進氣管預熱 的英文怎麼說

中文拼音 [jìnguǎn]
進氣管預熱 英文
efe early fuel evaporation
  • : 進構詞成分。
  • : Ⅰ名詞1 (氣體) gas 2 (空氣) air 3 (氣息) breath 4 (自然界冷熱陰晴等現象) weather 5 (氣味...
  • : Ⅰ名詞1 (管子) pipe; tube 2 (吹奏的樂器) wind musical instrument 3 (形狀似管的電器件) valve;...
  • : Ⅰ副詞(預先; 事先) in advance; beforehand Ⅱ動詞(參與) take part in
  • 進氣 : air admission; admission; inlet; onflow; charging; access of air; admittance; air in; air intake;...
  1. Firstly, simulate flow field of rear smoke channel, plot velocity magnitude and ash concentration distribution in section of entry of heat pipe air preheater, compare with data which were measured in guiyang power station, verify simulation to be reasonable and right. secondly, simulate all kinds of factors which affect flow field ' s uniformity such as length, thickness, location of diffluent board, ash concentration, ash diameter, and so on, find the chiefly factors. thirdly, install guide board in curve channel in rear smoke channel, then simulate its " flow field, plot velocity magnitude and ash concentration distribution

    在此基礎上模擬在冬夏兩季不同情況下,不同流速對器壁面溫度的影響;然後對影響整個流場分佈的各種因素:包括分流板長度、厚度、偏離中心流道位置的偏離度、飛灰濃度、飛灰粒徑等因素行數值模擬;最後提出在分流煙道轉彎處加裝導流板,並模擬加裝導流板后的流場分佈,得到下級空器出口、口處的斷面速度場分佈、濃度場分佈,以論證加裝導流板能達到流場均勻化的作用。
  2. In this paper, thermal evolution history of organic matter of the source rocks and hydrocarbon generation history have been researched by tti method, hydrocarbon migration direction and migration times were probed combining with the area structure development feature ; distribution pattern of the main reservoir intervals on lateral and longitudinal have been predicted by researching on development feature and control factors of the reservoir intervals, the actions of reservoir conditions in hydrocarbon accumulation and bearing also were probed combining with pore evolution feature ; the micro - pore feature of regional cap and direct seal in carboniferous - lower triassic in this area have been determined with micro - capillary pressure curve and intrusive mercury curve ; the prospecting districts have been pointed out combining with the hydro - geologic feature, the potential reservoirs were classified according to trap types in this area, the author attempt to evaluate on the hydrocarbon - bearing condition in the str ata of carboniferous ~ lower triassic from hydrocarbon generation and migration reservoir condition, reserved condition etc, and predict the reservoir types and hydrocarbon - bearing patterns combining with the structure evolution. based on above, the author point out that the central block of chenghu - tuditang synclinorium and the southern block of dangyang synclinorium are the advantageous regions for exploration

    本文用tti方法研究了烴源巖有機質的演化史和油生成史,並結合區內構造發育特徵,探討油在區域上的運移方向和在時間上的運移期次;通過對儲集層段的發育特徵和控制因素的研究,測了本區主要的儲集層段在橫向上和縱向上的分佈規律,並結合孔隙演化特徵,探討儲集條件在油聚集成藏中的作用;利用微毛細壓力曲線法和壓汞法,對石炭系?下三疊統的區域蓋層和直接蓋層的微孔隙特徵行了定量評價,並結合水文地質分佈特徵,指出有利於油保存的地區;根據區內存在的各種圈閉類型,對可能存在的油行了分類,並試圖從油的生成與運移、儲集條件、保存條件等方面,動態地綜合評價石炭系?下三疊統油成藏條件,並結合構造演化特徵,測其油藏類型和成藏模式。
  3. Although the accuracy in meterological forecast of tropical cyclones has been distinctly improved, it is still a difficult problem confronting masters and anti - typhoon team leaders of the companies how to steer clear of typhoon reasonably and safely in case that the actual resistance to typhoon is strong enough, the sea area wide enough, and the time permitting ; to avoid unreasonable deviation, anchoring for shelter, blindly rushing onto her path, being involved in storm area, even into the the center of typhoon ; under the limitation of the condition of the sea area and time. how to take correct meassures to escape, such as navigating with wind or windward in bias angle, slowing down, anchoring, berthing alongside the warf, mooring to buoy, etc. as early as possible

    象部門對旋監測報的準確率已經比過去有了明顯的提高,然而船舶在海上如何避離臺風,如何做到在本船實際抗風能力允許、海域條件允許、時間也充裕的前提下合理避臺,安全避臺,避免不合理的繞航、 「扎風」 ,避免盲目冒「搶風頭」 ,更避免被捲入強風區甚至臺風中心;在海域條件受限、時間尷尬的情況下又如何正確採取偏順航、偏頂航、滯航、錨泊、系岸、系浮等抗臺措施和技術,盡快擺脫臺風的影響,仍然是擺在船長和公司防抗臺領導小組面前的一個實實在在的難題。
  4. 2. design scheme of gravity heat pipe air pre - heater is proposed which fits the actual situation of injecting steam boilers. detailed heat calculation and design on heat recovery of flue gas is carrying out

    提出了採用適合於注汽爐實際工況的重力式空器的設計方案,對煙的余回收行了詳細的力計算和設計。
  5. In the end, the paper makes an thermodynamic analysis, evaluation of investment and techno - economic analysis on the retrofit plans of heat recovery steam generator and air pre - heater, which helps to make the evaluation of the plans from the view of energy conservation and economy benefit

    完成布置設計和設備細部結構設計,繪制余回收設計圖紙。最後對所設計的余鍋爐和空器方案力學分析、投資概算和技術經濟分析,從節能和經濟性角度評價了設計方案的效益。
  6. This thesis focuses on the overall optimal design of pipe parts and head pipe exchanger. an example is also presented to stand for the typical heat pipe heat exchanger ( that is, head - pipe air pre - heater ). the specific details and methods are introduced in the integrated optimal design and the optimal selection for head pipe heat exchangers

    本課題就是要針對這一問題,對元件及器整體優化設計行研究,以- - -器中典型代表- - -器為例,利用最優化理論,提出了對其行整體優化設計的方法。
分享友人