過渡頻率 的英文怎麼說

中文拼音 [guòdùbīnlǜ]
過渡頻率 英文
crossover frequency
  • 過 : 過Ⅰ動詞[口語] （超越） go beyond the limit; undue; excessiveⅡ名詞（姓氏） a surname
  • 渡 : Ⅰ動詞1 （由此岸到彼岸;通過） cross （a river the sea etc ） 2 （渡過） tide over; pull through 3 ...
  • 頻 : Ⅰ形容詞（次數多） frequent Ⅱ副詞（屢次） frequently; repeatedly Ⅲ名詞1 [物理學] （物體每秒鐘振動...
  • 率 : 率名詞（比值） rate; ratio; proportion
  • 過渡 : transition; transit
  • 頻率 : frequency; rate
  1. Finally, using the low loss 3 - db three port network as power dividing and combing network and using hmmc 5040s fabricated by agilent co. as single - way amplifiers, with the help of e - plane waveguide to microstrip transition, we have designed a two - way power combing circuit with waveguide as interface ports. in 33ghz ~ 35ghz, the measured saturated output power is about 170mw, and the combing efficiency estimated is greater 70 %

    最後，採用我們設計的3 - db三埠網路作為功率分配、合成網路，以常用的微帶e面探針作為微帶-波導過渡結構，採用agilent公司hmmc5040作為放大單元，製作出了波導介面的兩路合成電路，在頻率為33 35ghz實測飽和功率達170mw ，合成效率高於70 。
  2. In active section, in order to meet performance of out put power above 10dbm, the power amplifier module of ka - band is fabricated by using hmc283 to achieve the 14db conversion gain. there are five parts that include of waveguide - to - microstrip ? mixer ? filter ? power amplifier and waveguide - to - microstrip. input signal ' s power is 10dbm, after it pass waveguide - to - microstrip, it ' s frequency is escalate from 30ghz to 35ghz

    該組件由五個部分組成：功率為10dbm信號經過波導? ?微帶過渡，然後混頻，濾波將30ghz提高到35ghz濾除不需要的諧波鏡頻以及三階交調信號，為了彌補混頻濾波的變頻損耗，加一級功率放大器，此放大器採用hittle公司hmc283晶元，此上變頻放大組件完成了上變頻?濾波?放大功能。
  3. ( 2 ) the crack compares with one depth with the first steps and the second steps natural frequency vibration, crack position near crank arm and main shaft transition round natural frequency little place under crankshaft ; with the third steps and the fourth steps natural frequency vibration, the smaller close to the second crank arm of crankshaft and round place natural frequency of the main shaft transition the position is

    （ 2 ）裂紋同一深度比以第1階和第2階固有頻率振動，裂紋位置越靠近曲軸中間曲柄臂與主軸過渡圓處固有頻率越小；以第3階和第4階固有頻率振動，位置越靠近曲軸第二個曲柄臂與主軸過渡圓處固有頻率越小。
  4. Transitional feature of the arc and metal droplet in the welding process with steam shielded arc is investigated by means of analysing the waveforms of welding voltage and current under different welding regimes and it is found that there are two types of arc process behavor ? " arc starting - arc blowing out - short - circuiting " and " arc - starting - short - circuiting ". under the condition of constant diameter of welding wire and its feeding speed, the arc process behavor can be changed by adjusting the inductance of welding circuit as well as the voltage of power supply. if arc process behaves as alternative process of " arc starting - arc blowing out - short - circuiting " with minimum time duration of arc blowing out and maximum frequency of short - circuit transition, the welding process will be stable with less spatter and smooth weld bead

    通過分析不同焊接規范下的焊接電壓和電流的波形.研究了水蒸氣保護下電弧及熔滴過渡的特點，發現其電弧過程行為有「燃弧?熄弧?短路」和「燃弧?短路」兩種形式.在焊絲直徑和送絲速度一定的情況下，通過調節焊接迴路中的電感量和電源電壓，可以改變電弧的過程行為形式.若電弧過程呈「燃弧?熄弧?短路」交替進行，並且熄弧時間最短時，短路過渡頻率最高，在這種情況下，飛濺小，焊道成型好，焊接過程穩定
  5. Furthermore, it deserves more attention for easily fabrication process, very good firmness, and the input and the output lying in a line to meet the particular requirement

    本文描述的波導-脊波導-微帶過渡結構，在頻率為32ghz 37ghz范圍內損耗小於0 . 2db ，加工製作容易，輸入輸出在同一直線上，機械性能良好。
  6. In the paper, the transition of ka band rectangular waveguide to micro strip probe and the back - to - back structure are designed. the measurement results indicated the low insert loss and low return loss from 35 ghz to 40 ghz

    本文設計了ka波段矩形波導到微帶探針過渡結構以及背對背結構，測試結果表明，在35 40ghz頻率范圍內，其插入損耗和回波損耗都比較小。
  7. When this fault is cutted off and the breaker is reclosed, this scheme ca n ' t start by mistake. the availability of this scheme is proved with matlab test. the single phase high - impedance grounding fault is settled properly

    Matlab模擬分析證明了該方案耐受過渡電阻的能力強，在故障切除和重合閘時不會因出現的暫態信號而誤啟動，不受系統振蕩、頻率偏差的影響，克服了常規保護靈敏度不足的缺點，較好地解決了單相高阻接地故障的難題。
  8. Based on the transfer - matrix method, the general expressions of equivalent four - terminal network parameters of varying section torsional horn are derived, the relations between frequency equation and both the rotational velocity amplification and that of the surface tangential velocity of stepped type torsional ultrasonic horn with transitional section of cosine - like type are obtained

