過濃混合氣 的英文怎麼說

中文拼音 [guònónghúngěqì]
過濃混合氣 英文
overrich mixture
  • 過 : 過Ⅰ動詞[口語] （超越） go beyond the limit; undue; excessiveⅡ名詞（姓氏） a surname
  • 濃 : 形容詞1. （液體或氣體中所含的某種成分多; 稠密） dense; thick; concentrated 2. （程度深） （of degree or extent） great; strong
  • 混 : 混形容詞1. （渾濁） muddy; turbid2. （糊塗; 不明事理） foolish; stupid
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 混合 : （攙雜在一起） mix; blend; mingle; admix; mixture; mix up; interfusion; commixture; blending; cre...
  1. A th - 1025 thoron source made in pylon company of canada was adopted. thoron gas is mixed with circulation gas before they are input into the thoron accumulation box. the thoron level in the thoron accumulation box can be adjusted by changing the gas flow rate through the thoron source, or adding different volume of delay boxes in source input circuit, and me

    簡易（氣土）室採用加拿大pylon公司生產的th - 1025型流氣式固體（氣土）源， （氣土）進入積累箱之前先與循環氣流混合，積累箱中的（氣土）濃度可以通過改變流經（氣土）源的氣流流率或在充源迴路加不同體積的延遲瓶加以調節。
  2. Also, the author ’ s design strategy and creativity has been given in this paper. specifically, it includes : based on the feasibility analysis of the fit selection of control parameters in the aeration process, the aeration process of wastewater treatment of the joint - constructional complete - mixed activated sludge process has been aimed at in this paper. then, the state equations of the aeration process have been proposed in this paper, which is on the base of dissolved oxygen concentration ( do ) and discharge quantity of sludge ( qw ) as control variables, the concentration of bod and sludge as state variables. based on the present study on optimization control of wastewater treatment, the multivariable optimal control model with restriction factor has been presented in the paper with introducing modern control theory and system analysis into the field of activated sludge wastewater treatment,

    具體包括:以完全混合、表面曝氣合建式活性污泥工藝的污水處理曝氣過程為研究對象，在闡述了曝氣過程式控制制參數選取可行性的基礎上，建立了以溶解氧濃度do和活性污泥排放量qw為控制變量，以曝氣池中有機物濃度s和微生物濃度x為狀態變量的活性污泥曝氣過程的基本狀態方程;運用現代控制理論的觀點和污水處理理論，在現有關于污水處理最優控制問題研究的基礎上，建立了有約束條件多變量能耗最小數學模型，該數學模型是以有機物排放總量和狀態變量的末值條件作為約束條件，曝氣過程的能耗最小作為目標泛函;採用增廣拉格朗日乘子法對最優控制問題進行轉化，並對應用極大值原理求解能耗最小這一最優控制問題進行了詳細的解析;引入約束運算元，應用具有控制約束的共軛梯度演算法對能耗最小這一最優控制問題進行求解，並進行模擬實驗驗證。
  3. This partly opens the choke so that an overich mixture is prevented.

    這種阻風門的部分開啟可以防止混合氣過濃。
  4. We make a theoretical analysis of the experimental results and draw some conclusions as follows : the saturated temperature r290 - oil mixture is higher than that of pure r290 at a same pressure. the temperature difference, which is called superheat temperature of refrigerant - oil mixtures, increases as the oil concentration and the vapor quality are increased at a certain saturated pressure and pressure has negligible effect on the superheat temperature of the mixture. ( oil concentration is 0. 43 ? - 5. 28 ? )

    並根據實驗結果進行理論計算，得出以下結論：天然製冷劑r290含油混合物的飽和溫度高於相同壓力下純工質的飽和溫度，這個溫度差，也就是本文中提到的所謂製冷劑含油混合物的過熱溫度隨混合物質量含氣率、含油濃度的增加而增加，而飽和壓力對過熱溫度的影響不大（含油率0 . 43 ? - 5 . 28 ? ） 。
  5. Ore - forming fluid, mineralizing agent, auxiliary aget came mainly from the mixing of deep - source bittern, formation water, palaeometeoric water. ( 5 ) when sinking palaeometeoric water and rising deep - source solution mixed during their moving, their physicochemical condition was changed, which made ore - forming

    下滲的大氣降水與上升的深源流體在運移過程中混合，使得溶液的溫度、 ph值、 h _ 2s的濃度、硫逸度、氧逸度以及氧化還原電位改變，從而發生成礦作用。
  6. Planar laser induced fluorescence ( plif ) was used to study the spray / wall impinging in constant volume vessel. the experimental result show that when fuel spray impinging on the plane wall, wall jet was formed while fuel impinging on a plane wall with a bump, when the wall jet meet the bump, a secondary jet can be formed. some parameters affecting the secondary spray were studied, including bump height, the secondary impinging distance, impinging distance and injector parameters

    對傳統燃燒室和bump燃燒室內燃油空氣混合過程進行了對比研究，發現燃油撞壁以後在傳統燃燒室壁面形成壁面射流，這一層燃油濃度很高，很難與空氣混合，而在bump燃燒室內，壁面射流遇到bump后，會在空間形成二次射流，二次射流進一步能快速與空氣充分混合。
  7. In this model, the most essential hypotheses were brought forward : the room in the building is a node neglecting its ’ volume ; smoke mix with air in a very short term, the temperature and the smoke concentration are well - proportioned in the room. therefore, the net - model can only apply to the special building : there is little discrepancy in room volume

    另外，該軟體採用的數學模型是網路模型，而網路模型最基本的假設就是:無論建築物中任一受限空間的體積大小，統一地視為一個節點;在火災過程中，煙氣與空氣混合過程是在瞬間發生的，受限空間內任意一點的溫度、煙氣濃度等都是均勻的。
  8. A few layers of temperature measuring nets was fixed in the furnace in the test - bed. the distribution of the concentration of diffenent temperature air was gotten through measuring the distribution of the temperature in the furnace. finally, the mixture situation in reburning area and burnout area were gotten totally

    即主氣流和燃盡風採用室溫氣流，再燃天然氣採用高溫空氣模擬，在爐內布置多層測溫網路，通過測量爐內溫度場的方法獲得爐內再燃風、燃盡風及主氣流的混合濃度場，從而定量反映出爐內再燃區及燃盡區的混合情況。
  9. The demand of protecting the ozone layer, saving energy and improving room comfort is a developmental trend to air source heat pump system in recent years. composition modulation is one form of capacity controls, which changes system capacity by varying composition of nonazeotropic mixtures

    環保、節能、舒適性是當今空氣源熱泵系統發展所追求的方向，而混合工質容量調節是利用非共沸混合工質的組成特性，通過改變系統中混合工質的濃度來調節系統容量的一種調節方式。
分享友人
分享到 Line

分享到臉書