過飽和蒸汽 的英文怎麼說

中文拼音 [guòbǎohézhēngqì]
過飽和蒸汽 英文
supersaturated steam
  • 過 : 過Ⅰ動詞[口語] （超越） go beyond the limit; undue; excessiveⅡ名詞（姓氏） a surname
  • 飽 : Ⅰ形容詞1 （吃足） have eaten one s fill; be full 2 （充實; 飽滿） full; plump Ⅱ副詞（充足; 充分）...
  • 和 : 和動詞（在粉狀物中加液體攪拌或揉弄使有黏性） mix （powder） with water, etc. : 和點兒灰泥 prepare some plaster
  • 蒸 : Ⅰ動詞1. （蒸發） evaporate2. （利用水蒸氣的熱力使食物熟或熱） steam Ⅱ名詞[中醫] （將藥物隔水蒸熟） steaming
  • 汽 : 名詞1. （由液體或某些固體變成的氣體） vapour2. （水蒸氣） steam
  • 飽和 : （在一定溫度壓力下, 溶液可含溶質的量達到最大限度, 不能再溶解, 泛指事物達到最高限度） saturation; saturated
  • 蒸汽 : vapour; reek; breath; steam蒸汽採暖 steam heating; 蒸汽錘 [機械工程] steam hammer; 蒸汽打樁鍾 ste...
  1. Abstract : based on the analysis of the mathematics models of saturation steam density and superheat steam density the paper states that the deviation of the detection on temperature highly affects the accuracy of intelligent flow totalizer. especially for saturation steam ， the accuracy of the temperature detection circuit shall be designed higher than the accuracy of the instrument. thus a temperature detection circuit based on ratio method with high accuracy is introduced

    文摘:在分析飽和蒸汽和過熱蒸汽密度的數學模型的基礎上指出，溫度檢測的偏差對智能流量積算儀的精度影響極大，尤其是飽和蒸汽，測溫電路的精度應設計為遠高於儀表的精度，同時引入一種基於比率法的高精度測溫電路。
  2. Segment timer may use to record pressent year, month, date, display pressent time, and with four - segment alarm function, alarm circlate in the sequence of time from first segment to forth segment alarm point it is display intuitional, clocking accuracy, alarm reliable, with clock keep function while key off function

    採用先進的微處理器進行智能控制，主要適用於供熱供暖製冷等熱能系統中，對熱水過熱蒸汽飽和蒸汽氯化鈣水或其它制熱製冷介質中的熱能進行高精度的積算與控制。
  3. The "supersaturation ratio" is the ratio of the excess vapor density to the saturation value.

    「過飽和比」是超過飽和值的蒸汽密度與飽和值的比。
  4. Through analyzing the effect of temperature and nitrogen on crude oil viscosity the influences of different nitrogen injection volume and injection modes on steam displacement are contrasted, the mechanism of nitrogen - assisted steam stimulation is clarified, which includes : heat carrying capacity is raised, the saturation of remaining oil is reduced after nitrogen - assisted injection is made ; crude oil flow is enhanced because of nitrogen compression and dispersion and the change of oil flow shape ; water back - production rate is improved by expanding the steam sweep volume and compensating in - situ energy ; steam distillation effect is enhanced

    通過分析溫度、氮氣對原油粘度的影響，對比不同注氮量、不同注入方式等對蒸汽驅油效果的影響，弄清了氮氣輔助蒸汽增產的機理主要表現在：氮氣輔助后增加攜熱能力，降低殘余油飽和度，氮氣的壓縮膨脹作用分散和改變了原油流動形態，增強了原油流動性；擴大蒸汽的波及體積，補充地層能量，提高回採水率，強化蒸汽蒸餾效應。
  5. The project studied the direct contact condensation behavior of saturated steam on the subcooled liquid in passive gravity injection system. the experiment parameters were as follows : the initial pressure of prz ranged from 0. 2 0. 6mpa and the initial fluid temperature of core makeup tank ranged from 10 80. condensation phenomenon in cmt was observed

