過硫酸銨 的英文怎麼說

中文拼音 [guòliúsuānǎn]
過硫酸銨 英文
ammonium peroxysulfate
  • : 過Ⅰ動詞[口語] (超越) go beyond the limit; undue; excessiveⅡ名詞(姓氏) a surname
  • : 名詞[化學] sulphur; sulfur [美國] (16號元素, 符號s)
  • : 酸構詞成分。
  • : ammonio
  • 硫酸 : [無機化學] sulphuric acid; sulphoacid; vitriol; vitriol oil; dipping acid; sulfuric acid; hydric ...
  1. Different molecular weight igy exitence in the purified igy suggested that the igy is uniform. through colligate comparison, the best method suit for industrialization is eliminating lipid by 0. 07 % alginic acid sodium combined with ammonium sulfate salting out afterl0 - fold diluted with ph5. 0 water

    綜合比較,認為性條件下10倍去離子水稀釋卵黃液,離心後上清用0 . 07的海藻鈉去脂,再用鹽析提取純化igy的工藝流程適用於工業化的規模生產。
  2. The cell extract aliquots were added by ammonium sulfate with 30 %, 40 %, 50 %, 60 %, 70 %, 80 % and 90 % saturation, separately. the activities of sod for the re - suspensions were detected after dialysis and centrifugation. it was found sod activity could be detected after the precipitation by ammonium sulfates with 30 % saturation or above, and the highest sod activity could be obtained by precipitation of ammonium sulfate with 80 % saturation

    Maltophilia276菌株細胞提取物中分別加入飽和度為30 、 40 、 50 、 60 、 70 , 、 80和90的,經透析、離心、重新懸浮后檢測sod的活性發現:當的飽和度為30時,其活性可檢測出sod活性,當的飽和度為80時,檢測出的sod活性最大。
  3. In adding - acid system : the resistivities of different lithotypes " cp tend towards being constant and equal when weight percentage of aniline exceeds 50 % ; because of the structure difference of different lithotypes, the polymerizing places and processes are different ; the resistivities of vituain / pan and fusain / pan reach the lowest point respectively when ( ntloisiog / an is 0. 6, 1. 0 ; the resistivities of cp decline fast and tend towards being constant along with the reduction of diameter of coal. in not adding - acid system : the resistivities of different lithotypes ' cp decline evenly ; it is found on the crossed experiment of cp, that ( nflsaog / an mole proportion is the most important factor to influence output ratio of cp and the weight percentage of aniline is the most important factor to influence resistivities of cp. according to the result of the crossed experiment of cp

    在有外加體系中:苯胺百分含量大於50時,不同煤巖組分的電阻率趨于恆定和一致;由於不同煤巖組分結構上的差異,導致苯胺聚合場所和聚合程的不同;當過硫酸銨/苯胺摩爾比為0 . 6 , 1 . 0時,鏡煤-聚苯胺導電材料電阻率和絲炭-聚苯胺導電材料的電阻率分別達到最低值;在無外加體系中:不同煤巖組分/聚苯胺導電材料的電阻率隨著聚合時間的增加而均勻下降,並在8小時左右達到恆定;在對絲炭-聚苯胺導電材料進行的正交試驗中發現:過硫酸銨/苯胺摩爾比對產率的影響最大,苯胺重量百分比對產率影響最小,而對產物電阻率影響最大的是苯胺重量百分比。
  4. Some main results of testing research were as fellows : i. in the course of testing of leaching zinc dross, leaching zinc dross by sulfuric acid was researched and the effects on the leaching rate of the zinc dross were analyzed by author, the optimum conditions of leaching testing of zinc dross were determined as fellows : liquid - solid ratio 6 : 1, stirring ratio 250r / min, granularity 120 mesh, the soaking time 5h, the concentration of sulfuric acid of 30 %, and under these conditions, the rate of leaching zinc is above 92. 0 %. ii. in the course of testing of purification, on the basis of comprehending and comparing all present methods of the manganese - removal and iron - removal, the oxidizing method of manganese - removal in zinc sulfate solution using ammonium persulfate was put forward and the oxidizing method of iron - removal in zinc sulfate solution using the goethite process and oxidation - hydrolysis process was adopted

    研究的主要結果具體如下: 1 、研究了浸出鋅浮渣並分析了影響浸出率的各種因素,確定了浸出鋅浮渣的最佳條件為:液固比為6 : 1 ,攪拌速度為250r min ,粒度為- 120目,浸時間為5 . 0h ,濃度30 ,鋅浮渣的浸出率大於92 . 0 ; 2 、在綜合和比較了目前除錳和除鐵的各種方法基礎上,提出了過硫酸銨氧化除錳方法和選擇了針鐵礦-氧化水解聯合法除鐵方法,並分析和討論了影響除錳率和除鐵率等各種因素,確定了除錳的條件為:溫度90 , ph值5 . 4 ,反應時間3h ,過硫酸銨達到理論值的1 . 2倍,除錳率超99 . 86 ;聯合法除鐵的條件為:氧化反應時間1 . 5小時、溫度控制在90 92 、 ph值5 . 2 5
  5. Paucity manganese in drinking water by way of oxidization of ammonium persulfate

