配料間 的英文怎麼說

中文拼音 [pèiliàojiān]
配料間 英文
compounding room
  • 配 : Ⅰ動詞1 （兩性結合） join in marriage 2 （使動物交配） mate （animals） 3 （按適當的標準或比例加以...
  • 料 : 名詞1 （材料; 原料） material; stuff 2 （喂牲口用的穀物） feed; fodder 3 （料器） glassware 4 （...
  • 間 : 間Ⅰ名詞1 （中間） between; among 2 （一定的空間或時間里） with a definite time or space 3 （一間...
  • 配料 : charge mixture; batching; burdening; ingredient; furnish; dosage; [冶金學] burden
  1. The brewing characteristics of shaoxing wine were presented in the following eleven aspects : the uniqueness of adjunct materials and the variety of different wine, the treatment of soaking rice at low temperature for a long time, the variety of fermentation state, the characteristics of rice wine broth, the variety and complexity of microorganisms, the uniqueness of inoculation and strain preservation, the process of mixed fermentation of yeast and lactic acid bacteria ( e. g. the concurrence of saccharification, yeast fermentation and lactic fermentation ), the over - mixing of different liquors, the high sterilization temperature, and the storage of produced wine

    摘要該文從11個方面論述了紹興黃酒的釀造特點，即配料的特殊性和酒種的多樣性；低溫長時間浸米；發酵狀態的多樣性；黃酒醪的發酵特點；微生物的多樣性，復雜性；接種方式獨特；菌種保存方法獨特；酵母與乳酸桿菌協同作用的混合發酵并行的過程（即邊糖化、邊酵母發酵、邊乳酸發酵同時進行的三邊發酵） ；酒液勾兌；較高的滅菌溫度；成品酒的貯存。
  2. The heat expansion coefficient of casting nylon materials is about 10 times larger than steel, so the internal dia shrinks caused by the expansion. it will influence the connection gap of the abrasive surface

    鑄型尼材料的熱膨脹系數約比鋼材大10倍左右，所以軸套在運行時由於摩擦熱所造成的膨脹變形使內徑縮小，影響摩擦面的配合間隙。
  3. Our company has an independent weaving workshop, mechanical processing workshop, plastic extruding - press workshop and an assembly workshop

    公司擁有獨立的編織車間機加工車間塑料管材擠出車間及裝配車間。
  4. The interface behavior between essence and ethylene - vinyl acetate copolymer pallets was studied so that necessary data were obtained to guide the preparation of fragrant masterbatch. the adsorption type and wettability between essence and the copolymer pallets were analysed by measurements of fourier transform infrared spectrum, surface tension, contact angle and specific surface area. the technical factors affecting absorptivity such as the charge ratio, temperature, pressure and stirring speed were studied by series of adsorption experiments. the results showed that the adsorption of essence on the surface of ethylene - vinyl acetate copolymer pallets is physical in nature. essence couldn ' t moisten the surface of ethylene - vinyl acetate copolymer pallets absolutely, but it could be soaked into the surface of the pallets partly. adsorptivity could be increased by enhancing the temperature, pressure and stirring speed, but the extension of adsorption time had little influence on adsorptivity

