進氣門定時 的英文怎麼說

中文拼音 [jìnqìméndìngshí]
進氣門定時 英文
intake valve timing
  • 進 : 進構詞成分。
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 門 : Ⅰ名詞1 （房屋、車船等的出入口 ） entrance; exit; door; gate 2 （形狀或作用像門的東西） switch; va...
  • 定 : Ⅰ形容詞1 （平靜; 穩定） calm; stable 2 （已經確定的; 不改變的） fixed; settled; established Ⅱ動詞...
  • 時 : shí］Ⅰ名1 （比較長的一段時間）time; times; days:當時at that time; in those days; 古時 ancient tim...
  • 進氣 : air admission; admission; inlet; onflow; charging; access of air; admittance; air in; air intake;...
  1. Between the infantry and the cavalry the artillery, in a long line of polished, shining cannons quivering on their carriages, crawled slowly by with their heavy, brazen sound, and their peculiar smell from the linstocks, and ranged themselves in their places

    時而可以看見炮隊拉長了距離，一門門擦得閃閃發亮的大炮在炮架上顫動著，可以聽見銅件震動的響聲，可以聞見點火桿散發的氣味，炮隊在步兵和騎兵之間爬行前進，在指定的地點拉開距離停下來。
  2. Because the monitoring of electricity equipment is still in the condition of traditional prophylactic test ( monitoring off line ), wordage list and management method of handwork operation, to strengthen the real - time monitoring of the operation state of electricity equipment ( monitoring on line ), find out the anomaly of equipment, monitor and analysis the fault, then take a corresponding measures to lower the fault loss so that we can make the transition between the regulations of periodic repairing equipment and the regulations of reasonable state repair, is the work which the department of power supply and operation make much of

    針對對現有電氣設備的監測大都還處于傳統的預防性試驗（離線監測） 、文字報表、手工操作的管理方式的現狀，加強對電力設備的運行狀態進行實時的監測（在線監測） ，及時發現設備的異常徵兆、對故障進行診斷分析，並採取相應措施，把故障損失降低到最低水平，進而將目前實行的設備定期檢修制過渡到更為合理的狀態檢修制，一直是供電和運行部門十分重視的工作。
  3. In this experiment, adjusting the throttle to the specific position, and letting engine rotary speed change from the lowest to the highest, at the same time, the data of the water temperature, the fuel temperature, the air press and the rotary speed can be noted. moreover, we can measure the fuel quantity and the ignition angle

    實驗中，調節節氣門在特定位置，並讓發動機的速度依次從最低變化到最高，同時記錄水溫、油溫、進氣壓力和轉速等數據，還可以測出相應的噴油量、點火提前角。
  4. While according to dynamics correction method, the valve displacement curve has to be design, which can be acquired by boundary condition and calculation method. then by dynamics analysis, the tappet displacement curve equation can be obtained based on the dynamics differential equation. thus, the design of cam profile can be carried out based on the tappet displacement curve equation

    按照動態設計的動力學修正方法進行設計時，又得先進行氣門升程曲線的設計，利用一定的邊界條件和計算方法得到氣門確定的運動規律，再通過動力學分析，根據建立的動力學微分方程，經過計算得到挺柱的升程曲線方程，至此，就可以根據挺柱的升程曲線進行凸輪輪廓曲線的設計。
  5. Based on advanced technology, this thesis bring forward the optimal scheme and set down general system - drawings and flow charts. using step7 - micro software, we achieve the auto - control aim in drinking water treatment. in practice, the complexity and non - linaerity exit in the system of water treatment, so we apply fuzzy control in water treatment and design a kind of controller which structure can be altered according to the using - rate of ozone and the variety of water quality

    實際飲用水處理系統由於存在復雜性、非線性、時變性，本文根據臭氧生物活性炭水處理工藝存在復雜性、非線性、時變性等特點，將模糊控制應用在水處理這一不確定的非線性時變系統，針對不同水溫下臭氧利用率及水質的變化，設計一種基於系統過程狀態的變結構的模糊控制器，以單片機作為主要控制硬體，按查表方式設計軟體，對進水閥門開度進行在線控制，調節臭氧氣體與進水的比例（臭氧流量及濃度不變） ，達到氣水比最優化。
  6. The thesis was written under the direction of dynamic theory of forming reservoir, follows the rules of comprehensive information, judgment, interpretation and assessment and even makes full use of outcrop geology, data from drilling and logging, data from laboratory analysis and achievements in geophysical exploration. considering the basic factors of forming reservoir in the south of ordos basin as the starting point, the thesis defines that yanchang group of triassic goes into the start of generating oil in the late period of mid - jurassic and that the largest oil generation peaks in the middle period of early cretaceous, after the analogue - history of hydrocarbon generation. meanwhile it also establishes the relationship between the evolution of oil and gas and the formation of traps, the time of oil exploration

    本文以成藏動力學理論為指導，本著綜合信息、綜合判斷、綜合解釋、綜合評價的原則，充分利用露頭地質，鉆測井資料，實驗分析資料及物化探成果，以鄂爾多斯盆地南部的基本成藏要素為出發點，通過生烴史模擬，確定了三疊系延長組在中侏羅晚期（ 150ma ）進入生油門限，于早白堊世中期達到最大生油高峰期；同時並確立了油氣演化與圈閉形成、捕油時間的關系；通過流體勢的全區計算，提出了該區油勢具有明顯的「雙層」結構特徵，並建立了以靜水壓力為主的重力流系統和以差異壓實作用為主的壓實流系統的流體動力分佈模型；通過成藏動力學系統的劃分及事件分析，探討了該地區油氣聚集規律，最終指出了有利的含油氣遠景區。
  7. At the same time, when the gas flow passes the flow area of the inlet valve at a high speed, turbulent throw - outs will appear and lead to the generation of high frequency noises. as the flow area of the inlet valve keeps changing, the turbulent noise is of fixed frequency range ( generally over 1 000 hz )

    與此同時，當氣流以高速流經進氣門流通截面時，產生湍流脫體，導致高頻噪聲的產生，由於進氣門通流截面是不斷變化的，因此湍流噪聲具有一定的頻率范圍，主要集中在1000hz以上的高頻范圍。
  8. Intake valve timing

    進氣門定時
  9. When the inlet valve opens, a pressure pulse is generated in the air inlet pipe, which is damped as the piston continues to move. when the inlet valve closes, another pressure pulse of certain duration is generated, thus giving rise to a periodic inlet noise

    當進氣門開啟時，在進氣管中產生一個壓力脈沖，而隨著活塞的繼續運動，它受到阻尼；當進氣門關閉時，同樣產生一個有一定持續時間的壓力脈沖。
分享友人
分享到 Line

分享到臉書