    摘要基於傳遞矩陣演算法，推導出了變截面桿扭轉振動時等效四端網路參量的一般表達式，研究了帶類餘弦過渡段階梯形變幅桿扭轉振動頻率方程與角速度放大倍數及外表面切向速度放大倍數等的關系。
  9. Meanwhile by using numerical method, the beam ' s one - order current density, and the power exchange between the beam and the field are solved. curves are given to illustrate the relations among the above solved parameters and the gap ' s transit angle in different electron velocity and number density

    然後通過數值求解得到了不同初始速度和電子數密度時徑向間隙中一階電流密度、高頻電場、電子束與本徵場的功率交換等隨間隙直流渡越角的變化規律。
  10. To solve these issues, a new idea i. e. co - frequency transmission technique is proposed. it can not only realize the smooth transition from 2g to 3g but also optimize spectrum efficiency and expand system capacity to accommodate more users in major metropolitan markets

    本文的同頻傳輸技術就是為了解決上述問題而提出來的一種全新的技術構想，它不僅可以實現由第二代系統向第三代系統的平滑過渡，而且可以更有效地利用現有的頻譜資源，解決現階段嚴重的頻率資源不足問題。
  11. Based on this arithmetic, the high frequency characteristics of five - cavity with open boundary is calculated by the code written in fortran language. then the transit effect of five modes of five - cavity with open boundary is also calculated using code mathcad and matlab. the results show that the working mode of five - cavity transit tube oscillator is 3 / 6 mode, and the analysis of the theory are in good agreement with the simulation results

    根據從基於四腔渡越時間效應的自調制出發，經過一段飄移，然後再採用雙間隙提取腔邊耦合輸出高功率微波的思路，採用粒子模擬方法優化設計出一種峰值功率為1 . 5gw ，頻率為9 . 3ghz的六腔渡越輻射振蕩器，並研究了它的一系列工作特性。
  12. 2. finline - to - microstrip transitions are designed and used in the power - driver at ka - band

    2 .設計了ka頻段鰭線-微帶的過渡，並將其運用於功率驅動級放大器之中。
  13. At the same time, we have manufactured a transition from microstrip line to rectangle waveguide, working in full ka - band. the insert loss of a single transition is between 0. 25db and 1db

    同時，完成了ka全頻段微帶波導過渡的研製，在26 . 5 39 . 5ghz頻率范圍內，單個微帶波導過渡的插損在0 . 25 1db
  14. Based on the results of the theory analysis and computer simulation of ratrace, waveguide - to - microstrip probe transitions, dgs lowpass filter, the structure was designed and manufacture was made. finally, the index of this mixer was measured

    在對所用到的功率混合電路，波導-微帶探針過渡，以及dgs低通濾波器進行理論分析、計算、和計算機模擬的基礎上，製作混頻器，並對設計結果進行了測試驗證。
  15. Because of the affection of noise and signal fading, in order to high data rate access and high quality, wireless communication need new technology to improve the link reliability and enhance the spectrum efficiency. mimo ( multiple input and multiple output ) can enhance the spectrum efficiency and increase channel capacity greatly, and reduce the multipath affection without spectrum band and power increasing. the 3th generation mobile communication wcdma is coming, with the purpose of putting mimo, stbc ( space time block coding ), space diversity into practice of wcdma systems, in order to lay the foundation of 3g toward 4g, this dissertation has done some research under this background

    在發射機和接收機使用多個天線進行數據傳輸的多輸入多輸出（ mimo ）技術，可以在不增加帶寬和天線發送功率的條件下，成倍的提高頻譜利用率，提高系統的通道容量，還可以抗多徑干擾。第三代移動通信wcdma即將到來，為了將多天線技術（ mimo ） ，空間分集技術，空時編碼技術用到wcdma系統中去，為第三代移動通信向第四代移動通信系統平穩過渡奠定一定的基礎，需要做一些理論上的研究。
  16. The problem of joint estimating the frequencies and time - delay of multiple sinusoids received at two separated sensors is considered. the frequencies are firstly estimated using a state - space realization approach. the tune - delay is then found using a direct - form esprit - like method. finally, the performance of the proposed algorithm is demonstrated via computer simulations using sinusoidals as well as real speech data

    6 .在第七章提出了一種基於狀態空間實現的頻率、時延聯合估計演算法，正弦波的頻率首先用狀態過渡矩陣的特徵值估計得到，然後時延由估計的頻率和觀測矩陣直接給出。
  17. For getting better filter performance, we design quadrature mirror filter banks using window function method. considering the frequency response of filter change rapidly, we make the filter is perfect reconstruction on the point of center frequency. the error of reconstruction is small by the point

    考慮到濾波器組在過渡帶出現的其幅頻特性變化的情況，選擇在兩個濾波器交疊的中心頻率處，使其滿足濾波器的完全重構條件，其附近頻率處的誤差也降到很小的范圍之內。
  18. The transient analysis and simulation studies in time - domain showed that the transient capacitance current of busbar is unable to be caught due to the limitation of the given sampling frequency, therefore the transient current singularity of the fault line and the non - fault line will approximate, which prevents to identify the fault line with the criterion calculation result of transient current protection

    研究結果表明，線路出口故障時暫態電流保護完全失去選擇性的根本原因是，在給定的采樣頻率的限制下，難以捕捉到過渡過程中極其短暫的母線分佈電容中的暫態電流，從而故障線路與非故障線路暫態電流波形的奇異性相近，根據故障線路和非故障線路的暫態保護判據計算結果不能正確識別故障線路。
分享友人
分享到 Line

分享到臉書