過高誤比特率 的英文怎麼說

中文拼音 [guògāowùbǐtèlǜ]
過高誤比特率 英文
eber excessive bit error rate
  • 過 : 過Ⅰ動詞[口語] （超越） go beyond the limit; undue; excessiveⅡ名詞（姓氏） a surname
  • 高 : Ⅰ形容詞1 （從下向上距離大; 離地面遠） tall; high 2 （在一般標準或平均程度之上; 等級在上的） above...
  • 誤 : Ⅰ名詞（錯誤） mistake; error Ⅱ動詞1 （弄錯） mistake; misunderstand 2 （耽誤） miss 3 （使受損害...
  • 比 : Ⅰ動詞1 （比較; 較量高下、 長短、距離、好壞等） compare; compete; contrast; match; emulate 2 （比...
  • 特 : Ⅰ形容詞（特殊; 超出一般） particular; special; exceptional; unusual Ⅱ副詞1 （特別） especially; v...
  • 率 : 率名詞（比值） rate; ratio; proportion
  1. For rotor steel ( 30crlmolv steel ), the tests of low - cycle fatigue property are done under different temperatures. the fatigue life under different temperatures is researched to make up for the defects of the testing for foreign similar materials. when pull - stretch data is attempted to evaluate low - cycle fatigue data, the result shows that four - point associated method in middle - low life zone is done well under room temperature, but there are large errors of four - point associated method and general - slope method under other temperatures

    在本文中，通過與國外同類材料的性能進行比較，國產材料與國外材料共有的材料特徵基本相同；對轉子鋼（ 30crlmolv鋼）進行了不同溫度下的低周疲勞性能實驗，研究其在不同溫度下疲勞壽命，以彌補國外對同類鋼材測試的不足；採用拉伸數據預測低周疲勞壽命時發現，室溫條件下用四點關聯法在中低壽命區預測較好，在高溫條件下四點關聯法和通用斜率法都有較大誤差，需要進行改進。
  2. Compared with the classical bp algorithm, robust adaptive bp algorithm possesses some advantages as following : ( 1 ) increasing the accuracy of the network training by means of using both the relative and absolute residual to adjust the weight values ; ( 2 ) improve the robustness and the network convergence rate through combining with the robust statistic technique by way of judging the values of the samples " relative residual to establish the energy function so that can suppress the effect on network training because of the samples with high noise disturbances ; ( 3 ) prevent entrapping into the local minima area and obtain the global optimal result owing to setting the learning rate to be the function of the errors and the error gradients when network is trained. the learning rate of the weights update change with the error values of the network adaptively so that can easily get rid of the disadvantage of the classical bp algorithm that is liable to entrap into the local minima areas

    與基本bp演算法相比，本文提出的魯棒自適應bp演算法具有以下優點： （ 1 ）與魯棒統計技術相結合，通過訓練樣本相對偏差的大小，確定不同訓練樣本對能量函數的貢獻，來抑制含高噪聲干擾樣本對網路訓練的不良影響，從而增強訓練的魯棒性，提高網路訓練的收斂速度； （ 2 ）採用相對偏差和絕對偏差兩種偏差形式對權值進行調整，提高了網路的訓練精度； （ 3 ）在採用梯度下降演算法對權值進行調整的基礎上，通過將學習速率設為訓練誤差及誤差梯度的特殊函數，使學習速率依賴于網路訓練時誤差瞬時的變化而自適應的改變，從而可以克服基本bp演算法容易陷入局部極小區域的弊端，使訓練過程能夠很快的「跳出」局部極小區域而達到全局最優。
  3. It contributes to the deeper comprehesion of these probability distributions, affords more detailed theoretical basis for further studying and simulating satellite mobile channels, ? theoretical analyses and discussions of the models which are often used in the study of the propagating characteristics of satallite mobile channels are given ; meantime, some discussions on the work of model simulations are also given, ? incorrect derivation of the equality between c. loo model and corazza model in some other papers is pointed out. via the conception of received power, we derivate that in the rural environments these two models really have the equal relationship by the way of theoretical derivation and simulatant fittings. therefore, it is able to use corazza model in studying the characteristics of satellite mobile channels in the rural environments and able to avoid the iterant work of modeling, in order to enhance the efficiency and accuracy of research work, ? detailed processes of simulating lutz model by using matlab6. 0 _ simulink4. 0 and the results of comparisions are given

