退磁處理 的英文怎麼說

中文拼音 [tuìcíchǔlǐ]
退磁處理 英文
demagnetization treatment
  • 退 : 動詞1 （向後移動） retreat; draw back; move back 2 （使向後移動） cause to move back; remove; wit...
  • 磁 : 名詞1. [物理學] （磁性; 能吸引鐵、鎳等的性質） magnetism 2. （瓷） porcelain; china
  • 處 : 處名詞1 （地方） place 2 （方面; 某一點） part; point 3 （機關或機關里一個部門） department; offi...
  • 理 : Ⅰ名詞1 （物質組織的條紋） texture; grain （in wood skin etc ） 2 （道理;事理） reason; logic; tru...
  1. The laboratory group leader shall assign a person to clear recycling samples that are judged as cancelled or out of the storage life ; recycling piece samples shall be returned to the sintering procedure, demagnetized, and then after completion, reported for inspection according to the regular program ; any waste samples shall be sent to the keeper of the waste warehouse of the production workshop, and relevant delivery procedures need be handled by filling in the " form for disposal of samples "

    判定為報廢的和超出保留期限的回用品由實驗室組長安排人員對樣品進行清理，回用的塊狀樣品退回給燒結工序，進行退磁處理，完成後按正常程序重新報檢，廢品交送生產車間廢品庫管理人員，辦理交接手續需填寫「樣品處置單」 。
  2. Cleaning the sample judge as scrap and recycle which exceed save limit time by lab leader, recycle block sample return to sintering process for demagnetization, re - inspection according to normal process after complete, the scrap deliver to production warehouse supervisor handing and fill in “ sample disposal form ”

    判定為報廢的和超出保留期限的回用品由實驗室組長安排人員對樣品進行清理，回用的塊狀樣品退回給燒結工序，進行退磁處理，完成後按正常程序重新報檢，廢品交送生產車間廢品庫管理人員，辦理交接手續需填寫「樣品處置單」 。
  3. By sims method, we analyzed the profile distribution of mn and c, found that increasing the annealing temperature is beneficial to the diffusion of mn, but has no influence to c. mfm and squid measurements demonstrate that sub micron single - domain magnetic mnas particles found in sample annealing at 850 for 15s show ferromagnetism at room temperature and have a high curie temperature more than 300k

    利用二次離子質譜方法對mn和c在樣品中的分佈進行了研究，發現退火溫度的上升，有利於mn的擴散；而對c的分佈影響較小。利用磁力顯微鏡和超導量子干涉儀對樣品的磁性質進行了研究。發現在850 + 15s退火處理的樣品中形成了亞微米級單疇磁性mnas粒子；經測試其在室溫下呈現出鐵磁性，居里溫度在300k以上。
  4. The results showed that the microstructure of as - deposited tbdyfe ii 1ms were amorphous and the crystal of tbfe2 were found in films after annealing at 500. annealing films in vaccum could improve the saturation magnetization ms and the susceptibility, decrease the coercivity and the saturaion field, and make the direction of the magnetic moments parallel to the film plane

    結果表明，制備態薄膜為非晶態結構，經過500真空退火熱處理后，薄膜出現了tbfe _ 2的結晶物，薄膜的矯頑力和外場的飽和磁場大大降低，飽和磁化強度增強，初始磁化率提高，易磁化軸轉向膜面。
  5. X - ray diffraction results revealed that the structure of as - deposited smco film was amorphous and crystallization happened after the films annealed at 500 in vacuum. the magnetic tests of smco thin films showed that its coercivity reduced with the increase of film ' s thickness while the ratio of mr / ms was opposite. the films " coercivity and mr / ms declined after it annealed at 500 because the machanism of magnetization were changed from domain wall nailing into magnetic nuclear forming

    研究結果表明，由於雜質fe的摻入降低了smco薄膜的磁性能；制備態smco薄膜為非晶態結構，矯頑力hc隨著薄膜厚度的增加而減小，剩磁比mr ms隨膜厚增加而增加；經過500真空退火熱處理后，薄膜出現smcos的結晶物，矯頑力hc降低， mr ms減小，磁化機制由疇壁釘扎類模型轉為形核類模型。
  6. In this paper, the effect of heat treatment on the magnetic properties of s s fibers was studied

    對不銹鋼纖維進行退火處理，以探索材料成分、熱處理工藝與相結構和纖維磁性能的關系。
  7. This paper has first summarized the experiment of granular film and theoretical research progress and the present major problem to be solved, has discussed the purpose meaning of this paper on this foundation, has introduced us soon afterwards with magnetic metal - non - magnetic metal material adopt for studying object to co - vapored deposited system such as the fexcu1 - x of different fe content x granular film sample, carrying out annealing handling for some of samples, using x ray diffraction instrument xrd ), scanning electrical microscopic ( sem ), vibrating sample magnetometer ( vsm ) the tiny structure for sample, appearance and the magnetic result that can carry out detection

