過冷器 的英文怎麼說

中文拼音 [guòlěng]
過冷器 英文
subcooler
  • : 過Ⅰ動詞[口語] (超越) go beyond the limit; undue; excessiveⅡ名詞(姓氏) a surname
  • : Ⅰ形容詞1 (溫度低; 感覺溫度低) cold:冷水 coldwater; 你冷不冷? do you feel cold?; are you feeling...
  • : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
  1. Freeze dryer idf, idus series, the adsorption dryer id series, opened polymer diaphragm air dryer series, the main stopover aff series of filters, moisture separators amg series, the oil mist separator am series, a series of micro - mist separator amd, ultrafine mist separator ame series, the filters trap ame series, clean air filters sf series

    凍式乾燥idf idu系列吸附式乾燥id系列高分子隔膜式空氣乾燥idg系列主路aff系列水分分離amg系列油霧分離am系列微霧分離amd系列超微油霧分離ame系列除臭ame系列清潔空氣sf系列。
  2. All the diathermanous processes of the measurement and control platform are analyzed from the angle of thermal science. we compute the design parameter of the thermoelectric refrigerator, present the measures of improving or weakening the corresponding diathermanous processes, which is the theoretical basis of the next design

    從熱學的角度分析了溫度測控系統的各個傳熱程,計算出半導體製的設計參數,給出了強化或削弱相應傳熱程的措施,為下?步設計奠定了理論基礎。
  3. The rapid solidification process of pb - sn eutectic alloy is investigated with acoustic levitation and the maximum undercooling of 38k has been achieved

    採用聲懸浮無容處理技術研究了pb - sn共晶合金在深條件下的凝固規律。
  4. The containerless rapid solidification of al - 32. 7wt % cu eutectic alloy in drop tube is investigated. the " lamellar eutectic - anomalous eutectic " microstructural morphology transition occurs with the decrease of droplet size

    採用落管無容處理技術研究了al - 32 . 7wt cu二元共晶合金在深條件下的快速凝固規律。
  5. The present thesis has carried out detailed investigation on the rapid solidification of undercooled bulk water and pb - sn binary eutectic alloy with acoustic levitation, and the various factors influencing the achievement of undercooling in sound field have been analyzed

    主要取得了以下幾方面的研究成果:研究了5 8mm的大體積水在聲懸浮無容條件下的快速凝固行為。獲得了最大為24k的度。
  6. Its current products include : top oscillation electrical precipitator, side electrical oscillation precipitator, magnetism controlled static electricity precipitator, wet electrical precipitator, honeycomb electric catching tar instrument, high - pressur silicon rectifier equipment and plc low - pressure controlling system, blast furnace gas impulse precipitator, high concentration pulverized coal collector, coke oven and boiler flue gas low pressure impulse precipitator, blower fan inhaler, crossing piping gas cooler, high temperature fume cooler, gyre - orientation impulse hop - pocker and all sorts of molded sections

    目前主要產品有:頂部振打臥式電除塵、側部振打電除塵、磁控靜電除塵、濕式電除塵、蜂窩電捕焦油、高壓硅整流裝置及plc低壓控制系統、高爐煤氣脈沖除塵、高濃度煤粉收集、焦爐及鍋爐煙氣用低壓脈沖除塵、風機空氣、橫管式煤氣、高溫煙氣、回轉定位脈沖大布袋及加工各種彎型鋼。
  7. Judgment of clogging in liquid air subcooler installed in an air separation plant and solutions

    空分裝置液空過冷器堵塞判斷與處理
  8. This article aims at the boiler ' s problems in operation : 1 ) under nominal load, the smoke temperature at the outlet of hearth reaches 1200, far more exceeds 1050 the original designed temperature. this will always result in slag inside boiler and the temperature of overheater ' s pipe superheat, so that boiler cannot take nominal load and all these influence boiler ' s nomal operation heavily, 2 ) this article also studied the reason why the assistant oil becoming necessary when coal changes. during the nomal operation, many factors ( makeup of combustor and its disposal, smirch and encrust of water wall, excessive air coefficient, temperature of primary air, coal type and density of coal dust ) can deviate the designed working conditions, then affect the boiler ' s nomal operation

    本文針對該鍋爐在實際運行中存在的問題:在額定負荷下,爐膛出口超溫、低溫段前煙溫高達936 ,遠遠超815的設計值;噴燃四周水壁結焦嚴重,管壁溫度超標,無法帶上額定負荷;甚至有時因燃煤質量的變化,必須投油助燃的嚴重情況進行了分析研究。在實際生產程中,燃燒的結構、布置,水壁的粘污、結垢,剩空氣系數、一次風溫、煤種及其濃度變化等許多因素都會偏離鍋爐的設計工況,從而影響爐內的傳熱和燃燒,造成爐膛出口超溫、水壁結渣等問題。
  9. Based on the refrigerant state, divides a heat exchanger into three zones with zoned lump method, i. e. superheat, two - phase and subcooling zones, works out the temperature difference and heat transfer coefficients of the three zones

    採用分區參數法將換熱按製劑狀態分為熱、兩相、三區,分別計算了各區的換熱溫差、傳熱系數等。
  10. Introduction to general ideas in air pollution control, air pollution effects, design of wall collection devices ( gravity settlers, centrifugal separators, electrostatic precipitators ), design of dividing collection devices ( surface filters, depth filters, scrubbers for particulate control ), design of controlling by concentration and recovery ( condensation, adsorption, absorption ), design of controlling by oxidation ( combustion, biological oxidation, biofiltration ) and the choosing of a control technology

