退出節點 的英文怎麼說

中文拼音 [tuìchūjiédiǎn]
退出節點 英文
exit node
  • 退 : 動詞1 （向後移動） retreat; draw back; move back 2 （使向後移動） cause to move back; remove; wit...
  • 節 : 節構詞成分。
  • 點 : Ⅰ名詞1 （液體的小滴） drop （of liquid） 2 （細小的痕跡） spot; dot; speck 3 （漢字的筆畫「、」）...
  • 退出 : withdraw from; bow out; secede; quit
  • 節點 : [電學] panel point; hybrid; packing; node; nodal points; joint of framework; pitch point; point pitch
  1. Based on measurement of strains of both horizontal stirrups in the joint core and longitudinal reinforcement passing througth the joint, in different stages, transfer mechanism and factors affacting seismic behavior of the joint, were analysed. under different shear compression ration, effect of axial force ratio on seismic behawior of the joint was also evaluated, static shear and seismic shear of the joint based on capacity design were investigated. on this basis, new governing criteria and conditions of seismic behavior of the joint were put forward

    通過對節點區水平箍筋以及貫穿節點梁、柱縱筋在不同受力階段應變的精細量測，對節點的傳力機理以及影響抗震性能的因素進行了分析研究；對不同剪壓比條件下軸壓比對節點抗震性能的影響規律進行了分析研究；對不同受力階段梁筋的粘結退化規律以及節點區的剪切變形進行了分析研究；對節點的靜力抗剪與建立在能力設計思路上的抗震抗剪問題進行了深入研究，提出了建立在新思路基礎上的節點抗震性能控制準則和控制條件。
  2. Mobile ad hoc network is a none - enter network, its chain between two nodes is implemented by several hops on other nodes. though any node is disabled or quit, there is not much trouble to the whole network

    移動adhoc網路是一種無中心的自組織網，它的節點之間的鏈路是靠在各個節點中進行多次中繼而實現的，任何一個節點的退出或失效都不會對網路造成比較大的影響。
  3. To completely avoid producing elements jointed at their corner nodes and checkerboard patterns, which frequently occur when the topology optimization of plane continuum is studied, the theory of topology analysis of plane continuum in topology optimization process and the simple algorithm for programming are studied. according to algebraic topology theory, the boundary of elements and plane continuum are operated as a one - dimensional complex. by use of the adjacency vector in graph theory, the structural topology is described and the topological operation is achieved on a computer. by above, the structural topological feature in the evolutionary process is gained. these methods are effcient and reliable. under topology constraints, according to the results of stress analysis, by deleting elements and moving nodes at the boundary, more satisfactory results can be gained by using a few numbers of elements and iterations. to demonstrate the efficiency of these methods, solutions including some well - known classical problems are presented

    避免目前平面連續體結構拓撲優化過程中經常出現的單元鉸接以及「棋盤格」等現象，研究了連續體結構拓撲優化過程的拓撲分析方法，以及在計算機上實現的簡便演算法.根據代數拓撲理論，單元及連續體的邊界作為1 -復形進行運算.利用圖論中的鄰接向量概念，在計算機上實現了結構的拓撲描述及拓撲運算，得到了結構在拓撲演化過程中的拓撲特性，方法簡單、可靠.在一定的拓撲約束下，根據應力分析結果，採用刪除單元、單元退化、移動節點等方法，可以用較少單元得到更為滿意的結果，提高計算效率.為演示方法的有效性，給出幾個包括常見經典問題的解答
  4. To exit the program, use your mouse to click the escape button on the side or use the esc key on your keyboard

    退出節目你用鼠標點擊按鈕的逃生方或使用鍵盤的esc鍵你
  5. Combined with the qos based initial route setup algorithms and destination node leaving algorithms, the qos guarantees for distributed multimedia dynamic group applications could be supported

    該演算法同初始路由建立演算法及目的節點退出演算法相結合，可以提供對分散式多媒體動態組應用服務質量保證的支持。
  6. ( 2 ) based on deterioration model of owerage bond stress of beam reinforcement accounting for effect of axial compression ration and number of displacement loops, and stress - strain relationship of the concrete in the joint core accounting for effects of both softening and confinement, the modified compression field theory was employed to simulate behavior of the joint core under loading reversals. analysis by means of the program jap on the tested specimens in this paper and those obtained from other researchers produced consistent results

    根據本文建立的考慮軸壓比和位移循環次數影響的梁筋平均粘結應力退化模型和考慮軟化效應、約束效應的核心區混凝土應力應變關系，通過在試驗中得出的節點核心區混凝土、箍筋、節點正面、背面柱筋在反復荷載下的受力特點，利用斜壓場理論模擬節點核心區在反復受力過程中的受力狀態。
  7. Finally, a graceful degradation method based on the fttcan protocol is put forward. on the basis of efficient sensor ability, a detailed implementation architecture of qos graceful degradation algorithm is designed, with the master node as the qos manager in the fttcan protocol

    最後，本文給出了一種基於fttcan總線協議的qos適度退化策略，在傳感器采樣能力較為充分的前提下，利用fttcan中的主節點作為qos管理器，對qos適度退化策略進行了具體化的設計。
  8. Behavior of the confinement mechamsm is also different. before obvious bond deterioration of the beam rebars passing through the joint core occurs, the shear is mainly transfered by the truss mechansim. when the bond deterioration occurs comprehensively, the shear transfered by the truss mechamism is reduced significantly, the majority of the shear is transfered by the diagonal strut

    當貫穿節點的梁筋未出現明顯的粘結退化之前，節點作用剪力主要通過街架機構傳遞，斜壓桿機構傳遞的剪力和約束機構發揮的作用較小；當梁筋全面出現粘結退化以後，行架機構傳遞的剪力明顯降低，作用剪力主要由斜壓桿機構傳遞。
  9. Then the essay proposes a p / s based 2 - level architecture qos communication solution in crcm, gives the critical technologies of this solution include the establish of the multicast group dynamic reliable mechanism and the node ' s join and leave. at last, the essay simulates and compares the c / s integrate scheme and p / s scheme, analysis the main parameter of the model

    然後針對鐵路管控系統，提出了一種採用p s兩級結構，廣域網環境下的qos通信解決方案，並給出了實現這一模型的幾個關鍵技術，包括：動態組播組的建立、可靠性機制、節點的加入和退出。
  10. If the node is the destination, we ' ve successfully finished ( quit )

    如果所在節點為目標點，任務成功完成（退出） 。
  11. Using the existed theories and methods of labeling on a planar object, all possible configurations of imperfect line drawing have been exhaustively studied, and it is found that imperfect line drawings are closely related to junction form. in a perfect line drawing, there are has just three lines belonged to every junction. but in an imperfect line drawing, there must be junctions which connect line numbers be not equal to three, that is more or less

    利用現有的平面立體線畫圖標記理論和方法，基於合理的節點標記形式，詳細分析了在存在多餘線和缺線的情況下線畫圖中節點的變化情況，把不完整線畫圖中存在的多線和缺線情況與節點形式緊密聯系起來，把判斷一個線畫圖中的缺線或多線轉化為判斷線畫圖中的節點是否為合法節點的問題，推出了在存在缺線的情況下合法節點的退化形式，提出了一種補全線的有效方法，並提出了一種判斷線畫圖中存在多餘線的方法。
分享友人
分享到 Line

分享到臉書