    本課題進行了非能動重力補水系統中飽和蒸汽在過冷液面上直接接觸冷凝的實驗研究，研究了在加裝遮流板時，系統壓力0 . 2 0 . 6mpa ， cmt初始溫度為10 80條件下壓力容器cmt中飽和蒸汽在過冷液面上冷凝的瞬態特性。
  6. A treatment method of super - saturation steam for deposited salt in steam turbine is introduced, output of the steam turbine is therefore improved through purge. purification process and attentions are introduced

    摘要介紹了背壓式汽輪機積鹽積垢的處理方法?過飽和蒸汽法，通過清洗使汽輪機的出力率得以提高。介紹了清洗的過程和注意事項。
  7. The paper is on how to set up lab platform of vapour spewing to uppercooling water surface to coagulate directly and to observe and analyse which vapour coagulate on the water surface, the results enable people to know the security system of nuclear power. the range of the pressure parameters of prz is from 0. 2mpa to 0. 6mpa, and the range of the initial temperature parameters of cmt is from 23. 5 to 78. 5, all of the testing points are 30 and there are fifty thousand testing data. many results of vapour spewing to uppercooling water surface vertically to coagulate can get. for example : coagulating can make the water of cmt surge forcefully when vapour spews to uppercooling water surface, too many vapour - bubbles come into being and strike the water of cmt owing to rupture continually, all these will strengthen the surge because of the vapour pressure of cmt

    實驗中prz飽和蒸汽壓力變化范圍為: 0 . 2mpa - 0 . 6mpa ， cmt中水初始溫度變化范圍: 23 . 5 - 78 . 5 ，實驗中測試工況30個左右，實驗測試數據50萬余個，得出了很多與非能動安全系統相關的蒸汽垂直噴向過冷水表面凝結時的結論：蒸汽垂直噴入過冷水表面凝結時會造成cmt中液面的強烈波動和振蕩，產生大量蒸汽汽泡，汽泡不斷破裂對cmt中液體帶來很大沖擊，勢必引起cmt中液體的振蕩，造成cmt汽空間汽壓不均勻，加強cmt液體的振蕩和波動。
  8. There will be a hot water layer in the water of cmt when vapour spews to uppercooling water surface vertically and coagulates directly. the higher of the vapour pressure of prz and the initial water temperature of cmt are, the deeper the hot water layer is. and obtaining the experience formula of the hot water layer is as follows : the condensation coefficient is high when vapour coagulate at first, then it will lessen with the process of coagulation, the higher of the vapour pressure of prz and the initial water temperature of cmt are, the higher of condensation coefficient is

    蒸汽垂直噴入過冷水表面凝結時， cmt中水有明顯熱分層現象， prz中飽和蒸汽壓力越高， cmt中水初始溫度越高，熱分層厚度越大，熱分層厚度的經驗關聯式為：凝結剛開始時，凝結換熱系數非常大， ，隨著凝結的進行，凝結換熱系數越來越小， prz中飽和蒸汽壓力越高， cmt中水初始溫度越高，凝結換熱系數越大。
  9. Emcyldn oils with good atomization characteristics are the suitable lubricants for saturated or overheated steam cylinder and worm gear drives

    Emcyldn具有優良的霧化特性，特別適合飽和或過熱蒸汽汽缸與蝸型齒輪的潤滑。
  10. Pressures, water level, surface and axial temperatures and total clotted liquid were obtained and analyzed. by experimental phenomenon, the condensation process was divided into two phases : steam supply limit and condensation limit. the interfacial heat transfer coefficient in steam supply limit phase was calculated

    通過實驗，觀察飽和蒸汽在cmt內的冷凝現象，獲取cmt內壓力、水位變化、表面、軸向溫度分佈和累積冷凝量等重要實驗數據，對實驗所得的數據進行分析。
分享友人
分享到 Line

分享到臉書