    本文首先綜述了顆粒膜的實驗和理論研究進展情況和目前待解決的主要問題，在此基礎上論述了本文的目的意義，隨后介紹了我們以磁性金屬?非磁性金屬材料為研究對象，採用共蒸發法制備不同fe含量x的fe _ xcu _ （ 1 - x ） ，顆粒膜樣品，對部分樣品進行退火處理。給出了用x射線衍射儀（ xrd ） 、掃描電鏡（ sem ） 、振動樣品磁強計（ vsm ）對樣品的微結構、形貌及磁性能進行檢測的結果。
  8. The relationship between sputtering conditions and the depositional speed shows : with working pressure 1. 2 pa, sputtering power 180w, the depositional speed of tio2 thin film is 40nm / h, and increases with the increasing of sputtering power. it can be also founded that the depositional speed is nearly proportional to the working pressure : within the range of 0. 3pa to 1. 6pa, the depositional speed increases linearly with the increase of ar pressure. with the enhancement of the substrate ' s temperature of sputtering or annealing, the resulted thin films show a tendency of decreasing in thickness, and increasing in refractivity

    本實驗是採用磁控濺射方法，在不同的溫度下制備了tio _ 2薄膜，並對薄膜進行了不同溫度和時間的退火處理，通過原子力顯微鏡（ afm ） 、 x射線衍射（ xrd ） 、掃描電鏡（ sem ）等檢測手段對薄膜的表面形貌和組成結構進行了分析，結果如下： （ 1 ）濺射工藝條件與薄膜沉積速度的關系表明：採用1 . 2pa工作氣壓， 180w的射頻功率tio _ 2薄膜的沉積速率為40nm h ，並隨射頻功率的增加而提高，呈近似的線性關系，在0 . 3pa 1 . 6pa氣壓范圍中，氬氣壓強升高沉積速率迅速增加，濺射溫度提高和退火處理能使薄膜的厚度減小和折射率提高。
  9. For example, the furnaces can be used for quenching of high - speed steel, mould steel, alloy structure steel, bearing steel, elastic alloy etc, sintering and annealing of magnetic materials, and so on

    其它熱處理工藝根據用戶要求實例：高速鋼模具鋼合金結構鋼軸承鋼彈性合金等材料的淬火，以及磁性材料的燒結退火等。
  10. In this paper, we implanted mn + ion of different dose into undoped semi - insulating ( 100 ) gaas substrate then performed rapid thermal annealing in different temperature and time. studied the different annealing condition dependence of the samples " structure, electrical and magnetic properties and the relation of the mn + forms and these properties

    本課題採用離子注入的方法將不同劑量的mn ~ +注入到非摻雜半絕緣（ 100 ） gaas單晶襯底中，然後進行不同溫度和時間的快速熱退火處理，研究了不同的退火條件對樣品注入層的晶體結構、電特性和磁特性的影響以及mn ~ +在樣品中的存在狀態與這些性質之間的關系。
  11. It has been found that a preferable orientation can be obtained while both the smco5 phase and the sm2co17 phase have deposited plenty in the two - steps heat treatment

    而合適的兩級退火熱處理能使smco5和sm2co17永磁相充分析出，並形成一定的擇優取向，從而可以顯著提高薄膜的矯頑力。
  12. Analyses showed that the effect of heat treatment is remarkable to 304 stainless steel fibers. and a new martensitic phases formed, and ms increased during annealing at 180c ; annealing above 180c decreased the ms. after annealed in the range of 380c ~ 440 c, the he increased and the product ( mr hc ) improved. it was also shown that annealing affected the mechanical properties of 316l ss fibers obviously

    304不銹鋼纖維在180附近退火處理其ms略增加，其內部相變與一般的304不銹鋼體材料存在差別； 380 440區間退火處理，其矯頑力急劇增加、磁能積參數配合比較好；退火熱處理對316l不銹鋼纖維的力學性能作用明顯。
  13. The better magnetostriction of tbdyfe thin films was 120x 10 - 6 in 100ka / m and 240 x 10 - 6 in 330ka / m the research on the magnetostriction of smco / tbdyfe bilayer films indicated that smco thin films could improve the magnetostricion of tbdyfe thin films effectively through improving its saturation magnetization ms and susceptibility

    退火熱處理和襯底粗糙度的降低有助於薄膜磁致伸縮性能的提高。對smco tbdyfe復合薄膜磁致伸縮特性的研究表明， smco薄膜的復合能提高磁致伸縮薄膜的磁化率和飽和磁化強度從而提高tbdyfe薄膜磁致伸縮性能。
  14. The results of gmr testing indicate that the gmr effect is much little in the assputtered films, but they will be enhanced after vaccum annealling in magnetic fileld. and we also found that the thickness of the films and the

    磁阻性能測試結果表明，沉積態薄膜的磁阻性能微弱甚至沒有，經過真空磁場熱處理后的薄膜磁阻性能明顯得到提高，並且薄膜厚度與退火溫度均對薄膜的巨磁阻性能有重要影響。
分享友人
分享到 Line

分享到臉書