進行退火 的英文怎麼說

中文拼音 [jìnhángtuìhuǒ]
進行退火 英文
process anneal
  • 進 : 進構詞成分。
  • 行 : 行Ⅰ名詞1 （行列） line; row 2 （排行） seniority among brothers and sisters:你行幾? 我行三。where...
  • 退 : 動詞1 （向後移動） retreat; draw back; move back 2 （使向後移動） cause to move back; remove; wit...
  • 火 : fire
  • 進行 : 1 （開展） be in progress; be underway; go on 2 （從事） carry on; carry out; conduct; make 3 （...
  • 退火 : [冶金學] anneal; annealing; back-out
  1. The procedure functions in the compare between partial image of dynamic collection and corresponding image of the airscape. in chapter 5, basing on the analysis of correlative theory of digital image, we introduce the improved fasted - down algorithm and simulative anneal algorithm, which applies to nn calculation, an d bring forward the unique and effective means, correlative original value evaluation. basing on the combination of correlative arithmetic, a stable, high - speed and exact correlative arithmetic is formed, which makes it possible to apply computer vision detection of single - needle quilting in industrial production

    本文展開研究並取得一定成效：構建了基於pci總線的微機實時圖像採集系統；在採集的布料總圖（鳥瞰圖）的基礎上，通過數字圖像的數字濾波、圖像增強、邊緣檢測等處理，提取布料圖像的邊緣，對輪廓的矢量化的象素點進行搜索，得到相應的圖案矢量圖，從而確定絎縫的加工軌跡，生成加工指令；在進給加工過程中，主計算機對動態局部圖像與總圖（鳥瞰圖）的對應部分進行圖像相關的匹配計算，應用數字圖像理論，結合神經網路計算的改進最速下降法和模擬退火演算法，提出獨特而有效的相關迭代初始值賦值方法，形成穩定、高速和準確的相關運算，實現單針絎縫視覺測量和自動控制。
  2. Chapter 4 studies simulated annealing algorithm

    第4章對模擬退火演算法進行了研究。
  3. Slices of hg _ ( 1 - x ) mn _ ( x ) te crystals were annealed under low temperature in hg atmosphere to improve their electronic properties. the electronic properties of annealed slices and coterminous non - annealed slices were evaluated by hall measurement

    為改善晶體的電學性質，本文通過優化退火工藝，對hg _ （ 1 - x ） mn _ xte晶片進行了低溫hg氣氛下的退火。
  4. In this paper, the flow pattern defects ( fpds ) were revealed by secco etchant and their shape, distribution on wafer and tip structure were studied in details by optical microscope and atomic force microscope ( afm ). the relationship between etching time and the tip structure of fpds was also discussed. furthermore, by studying the effect of rapid thermal annealing ( rta ) on the density of fpds in ar, the annihilation mechanism of fpds was discussed in this paper

    本文將cz硅單晶片在secco腐蝕液中擇優腐蝕后，用光學顯微鏡和原子力顯微鏡對流動圖形缺陷（ flowpatterndefects ， fpds ）在矽片中的形態、分佈及其端部的微觀結構進行了仔細地觀察和研究，並討論了腐蝕時間對fpds缺陷端部結構的影響；本文還通過研究ar氣氛下快速退火（ rapidthermalannealing ， rta ）對fpds缺陷密度的影響，初步探討了fpds的消除機理。
  5. Adopt two neural networks ; using principal component analysis based neural network ( gha ) to acquire three principal components and using simulated annealing ( sa ) and bp network to class and recognize the marrow cells

    採用兩級神經網路，利用基於神經網路的gha演算法獲得圖象的三個主分量，然後採用模擬退火演算法和bp演算法進行細胞的分類識別，獲得了較好的識別效果。
  6. Based on the project imbrued especially by hunan province construction office, the study of this paper includes four parts as follows : the first part does some simplify on the characters of the rc material under high temperature. after transferring the rc section under fire to equivalent one at normal temperature based on the stiffness and intensity equivalent, the rc members under fire can be calculated as ones at normal temperature

    主要研究內容如下: （ 1 ）基於剛度等效或強度等效原則，根據截面各點材料力學性能的退化，把受火鋼筋混凝土非均勻截面等效成常溫下的鋼筋混凝土截面，使得高溫下構件剛度和強度的計算可按常溫下的計算理論進行。
  7. 3 ) improving the method of penalty function inosculating with simulated annealing. delivery is very important in logistics system

    3 ）融入模擬退火演算法降溫處理的知識，對約束條件處理的罰函數法進行了改進。
  8. The simulation shows that the improved saa is both feasible and efficient

    實驗證明，改進的模擬退火演算法是可行和有效的。
  9. By analyzing the microstructure of as - cast alloys with different surplus of samarium added, the optimum surplus of samarium is decided. by comparing the microstructure of the alloys annealed for different time, the ideal and economical annealing time is confirmed. the microstructure and phase composition of alloys during the whole preparation of sm2fe17nx are analyzed using the scanning electron micrograph with energy - dispersive x - ray analysis and x - ray diffraction patterns

    本論文首先就熔煉工藝參數對鑄態組織微結構的影響進行了探討，並制定出一套較為合適的熔煉工藝；通過對不同釤加入量的鑄態組織微觀結構的觀察分析，確定了原料配置過程中釤的最佳補償量；通過對採用不同退火時間的合金組織進行比較，確定了理想、經濟的退火時間；同時還利用掃描電子顯微圖像和x射線衍射圖譜，比較了整個制備過程中，試樣微結構和相組成的變化情況。
  10. The dependence of oxygen precipitation and induced - defects in heavily as - doped silicon on heat treatment process was studied by annealing and ig process, chemical etching, scanning electron micrograph ( sem ) and transmission electron microscopy ( tem ). a developed ig technique was suggested and the mechanism of the influence of as on oxygen precipitation formation in heavily as - doped silicon was discussed

