近距控制 的英文怎麼說

中文拼音 [jìnjùkòngzhì]
近距控制 英文
sensitivity time constant control
  • 近 : Ⅰ形容詞1 （空間或時間距離短） near; close 2 （接近） approaching; approximately; close to 3 （親...
  • 距 : Ⅰ名詞1 （距離） distance 2 （雄雞、雉等的腿的後面突出像腳趾的部分） spur （of a cock etc ）Ⅱ動詞...
  • 控 : 動詞1 （告發;控告） accuse; charge 2 （控制） control; dominate 3 （使容器口兒朝下 讓裏面的液體慢...
  • 制 : Ⅰ動詞1 （製造） make; manufacture 2 （擬訂; 規定） draw up; establish 3 （用強力約束; 限定; 管束...
  • 控制 : control; dominate; regulate; govern; manage; check; cybernate; manipulate; encraty; rule; rein; c...
  1. For quick truning to target of air - to - air missile ( aam ) for short range dogfight in large off - boresight it is necessary to study the agile turn control law

    摘要為了使近距格鬥空空導彈在大離軸角發射時能快速地轉向目標，需要研究快速轉彎控制律。
  2. Key about control of the captain moving closer to guns, there will be a white circle there, when the artillery pieces can operate ; the next key adjustment shelling distance, the space bar shooting

    左右鍵控制船長移動，接近大炮時，會有一個白色圓圈出現，此時該門大炮可以操作上下鍵調整炮擊距離，空格鍵射擊。
  3. The digital simulation based on this control law denotes that it possesses very well performance, and the interception ability of aam for short range in launching of large off - bore sight angle can be raised

    數字模擬表明，該控制律具有很好的性能，能使近距空空導彈在大離軸角發射時的截擊能力得到提高。
  4. Specification for low - voltage switchgear and controlgear for industrial use - inductive proximity switches - form c, for alternating current, 2 terminals

    工業用低壓開關設備和控制裝置規范. c型交流雙引線感應式近距離開關
  5. The source faults control oil gas accumulation and distribution in the research area : 1 ) the nearer to the source faults is, the higher the oil - gas accumulation degree is ; 2 ) the smaller fault displacement of the source fault is, the higher oil gas output near the source fault is

    源斷裂控制著貝爾凹陷布達特群油氣成藏與分佈，主要表現在距源斷裂越近油氣富集程度越高及斷距越小的源斷裂附近油氣產量越高2個方面。
  6. Taking the vr step motor as example in the paper, systemic research is conducted about the principle of the subdividing drive, the non - linearity relationship between microstep and phase current, the method of velocity adjusting and the interrelated factors. the system is designed to realize the subdividing drive, velocity adjusting and position. especially, there are two innovations in this paper. one is the first introduction of pld device and isp technology to the design of phase sequencer, the other is the new measure and amend method of microstep

    本文以三相反應式步進電機為實例，對細分驅動原理、細分驅動的非線性、變細分調速以及相關影響因素進行系統的研究；實現細分驅動器、調速控制、定位控制和軟硬介面的設計。在此基礎上，本文對細分驅動環形分配器的設計和微步距測量修正進行了創新；提出將pld器件和isp技術引入到細分驅動環形分配器的設計思想和錯位測量和逼近修正法。
  7. Benefited from the ceaseless development of information technology and control technique, research on grid - connected wind power generation has been in fast progress, with commercial application from several kilowatts up to more than one megawatts per unit, and category of controls from stall type to pitch regulation type up to the state - of - the - art varying speed type

    隨著計算機與自動控制技術的飛速發展，風力發電技術的發展極為迅速，其單機容量從最初的數十千瓦級發展到最近進入市場的兆瓦級機組；控制方式從基本的定槳距失速型控制向變槳距控制直到最新的變速控制發展。
  8. He finds the pitch range after calculated the three important parameters through the bladed for windows software, then presents an optimized control strategy that regulate the pitch angle in terms of the wind speed. it must control the output power because the variational output power brings the variational loads. he confirms and optimizes the control strategy that the output power is the control target, the output power is divided into three parts

    將功率作為系統控制的目標，將功率分成三段進行控制，在低風速區，載荷是有限的，以功率最大化作為控制目標；在額定風速附近，由於處在升力曲線斜率的變化點，功率變化較大，應盡快調整槳距角進入失速區工作，減少載荷的波動，該額定風速區的上下工作點要通過現場試驗的手段來確定；在額定風速以上，使功率維持在額定輸出，減少功率波動，並通過bladed軟體的模擬計算對控制策略進行了驗證。
  9. We prove theoretically that under certain reasonable assumptions the formation is asymptotically stable even wills bounded disturbances ; that is, the proposed sliding mode controller can asymptotically stabilize the errors in relative distance, relative bearing and heading direction, respectively

    在合理的假設下，從理論上證明了存在有界干擾情形下機器人編隊的漸近穩定性，即所設計的滑模控制器使得相對距離誤差、方位角誤差及運動方向誤差漸近穩定。
  10. With the mathematic model of tracking beam current by velocity, real - time tracking can be obtained ; with current simulation controlling transducer and subsection linearity, precision of velocity ( error in ? 1 % ) is triumphantly can be controlled ; with inspection of the pulse numbers of switches, the position of all vehicles are checked to eliminate the error of calculating distance between all ones

