連接結 的英文怎麼說

中文拼音 [liánjiējiē]
連接結 英文
joining knot
  • : Ⅰ動詞1 (連接) link; join; connect 2 (連累) involve (in trouble); implicate 3 [方言] (縫) ...
  • : Ⅰ動詞1 (靠近;接觸) come into contact with; come close to 2 (連接; 使連接) connect; join; put ...
  • : 結動詞(長出果實或種子) bear (fruit); form (seed)
  • 連接 : connect; fit together; link; marry; mate; joint; association trail; linkage; concatenate; concate...
  1. The most commonly used joint configurations are the lap, scarf, and butt joints.

    最常用的連接結構是搭,嵌和平
  2. Ambiguity analysis on the basis of junction and nexus

    基於連接結構和主謂構的歧義分析
  3. Full floater technology connects the rear shock mounts to two moving linkages - the evo link on the top, and the extension of the swingarm at the bottom

    全漂移技術將後防震架與兩個移動的連接結合起來evo位於頂部,搖臂擴展位於底部。
  4. Body / bonnet joints on pacific valves are designed for rugged services with a more than adequate number of bonnet bolts

    美國太平洋閥門上的閥體/閥蓋連接結構適用於惡劣的應用環境,可配置足夠數量的閥蓋螺栓。
  5. Laboratory data communication - part 1 : point - to - point connection with rs - 232 ; physical arrangements

    實驗室數據通信.第1部分:用rs - 232進行點對點.
  6. The following conclusions are gained : ( 1 ) the located shear band prongs the ligament near the top crack tip and the structure may occur shear - mode fracture at the angle of 155 ? to crack when load is 87. 92mpa ; the mode of fracture of the flange joint structure is not possible to be void - mode ; ( 2 ) it is proved that loading and then unloading repeatedly can not increase the possibility of invalidation of the structure when the times of loading and unloading are not too more when load is operating pressure ; the structure is safe when the vessel is operating ; ( 3 ) in the fe model of the thesis, not considering the influence of water pressure test which is in the process of fabrication of vessel in fe results in larger deviation in analysi

    得出了以下論:在8792mpa的載荷下筒體一封頭連接結構處的集中剪切帶貫穿韌帶,可能發生沿與原裂紋線成155 「角方向剪切型斷裂;筒體一封頭連接結構不可能發生韌窩型斷裂; ( 2 )在工作壓力下進行次數不多的反復加、卸載,構不會破壞,也不會喪失安定性:構在工作狀態下是安全的; m在本文的彈塑性有限元模擬計算中,對于裂紋尖端進行力學分析時,不考慮壓力容器製造過程中水壓試驗的影響,將導致計算果出現較大的偏差; ( 4 )筒體完全屈服時的載荷為92石3mpa ,封頭完全屈服時載荷為86
  7. Coupling dimensions of suspension insulators for high voltage lines

    高壓線路懸式絕緣子連接結構和尺寸
  8. Finger jointed structural timber - performance requirements and minimum production requirements

    指形連接結構木材.性能要求和最低生產要求
  9. Acoustics - characterization of sources of structure - borne sound with respect to sound radiation from connected structures - measurement of velocity at the contact points of machinery when resiliently mounted

    聲學.關于由連接結構產生噪聲輻射的構載振動噪聲源的特性描述.機械裝置彈性觸點聲速測量
  10. In this dissertation : the advance of the attachment of the metallic tps is reviewed, including the history and development home and abroad and so on

    本文內容主要如下:對金屬熱防護系統連接結構的研究現狀進行了分析,包括金屬熱防護系統的發展歷史,國內外研究現狀等。
  11. As an important part of metallic tps, the attachment must be strong enough to transfer mechanical load to the substructure and at the same time not much heat quantity

    連接結構是金屬熱防護系統的重要的子部件,要求其在傳遞力學載荷同時,不能向機體傳遞過多的熱量,對其研究具有重要意義。
  12. Continuous queries processing by sharing intermediate join results

    共享連接結果的續查詢處理
  13. The story suggests that the only way for ugly girls to get through is plastic surgery. inner beauty is not valued at all. all that matter is a pretty face

    不過劇情發展到中後段漸漸失控,四女求救于怪醫的部分不及預期有趣,后來的軟禁戲更是情理都不能局令人失望。
  14. At the same time, this allows for a more direct connection to the engine, resulting in less slip - loss - which ultimately leads to higher fuel economy

    同時,這考慮了更多的與發動機直果是減少了滑差? ?最終導致了燃油經濟性的提高。
  15. For example, a database connection for a particular unit test might record the query while always returning the same hardwired result

    例如,雖然某一特定單元測試的數據庫始終返回相同的硬連接結果,但可能會記錄查詢。
  16. 16mnr and 45 # steel are taken as examples. the obtained results have been applied to analyze the safety of operation pressure and rationality of design of a kind of engineering structure - a flange joint of hemispherical head to cylindrical shell. try to seek a sort of new method to assessment the capability of structure to load beyond the traditional method which regards stress and strain as main parameters

    本文以45 ~ #調質鋼和壓力容器常用鋼材16mnr為研究對象,對金屬材料韌性斷裂的斷裂模式進行細觀機理上的研究,進而分析一種工程構? ?採用與筒體厚度不同的半球形封頭的壓力容器的筒體連接結構? ?的靜載變形特點和破壞形式,嘗試在以應力應變為主要參數的傳統方法之外,尋求一種新的構承載能力分析的方法。
  17. Construction manufacturing and verification requirement of terminal box flexible connection for explosion proof motor

    防爆電機線盒軟連接結構製造檢驗暫行規定
  18. Once local repositories are created and connected to a task using a connector tool, the business item is usually associated with the connection

    一旦創建了局部存儲庫,並且使用工具到一項任務,該業務條目通常就會于連接結合起來。
  19. Check ring joint ( crj ) structure was utilized in uspg

    卡環式連接結構被應用於水下夾樁器。
  20. A ball and socket attachment structure

    一種球鉸式連接結
分享友人