退火再結晶 的英文怎麼說

中文拼音 [tuìhuǒzàijiējīng]
退火再結晶 英文
annealing recrystallization
  • 退 : 動詞1 （向後移動） retreat; draw back; move back 2 （使向後移動） cause to move back; remove; wit...
  • 火 : fire
  • 再 : 副詞1 （又一次） another time; again; once more 2 （表示更加） still; further 3 （表示如果繼續怎...
  • 結 : 結動詞（長出果實或種子） bear （fruit）; form （seed）
  • 晶 : Ⅰ形容詞（光亮） brilliant; glittering Ⅱ名詞1. （水晶） quartz; （rock） crystal 2. （晶體） any crystalline substance
  • 退火 : [冶金學] anneal; annealing; back-out
  • 結晶 : 1 （析出晶體） crystallize2 （晶體） crystal 3 （成果） crystallization; fruit; product; quintess...
  1. A satificatory effect is obtained by rime annealing

    採用再結晶退火工藝處理，可取得滿意效果。
  2. Zircaloy - 4 sheet, which was cold - worked followed by recrystallization annealing, exhibits longer lcf life in the rolling direction than that in the transverse direction, and the fact that difference in lcf life between both directions becomes larger as the range of plastic strain becomes lower can be attributed to the texture effect, p - solution treatment deteriorates the alloy ' s lcf property because the treatment lowers the average value of alloy ' s schmid factors, and the subsequent annealing - treatment in a - phase range has a impact on the lcf properties, i. e. the subsequent annealing - treatment at 500 ? for 1. 5h results in better property than that at 750 for 1. 5h, which comes mainly from the fact that the alloy annealled at 500 for 1. 5h has lower amount of the precipitate particles than the alloy annealled at 750 for 1. 5h

    對于冷加工后經再結晶退火處理的zr - 4合金，軋制方向的低周疲勞壽命比橫向要大。隨著_ p的降低，兩個方向的低周疲勞壽命的差別相應增加，這是由於合金中存在織構的緣故。冷加工后經再結晶退火處理的zr - 4合金在固溶處理后，抗疲勞性能明顯降低，這主要是由於固溶處理降低了合金的schmid因子；固溶處理后在相區的退火對疲勞性能有影響，即500 1 . 5h退火的抗疲勞性能要優於750 1 . 5h退火，這主要與500 1 . 5h退火的合金中沉澱相粒子的數量較少有關。
  3. Low cycle fatigue ( lcf ) behavior of zircaloy - 4 has been reviewed in the present paper. then, the lcf behavior of a recrystallized zircaloy - 4 plate with different texture has been studied at room temperature and 400, respectively

    並在此基礎上，研究了不同溫度（室溫和400 ） 、不同取向（平行於軋向和垂直於軋向）的再結晶退火態zr - 4合金板材試樣的低周疲勞性能。
  4. Again, because the ion influx technique have a little damnification on the skin - deep structure for the cdte thin films, among the experiment, we have let the doped cdte thin films be annealed a hour with n2 atmosphere at 500, and then slowly cooled until the room temperature. via the test and analyse, heat treatment has very important effect on the comeback of crystallattice surface disfigurements. finally, the films were characterized by x - ray diffraction ( xrd ), scanning electron microscopy ( sem ), ultraviolet visible ( uv ) and the hall effect measurement

    再次，由於離子注入會對薄膜表面的結構造成損傷，本實驗把被注入離子的cdte薄膜在n2氣氛中500下退火1個小時，然後緩慢冷卻至室溫。經測試分析，熱處理對晶格表面缺陷的恢復有很重要的作用。最後，利用xrd 、 sem 、紫外可見分光光度計及hall測試系統研究其結構，表面形貌和光電性能。
  5. Recrystallization kinetics of the galvanized strip continuous annealing process with acceleration

    熱鍍鋅原板變速連續退火再結晶動力學
  6. The alloys, which were cold - worked followed by recrystallization annealing, display cyclic softening in the range of low strain because the cyclic stress - strain curve lies below the monotonic stress - strain curve, and show cyclic hardening in the range of high strain because the cyclic stress - strain curve lies above the monotonic stress - strain curve

    在低應變范圍，冷加工后經再結晶退火處理的錯合金的循環應力一應變曲線位於單調拉伸曲線的下方，表現為循環軟化;在高應變范圍則位於單調拉伸曲線的上方，表現為循環硬化。
  7. Experimental results revealed that the carrier mobility increased with increasing of the annealing temperature, in the range of the annealing temperature from 650 ? to 850 ?, which implied that the crystal lattice structure was damaged by ion implantation and restored after annealing. furthermore, the square carrier concentration decreased, and the square resistance of the samples implanted by mn + and c increased with the raising of annealing temperature. these results indicated that the second phase such as mnga, mnas ferromagnets was formed by more mn + ions with increasing of the ( gaas ) annealing temperature, so the mn + ions which can provide carriers decreased

    由實驗結果可以知道在退火溫度為650 850范圍內，樣品的載流子遷移率隨著退火溫度的提高呈上升趨勢，說明雜質元素的注入對樣品造成晶格損傷，但退火對這些損傷具有修復作用；此外，隨著退火溫度的上升，樣品的方塊載流子濃度不斷下降，加c樣品的方塊電阻不斷上升，這都是因為隨著退火溫度的提高，摻入的mn ~ +離子不再提供載流子，而是形成了mnga 、 mnas等磁性第二相。
  8. The formation of a new set of strain - free grains within a previously cold - worked material ; normally an annealing heat treatment is necessary

    在冷塑性變形材料的內部生成等軸狀新晶粒的過程叫再結晶，通常發生於再結晶退火熱處理過程中。
分享友人
分享到 Line

分享到臉書