進氣管壓力 的英文怎麼說

中文拼音 [jìnqìguǎnyālì]
進氣管壓力 英文
manifold pressure
  • 進 : 進構詞成分。
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 管 : Ⅰ名詞1 （管子） pipe; tube 2 （吹奏的樂器） wind musical instrument 3 （形狀似管的電器件） valve;...
  • 壓 : 壓構詞成分。
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 氣管 : air tube; windpipe; trachea; weasand; tracheal sac氣管病 tracheopathy; tracheopathia; 氣管切開術 ...
  1. Bmap barometric and mainfold absolute pressure

    大氣進氣歧管絕對壓力
  2. This paper research the mining press the meaning of the spirit system with the principle of basic theories and superior, application that press the windpipe net to compute the analysis method of the system theories, press the present condition of the spirit system to proceed to investigate the research to old factory tin mine of company of yunnan tin industry group, minimum tree principle within " diagram theories " of key problem, adoption that find out the esse, right pressed the windpipe net to proceeds the superior

    本文闡述了研究礦山壓氣系統的意義和壓氣管網計算的基本理論及優化原理，並運用運籌學的分析方法，對雲南錫業集團公司老廠錫礦壓氣系統的現狀進行了詳細的調查研究。針對目前老廠錫礦壓氣系統存在的管網長、漏氣多、壓力損失大等主要問題，採用「圖論」中最小樹原理，對壓氣管網進行了優化研究。
  3. Before intervening in any circuit which has a gas filled pressure vessel, the pressure must be discharged from the circuit

    當管道與充有壓力氣體的容器連接時，如果需要對任何管線進行操作，必須先將管線中的殘余壓力進行釋放。
  4. Our factory mainly manufactures hydraulicfllfers, filter oil vehicles, hydraulic air cleaner, liquidlevel gage and liquid thermometer, liquid level control relay, switch of manometer, combined sealing washer, piezometer soft tebe assembly, andso on. we also carry on all kinds of non - standard, and bring in filters, air cleaner, liquid - level gage and liquid thermometer and complete set of design and manufacture of hydraulic system

    本廠主要生產各類液壓過濾器、濾油車、液壓空氣濾清器、液位液溫計、液位控制繼電器、壓力表開關、組合密封墊圈、測壓軟管總成、塑料管夾等產品，還承接各類非標、引進過濾器、空氣濾清器、液位溫計及成套液壓系統設計與製造。
  5. Specification for manifold pressure gauges for aircraft

    飛行器用進氣管壓力表規范
  6. On top of one of the fast - opening ends that closed to the pig receiver & launcher shall assemble vent valve, safety valve and pressure gauge, and at the bottom shall assemble drain valve, sideway inlet and vent valve to take out medium from the main pipe as the power of forcing pig and conveyance medium

    靠近收發球筒快開盲板一端上部應設防空閥、安全閥及壓力表、下部設排污閥、側面設進、出油（氣、水）閥，以便從干管中取介質作為驅動清管器的動力及輸出介質。
  7. In this paper, thermal evolution history of organic matter of the source rocks and hydrocarbon generation history have been researched by tti method, hydrocarbon migration direction and migration times were probed combining with the area structure development feature ; distribution pattern of the main reservoir intervals on lateral and longitudinal have been predicted by researching on development feature and control factors of the reservoir intervals, the actions of reservoir conditions in hydrocarbon accumulation and bearing also were probed combining with pore evolution feature ; the micro - pore feature of regional cap and direct seal in carboniferous - lower triassic in this area have been determined with micro - capillary pressure curve and intrusive mercury curve ; the prospecting districts have been pointed out combining with the hydro - geologic feature, the potential reservoirs were classified according to trap types in this area, the author attempt to evaluate on the hydrocarbon - bearing condition in the str ata of carboniferous ~ lower triassic from hydrocarbon generation and migration reservoir condition, reserved condition etc, and predict the reservoir types and hydrocarbon - bearing patterns combining with the structure evolution. based on above, the author point out that the central block of chenghu - tuditang synclinorium and the southern block of dangyang synclinorium are the advantageous regions for exploration

    本文用tti方法研究了烴源巖有機質的熱演化史和油氣生成史，並結合區內構造發育特徵，探討油氣在區域上的運移方向和在時間上的運移期次；通過對儲集層段的發育特徵和控制因素的研究，預測了本區主要的儲集層段在橫向上和縱向上的分佈規律，並結合孔隙演化特徵，探討儲集條件在油氣聚集成藏中的作用；利用微毛細管壓力曲線法和壓汞法，對石炭系?下三疊統的區域蓋層和直接蓋層的微孔隙特徵進行了定量評價，並結合水文地質分佈特徵，指出有利於油氣保存的地區；根據區內存在的各種圈閉類型，對可能存在的油氣藏進行了分類，並試圖從油氣的生成與運移、儲集條件、保存條件等方面，動態地綜合評價石炭系?下三疊統油氣成藏條件，並結合構造演化特徵，預測其油氣藏類型和成藏模式。
  8. It is studied that the formation mechanism of taylor bubble and its control method in gas - liquid two - phase flow, which affects the pressure balance and mechanical driving efficiency in the flow of petroleum engineering. experiments show that the formation of taylor bubble in gas - liquid two - phase flow is due to the intensive congregation and amalgamation of small bubbles driven by void fraction waves and that the highly turbulent flow is able to restrain this formation. thus, the flow regime transition may be checked by increasing the flow turbulence and controlling the disturbed frequency