    研究了香精與乙烯/醋酸乙烯共聚物粒子之間的界面行為，以便為香型母粒的制備提供必要的理論依據.利用傅立葉變換紅外光譜、表面張力、接觸角及比表面面積等測定手段，分析了香精與載體之間的吸附類型和潤濕作用.並通過一系列吸附實驗，討論了配料比、溫度、壓力、攪拌等工藝條件對吸附量的影響.結果表明，香精在乙烯/醋酸乙烯共聚物粒子表面的吸附為物理吸附；香精無法完全潤濕載體粒子表面，但可以對其形成部分浸潤；提高溫度、壓力、攪拌速度可以增加吸附量，而延長吸附時間對增加吸附量貢獻不大
  5. Abstract : the interface behavior between essence and ethylene - vinyl acetate copolymer pallets was studied so that necessary data were obtained to guide the preparation of fragrant masterbatch. the adsorption type and wettability between essence and the copolymer pallets were analysed by measurements of fourier transform infrared spectrum, surface tension, contact angle and specific surface area. the technical factors affecting absorptivity such as the charge ratio, temperature, pressure and stirring speed were studied by series of adsorption experiments. the results showed that the adsorption of essence on the surface of ethylene - vinyl acetate copolymer pallets is physical in nature. essence couldn ' t moisten the surface of ethylene - vinyl acetate copolymer pallets absolutely, but it could be soaked into the surface of the pallets partly. adsorptivity could be increased by enhancing the temperature, pressure and stirring speed, but the extension of adsorption time had little influence on adsorptivity

    文摘:研究了香精與乙烯/醋酸乙烯共聚物粒子之間的界面行為，以便為香型母粒的制備提供必要的理論依據.利用傅立葉變換紅外光譜、表面張力、接觸角及比表面面積等測定手段，分析了香精與載體之間的吸附類型和潤濕作用.並通過一系列吸附實驗，討論了配料比、溫度、壓力、攪拌等工藝條件對吸附量的影響.結果表明，香精在乙烯/醋酸乙烯共聚物粒子表面的吸附為物理吸附；香精無法完全潤濕載體粒子表面，但可以對其形成部分浸潤；提高溫度、壓力、攪拌速度可以增加吸附量，而延長吸附時間對增加吸附量貢獻不大
  6. This article studies the main factors, which affect the extract ratio of aluminum oxide from lean alumina ore, such as the ratio of raw material, particle size, broiled temperature, and broiled time

    摘要探討了原料配比、粒度以及配料燒結溫度、時間等工藝因素對貧鋁礬土中氧化鋁的提取效率的影響。
  7. The curve of mix proportion kept away from the restricted zone in order to provide enough voids in mineral aggregate ( vma ) to fill the high content of conductive materials. conductive powder can regard as a part of filler in asphalt concrete

    導電瀝青混凝土的級配設計採用superpave設計方法，合成曲線盡可能遠離禁區，提供足夠的礦料間隙率來填充高摻量的導電相材料。
  8. One - step synthesization made the electrical properties more stable, controling the reducing sintering temperature and retention time can adjust the electrical properties in a certain scope, changing the oxidation temperature made the varistor ’ s voltage v10ma changed, using the special double - layer silver plasm can eliminate the voltage - direction problem

    一次配料得到的樣品電性能一致性更好;控制還原氣氛燒結溫度和保溫時間，可以在一定范圍內調節鈦酸鍶壓敏電阻器的電性能，改變氧化溫度可以獲得不同的壓敏電壓，從而得到系列化產品;採用雙層銀漿工藝成功消除了壓敏電壓的方向性問題。
  9. Test method for determining open assembly time of carpet mastic adhesives

    測定地毯膠合鋪料粘合劑的開放裝配時間的試驗方法
  10. Attention : according to eu - law allergens have to be declared not only if your product contains allergenic ingredients according to your recipe but also if your product might contain allergens by possible cross contamination, e. g. incorrectly cleaned machines and tools or by other product lines in the same factory or if a single component of a compound ingredient ( e. g. : aroma ) is allergenic

    注意：根據歐洲法律，過敏素申明不僅必須說明依照處方你們的產品中是否包含過敏性配料，同時還需說明你們的產品是否可能因交叉污染而含有過敏素，如使用了未正確清潔的機器和工具、被同一間廠房內其它產品生產線污染、或一種復合配料（如芳香劑）中的某個單一成分為過敏性成分。
  11. The content of the paper includes an overview of the evolution and the present state of production control system, the working principle of the proportioning system and the overall design of the new control system, focuses on the details of the siemens plc ' s application including hardware design, programming environment and software design, configuration software wincc and some of its basic software design in the h igh level supervisory computer, as well as the communication between the plc and the supervisory computer

