein addition, the solute measurement replacement adsorption model ( sdm - a ) also obtained to the above research system has imagined not the but actually result, namely appeared " v " the glyph extension broken line in adsorption isothermal chart

    鑒于飲用水中三氯甲烷含量較低，採用理想溶液吸附模型（ iast ）來指導其吸附動力學的研究，結果令人滿意，另外，溶質計量置換吸附模型（ sdm - a ）應用於上述研究體系也取得了意外收獲。即在其吸附等溫線圖上出現了「 v 」字形的轉折線。該點對應飽和吸附量，可用來判斷單分子層和多分子層吸附的分界點。
  8. The response of mmcs has a turning point, associated with the initiation of interfacial debonding, which is decided by the interfacial strength. unlike the two predecessors, the evolving complaint interface ( eci ) model allows unloading of interfacial stresses

    在常響應界面情況下，復合材料橫向拉伸應力?應變曲線存在明顯的轉折點，對應于界面分離的始發點，轉折點的位置取決于界面粘結強度。
  9. As soon as the normal section cracks, the crack firstly appears in the flexural region. at this moment, the load - deflection curve has a turning point. with the increase of the load, the rigidity of the beam decreases compared with that before cracking because of the development of cracks in flexural region, and the formation and development of diagonal cracks toward the loading point, the load - deflection curve is basically linear till the beam fails

    正截面開裂前，荷載撓度曲線基本為線性，截面剛度較大；正截面開裂時，裂縫先在純彎段出現，荷載撓度曲線出現轉折點，隨著荷載的增加，純彎段正裂縫的發展以及剪跨段斜裂縫的產生並向梁的受壓區加荷點發展，使梁的剛度較截面開裂前減少，荷載撓度曲線也基本為線性直到梁破壞。
  10. The age of 4 was a notable turning point. nevertheless, tom ability still did not linearly rose after the turning. it dropped a little at the age of 4. 5, then rose again at the age of 5, and finally reached a new high point

    這種能力總體上隨年齡的增長而提高，但這種增長不是線性的， 4歲是一個明顯的轉折點，但兒童的心理理論能力並不就此直線上升，在4 . 5歲左右有所下降，之後到了5歲又開始上升，接近5 . 5歲時，再次達到一個新的高點。
  11. The article analyzes the traditional ways for modeling the turning point and the gradient, then puts forwards the better ways for it by using model to set down the direction in turning point and measuring in the midline, thus enhancing the efficiency

    摘要分析了轉點和坡度放樣的傳統方法，提出了採用模型放樣折線洞中線、在洞中線掛線上量測長度進行坡度放樣的簡易方法，提高了工作的效率。
  12. Dogleg control strategy was proposed for piston electronic control unit ( ecu ) engine of a small size unmanned helicopter in overrunning stage, and then compared with traditional method of increasing rotational speed in fixed slope

    摘要針對小型無人直升機使用的活塞式電噴發動機的沖速段特性，給出了折線法的轉速指令控制策略，並與常用的固定斜率轉速指令增量的方法進行比較。
  13. The problem of the film is that the story is too simple and it is presented in a way which is too linear. it lacks intensity and climax at all

    差勁之處-個人認為此片的劇情太簡單太直線化，缺乏了高潮疊起的轉折性，一切劇情都在掌握之中，無甚驚喜可言。
  14. Through analysis of engine ground test data, it ' s learnt that dogleg method can resolve efficiently the rich oil and overrunning problem, and achieve rotational speed control with strong robustness

    通過開車試驗數據分析，折線法能夠有效地解決沖速段的富油和沖速問題，實現沖速段的轉速控制，並且具備較強的魯棒性。
  15. This thesis is regarding its life cycle as the main line, management thought of analysis at each stage and strategy of mistake area in twist period, bring up necessary for integrating of human resource strategy system, executive strategy consciousness, configuring of building up system and important point of strategy management for enterprises run by private capital

    本論文以其生命周期為主線，分析時代集團在各個階段的管理思想和轉折期的戰略誤區，提出了民營企業轉軌中人力資源戰略系統整合的必要性，經營者戰略意識的轉化性，組織系統架構的適應性等戰略管理要點。
  16. We ca n ' t envisage and solve the problem of cadres in the great historical turning date, we ca n ' t insist on it extendedly

    如果我們對在偉大歷史轉折時期提出的幹部問題不能正視和正確解決，我們黨的正確路線就難以執行，更不能長期堅持下去。
  17. New idea toward the calculation methods for the rotary air preheater rotator mushroom type deformation and the installation method of folding gaskets. were put forward the calculation method for the pre - arangement of the folding line gap was presented

    摘要對回轉式空氣預熱器轉子蘑菇狀變形量的計算方法和密封片的安裝方法提出了新的觀點，並對這折線密封間隙的預留提出了新的計算方法。
  18. The results indicate that the kinetic expression for the formation of uo2 + x in 25 - 150 was initially nonlinear, but switched to linear at long reaction times, that is, there exist two stages in the uo2 growth kinetics : nonlinear portion and linear portion

    室溫150下的氧化動力學曲線表明：金屬鈾表層氧化形成uo _ （ 2 + x ）的過程中存在一個轉折點，轉折點前後形成兩個反應階段：非線性增長階段和線性增長階段。
  19. The electrical cut scanning mirror shows : this bilinear behavior results from different cracking ways under high and low strain amplitudes, that is, elastic cracking and brittle cracking respectively. cyclic hysteresis energy is an important fatigue parameter. the total cyclic hysteresis energy of gh4145 / sq increases gradually as strain amplitude goes from 1 % to 0. 5 %, but it decreases when strain amplitude is lower than 0. 5 %

    在高溫低周疲勞下， gh4145 / sq合金的循環滯?能具有如下特徵：在1 0 . 5應變幅范圍內，循環總滯?能是一個逐漸增大的過程，而當應變幅小於0 . 5時，總滯?能隨應變幅減小而趨于減小；半壽命處的循環滯迥能和總滯?能與壽命之間的關系曲線表現出雙線性特徵，轉折點對應0 . 5應變幅。
  20. A poly - linear moment - rotation model is calculated according to this method, which could represent the moment - rotation relation of two kinds of angle connection

    採用該模型和其計算方法，建立了兩種角鋼連接的彎矩?轉角多折線模型。
分享友人
分享到 Line

分享到臉書