    本課程介紹空氣污染防制概念,空氣污染之影響,壁式集塵設備之設計(重力沉降室、離心分離、靜電集塵) ,分隔集塵設備之設計(表面、深層、洗滌) ,以濃縮回收之控制設計(凝、吸附、吸收) ,以氧化之控制設計(燃燒、生物氧化、生物濾) ,以及控制技術之選擇。
  11. Make the theoretical and experimental research of self - cleanup, through the experimental research to the tin, we get the conclusions of jointed cold - blowing and hot - blowing period and the effective temperature range etc. proposed the practical measures to improve the effect of the self - cleanup, laid the groundwork for the future further in - depth study and application

    對蓄的實驗研究,掌握了吹期和熱吹期的溫度變化規律,獲得了熱吹期填料溫度閉合和輸出氣流有效溫度范圍等結論。通自清除原理的分析和自清除程的實驗,提出了改善自清除效果的實用措施,為今後進一步深入研究和應用打下了基礎。
  12. The article takes a 600mw natural cycle drum boiler ( soot blow using steam ) as investigating object, establishes soot accumulation loss and soot blowing energy loss models for its water cooling wall, superheater, economizer and air preheater respectively, set up instructions for soot blower operating. simulating calculation results are compared with site data to verify usefulness of key models. the article introduced the operation optimizing design of soot blowers of yanzhou no2 power plant based on theoretical research

    本文以600mw汽包自然循環鍋爐(蒸汽吹灰)為具體分析對象,分別建立其水壁、、省煤、空預的積灰損失和各受熱面吹灰能量損失的模型,建立相應的吹灰運行規則指導,對設計中的關鍵模型問題,通模擬計算及與現場數據作比較的方法,驗證其可用程度。
  13. The reform scheme of no. 1 boiler in fengtai company is confirmed on the basis of cold / hot tests, theoretical discussions and calculations. in the process of field retrofit, it is indicated in the operation of the improved furnace that without the change of furnace structure, the transform of the burner angle has shrunk the tangential diameter and prevented flames burning on furnace walls, and the burning state of furnace has been bettered, simultaneously, lowering the slagging wi in furnace, thus laying sol id foundation for the safe and economic operation of generating units. wuyanrong ( power plant thermal power engineering ) directed by prof

    本論文通、熱態試驗,經論證和計算,確定了豐泰公司~ # 1爐燃燒的改造方案,並進行了現場改造,改造后實際運行狀況表明:在無法改變爐膛結構的情況下,改變燃燒角度,縮小切圓直徑,使火焰不貼壁,改善了爐內燃燒工況,同時降低了鍋爐結渣的程度,為機組的安全經濟運行奠定了必要的技術基礎。
  14. Fini air treatment, recommended for the most demanding professional uses, is composed of refrigerating dryers, filters for separating impurities, condensate drain cocks, water - oil separators, tanks, and all other components necessary for optimising compressor operation

    Fini空氣處理系統,由藏乾燥組成,用分開雜質,立式凝物排出管,水油分離,氣罐和其他空壓機必須的零部件組成,建議使用在大多數要求苛刻的專業用途。
  15. Testing for leaks in the filters associated with laminar flow clean rooms and clean work stations by use of a condensation nuclei detector

    凝核探測對層流無菌室及無菌工作站配備的進行檢漏試驗
  16. In environment water treatment aspect, there are professional technology staff who are working on environment protect and dedicate to transplant foreign advanced technology, meanwhile they develop acidity / alkalescence waste water treatment technologies and equipment, soft water desalination technologies and equipment, high effectual lime preparation and putting set, high effectual integration putting set, at the same time, develop gravity sand filters, bevel precipitate set, many series of filter set, super filter set, prevent infiltration set, cooling tower, large - sized frothing water tank, cleaning device etc. all these technologies and equipments are domestic leading level

    環保水處理方面,有專業從事環保方面的技術專業人員,在從事多方面環境污染治理工作的基礎上,致力於消化移植國外先進技術,研製開發出酸性/堿性廢水處理工藝和成套設備、軟水脫鹽水工藝和成套設備、高效石灰乳制備及投加裝置、高效一體化加藥裝置,同時開發出重力砂濾、斜板沉澱、多種、超濾裝置、反滲透裝置、卻塔、大型鼓泡水箱、清洗裝置等單體設備,這些工藝技術與設備均居於國內領先水平。
  17. For manufacture water cooling panels, coal - saving devices, reheaters, superheaters and steam pipelines of boilers

    用於鍋爐水壁、省煤、再熱和蒸氣管道的製造。
  18. Avoid using the machine in extreme heat, cold or humidity

    不要在熱,,濕度大的情況下使用這臺機
  19. Choice of the water temperatures entering and leaving the supercooler in the dynamicice - making by supercooling system

    水連續製冰系統中進出口水溫的選擇
  20. Suitable for the domestic water, food processing water, cool the circulating water, the boiler supplies water, exceed the filtration in advance of the pure water, steam condensation water, build well liquid and water flooding in the oil field, chemical liquid medicine, electroplate the filtration that the liquid, much kinds of acid or alkaline solution, emulsifier wash helping, cleaning solution, medical products, ink and water treatment of the semiconductor, electron trade

    適用於生活用水食品加工用水卻循環水鍋爐供水超純水的預濾蒸汽凝水油田修井液及注水化學藥液電鍍液多種酸性或堿性溶液乳化劑洗滌濟洗滌液醫藥製品墨水的濾及半導體電子行業的水處理。
分享友人