    過硫酸銨氧化法測定生活飲水中的微量錳
  6. Chemical reagent. ammonium persulfate

    化學試劑過硫酸銨
  7. The ammonium persulfate oxidation volumetric method for the determination of chromium content

    過硫酸銨氧化容量法測定鉻量
  8. Nickel base alloy powder - determination of chromium content - persulfate oxidation titrimetric method

    過硫酸銨氧化滴定法測定鉻量
  9. The alkaline fusion - ammonium persulfate oxidation volumetric method for the determination of chromium content

    過硫酸銨氧化容量法測定鉻量
  10. Fireclay and high - alumina refractories - determination of manganese oxide content - ammonium persulfate photometric method

    過硫酸銨光度法測定氧化錳量
  11. Medium experiments were arranged under uniform design, and then an optimum medium was got accordingly. the culture liquid was centrifugalized at 3, 500r / min for 30min, then ammonium sulfate was added into the supernatant to a final concentration of 30 % to precipitate the others

    過硫酸銨分級沉澱、 deaesephadexa - 50陰離子交換凝膠層析和sephadexg - 75凝膠柱層析對發酵液進行分離和純化,並得到電泳純的酶。
  12. With 2, 2 " - azobis - 2 ( amidineopropane ) dihydrochloride ( v5o ) and ammonium persulphate ( aps ) being used as initiator, the cationic and anionic nanoparticles polystyrene ( ps ) latex were synthesized via emulsion polymerization respectively

    使用過硫酸銨和偶氮二異丁脒鹽鹽作引發劑,利用乳液聚合法制備了粒徑約為100nm ,表面分別為負電性和正電性的ps (聚苯乙烯)乳膠粒。
  13. Test methods for bare wires - test for continuity of coating - ammonium persulphate solution method

    裸電線試驗方法鍍層連續性試驗過硫酸銨
  14. Under these conditions the fibrinolytic activity of the supernatant can reach 820 urokinase units per milliliter broth. ba - dfe was purified from the supernatant of b. amyloiquefaciens dc - 4 culture broth by ammonium sulfate precipitation, ion - exchange chromatography on cm - and deae - sepharose fast flow, hydrophobic interaction chromatography on phenyl sepharose 6 fast flow and gel filtration on sephadex g - 50. the purified enzyme displayed thermophilic, hydrophilic and strong fibrinolytic activity

    過硫酸銨分級沉澱、 cm - sepharosefastflow和deae - sepharosefastflow離子交換層析、 phenylsepharose6fastflow疏水層析和sephadexg - 50凝膠濾等方法,從解澱粉芽孢桿菌dc - 4的發酵液中分離純化出電泳純的ba - dfe 。
  15. Methods for chemical analysis of silicochromium - the alkaline fusion - ammonium persulfate oxidation volumetric method for the determination of chromium content

    硅鉻合金化學分析方法堿熔-過硫酸銨氧化容量法測定鉻量
  16. Methods for chemical analysis of copper - chromium - zirconium alloys. the determination of chromium by persulfate oxidation volumetric method

    銅鉻鋯合金化學分析方法.過硫酸銨氧化容量法測定鉻
  17. Methods for chemical analysis of ferro - chromium - the ammonium persulfate oxidation volumetric method for the determination of chromium content

    鉻鐵化學分析方法過硫酸銨氧化容量法測定鉻量
  18. Methods for chemical analysis of iron, steel and alloy - the ammonium persulfate oxidation volumetric method for the determination of chromium content

    鋼鐵及合金化學分析方法過硫酸銨氧化容量法測定鉻量
  19. Electromagnetic wave shielding fabric was prepared by in - situ chemical polymerization of aniline in the presence of cotton substrate, using hydrochloric acid as the doping agent and ammonium persulfate as the oxidant

    摘要以鹽為摻雜劑,過硫酸銨為氧化劑,在棉織物表面採用現場吸附聚合法生成一層導電聚苯胺,由此設計出一種具有良好電磁屏蔽效能的織物。
  20. Method for chemical analysis of constantan resistance alloy the ammonium persulfate oxidation - ammonium ferrous sulfate titrimetric method for the determination of manganese content

    康銅電阻合金化學分析方法過硫酸銨氧化-亞鐵滴定法測定錳量
分享友人