配重 的英文怎麼說

中文拼音 [pèizhòng]
配重 英文
additional weight
  • 配 : Ⅰ動詞1 （兩性結合） join in marriage 2 （使動物交配） mate （animals） 3 （按適當的標準或比例加以...
  • 重 : 重Ⅰ名詞（重量; 分量） weight Ⅱ動詞（重視） lay [place put] stress on; place value upon; attach im...
  1. Correction of torpedo ' s centroid eccentricity with counterweight technology

    魚雷質心配重糾偏技術的實現
  2. Standard counterpoise please provides flow rate, density

    標準配重請提供流速密度
  3. Experimental study on overspan safety of counterpoised travelling bridge - erecting machine

    配重行走式架橋機過跨安全性試驗研究
  4. The weight of the extensometer is balanced by means of a counterweight.

    利用一個配重來平衡引伸儀的自重。
  5. Passenger lift installations. guide rails for lifts an counterweights

    載客電梯和貨物電梯.電梯室和配重指南. t型材
  6. Manufactures electronic platform scales & loads cell kits to determine center of gravity on aircrafts

    製造電子平臺配重測量工具，以確定飛機重力中心。
  7. Study of balance weight in wheel vane welding installation

    轉輪葉片裝焊配重工藝研究
  8. Balance weight and rim flange design specifications, test procedures, and performance recommendations

    配重和輪輞輞圈的設計規范試驗程序和性能推薦標準
  9. It can protect movements of motors, electrical appliances, it may balance weight in cutting, and make it more stable

    對電機、電器動作均有保護，並在切割時有配重，使之更加平穩。
  10. In the light of the problems of the air balance system of model lcj1250 chain drive pumping unit, it is proposed to change the air balance with counterweight balance, and three criteria for the modification is put forward : ( 1 ) ensuring the reliability of the unit with smooth operation, low noise and long life ; ( 2 ) cutting down the production cost and using less component parts as possible ; ( 3 ) carrying out modification without such main technical parameters as stroke, pumping speed and maximum polished rod load

    針對lcj1250氣平衡式鏈條抽油機存在氣平衡故障率高和現場維修困難等問題，提出將氣平衡改造成工作可靠的重力平衡的方案，並確定了改造的三個原則：一是保證整機的可靠性，使抽油機運轉平穩，振動噪音小，壽命長；二是力求降低生產成本，減少零部件製造，盡可能選用原來的通用件，捨去平衡缸和空氣包等氣平衡附件，在原往返架主體上懸掛一個配重箱；三是力求不改變沖程、沖次及最大懸點載荷等主要技術參數。
  11. Abstract : in the light of the problems of the air balance system of model lcj1250 chain drive pumping unit, it is proposed to change the air balance with counterweight balance, and three criteria for the modification is put forward : ( 1 ) ensuring the reliability of the unit with smooth operation, low noise and long life ; ( 2 ) cutting down the production cost and using less component parts as possible ; ( 3 ) carrying out modification without such main technical parameters as stroke, pumping speed and maximum polished rod load

    文摘:針對lcj1250氣平衡式鏈條抽油機存在氣平衡故障率高和現場維修困難等問題，提出將氣平衡改造成工作可靠的重力平衡的方案，並確定了改造的三個原則：一是保證整機的可靠性，使抽油機運轉平穩，振動噪音小，壽命長；二是力求降低生產成本，減少零部件製造，盡可能選用原來的通用件，捨去平衡缸和空氣包等氣平衡附件，在原往返架主體上懸掛一個配重箱；三是力求不改變沖程、沖次及最大懸點載荷等主要技術參數。
  12. Countor weight charging crane

    配重式裝卸車
  13. 4. in accordance with the difficult problem of trial - weight on the using horizontal decanter centrifuges, this paper bring forward a method to gain the inner unbalanced weight through adding trial - weight on the external rotor. we have discussed the theory of this method in detail and the feasibility of this method have been accepted by the high - grade technician in some factory

    針對目前在役臥螺離心機的內轉子沒有預留可裝拆的配重處的問題，本文提出了在外轉子上試重進行平衡再換算到內轉子校正面上的平衡方法，此方法在理論上已得到充分的論證，在可行性方面已得到了有關企業高級技術人員的認可。
  14. Study on the attached drive impeller in small four - wheel tractor

    小四輪拖拉機驅動輪附加配重研究
  15. Guide shoes for shaft conveyances and counterweights with guide rollers in mining

    采礦用帶導向輪的井筒運輸工具和平衡配重用的導瓦
  16. Guide shoes for shaft conveyances and counterweights with slide - ways in mining

    采礦用帶滑槽的井筒運輸工具和平衡配重用的導瓦
  17. In the modal analysis, the similarity laws has been introduced to reduce the error during the assessment of the prototype building ' s natural frequency under the insufficient balance weight testing. by the author ' s theory, the prototype natural frequency can be the same even the balance weight of model is changeable

    在模態分析方面，本文利用相似性原理，解決了模態試驗在配重不足時，求解原型結構自振頻率誤差過大的問題，並且得出了在不同配重條件下，試驗模型與原型結構的頻率可以達到一致的相似準數。
  18. Every driving interface module could equally be driven by one or two ball leading screws

    垂直方向的三個驅動介面模塊附加配重。
  19. Due to the vibration and swing of generating units of wujiangdu hydropower station are larger than specifications when its capacity is added, the authors analysis the reasons and provide the measure of weight correction

    摘要針對烏江渡水電站增容改造后1號機組振動擺度偏大的現象，分析了引起機組振動擺度過大的原因，並提出了配重校正的措施。
  20. The control force characteristics of manual-control system can be modified by the introduction of weights and springs.

    可以通過引進配重和彈簧來改善手控操縱系統的操縱力特性。
分享友人
分享到 Line

分享到臉書