過偏壓放大器 的英文怎麼說
中文拼音 [guòpiānyāfàngdàqì]
過偏壓放大器
英文
overbiased amplifier- 過 : 過Ⅰ動詞[口語] （超越） go beyond the limit; undue; excessiveⅡ名詞（姓氏） a surname
- 偏 : Ⅰ形容詞1 （不正; 歪斜） inclined to one side; slanting; leaning 2 （只側重一面） partial; prejudi...
- 壓 : 壓構詞成分。
- 放 : releaseset freelet go
- 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
- 放大器 : amplifier; pantograph; lawnmower; enlarger; magnifier
- 放大 : amplify; magnify; boost; enlarge; blow up; gain; amplification; enhancement; multiplication; magn...
-
The way of taking one nth out of capacitor ' s the first harmonic capacitive reactance as its nth harmonic impedance is verified whit the data from tang7c. according to the approximately estimating method, the first harmonic impedance of 220kv system is calculated. on the basis of the models, this paper gives the harmonic equivalent circuit of substation and gives the b ( n ) function of the harmonic time n. when the capacitors has different combination, b ( n ) ' s value will also change, with the inputting local measurement data, the paper studies the series and parallel resonance at the substation, and deduces that the reason the capacitor ' s fuse of tang6c is frequently interrupted is that its capacitor current contains a large number of 5th harmonics, and that the reason the discharging pt of tang7c capacitor being exploded is also that the 7th and 9th harmonic currents are amplified
據此，對該站進行了串聯諧振分析和並聯諧振分析，並結合測試數據和有關變電站的運行記錄，指出了導致該站電容器湯6c頻繁燒保險的主要原因是5次諧波電流含量偏高，引起湯7c放電pt爆炸也是因為7次和9次諧波電流被放大。針對這些導致湯陰變電站補償電容器故障的原因，提出了相應的諧波治理措施，包括針對湯6c電容器5次諧波電流含量偏高的原因，提出了停運湯6c電容器或者通過把湯sc電容器的部分容量併入湯6c電容器（湯sc其餘部分停運）以增加湯6c諧波承受能力的措施;針對# 2變低壓側7次和9次諧波電流被放大的現象，提出了在湯7c電容器上加裝一定百分比的串聯電抗器的措施。According to the requirements to pd pattern auto - recognition, this paper studies systematically the basic theories and realizable methods for auto - recognition of pd gray intensity image : ( 1 ) in the requirement of on - line pd monitoring for transformer, several discharge models are designed and the relevant experiment methods projected. with discharge model tests, a lot of discharge sample data is acquired. on the base of systematical research on recognition for pd gray intensity image, this paper puts forward two kinds of fractal features, the 2nd generalized dimensions of original pd images and fractal dimensions of high gray intensity pd images, and then the relevant extraction methods
針對局部放電模式自動識別的需要，作者系統地研究了局部放電灰度圖像自動識別中的基本理論和實現方法： （ 1 ）根據變壓器局部放電在線監測的要求，設計了放電模型和實驗方法，並通過模型實驗獲得了大量放電樣本數據，為構造局部放電灰度圖像和採用bpnn進行識別作好準備； （ 2 ）研究了局部放電灰度圖像的構造方法以及降維構造32 32灰度和矩陣的方法；在用人工神經網路對局部放電進行模式識別時，分析了bp網路的優缺點，對典型bp網路的結構和學習訓練演算法提出了改進，採用帶有偏差單元的遞歸神經網路作為模式分類器；採用32 32灰度和矩陣進行bpnn識別結果表明這種方法是有效的。At present the manufacture of surface acoustic wave use the technology of the final submicron. a series of the devices of low insertion loss, high q saw rayleigh surface acoustic wave resonators or stws that insertion loss has less than 5db, load quality factor ( ql ) is more than 1000 on the quartz piezoelectric with zero of first temperature factor in the research. these difference frequencies are 60mhz, 280mhz, 739mhz and 1ghz of normal frequency and at also surface acoustic wave. using 1. 25db noise factor amplifier, careful design curcuit, good setting printed curcuit board, and using the 1ghz surface transverse wave resonator as frequency element, researching the low phase noise surface acoustic wave with sideband phase noise near ? 120dbc / hz deviating 1khz on carrier, spurious suppress with 80db
本研究採用一階溫度系數為零的壓電石英基片上製作出損耗小於5db 、有載品值因素（ ql值）超過1000的一系列低損耗、高q值聲表面波rayleigh波或stw諧振器，頻率分別為60mhz 、 280mhz 、 739mhz和1ghz等不同頻率的高性能聲表面波諧振器。並採用噪聲系數為1 . 25db的低噪聲系數放大器，精心設計電路，優化設計布置印製電路板，用標稱頻率為1ghz的聲表面波諧振器為頻率控制元件，製作出在偏離載頻1khz處的單邊帶相位噪聲近- 120dbc / hz 、雜波抑制達80db以上的低相位噪聲聲表面波振蕩器。
分享友人