    論文內容包括對生產過程式控制制系統發展和現狀的綜述；配料系統工作原理和配料控制系統的總體設計，重點描述了包括硬體設計、編程環境及軟體設計在內的西門子plc在配料系統中的應用一些細節，組態軟體wincc及其在上位機監控系統中一些基本設計，以及plc與上位機之間的通訊。
  12. Abstract : in this paper, the relation between the void in mineral aggregate ( vma ) and bituminous mixture capability are analyzed. the void in mineral aggregate is calculated based on the compose - parameter of bituminous mixture. the paper presents the method of proportioning design that controls the void in mineral aggregate, and the result has been checked out by marshall test and wheel tract test

    文摘:分析了礦料間隙率對瀝青混合料路用性能的影響規律.計算了各種混合料組成參數時礦料間隙率的大小.提出了通過控制礦料間隙率來進行瀝青混合料配合比設計的方法，並通過馬歇爾實驗和車轍實驗來加以檢驗
  13. When the " rice noodles crossing the bridge " gets to the table, it includes a hot soup that gives off no steam, a bowl of rice noodles which have been cooked but then dried, strips of raw meat, and chinese chives. first you scald the meat in the soup, then drop in the rice noodles along with the condiments. prepared in these stages, the dish preserves that fresh - cooked taste all the way through

    過橋米線端上桌，包括一碗浮著雞油卻不冒煙的滾燙熱湯一碗燙熟而瀝乾的米線幾片生肉與韭菜等配料，先將肉片放入熱湯中涮熟，再放入米線與配料，一碗分段完成的米線，保留了第一時間離鍋的火候，而這樣大費周章的背後，有一段溫馨感人的故事。
  14. Impact on the environment and traffic of three concrete batching plants to be built in the vicinity of tong yan san tsuen

    將在唐人新村附近興建的3間混凝土配料廠對環境及交通的影響
  15. Lands department had not received any further complaint against the concrete batching plant between 1992 and october 2000

    在一九九二年至二年十月期間，地政總署再沒有收到有關該混凝土配料廠的投訴。
  16. The criticism may be unfair ? differences between products lie largely in the varying proportions of ingredients used ? but the perception of reduced value will be hard to shift

    由於產品之間的差異很大程度上取決于所用配料的比例，從這個角度來講，上述批評顯得有些不公平，但是名牌產品價值打折扣的可能性很難避免。
  17. Short production cycle and fast material feeding via the smart control of the material feeding time, no waiting between weighing equipments

    智能化控制配料時間，配料各秤（稱）之間無任何等待，生產周期短、配料速度快。
  18. Temperature fluctuations caused by either power transients or environmental changes, along with the resulting thermal expansion mismatch between the various package materials, results in time and temperature dependent creep deformation of solder

    然而封裝的高密度使單位體積內容易產生更大的熱量，因此必須關注熱引起的封裝失效問題。特別是由於封裝材料間熱膨脹系數不匹配而導致的焊點失效。
  19. Thermoplastics piping systems. end - load bearing joints between small diameter pressure pipes and fittings. test method for leaktightness under internal water pressure, including end thrust

    塑料管道系統.小直徑壓力管與配件間的端負荷軸承連接.包含軸向推力的內部水壓下密封性試驗方法
  20. Guangzhou youbao biotech co., ltd. ( gzyb ) is a sino - foreign joint venture high - tech enterprise, which combines the development, production and trading of bio - products, medical material, food antioxidants ， anti - staling agents and food supplement

    廣州優寶公司是一家從事生物降解材料（環保產品） 、食品抗氧化劑和食品配料、醫藥中間體的研發、生產、經營的高新技術企業，注冊資本為1000萬元。
分享友人
分享到 Line

分享到臉書