    對大管徑氣-液兩相流動中嚴重影響壓力平衡與機械驅動效率的段塞流生成機制和控制方法進行了研究，實驗證明段塞流的形成是由於空隙率波的大幅度增長使氣泡高度集中，並形成聚並所致。強湍流運動可以抑制taylor泡的形成。因此，通過強化湍流或控制擾動頻率可以對氣泡聚並起明顯的抑制作用。
  9. In order to improve the prediction accuracy, the sensitivities of pipe friction coefficients, pressure loss coefficients in bents, wall temperatures and heat transfer coefficients in pipes and cylinders on the volume efficiency are investigated

    為提高充氣效率的計算精度，由模擬計算和相關試驗，分析了管道的摩擦系數、彎管的壓力損失系數、進氣管壁和氣缸壁溫度及其傳熱系數對充氣效率的影響程度。
  10. The results show that the heat transfer in intake manifold and cylinder has obvious effects on the volume efficiency, while the pipe friction coefficients and bent pressure loss coefficients have less effect

    結果表明，進氣管和氣缸的傳熱對充氣效率的影響較顯著，而管道摩擦系數和彎管壓力損失系數對充氣效率的影響較小。
  11. An engineer case is introduced, which is about " the reconstruction of high voltage fan ' s speed - adjusting by frequency conversion and the design of plc ( programmable logic controller ) control system in shui cheng iron and steel company ". in this project, an advanced controlling technology, based on the method in this paper, is used to realize the closed loop control of discharge header pressure of two coke ovens

    介紹「水鋼煤焦化公司鼓風機高壓變頻調速及系統plc控制改造」的工程概況，對煤氣鼓風機採用先進的變頻調速技術和計算機控制技術進行改造，實現對兩座焦爐集氣管壓力自動調節的閉環控制功能，既滿足了煤氣量的自動調節的要求，又避免了煤氣鼓風機出口閥門的節流調節，節能效果相當可觀。
  12. Map manifold aabsolute pressure sensor

    進氣歧管壓力傳感器
  13. Mpc manifold pressure control

    進氣歧管壓力控制
  14. This paper investigates the structural parameters of air inlet pipe, air compensating pipe and air compensating valve which influence the air compensation of air compensating valve for motorcycle catalytic converter, the position of air compensating hole, and the relationship of air compensating pressure with engine speed

    本文就影響摩托車催化轉化器補氣閥補氣量的進氣管、補氣管、補氣閥的結構參數，以及補氣孔的位置、補氣壓力隨轉速的變化關系等進行了探討。
  15. Then the paper also study the atomizer structure ( the protrusion of the delivery tube value h ), atomizing gas pressure p, over - heat temperature of alloy a t, the component of solder alloy and atomizing medium and so on

    進一步對霧化器結構（導液管突出高度h ） 、霧化氣體壓力p 、合金過熱度t 、焊錫合金成份和霧化介質進行了研究。
  16. The size of the nanoparticles prepared with the flow - levitation method can be controlled by controling the gas pressure in the action tube, the velocity of cooling gas flow and the temperature in the melt metal globule

    自懸浮定向流方法制備納米鋁粉和銅粉的過程中，通過控制反應管內的氣體壓力、冷卻氣體的流速、熔球的溫度等因素可以對粉體的尺寸分佈進行控制。
  17. When the inlet valve opens, a pressure pulse is generated in the air inlet pipe, which is damped as the piston continues to move. when the inlet valve closes, another pressure pulse of certain duration is generated, thus giving rise to a periodic inlet noise

    當進氣門開啟時，在進氣管中產生一個壓力脈沖，而隨著活塞的繼續運動，它受到阻尼；當進氣門關閉時，同樣產生一個有一定持續時間的壓力脈沖。
  18. Fault description ( reason ) : high voltage detected at intake manifold pressure sensor signal pin

    故障描述（原因） ：檢測到進氣歧管壓力傳感器信號電壓值高。
  19. Based on analyzing the influence factors and coupling relations of coke oven gas collector, pid control, decoupling control and expert control are used to control gas collector pressure

    摘要集氣管壓力的穩定影響焦炭的質量和焦爐的壽命，通過分析焦爐集氣管壓力影響因素及其耦合關系，採用pid控制、解耦控制、專家控制來進行集氣管壓力的控制。
  20. In this paper, based on the gas collector pressure control system of the no. 1 ~ no. 4 coke oven in the coking plant, xiantan iron and steel company, the theory of single neuron adaptive pid control is researched, mainly in its algorithm and the algorithm modification. a perfect control performance is obtained after the improved algorithm is applied in the gas collector pressure control system

    本文以湘鋼焦化廠的1 # 4 #焦爐集氣管壓力控制系統的開發為背景，對單神經元自適應控制理論進行研究，著重研究了單神經元自適應pid控制器的設計以及對演算法的改進，並把改進后的控制器應用到焦爐集氣管壓力控制系統中，取得了良好的控制效果。
分享友人
分享到 Line

分享到臉書