    本文通過化學腐蝕、光學顯微鏡、掃描電鏡（ sem ） 、透射電境（ tem ）等分析技術，對重摻砷硅單晶在單步退火工藝和內吸雜退火工藝中氧沉澱及誘生缺陷的形態，形核與熱處理溫度、時間的關系等進行了研究。
  11. Due to high - thermal stability and independent of impurities dj - center is argued to originate from antisite or antisite complex. furthermore, the ltpl measurements have been taken on as - irradiated and postannealed p - type 6h - sjc, l ; lines related to dj - center were not observed with sample after postannealing at 1500 ?, the observation of a series of high intensity spectra which may mask the d1 - center due to the recombination of the d - a pairs

    本文還對經幅照的p -型6h - sic的幅照退火特性進行了研究，在經過1500後退火的樣品中沒有觀察到d _ i - center ，這可能是由於d _ i - center被實驗中觀察到的源於d - a對輻射復合的高強度的譜峰所掩蓋。
  12. Then, by annealing, the si / sic / sich nano - composite films are prepared. the influence of the post - heating on the microstructure of the films has systematically been studied by the means of the measurements of hrem. the nano - crystals are found embedded in the amorphous matrix in the unannealed sample and the crystallinity is not high

    以硅烷和乙烯為原料氣採用常壓化學氣相沉積制備得到si / sic復合薄膜，並使用退火處理方法對該薄膜進行后處理，最終得到si / sic / slo ：納米鑲嵌復合薄膜。
  13. In this paper, the effect of heat treatment on the magnetic properties of s s fibers was studied

    對不銹鋼纖維進行退火處理，以探索材料成分、熱處理工藝與相結構和纖維磁性能的關系。
  14. Explanation carries out annealing handling for sample, the coercivity of pellet membrane average, it is little to reduce

    5910e之間。說明對樣品進行退火處理，顆粒膜的矯頑力平均來說減小了。
  15. A basic design is first proposed that modulator is manufactured by annealing the waveguides that come into being by proton exchange on the substrate of x - cut y propagation lithium niobate

    本文首先分析了所採用的基本方案：對x切y傳鈮酸鋰進行退火質子交換工藝來製作波導。
  16. The samples that annealed at different temperatures and different cooling ways ( fast or slow ), separately, was compared. the experimental results showed that the temperature and the cooling - way of the gettering process were very important for the gettering efficiency

    之後二極體分別進行退火溫度700 6hr 、 800 6hr 、 900 6hr和退火后快、慢降溫方式下j _ r值的比較，結果表明吸除熱處理摘要abstraer溫度對于吸雜效果至關重要。
  17. Bulk crystals of cd1 - xznxte with high quality are very difficult to obtain. commercial cd1 - xznxte crystals usually contain defects such as twins, sub - grain boundaries, dislocations, and te precipitates. these defects will seriously deteriorate the optical and electrical properties of the crystals

    為了提高晶體性能、減少或消除晶體缺陷，尤其是te沉澱和te夾雜，必須將cd _ （ 1 - x ） zn _ xte晶體在一定的溫度和氣氛條件下進行退火處理。
  18. This paper has first summarized the experiment of granular film and theoretical research progress and the present major problem to be solved, has discussed the purpose meaning of this paper on this foundation, has introduced us soon afterwards with magnetic metal - non - magnetic metal material adopt for studying object to co - vapored deposited system such as the fexcu1 - x of different fe content x granular film sample, carrying out annealing handling for some of samples, using x ray diffraction instrument xrd ), scanning electrical microscopic ( sem ), vibrating sample magnetometer ( vsm ) the tiny structure for sample, appearance and the magnetic result that can carry out detection

    本文首先綜述了顆粒膜的實驗和理論研究進展情況和目前待解決的主要問題，在此基礎上論述了本文的目的意義，隨后介紹了我們以磁性金屬?非磁性金屬材料為研究對象，採用共蒸發法制備不同fe含量x的fe _ xcu _ （ 1 - x ） ，顆粒膜樣品，對部分樣品進行退火處理。給出了用x射線衍射儀（ xrd ） 、掃描電鏡（ sem ） 、振動樣品磁強計（ vsm ）對樣品的微結構、形貌及磁性能進行檢測的結果。
  19. Another possible reason for this phenomenon is that with higher temperature, the mobility near defects of carbon atoms in grown carbon nanotubes would be also elevated, which gave carbon atoms higher mobility and have chance to readjus to decrease or eliminate some defects. a series of pretreatments and modifications including purification, annealing and doping were performed before hydrogen storage experiments carried out at room temperature under modest pressure ( 12mpa )

    在氮氣中進行退火處理納米碳管的儲氫性能高於在空氣中退火的納米碳管，主要原因是在空氣中退火時，納米碳管的表面引入了大量的氧官能團，而氧官能團能夠占據納米碳管的缺陷位，減少了氫的可吸附位置，阻礙氫進入納米碳管，從而降低了納米碳管的儲氫能力。
  20. The first one was called one step process or isothermal deposition and annealing process. in this process, the ceo _ 2 layers were formed at high temperature and oxidative atmosphere and then annealed at the same temperature. the relationship between the growth parameters and the textured degree of ceo _ 2 thin film was systematically studied, and the optimal growth parameters were summaried

    採用等溫退火法（或稱「一步法」 ）沉積ceo _ 2 ，即:先在氧化性氣氛下直接反應生長ceo _ 2薄膜，再在與沉積溫度相同的溫度下對薄膜進行退火處理，系統研究了沉積溫度、退火時間、水蒸汽分壓對薄膜c軸織構程度的影響。
分享友人
分享到 Line

分享到臉書