    通過建立速度跟蹤束流的數學模型，較好地解決了速度跟蹤束流的實時性問題;通過採取用電流模擬量控制變頻器和分段線性處理的辦法，成功地解決了速度精度問題（誤差在士1 %內） ;通過檢測接近開關觸發的脈沖數，適時校核所有小車位置，消除各車之間距離計算誤差，從而很好地解決了距離累計計算誤差。
  11. Gets or sets the minimum distance that must remain between the splitter control and the edge of the opposite side of the container or the closest control docked to that side

    獲取或設置拆分器控制項和容器（或停靠到離該側最近的控制項）另一側邊緣之間必須保留的最小距離。
  12. The parametric speed of the curve is firstly approximated by the bezier polynomial which takes the lengths of control polygon ' s edges of the direction curve of normal as bezier coordinates. then the corresponding geometric offset approximation algorithm is given. moreover, an offset approximation with high precision is obtained by degree elevation of the direction curve of normal

    首先利用以法矢方向曲線的控制多邊形邊長為b zier縱標的b zier多項式來逼近曲線的參數速度，給出了相應的幾何等距逼近演算法，進一步結合法矢方向曲線的升階獲得了高精度逼近
  13. Such conclusion is given : shorten the fresnel shu, shorten the obscuration ’ s area percent and shorten the equivalent diffraction distances will improve the optical quality. ( 4 ) the nonlinear paraxial equation is understood to analyze the n slabs ’ hot - image rule

    得出在高功率固體激光裝置中應縮小散射點的菲涅耳數和散射面積比，控制散射點的等效衍射距離，使散射點接近等效衍射距離為零，即像面的位置。
  14. Since the controller concerned did not positively apply vertical separation between the two aircraft or take prompt recovery action when they came close to each other, a loss of standard separation occurred

    由於控制員未有為兩架航機提供適當的高度間隔，或在兩機接近時立即採取糾正行動，因而導致這次標準距離出現偏差事件。
  15. In the article, i mainly analyzed the earning power ratios of four state banks with financial analysis method. referring to dupont financial analysis system and four state banks " financial data and main earning power ratios in 1998 - 2002, 1 analyzed the current status of their eaming power and those related factors, such as earning level of main business, structures of income and assets, operation fee management. then by comparison with other domestic stock banks and world ten top banks in tier one capital, assets, pre - tax profits, cost / income ratio and pre - tax profit per employee, i found that the four banks had advantages in scale and strength, but lagged far behind other banks

    本文主要採用財務分析的方法，在對四大國有獨資商業銀行近幾年總體的盈利指標進行分析后，借鑒杜邦財務分析體系，分別對四大銀行1998 - 2002年的財務數據和主要盈利能力指標進行趨勢分析，從主營業務的盈利水平、收入結構、資產結構、費用控制等方面分析了四大銀行盈利能力的現狀及其影響因素，並且通過與國內股份制銀行、世界十大銀行資本、資產規模、利潤、收益率、人均利潤等指標的比較，分析四大銀行的盈利能力在國內和國際銀行業中所處的水平，找出存在的差距。
  16. Through approximating the deformation space by using curve and surface offset techniques, we obtain a unified space deformation model. thus the sampling problem is solve naturally at the same time, we provide a unified kernel for the implementation of different space deformation models

    通過對曲線、曲面控制變形中的變形空間進行等距逼近的方法，我們實現了一個一維、二維、三維控制手段的統一空間變形模型，這種統一不但自然地解決了曲線、曲面控制變形中的采樣問題，同時為實現各種空間變形提供了一個統一的數學模型。
  17. Dilution and dispersion in constant horizontal flow and bottom multi - port discharging was studied in accordance with the hydraulic model test. the influence of diffusion parameters ( jet angle, jet velocity, number of nozzle, riser space ) and environmental parameters ( water depth, water velocity ) on dilution were analyzed. the experimental results show that environmental parameters have prominent effects on wastewater dilution and dispersion, in addition to that, diffuser design parameters have significant influence on wastewater dilution and dispersion. for bailonggang outfall zone, jet angel is 10 or so, nozzle number is 16 or so

    藉助於人工模型試驗，分析了恆定橫流底部多孔排放時擴散器設計參數（射流角度、射流速度、噴口個數） 、上升管間距）及環境參數（環境水深、環境流速）對污水近區稀釋擴散效果的影響，實驗結果表明，除了環境條件對污水稀釋擴散效果影響明顯之外，擴散器設計參數對污水的近區稀釋擴散也有顯著的影響，針對白龍港排放口水域，噴口射流角度宜控制在10左右，噴口個數取16個
  18. Studies on the methods for fiber tip fabrication and tip - sample distance controlling, which are vital for high quality snom imaging, were the research focus of the first part of the theses

    對近場光學顯微鏡而言，光纖探針制備與探針-樣品間距控制是保證成像質量的兩個關鍵因素。
  19. Medical electrical equipment - part 2 - 17 : particular requirements for the safety of automatically - controlled brachytherapy afterloading equipment

    醫用電氣設備.第2 - 17部分:自動控制近距放射治療后裝設備安全的特殊要求
  20. Medical electrical equipment - part 2 - 17 : particular requirements for the safety of automatically - controlled brachytherapy afterloading equipment iec 60601 - 2 - 17 : 2004 ; german version en 60601 - 2 - 17 : 2004

    醫用電氣設備.第2 - 17部分:自動控制近距放射治療后裝
分享友人
分享到 Line

分享到臉書