    本文包含有以下的主要內容： ?對衛星移動通信通道傳播特性研究中常用的三個概率分佈給出了詳細的推導過程；以便對這幾個在衛星移動通信通道傳播特性的研究中常用的概率分佈函數有更深的理解，對進一步研究衛星移動通信通道傳播特性和對通道的建模提供了更為詳盡的理論基礎； ?對衛星移動通信通道傳播特性的研究中常用的通道模型進行了理論上的分析和討論，並對衛星移動通信通道建模的研究工作提出了一定的看法； ?指出了以前的文獻中關于c . loo模型和corazza模型的等同性的證明錯誤；並從接收信號功率的角度出發，通過理論推導及模擬曲線擬合重新證明了在鄉村環境下，這兩個模型的確是具有等同性的；從而在對鄉村環境下的衛星移動通信通道傳播特性進行研究時，可以只採用corazza模型來對實際的通道進行建模，這樣可以避免重復的建模工作並提高研究工作的效率和準確性； ?給出了lutz模型在matlab6 . 0 _ simulink4 . 0環境下的軟體模擬實現的詳細過程和整體模擬測試的對比結果，保證了該模型在硬體實現時的可靠性和可行性，從而可以將它們應用於指導模型的硬體模擬實現並可以降低硬體實現時的風險。
  4. The ids works by two way, misuse detection and anomaly detection, misuse detection flags an intrusion on intrusion signature, this kind of detecting technic can be realized much more easily, and much more accurate, but it can not find some intrusiones that have been disguised or new kinds of intrusion. the anomaly detection can detect in more wide field, anomaly detection can compare new statistic data with average record, then anomaly record will be found, but it ' s more difficult to set a threshold, if the threshold is too big, some intrusion may be put through, if the threshold is too small, the ids will give more false positive alarm, and the threshold will be different with different people or different period, so the ids just simply show us their suspicious record, the administrator or expert will be in duty to analyze this record and give conclusion, the ids give more alarm than it should, leave us more detection record to analyze, and this is a hard work, we can not distinguish an intrusion or not if we analyze only one record, but we can judge if we find the relation among mass detection evidence. in this article, we try distinguish an intrusion using d - s theory ( proof theory ) instead using manual work, the ids will be more helpful and efficient

    濫用檢測採用的是特徵檢測的方法，實現較為簡單，判斷的準確性較高，但是不能判斷一些經過偽裝的入侵或特徵庫中尚未包含的入侵，異常檢測能夠根據以往記錄的特徵平均值，判斷出異常情況，但是對于異常到什麼程度才視為入侵，這個閥值非常難以確定，閥值設定的太高，有可能漏過真正的入侵，如果設定的閥值太低，又會產生較高的誤警率，而且這個閥值因人而異，因時而異，因此現在的入侵檢測系統把這部分異常記錄以一定的形式顯示出來或通知管理人員，交給管理人員去判斷，而這些ids系統難以判斷的記錄，如果對每個證據單獨地進行觀察，可能是難以判斷是否是入侵，而把許多先後證據關聯起來，專家或管理人員根據經驗能夠判斷訪問的合法性，本文試圖引入人工智慧中證據理論的推理策略和示例學習方法，代替人工檢查分析，可以提高效率，降低誤警率，並可以對一個正在進行得可疑訪問實現實時檢測，通過搜索及時判斷，及時阻斷非法訪問，比事後得人工處理更有意義。
  5. The solution formula of dwell time is deduced by using the pulse iteration method and the smoothing fourier transition method, and the formula can be simplified referring to workpiece shape. according to the anastomotic status of the tool and workpiece surface, we present the new model of the inherent relation among local pressure density, removal rate, convergence ratio and residual errors, and the corresponding formulas are given. the forming cause of the edge effect in the polishing process is analyzed, and the means which reduces the edge effect is put forward

    2 、針對計算機控制光學表面成形（ ccos ）的加工方式、誤差收斂特點，研製了去除函數呈高斯分佈的雙轉子結構研拋模；採用脈沖迭代法、平滑因子傅立葉變換法推導出駐留時間的演算法，求解過程中根據工件面形的特點作了各種形式的簡化；提出了工件表面和研拋模的吻合誤差與局部壓強、材料去除率、收斂比之間內在關系的數學模型，並推導出相應的計算公式；分析了邊緣效應產生的原因，在加工過程中採用相對壓力因子對去除函數進行修正，可以消除邊緣效應的影響。
  6. In the fourth section of the thesis, the method that constructing statistical features based - on time for connection records and using these features to construct classification models were studied in detail. in order to improve the accuracy of classification model and decrease the rate of false positive, some factors that may have bad influence on accuracy of classification model were analyzed and the method of selecting appropriate set of features was also provided

    論文的第四部分，詳細研究了使用網路連接記錄的基本特徵屬性構建基於時間的統計特徵屬性方法，通過選擇適當的特徵屬性集來提高異常檢測模型的分類精度，降低誤報率；同時分析了影響檢測模型分類精度的因素；對不同實驗條件下得到的實驗結果進行了比較和分析。
  7. Last, based on the mc - cdma system model above mentioned, the matlab simulation is done. by the simulation of the ber performances from white gaussian noise, peak power clipping and combating multipath interference are analyzed, and some conclusions are obtained that mc - cdma is superior to ofdm

    最後，在上述給出的mc - cdma模型中，通過matlab模擬分析了在mc - cdma與ofdm兩種系統中由高斯白噪聲、削波噪聲以及多徑干擾所造成的誤碼率分佈曲線，得出mc - cdma系統在無線數據傳輸方面較ofdm系統更具有優良的特性，並給出了比較具體的性能分析。
分享友人
分享到 Line

分享到臉書